Ford F-150 (2004-2008) :: Spark Knock Under Load?
Jun 11, 2012
I have a 04 5.4 w/ a whipple supercharger. truck has 104k miles. Has a misfire in cyl 4 (p0304, p0316) And spark knock.. I've changed the plugs, coil on cyl 4, fuel filter, and today the o2 sensor(pass side upper, bank 2??). I've ran tecron injector cleaner threw it, and always used Chevron 90 octane. (highest in Alaska)
The noise only happens when under load, or accelerating with more then half the throttle. doesn't happen when i slowly get up to speed. What I could do next? About to take it to the dealer to run a full diagnostic test on it.. Also, does not hesitate or bog. drives normal just with that noise
View 5 Replies
Advertisement
So we finally found a travel trailer and picked it up yesterday. It is a 2008 Jayco 29A. Fiberglass with aluminum frame. 5345 dry weight, so shouldn't be too taxing on the Ex, but we towed it through parts of the NC mountains to get home and on steep grades it would downshift to 2nd gear and I would hear what sounded to me like pinging from the engine.
As far as I know the plugs are original, so should I just go ahead and replace them, or there also a possibility that this is just the notorious exhaust manifold leak? If all exhaust manifold bolts are still intact, is there a good test to know if it is the exhaust? No engine codes were thrown. The truck has 72k miles on it now.
View 11 Replies
I have a '94 Mazda B3000 3.0L V6. The engine finally gave out at 244,000 miles. I had a used motor installed with approx. 110,000 miles on it. I now hear a knocking sound only when the engine is under load (in gear and accelerating). The knocking is not present while revving the engine while in park or neutral. The transmission was rebuilt last year about this time. I have described this problem to several respected mechanics and they don't know what it could be. What could cause this condition?
View 12 Replies
A 2004 and up f150. I found one in great shape for 5,000 dollars with 120,000. Drives good but it has a knock I'n the 5.4 engine. It gets quieter when the engine is warm. Should I avoid this truck or will I be okay with purchasing? Only thing holding me back from buying truck is the knock...
View 9 Replies
I've got a 97 truck, broke the crank, swapped in a motor from an 07. Heads down is 07, intake up is 97. had heads planed and a valve job with new seals done. Left it alone from the rings down. Got it in this weekend, running today. Ran it in the driveway with no load for about 30 minutes, top end was noisy for about 5 minutes till the top end got good and oily (I'm assuming). Purred like a kitten, sounded real smooth. Took it for a drive around the block, heard the clatter in the video below. It's almost always there when driving. Brought it back, turned it off to check oil, it was a quart low. Added oil, startup was VERY labored with a real hard knock in the bottom end. Ran like poo till I gave it some throttle for a couple seconds, then it cleaned up and idled well. Let it run for a couple minutes, turned off and let it sit for a couple minutes then started back up, same thing. Very labored with hard knocking.
View 2 Replies
My 4.6 explorer has a spark knock noise when hot. When the engine is cold or on cold rainy days it does not make the spark knock noise. I have tried higher octane gas and octane boosters but it does not seem to work. Check engine light is not on and there are no codes. Could I have a bad egr valve or knock sensors with no codes...
View 5 Replies
Have a friend and looking at his truck for him. He was towing a boat and climbing a steep grade hill. As he described it, it felt like he lost all power. Did manage to get it to the top of the hill and stopped to check it out.
Noticed the under of the truck dripping oil. Checked the motor oil and none on the stick. Put 4 quarts in the motor, started it back up and oil pressure is good and motor sounds fine.
The strange thing is the motor is dry. Can not find where the oil leaked out. All the oil is located on the transmission and transfer case. I'm not too familiar with these Triton 5.4's but where could that oil possibly have come from? I'll re-look this morning.
Also, with oil in motor, and it is idling, there is no oil leak or drip anywhere. Is there a pressure regulator in this oil system and the load he was exerting cause it to release?
View 13 Replies
I replaced my knock sensors on 2004 5.4L and now it will not idle without me keeping foot on gas. Idles down to +- 450-500 rpms. If I hold down gas pedla seems to run smooth. What to check to fix this problem?
View 10 Replies
Had it before, code p1401. Changed out dpfe and it worked for 6 months. Now spark knock again. Now though I have no codes though. No vacuum leaks that I can find. New egr from before I had the problem. I applied vacuum to the green hose and it stumbled so the ports should be ok. Snytime I go above 3000 rpm i get the pinging. I replaced the dpfe again and no difference.
View 3 Replies
I recently replaced the plugs & wires on my '97 3.0L XLT automatic, and now I'm hearing some pre-ignition (spark knock). Only happens under light load, as in climbing a slight grade on the highway. No CEL, no codes on my code reader. Was not happening before I did the work.
The plugs & wires I removed were the factory originals (AWSF32P & PG, 3 of each), truck only has ~85,000KM (~50,000 Miles) on it. Well maintained, & only used occasionally. The only mod from stock are the wheels & tires, I'm running 215/70 R15 instead of the stock 225/70 R14, the difference in the tire circumference is minimal.
The gap on the old plugs was just over .050", no evidence of any fouling or other problems. The new plugs are Autolite XP104 Iridium, which is what the Autolite catalog calls for. Plug gap was checked & set to .044", midway in the range called for by Ford (.042-.046).
I realize that the narrower gap on the new plugs will cause a slight advance in timing, and I have done a computer reset/relearn as per Paw Paw's instructions. I'm stumped.
View 8 Replies
I have a 2004 f150 lariat crew cab 4x4 with the 5.4 3 valve. It now has 113 000 miles. Since i got it at 85 000 miles its had a hiss when the engine was under load. So like light acceleration or driving into wind. The guy i bought it from said that it had a manifold leak so that's what i figured it was. I got the manifold fixed and it still hisses. There are no check engine lights. It almost feels like my engine lags when it starts hissing. It sounds like its coming from right on the other side of the fire wall. What it could be?
View 3 Replies
I have a 2004 150 with 165,000 miles I sometimes pull a 5 by 8 trailer. when pulling trailer in overdrive and excelorating the engone will cough several times. I took it to a mechanic and he told me that there was nothing he could do that I needed a new engine. I can pull trailer out of overdrive with no problem. don't undrstand why I need new engine....
View 3 Replies
I have a Lariat 4x4 supercrew cab with a CD 6 disc changer head unit. Error message. No Disc, and Load Error. Will not eject any of the 6 loaded CDs. Pulled/reset fuse. No luck. Banged on dash while trying to eject any of the loaded CDs.. no luck. Unit cycles when first starting the engine. Radio works fine. Unit locked up....Ford Mx tech says the solenoid that holds the CD is frozen in position and will not release.
View 3 Replies
Hard to describe sound, but it only happens under load. It happens at any speed, but more predominently at higher speeds. When I lift off the gas it stops. I can keep it going up hill since I'm maintaining speed rather than accelerating over the limit. The other day I heard another F150 beside me making the same noise going up a hill.
View 14 Replies
Knock or tick at 1000 rpm. Truck has 20000 miles on it. Dealer replaced cam phasers. What next?
View 1 Replies
I just bought this truck yesterday. During the test drive and everything it seemed all fine. After all the paperwork and the truck was actually mine. I noticed once it is all warmed up it seems to have a slight knock/tick? and a slight miss to it. I shot a couple videos, one up underneath where it sounds like most of the noise is coming from. Could it be an exhaust leak? Or is it something internal? Like the Cam Phasers, or a rod or something!
Here is a video around the exhaust area.
Here is up underneath the truck.
View 5 Replies
I have a 2006 ford f 150 with a 5.4 Triton 3v engine and every time I floor it and the engine reaches 3000 rpms the truck backfires and looses power. Sometimes it wont pass 3000 rpm it just stays there and backfire and have no power. Sometimes the check engine light flashes...... I took the coils off and looked at them and they all looked pretty clean. Also the truck idles rough and sometimes when it cruising at low rpms, and I give it a little gas the truck will randomly misfire and shake hard. also the engine sounds like a diesel engine........ What might be wrong.
View 6 Replies
I have a 2006 Ford F150, king ranch, 4x4, super crew 135k miles. I bought the truck and shortly after noticed the miss under a load at 40-60 mph while in OD, or at higher RPMs at WOT, but never a CEL. Well 3 months went by and I couldn't take it anymore so with lots of research I decided to change the plugs. Ran seafoam through 2 tanks of fuel prior to this job to break up the carbon in hopes of none of the plugs breaking.
All 8 plugs came out with no issue and I replaced them with the Motocraft SP 515s (old ones were very nasty and brittle, most likely the original). I put copper anti seize on the end that goes through the channel in the head, however none got on the end near the electrode, and also on the threads. Put it all back together and it had the worse misfire an pretty much not drivable....flashing CEL and codes p0308, p0355, p0356. So I decided to buy 8 new coils as well, got all 8 of them on and now the truck is drivable but the miss is still there (no CEL).
Feels like maybe just one cylinder and I believe I got it pin pointed to cylinder 8. I put a vacuum gauge on it and unplugged the injectors 1 at a time and cylinder 8 is the only one that there is no change while unplugged. So I switched out the coil thinking maybe I got a bad one, still does it. My COP electrical plug has 12v Constant and also confirmed with an led it is getting signal. The injector is ticking or pulsing as i confirmed with a mechanic stethoscope. What am I missing????? Today when I get off I plan pulling the spark plug, checking for carbon tracking, check compression, check actual visual spark, and pull and clean the injector.
View 6 Replies
How's it going? I have a 2005 F150 with the 5.4L V8. It has 70,000 miles on it and until yesterday and has been a great truck. While driving in traffic yesterday the truck started running rough and hesitating. It through two codes - misfire cylinder 5 and misfire cylinder 6.
In response, I purchased two new coils and 8 new autolite plugs. The plug installation went smoothly and the coils all went on without incident. However, this didn't fix the problem!
The next day I found that cylinders 5, 6, 7, and 8 were all having issues. At this point I also had an "O2 stuck lean" code so I pulled the plugs and found all four brand new plugs fouled and smelling like gas and an ehaust that smelled like raw fuel. This led me to replace the O2 sensor on the drivers side. With the new O2 my lean code disappeared but I still had a rough idle.
Further troubleshooting found that injector 6 was stuck open (which presumably fouled my O2 causing it to read lean and dump fuel thus fouling all the plugs on one side). I replaced the injector and the rough idle disappeared and all seemed really well as the truck idled in my driveway.
However, as soon as I hit the road I noticed a major hesitation. The motor is also noticeably louder and has a very hard time accelerating. I'm thinking that I've plugged up my cat by dumping so much fuel in to it and the hesitation is caused by a lack of breathing - does this sound possible? How would I confirm this without replacing the cat? Anything else I should look for? I'm fairly confident I have combustion in all 8 cylinders now so I'm leaning towards intake/exhaust issues.
View 13 Replies
I'll try to explain what the truck is doing best I can. I'm not sure if it's the engine or tranny. When you lug the truck on a hill or put a load behind it and lug it the truck jerks like the engine is cutting out or the tranny is jerking, I can't tell which. You can drive it all day long on a flat road or small hills and you can't make it do it. It does it worse going up a hill with a load behind it. You can lug the truck on a steep hill let off the accelerator and mash it back down and it will do it almost every time. I've tried overriding the overdrive and it still does it. If you keep the rpms above 2000 up a hill it won't do it. I've had it checked by a transmission shop and they couldn't make the truck do it. Also it doesn't throw any codes or put the check engine light on when this happens. 2007 F150 supercrew 5.4 auto, with 88,000 miles.
View 12 Replies
I have an 05 F150 with the 3v 5.4 with 170k on it. Last fall we changed the timing chains, cam phasers (aftermarket), plugs, coils (OEM), VVT solenoids (OEM), Cam Position sensors (OEM) and swapped in a GT500 oil pump. Recently under moderate load (fairly heavy acceleration onto the freeway, pulling a large camper) I get a pretty rough misfire. Tonight I pulled the codes and it was Cylinder 5 misfire. In the past I have also had Bank 2 Over-Retarded code. What are the next things to verify and check? I plan to clean the throttle body and change fuel filter but I'm not sure either of those would cause the misfire code?
View 3 Replies
