I wanted to put bigger tires on my truck, something more agressive. Is there a torsion bar? Can it be adjusted? How? If not what is the biggest tire i can put on with my stock 17" rims? 2wd 2005 f150...
View 2 RepliesI just got this truck with the plow installed so I'm not sure what kind of adjustments are available for the plow itself. If I add a 3-4" lift, will the plow still reach the ground and work OK? What kind of adjustments would need to be made?
View 2 RepliesI have a 2002 Ranger that I adjusted the torsion bar so the front end sits level. My dad has a 2007 F150 XLT that doesnt appear to have a torsion bar. I am looking at trading for a 2010-2012 F150. What year did the F150's stop having torsion bars? Do ALL F150's not have them or does it vary by trim package? If I were to buy a 2010-2012 F150, what would I have to do to make the truck sit level (raise the front end)?
View 8 RepliesI'm not too familiar with the difference between lift kits and leveling kits. I want to lift my truck 2" but in doing research do i need get a lift kit and a leveling kit? For the front and the back? I have a 2006 F150 4.6 V8 RWD I also haven't been able to find any good places to but the kits (also because I don't know what all i may need) It would be ideal to get a kit i can bolt on myself.
View 1 RepliesI have a 2004 fx4 supercrew 4x4 , 170k miles. I bought it a few months ago and installed a 6" rough country lift and 35" tires. I noticed a little shake in the steering wheel but not too bad, just annoying. I just put on a fabtech dual steering stabilizer to remedy the problem and its much worse. What could be at fault that dual stabilizer would make it worse? I hate to just take them off, I would rather find the problem. Oh, the tires are all balanced and I had an alignment done also.
View 14 RepliesWhat are the largest size tires that will fit to give my truck a tougher look without rubbing or causing any other issues? Again I have a 2008 FX4 SuperCrew.
View 14 Repliesthis is my brothers truck 05 f-150 4x4, i put brakes front and back and flushed the system about six months ago now. the other day when he was coming home from college the front passenger tire locked up. he drove it home and i went over took it apart nothing was sticking put it back together and it was fine. now today he call it stuck again so i just pulled it apart, pads are now purple from the heat, pins are free, caliper moves i put a small piece of wood in it and had him press the brakes the caliper moved out and i pused it back in, reinstalled everything and its not stuck no more. what do you think is causing this? my uncle says it could be the abs box acting up, when he bought the truck my dad made him buy the extended warrenty but he wont pay the 100 dollar deductible because this past winter we all went out in the two foot of snow and he got stuck so i pulled him out and our dad says thats what f$ucked his brakes up so now his is pissed. so how can i fix this for him? oh it only has 42k on it
View 7 Replies2005 FX4 truck. Doesn't click when going straight, but if turning wheel like turning into or out of a parking spot, it makes a clicking noise that gets faster as you get faster. It sounds almost like a baseball card in a bicycle spoke honestly. Don't know if its related, but about 3 months before i noticed the sound I had the Rancho quick lift struts installed on the truck. Somebody told me it could be wheel bearings but in my experience a wheel bearing will make a roaring noise, and it would roar while going straight down the road. This is only when turning the wheels. Also, it doesn't matter if you turn left or right, you can hear it both directions.
View 6 RepliesI have a 2005 f150 and it will not engage the front hubs. It is a manual shift on the fly not electric. I have done some checking and this is what i have found so far. Pull the lever into 4H, dash light comes on, IWE's do not lock onto axle. Same for 4L. The transfer case does come in when lever is pulled into either 4H or 4L. Front end up on jack stands, engine off. Turn either wheel and axle turns with it as it should. Start engine, turn either wheel and it is free from axle, as it should be. so there is vacuum going to IWE when engine is on. Not sure what to check next. Is the vacuum solenoid on the firewall bad?? Is there something not getting activated when i pull the floor lever back?
View 4 RepliesI have a 2005 Supercrew 4X2 with 110,000 miles on it. Lately I've noticed at 30 mph and up if I steer to the left I get a growling noise from the left front. When I straighten up or steer right it goes away. I don't feel anything in the steering wheel or seat of the pants...just this growling noise during a left steer. Tires are about half wore out...I went ahead and rotated them to see if the growl moved. It didn't, stays in the left front.
Does that sound like the bearings in the rotor are on the way out? It won't stop raining so I haven't had a chance to jack it up and see if I have I have play in that tire/wheel. I thumbed through my Haynes manual and it seems pretty straight forward to replace the rotor. New rotors/bearings, one time use nut, might as well do pads while I'm in there, torque nut to 275 ft. lbs. Am I on the right track? Any other way to diagnose this growl? Is the R&R of the rotor as easy as it sounds? Tips or trick, things I should know that Haynes isn't telling...
My 2005 F150 is making a thumping noise in the front end. It increases as speed increases and is more pronounced when turning wheel left and almost goes away when turning to the right. Sometimes at higher speeds I can feel it in the gas pedal. Seems to be coming more from the driver side but I could be wrong On that.
View 3 RepliesI want to level the front of my truck. 1999 GMC Serria 2500 4x4. Wondering what is involved. Do the cams on the torsion bars need to be released and rotated or can I just turn the bolts in?
View 2 RepliesMy 2005 f150 extended cab / supercab front doors wont close fully. The light on the dash goes off, but you can see the door is still open in the mirror. It also sounds open. The rear doors are fine.
View 6 RepliesI have a 2005 F150 4x4, with just over 75K, and I have owned it from new. I am having left front brake issues. The left front brake seems to drag, but of course does not do it consistentally or after a given type of braking event. It just does it very randomly. I originally replaced the caplier pins thinking one may have been hanging up. It seemed to fix the issue for a couple months then it happened again. So doing more inquiry it seems some have had issues with the front rubber lines.
I just had both front lines replaced with OEM Ford parts and the system flushed out at a dealer. The brakes again seemed to work fine driving home from the dealer anto work today. Then on the way home it did it again, started dragging. The truck starts to feel sluggish while accelerating and slows very quickly just lifting off the gas. then when you get out you feel the wheel and it is very HOT and you can hear a heat popping sound. (First time it happened it was smoking it got so hot.) Right side seemsfine.
Since it does it so randomly I am at a loss. I can not just drop it off at the dealer and say drive it until it. I am considering having the caliper replaced, which I really considered when it was at the dealer for the hoses since I had the IWE's done at the same time, so they were off.
I have a 2005 ford f150 supercab 4x4, and around feb I replaced all the ball joints my self, and now recently when back with the wheels turned turned to the left and then put it in drive and turn the wheels all the way right and give it has to take off there is a popping noise that comes from the driver side front wheel and it just does it once I take off and quit . I've looked and everything and cant see anything that would cause this. And know when I put it in park and it rolls forward I can hear a popping noise that sounds likes it coming from the rear end. I had my rear rebuilt, with new pinion bearing and race, a new axle on the pass side with bearing and the shop told me that it the driver side is questionable on the axle but it has new bearing also, they also told me that it needs a carrier case cause it had groves wore in it where the axle bearings wore out so much. at the time I could afford to have them to replace the carrier case. what would cause the popping from the front end and now the popping in the rear end.
View 1 RepliesI have a 2005 F150 4X4, has 43,000 easy miles on it. When I started the truck I notices white smoke come fron the exhaust. It was a cool morning and the truck was sat for 24 hours, I have read some post about how that could be the reason. I was also told that adding a quart of lucas in place of one of the (motorcraft synthetic) quarts.
View 3 RepliesMy 05 f150 is lift with a 6" skyjacker lift I've only had it a week from the dealership when it stopped firing on cylinder 8 which is a lil problem easy to fix,but then it started clunking around turns in the front and rear end. So I took it the dealer and 3 days later they give it back. It's running good but its still clunking in the front they said they changed the cv joints and tie rod ends but after I got home. I inspected it they changed one damn tie rod and that was it. Is it the tie rod end that's still making the noise?
View 1 RepliesI have a 2008 extended cab gmc, I noticed the top of the front door sinks in more than the back when the doors are closed. They are not aligned flush, can I adjust the doors to have the same gap and be flush? did someone adjust the door that way for wind noise maybe?
View 2 RepliesIs there any mechanical adjustment on the manual shift hydraulic clutch? My clutch is not slipping but is just about all the way up on the pedal.
View 3 RepliesMy 05 Supercrew 4X4 with 172k miles started making a horrible noise these last couple days. It sounds like its coming from the front passenger side area. The best I can describe is that it sounds like an electric tool motor with bad bearings. I'll be driving along at 45mph or above and every now and then I'll hear a really bad bearing squeal. It's bad enough that I can feel the extra friction caused by the squeal start to slow my truck down. It's vehicle speed related. I know what a bad wheel bearing sounds like and this is nothing like that. It's gotten bad enough I'm nervous to drive anywhere.
View 4 Replies2006 4.2L The pedal is good and the fluid is full but the clutch engages and releases about 2 inches from the floorboard. Is there possibly a rod that can be adjusted at the slave cylinder that moves the engage/release point along the pedal travel? Any thoughts before I get out the creeper?
View 1 Replies