I'm not too familiar with the difference between lift kits and leveling kits. I want to lift my truck 2" but in doing research do i need get a lift kit and a leveling kit? For the front and the back? I have a 2006 F150 4.6 V8 RWD I also haven't been able to find any good places to but the kits (also because I don't know what all i may need) It would be ideal to get a kit i can bolt on myself.
View 1 RepliesI wanted to put bigger tires on my truck, something more agressive. Is there a torsion bar? Can it be adjusted? How? If not what is the biggest tire i can put on with my stock 17" rims? 2wd 2005 f150...
View 2 RepliesPut in 2.5" leveling blocks under front coil springs. Now I hear a clunk nearly every time I turn to the right. Why this might be?
View 3 RepliesSo this may be a really dumb question, but here goes. I have a new to me 2001 v10 gas 4x4 ex. It has obviously been lifted in the past. The springs seem totally shot as the back end is quite a bit lower than the front and drops dramatically while towing. I am adding a helwig and have a wd hitch but have not set it up yet. So my question is can i do the spring swap? It would seem that i would need to address whatever changes are made from the stock ride but im not sure. I like the current lift and would be fine keeping it and adding the lift from the new springs.
View 14 RepliesI put on a leveling kit a few months ago and pretty much replaced a lot of worn out parts in the front fenders. With the exception of lower control arms, shocks and springs. Just about everything else that moved was replaced I think.
Well now it seems like every time I hit a decent bump in the road my truck jumps to the side. It's very noticeable if I'm going around a corner and hit a bump. The steering wheel is thrown from side to side so I'm fairly certain that the issue is up front but don't really know where to start looking.
The truck may have done this before the leveling kit but it's very exaggerated now. It's so bad at times that my husband won't drive it.
I want my the front of my truck to be higher that the back. I want it to lean a bit; what should I purchase?
View 7 RepliesNot sure what I put in there but can't get it to open. It slides back but it does not lift up. I could peek through and see that nothing's preventing from lifting up the are rest so I'm thinking it's something in the top bin that's getting it stuck. (maybe phone charger cable?)
How I can fix this. The top cover is air tight so I can't even see what the problem would be.
I have a 2004 fx4 supercrew 4x4 , 170k miles. I bought it a few months ago and installed a 6" rough country lift and 35" tires. I noticed a little shake in the steering wheel but not too bad, just annoying. I just put on a fabtech dual steering stabilizer to remedy the problem and its much worse. What could be at fault that dual stabilizer would make it worse? I hate to just take them off, I would rather find the problem. Oh, the tires are all balanced and I had an alignment done also.
View 14 RepliesWhat are the largest size tires that will fit to give my truck a tougher look without rubbing or causing any other issues? Again I have a 2008 FX4 SuperCrew.
View 14 RepliesI just got this truck with the plow installed so I'm not sure what kind of adjustments are available for the plow itself. If I add a 3-4" lift, will the plow still reach the ground and work OK? What kind of adjustments would need to be made?
View 2 RepliesI am finally thinking of leveling out my 2012 f-250. First of, I have the FX4 off road package on it, I guess with heavier duty shocks. When I pull my camper the back end of my truck sags quite a bit, it actually sags a lot with just my polaris sportsman 4 wheeler loaded in it. So I was wondering would a 2.5 inch leveling kit with a 4-5 inch block in the rear work? Would I have to add air bags to solve my sagging problems? Would I be better off just getting a whole suspension lift kit?
I had a 2.5" level kit with a couple inch block in the rear on my f-150 with 35s and I loved the look, not to mention you couldn't beat the price.
My 2006 F150 was purchased by me in early 2009 with about 28,000 miles on it. It's an XLT crew cab 4X4 with the 5.4. Stock except for a leveling kit and an aftermarket head unit. It currently has about 59,000 miles and has been babied since I purchased it. About 3 years ago I started noting some issues:
A. Oil pressure dummy gauge is all over the place. Some times it will show no oil pressure. Other times it is all the way to the highest mark. Other times the needle has gone 180 degrees past where normal is and is actualy pointing straight down towards the floor.
B. Recently my alternator dummy gauge has started doing the same thing as my oil pressure gauge.
C. The backlight behind my odometer works intermittently, but mostly not at all.
D. My dome light will flicker when first turned on. It doesn't matter which door is opened or if the override switch it turned on. It takes several seconds to come on and will flicker like there is a poor connection somewhere, but stays on once its on.
E. Blower fan will occasionally stop blowing. Once the climate control switch is turned to off, then back to on it resumes working. This doesn't happen often, but does occasionally.
Fortunately, the truck has not left me stranded and I want to keep it that way. We are getting ready to sale my wife's Toyota and this will become her daily driver. I want to take care of any issues before she starts driving it. Are these all separate issues or is there one common issue which could be causing them all?
2006 F150, SuperCrew with 5.4
I just replaced the firewall actuator valve for the hubs, and went to try out the 4 wheel drive. The hubs engage and lock to the axle shaft, the transfer case engages and locks to the front driveline, but the front differential isn't doing anything. Is there an actuator for the front or did something break inside?
I noticed the rear end of my F-150 starting to leak from the front of the rear end. What will I need to do to fix it and is there a quick way to fix this issue, as two kids unfortunately prevent me from having much time to fix the issue.
View 5 Repliesmy f150 has the push button 4x4 and the light on the dash illuminates but i get no power to the front wheels only a grinding noise if the rear wheels spin.
View 7 Replies2006 f-150 lariat 4wd:
The power Tailgate window works but the sunroof doesn't and i noticed tonight that the button for the tailgate window is illuminated green signifying it has power but the sunroof button right next to it is not illuminated. I just bought the truck yesterday and knew that the sunroof didn't work. i figured i could fix it i just am not sure where to start yet.
It looks like the sunroof might have leaked before and so the previous owner sealed it with silicone from the roof of the truck. i removed the silicone and made the sunroof free to open and close but i still have the issue that there is no power to the sunroof. i was thinking maybe the motor burned out because it couldn't move and that someone had tried to open it while it was glued shut, but that still doesn't explain the light not coming on.
2006 Lariat 4x4 Troubleshooting. My front wheels wont engage when I select 4H or 4L. No dash lights are ever lit.
I read up and understand how the system works and plan to replace the solenoid, transfer case motor and both hub actuators. I swapped out the solenoid and wanted to test that it was functioning properly so I followed the video below:
YouTube........
With the engine running and selector switch at 2WD, I pull the vacuum lines off and can feel vacuum at the supply. I then hook up just the supply line up (to the bottom port) and expect to feel vacuum at the other solenoid port (top port - what I would call the outlet) and cannot feel any vacuum.
This has halted my repair attempts as I am not convinced this is functioning and would pull in the actuators if they were functional. I know it's a small vacuum from a small orifice but I would think I should feel it by hand, no?
The solenoid's electrical connector is plugged in during this as well. I get the same performance with the old solenoid and the new. If I bypass the solenoid I can feel vacuum at the front wheel hubs.
Should I try a third solenoid? Seems unlikely I would have 2 bad ones...No OBDII codes at all. What to try next?
I just bought 2006 f150 4wd . It make a grinding sound on both sides in the front end..it seems to be independent and when I slow and come to a stop, I makes a clanking noise like its locking something in.
View 4 RepliesSome say the front drive shaft should turn by hand in 2h and some say it shouldn't.... I have an 06 FX4, with auto locking hubs (meaning if I want 4H i turn from 2H to 4H). I've been getting a terrible shake at 55mph (yes I've read the forums on that too, not my question) .
So I crawled underneath to look at rear driveshaft, u joints, etc..., and by chance I grabbed the front driveshaft to pull myself forward to check out everything else, and it didn't turn......
I twisted a little and the shafts going to both front wheels turned. Now shouldn't these turn freely in 2H?....The light to 4H never comes on when I switch it, but it is engaged (or else I'd never have gotten unstuck....several times)... Am I stuck in 4H and just didn't know? .
Previous owner of my truck installed a front leveling kit (2" aluminum shims under the coil spring seats) and was told by a dealer that it definitely lead to the wear and tear on the front end, specifically the track bar and track bar ball joints. They also stated it causing the truck to still pull to the left even when aligned because the geometry was off. My truck has 56k miles on it.
I was informed of this after months of trying to correct the death wobble. After 4 alignments at NTB, I took it to the dealer for diagnoses. I paid them to do the labor of replacing the track bar, but elected to remove the leveling spacers myself. Came out in about 45 mins, but had to purchase the shorter stock seat bolt from the dealer which was only available as a package with the coil spring seat...
Truck now rides better and seems perfectly aligned, before it pulled hard to the left. Wish I would have known about this earlier...
I owned a 99 f250 a little while ago. Just bought a 2006 crewcab F150 xlt about 2 months ago, and for the past month there has been this unusual grinding or whirring like noise coming from the front passenger side wheel.
I took it to the mechanic and he found a bad wheel bearing on drivers side and replaced it but that wasn't the issue. He could hear the noise but wasn't able to figure out what the actual issue was.
The noise only happens when my foot is on the throttle. (not when coasting) and i also just discovered that it doesn't make any noise at all when put in 4x4.