Ford F-150 (2004-2008) :: Grinding Noise Coming From Front Wheels
Apr 23, 2013
I have an intermittent grinding noise coming from what sounds like both front wheels, it sounds like metal on metal almost like something metal rubbing the rotor but I just put new pads on and the noise was there before as well with nothing touching the rotors but the pads. The sound will appear out of no-where at low speeds of 35 or below and will continue until I brake and slow down, just before I come to a compete stop the noise will stop with a slight clunk.
I can then drive away with no noise. I am pretty sure it is not brake related except maybe ABS somehow but was also thinking front axle or diff, also have read posts that are bearing related, but both at the same time?. It is the slight clunk before stopping that I can not figure out is related to. It is an 05 f150 xlt 5.4 super cab 4wd with 85k miles
View 2 Replies
Advertisement
Last week while my wife was pulling out the cart . I heard a grinding noise coming from the back wheels. i figured it was time for new brakes, I changed the front last year so rears were pending.
I changed rotors and pads, they were like 20 per left. also looked like the e brake was touching the rotors. I adjusted that a little.
So the noise is still there and its worse. I have no clue what could be making the noise. brake dust shield maybe.. shocks .. Its worse when i turn right...
I have done brakes on every car i have owned and it was pretty easy for lx. What could be causing the noise.
View 3 Replies
I owned a 99 f250 a little while ago. Just bought a 2006 crewcab F150 xlt about 2 months ago, and for the past month there has been this unusual grinding or whirring like noise coming from the front passenger side wheel.
I took it to the mechanic and he found a bad wheel bearing on drivers side and replaced it but that wasn't the issue. He could hear the noise but wasn't able to figure out what the actual issue was.
The noise only happens when my foot is on the throttle. (not when coasting) and i also just discovered that it doesn't make any noise at all when put in 4x4.
View 4 Replies
Just got a 2013 IS-F. Loving this car, but discovered an annoying issue. Grinding noise coming from front brakes when slowly coming to a stop below 5 mph. Is this normal?
View 9 Replies
I have a 2004 F150, 5.4L V8. A few years back I was in an accident when someone slammed into the front of my truck. The right front wheel & tire took the brunt of the accident. I thought the repair shop had everything back to normal until recently I occasionally have a grinding sound coming from the right front side, seems to be related to the axle. It doesn't do it all the time just at random while I'm driving. The only solution I can find is to pull over or slow my speed to a crawl. Once I slow down enough or turn my wheel one way or the other its like something SLAMS back into place. I had it looked at by a local mechanic and they couldn't find anything wrong. Could it be something in my right front axle?
View 7 Replies
2005 ford f150 Fx4 So last Friday I started hearing a grinding noise from the passenger side front of my truck. sounded like metal on metal. So I started rooting around and noticed that bottom ball joints were shot. so replaced bottom ball joints on both side. I aslo replaced wheel bearing hub assembly on both sides, still heard the grinding. So I noticed that both axles were slinging grease, so I replaced them on both sides.
Still heard the grinding noise. So then I removed everything from the passenger side and noticed that the locking hub actuator was grinding both axle and the wheel bearing hub. So I just got done replacing that on the passenger side, put it all back together, and still grinding noise ringtones free. Also replaced the 4wd solenoid that they said gets water in it, and I replaced the check valve. And I put new Rotors and breaks. What it could be?
View 2 Replies
I just bought 2006 f150 4wd . It make a grinding sound on both sides in the front end..it seems to be independent and when I slow and come to a stop, I makes a clanking noise like its locking something in.
View 4 Replies
When I start my vehicle, it makes a grinding noise, sounds like it's coming from the front of the vehicle, when I put into gear it stops. It started gradual and is getting worse. It's a 6 cylinder automatic, with 108 k miles.
View 3 Replies
I've got a new issue that is happening on the front end of my truck. Whenever I try turning my wheel while driving, I get this rubbing/grinding noise coming from the front of my truck. It only happens when the wheels are in motion. It seems to happen less when I'm driving at higher speeds, but I can notice it make the sound at any speed. I tried driving it slowly in an empty parking lot while turning and it's definitely making the sound every time the tires rotate.
I took it in for an alignment because this was happening every time I drove, whether it be driving straight or making a turn. Now that my alignment has been fixed, it no longer make this noise if I am driving in a straight line, so it only seems to happen when I'm turning. I had the mechanic check to see if they could reproduce the issue. The mechanic was able to hear what I hear, but when he put it on the lift at the shop, he was not able to reproduce the sound.
View 6 Replies
My R is developing a grinding noise from the front wheels. I thought changing the tires will fix this problem but it didn't. Any wheel bearings failure reports?
View 10 Replies
I've got a 2004...it has 90,000 miles. For about the last 5000 miles I've been experiencing - only a few times a month, and totally out of the blue - a grinding noise coming from the front (i think left). This happens when I'm traveling at about 55-58 mph (never at lower speeds). It even happened once when the cruise was set. It gets pretty loud, and i find that if i pull over and stop for a few seconds, then keep going, that it stops. In other words, it seems that breaking to a stop disengages whatever the cause is. Also, no warning lights come on at all...like i said, it happens totally out of the blue. No, it's not the wheel bearing.
View 6 Replies
I gotta a roaring noise coming from my right front while turning. Planning on replacing just the wheel bearings tomorrow & not the whole hub assembly(2008 2wd). Is there a thread that lays out the steps and other parts I may need? I've seen alot different stories on the net on how to do it. Everthing from I can press new bearings to I have to do 4x4 hub conversion. Seems to be some confusion.
View 2 Replies
Alright, so about a month ago I was driving when I heard a terrible noise sounded like a pop can stuck between a bike tire coming from the front end. I figured this was the dreaded noise most folks hear when the 4wd system isn't getting enough vacuum.
It did this for about two days, even after replacing the IWE solenoid, then it just stopped and I haven't heard it since. Me being on the cautious side, I'm a bit worried. I haven't jacked the truck up, but I did (brace yourself) lay under it while my buddy drove slowly over, there was no unusual movement.
Question is, if I had to replace anything, what exactly would it be and how much am I looking at? My warranty will be up in about a month or so and Ford has been less than spectacular with repairs thus far so I'd like to go ahead and fix it myself
View 1 Replies
I have a 2005 KR that the 4wd doesn't lock in the front wheels. I haven't seen my exact problem as I have been searching it. When I turn the switch. The dash lights both in high and low 4wd. I hear the transfer motor engage in both hi and low. No ratcheting noises from the wheels. I have replaced the solenoid. And still nothing. Checked fuses And they are OK.
View 3 Replies
I just recently bought a used 2004 fx4 with 148k and everything appears to be engaging but front wheels not pulling. I've already replaced the IWE solenoid behind the battery to avail, my question is, when I put it in 4H, light comes comes on, but I don't "feel" the transfer case engage, when I put it in 4L, light on I feel it shift. So could the shift motor not be engaging the front driveshaft even though the lights come on?
View 10 Replies
I recently installed a 2" aluminum HBS leveling kit on my F150. ('04 FX4 SCrew, 5.4, 61K miles). I was excited to finally improve the truck rather than fix something. The install was straightforward and I didnt have any issues (other than Cleveland, OH rust).
After installing the kit I noticed a whirring noise coming from the front end while driving, but I didnt think much of it and I got an alignment a couple of days later. Immediately after the alignment, the problem is still there. It sounds just like aggressive mud tires driving down the road, so I think it is coming from the tires.
The noise follows the speed of the truck (the pitch gets lower as you slow down) but you cant really start to hear it until you slow down below 45 mph. It is much more noticeable at lower speeds (probably because of the lower wind noise in the cab). I dont think it would be a CV joint/axle issue, but who knows. I am considering taking it back to have the alignment checked, but I figured I would check on here before I do.
I just bought this truck last fall, and it is one step away from being traded in because of the countless nuances this thing has (wet floors and consequently rust everywhere on the inside of the cab, rattling window trim, shaking bed, squeaky rear window, noisy phasors).
View 14 Replies
I have a 2005 ford f150 supercab 4x4, and around feb I replaced all the ball joints my self, and now recently when back with the wheels turned turned to the left and then put it in drive and turn the wheels all the way right and give it has to take off there is a popping noise that comes from the driver side front wheel and it just does it once I take off and quit . I've looked and everything and cant see anything that would cause this. And know when I put it in park and it rolls forward I can hear a popping noise that sounds likes it coming from the rear end. I had my rear rebuilt, with new pinion bearing and race, a new axle on the pass side with bearing and the shop told me that it the driver side is questionable on the axle but it has new bearing also, they also told me that it needs a carrier case cause it had groves wore in it where the axle bearings wore out so much. at the time I could afford to have them to replace the carrier case. what would cause the popping from the front end and now the popping in the rear end.
View 1 Replies
I have a 2006 XLT w/ the 5.4L engine. Manual transfer case, I'm wondering where to start looking for problems w/ the 4x4...the front wheels don't engage.
View 3 Replies
So I'm new to the all time awd car thing. I came from a 4x4 truck which 4x4 was never engaged on pavement or in tight cornering. When maneuvering my is250 awd in tight spots ie. parking lots and the front wheels are at full lock in either forward or reverse there is a slight binding/grinding feeling or faint noise. Is this normal on an awd car or Lexus specific??? Did a quick search and didn't find much about this issue. I'm pretty sure its not tire rub.....stock set up.
View 10 Replies
When I drive my prius and make sharp turns or any sort of UTURN, the wheels lock up, automatically brake and there is a grinding noise as if the wheels are rubbing and there is a beeping noise. I took my prius back to the dealer for warranty repairs and the problem persists. is this a normal thing?
View 1 Replies
I got an 08 F150 2wd. I noticed lately a mild roaring noise coming from right front wheel, but it only does it when I'm turning left. There is nothing while driving straight or during right hand turns. Only happens during left hand turning.
View 1 Replies
