Ford F-150 (2004-2008) :: RPM Drop - Engine Will Stall When Stopping At A Light Occasionally
Apr 12, 2011
I recently bought a 2006 STX with the 4.6 engine. Occassionally, when stopping at a light, the engine will stall. I took it to the dealer where I bought it and he put it on the computer and found that once on a test drive the RPM's dropped to 490, but it did not stall. He said everything checked out fine and thought it might be a carbon build up, since the truck only has 27,000 miles on it and was driven only around town. He suggested a couple of tanks of higher octane fuel and a fuel additive to remove the carbon.
View 10 Replies
Advertisement
I was driving when the truck made a terrible noise and while pulling over the check engine light went on as well as low oil pressure. I turned off truck and checked but no evidence of any leakage at all. Checked oil stick and was dry. Let sit for an hour and checked oil stick to find about 1/2" showing. Added oil to find that now it was overfull, drained oil back and stick showed proper level. Attempted to drive and it was fine until I came to a stop wherein it would stall with "low oil pressure" showing and check engine light on. Brought to shop and they said engine is very gunked up, they said they could try oil flush but probably will not work. They most likely will have to remove the valve cover and such to physically look at engine and take it from there... (I have always used type of oil stated on the cap, used synthetic and changed every 5-7k miles - showed diagnostic codes p0011, p0340, p0345 and p0021).
View 14 Replies
My mom gave me a 2004 f150 lariat with a 5.4l and were having an issue with the engine when coming to a stop the engine wants to stall out and runs like a bag of hammers and sounds like its going to explode then i give it a shot of fuel and it runs fine for a a while and then does it again. I brought it to the local dealer and he said it was either the vct or the cam phaser bank 2 so i changed both and it still does it just wondering before I keep getting intake cam sensor code retarded and a bunch of other codes but we replaced the cam sensor already.
View 2 Replies
My 04 F150 has started having a rough idle. While in park the engine will stall out with the A/C off. Also when in drive the truck will idle close to 1000rpm's. I had to the fuel filter cleaned and also the MAF sensor cleaned. Also did a vacuum check on it. Pulled the code and it's throwing a Lean Code. What else should I be looking for?
View 12 Replies
When you are accelerating anywhere from half to full throttle it may cut out at any given time. The RPM will drop down, it may bounce up and down for a bit and recover, or it will drop all the way down and stall. If you let off the gas it may or may not recover. If it stalls so far from the tests I have done if you never shut the key off it will never restart again. If you shut the key off and wait from 5 to 10 minutes it will all of a sudden restart normally like nothing ever happened. If you try to restart it immediately even if you shut the key off and back on it will not start.
When it does not start when I am attempting to start: Fuel pressure according to my gauge is between 55 and 60 psi. Inline spark tester shows that it is getting a spark. Engine sounds normal while cranking so in other words compression sounds normal. I have an LED test light rigged up showing when an injector fires, and it does show electrical activity going to the injector when it opens (flashes). Only clue is that it SEEMS dimmer when it wont start, but I have no clue if thats how it normally is on start up. Its only a slight difference from the brightness of a normal idle brightness. I have a snap on scanner hooked up, nothing that I know of looks abnormal in the data and it will not throw codes when this happens.
Parts I have changed or cleaned so far: Changed the fuel filter, crank sensor, cam sensor, ignition module, and MAF sensor. Cleaned the throttle body. When the car is working normally it runs strong, good power, smooth. Starts great normally.
View 8 Replies
My wife has a 1998 Windstar 3.0
Prior to going out yesterday, I noticed that the van seemed kind of 'jumpy' when idling - the timing was a bit sticky and inconsistent and kept seeming to try and right itself. I stuck the accelerator down and it ran perfect when it was getting gas but started 'stagering' again when I took it off.
So my wife went out to walmart - a 30 min drive (we are in the country) - and all was good till she was turning the corner into the parking lot and the engine stalled. It was your standard stall - power steering went out but all other electrics kept going etc etc.
She sat there for a minute - put it in park - then fired it right back up again. After running into walmart, she just drove home as fast as possible to reduce the length of time it had to happen again.....
So while there are, Im sure, a plethora of possible issues - I was wondering about the IAC value? How could that be responsible for the parking lot though - doesn't it only act when the car is stationary?
The sort of thing was happening about 3 months ago, and I ran seafoam through the fuel - which seemed to work for a while.
View 9 Replies
I have a 2001 Mazda Tribute with 150,000 miles that is meticulously maintained. This past winter (as far as winter goes in San Diego) the engine would run rough and the rpm's would drop close to stalling when stopping at a light for the first 2 or 3 miles. After that the engine has warmed and there is no problem. Could this be the intake gaskets needing replacement. This only happens on a cool or damp, rainly morning.
View 6 Replies
My 2007 elantra has been rumbling when i change gears occasionally and sometimes when stopping at a stop sign the car just dies. The car starts right up though as if nothing happened. It only happens like twice a week but i really want it fixed. I already changed the motor mount next to the engine block on the left. Could it be the motor mount connecting to the transmission?
View 1 Replies
I have a 2001 santafe with a 4 cyl The code 102 was up so I replaced the mass air flow censer . I go on a test drive and the light stays off , but when I go to re start it again the light come on and stays on, with the same code. The only strange thing is the idle will raise for a min then drop down to almost a stall.
View 2 Replies
After I fill my 6 cyl 2004 Hyundai Sonata (280,000 km), the engines starts, then stalls. I can only get it to work by keeping the accelerator pushed to ensure sufficient rpm's. If I remove my foot from the accelerator, the rpm's drop to zero.With the engine revving, I put the car in drive and 'lurch' away from the pump. After that, everything is fine. It starts up properly … until the next fill. My mechanic is mystified and I am frustrated.
View 6 Replies
I have a 1998 Accord, 4-cylinder VTEC standard transmission, 226,000 miles. Last fall I first experienced a problem with the car where within 5-10 minutes of starting the engine and driving, the engine seems to lose power/fuel and RPMs act as if they'll drop low enough for the engine to stall. If I take my foot off the accelerator, and reapply, the engine seems to gain power again.
Also, if I open the accelerator to full while the problem is occurring, it can occasionally "push through" and gain power again. Similar things will happen while stopped. In neutral, RPMs fall low and suddenly jump back up and then settle into normal idle. The problem never persists longer than 10 minutes within starting the car.
I took my car into a local shop that came recommended by a friend. They investigated a "check engine" light that didn't explain the problem and were never able to recreate the condition themselves. They replaced a few parts but lost the work order so I don't even know what they changed, but the problem seemed to have solved itself for a while. Recently it started up again and I would love to sort it out.
View 2 Replies
So yesterday i was driving fine and all of the sudden the car started jolting like it was going to stall and the check engine light came on. I pulled over popped the hood to see if there was anything i could see and got back in and took off no problem and the light went off. I starting pushing it and accelerating it to see if it would come back on and it didnt. Today it started doing the same thing but this time the light stays on and every time i change gears it does that jolting like its going to stall.
Its a 2004 gli 6 speed gli 1.8t ....
View 7 Replies
New issue I've discovered , when stopping , the RPM's drop down to 500, truck acts like it wants to stall , then goes up to 750 RPM's . Then it's fine . Doesn't hesitate when accelerating . Idles slightly rough after start up , about 30 seconds . I've checked the air filter , cleaned the IAC and MAF. Fuel filter is only a year old . What I should check next ?
View 14 Replies
I have an 2006 f-150 King Ranch with 103k miles and it was misfiring and then stalling when stopping at lights. Both cam shaft sensors and all coil packs were relaced then it was still misfiring. The head was recently replaced and now they are waiting on a new computer. When it starts misfiring it vibrates the whole truck and the engine light flashes. If you turn the truck off then back on it will run fine for about 50 miles. Im worried that replacing the computer is not going to fix it, what else could it be?
View 14 Replies
In my 2008 F150 with 108,000 miles, I am having a vibration in the brake pedal. When I am stopping or at a dead stop. I first thought it might be the rotors needing to be turned, but the vibration seems to go away when I turn off the a/c.
View 11 Replies
I have an ambient temp switch connected to the vac port on my throttle emissions control solenoid for my 2150 carburetor. It's a 78 F-150 with a 5.0L 302, automatic 2WD. Would a bad ambient temp switch screw up my idle? I've disconnected the vac hose and it won't idle at all, and it does the same thing when I disconnect the two wires from the ambient temp switch. If I leave everything alone, I can get the idle down to around 1800rpm, but any lower than that and it stalls.
Is it possible to swap out this throttle emissions control solenoid with another type? I've looked everywhere and can't find an exact replacement, and I have no instructions on how to tune it.
View 4 Replies
Drive a 2004 Ford F150 4.6L V8 EXT CAB. It has 71,000 miles on it. Truck runs great, doesn't stall or miss and idles good but my gas mileage lately has been very bad. Oil, air filter and fuel filter have been changed. What could cause this?
View 14 Replies
2002 V10 72k, starts fine, runs fine, occasionally misfires and will stall at idle. So far.
Replace boots
Replaced Air Filter
Tested resistance in all coil packs all within value
CODE P0720 - OSS (replaced, knew it wasn't it but...)
Seafoamed truck (very anticlimatic)
Cleaned MAS
Headed to clean IAC next.
Still has the original plugs, any reason to change them yet?
Does the IAC have a function when engine is at temperature? Getting ready to bite the bullet on AE. Any first hand experience with AE? I STFF and couldn't find anything.
I'm about 90% convinced it's a bad COP, but I'm not about to buy 10 of them on I think. Also not inclined to switch each COP with a known good one. I'm hoping the AE will show misfires and pending codes.
View 14 Replies
I have a 2012 5.0 with about 1500 miles on it. I have noticed occasionally on start up that it feels like it is trying to stall? I give it a little gas and it goes away.
View 14 Replies
Let me describe this perplexing issue. I have a speratic rough idle problem. When it happens it's almost like the truck wants to stall. Once going the truck is fine. There has never been any acceleration issues, but for a short time the truck would kind of lunge off idle. It hasn't done that for quite some time. I've replaced the fuel filter. There are no vacuum leaks that I know of. I've tried higher octane fuel. I've tried injector cleaner for a month. What should the fuel pressure be and what is the test port located? Is the fuel pump in the tank? If so, whats that big log looking thing behind the gas tank that the fuel lines run to? Also, there are no MIL codes...
View 14 Replies
I have a 2007 F150 It will stall out when I go over a speed bump. It has happened several times and getting worse. No codes stored. It will also skip between 40 and 50 mph.
View 3 Replies
