Ford F-150 (2009-2014) :: Repeated Front Wheel Hub Failures
Jan 22, 2015
I'm new to the site and I've got a 2012 F-150 SuperCrew EcoBoost that has had the front wheel hubs replaced twice. Both hubs two winters ago and one hub last winter. I'm taking it in again tomorrow because the wheels are growling again when turning slightly at low speeds and sometimes without turning. I'm running in 2H, so the hubs should not be engaged. Previous years it was when running in 4H or 4A.
When I took it in, the service manager said it was common this time of year because of the temperature. Always seems to be cold, but not frigid, days here in SD. I asked why I should tolerate having hubs replaced every year, but he can't answer that.
I'm at 36,450 miles/29 months. I'm not beating on it or running in 4wd on dry pavement. Just normal highway miles. I should know more tomorrow after it comes out of the shop.
View 14 Replies
Advertisement
Repeat Front Hub Failures -- 2WD Try this situation -- Purchased 2006 F-150 XL with 57,000 miles. Truck built on 05/24/2006.
Sept 2011 68,621 miles -- Left front hub failure -- Wheel bearing grinding -- Done by Bell Ford in Phoenix.
2013 -- Left front hub failure -- wheel bearing grinding -- done by independent shop.
Sept 2014 -- Left front hub failure -- wheel bearing grinding -- done by independent shop.
Sept 2016 -- Upper & lower control arms, struts, strut mounts, springs replaced -- Quality part used -- Complete front end alignment -- Brake job front and rear.
Nov 2016 -- New performance exhaust system due to exhaust leaks.
Dec 2016 -- Failed automatic transmission -- Remanufactured FORD transmission installed w/ 36 mo warranty. Sanderson Ford gets an A+
March 16, 2017 151,000 miles -- Left front hub failure -- wheel bearing grinding! Verified by jacking up truck and spinning left front wheel -- GRIND! This is coming from down in the hub. This is a 2 wheel drive truck. Yes, you counted correctly, this will be the 4th replacement on the Left side!
NO Towing! NO Overloading! Wheels are 2006 XLT style Aluminum rims with P235/70R17 Michelin XLT M/S (Defender LTX) tires all around.
It only hauls maybe 200 to 300 pounds of electronic equipment at the max, once in a while. This is driving me crazy! I always use FORD PARTS for the HUB ASSEMBLIES. Really loosing faith, the front right hub is OEM original - NEVER CHANGED!
View 7 Replies
The dealer has replaced the DMTL pump 4 times on my 2004 BMW325. The last time the dealer checked the gas cap and smoke tested the fuel system - all OK. I do not overfill the tank. The pump has failed again and I am getting tired of taking it to the dealer for a new pump. Fortunately it is under warranty but I am sure that there is something else causing these pump failures.
View 5 Replies
I recently purchased my 2011 F150, which is the first new vehicle I've ever owned. I have always changed my own oil, and if possible I would like to continue doing this myself. My only concern is any potential warranty claims down the road.
If I change my own oil can Ford blame any drivetrain failures on me? What should I do to maintain records of my own maintenance to prove I've changed the oil regularly?
I am aware that I must use synthetic oil and a Motorcraft filter.
View 14 Replies
Passenger side front wheel won't engage
View 11 Replies
I just went to Steamboat this weekend which requires driving over two mountain passes in a snow storm...I only go if it is snowing. This was the first trip with my new 2013 FX4 and the front wheel wells filled up with so much ice that the wheels would rub after a bump in the road. The mountain roads do have lots of frost heaves so this would happen fairly often. The ice was all around the wheel well with a huge build up behind the wheel. It also covered the step rails. Would mud flaps do anything to preovent this build up? Or any other tricks?. Otherwise the truck did fine...
View 12 Replies
Just installed new actuator and wheel hub assembly on my 2009 f150,truck still had grinding noise in front passenger wheel , New solenoid and vacuum hose kit installed when test drove noise still there until you put the truck in 4 wheel drive it disappears . The noise returns as soon as you take it out of 4 wheel drive. Also mechanic said steering was tight,installed new shaft same thing, could this be the rack and pinion.
View 5 Replies
I have noticed recently that I have a "rubbing" noise and vibration coming from the right front wheel on my FX4. It is most noticeable from 5-10 MPH, and more pronounced when turning right. it is not constant. It sounds almost like a brake pad rubbing on a badly warped, wet rotor. It goes away when I apply the brakes. I am thinking bearing or possible CV joint.
The dealer can't get it in until Tuesday, and they say I will have to pay the deductible on the ESP, even if it is related to the steering vibration they could not replicate or fix about a month ago. I am seriously considering going to another dealer for my service. Given, they did absorb the deductible last time, but they didn't fix the problem!
View 14 Replies
Front wheel bearings making noise. Can I buy replacement bearings/races/seals, or must i buy a whole new hub front assembly?
View 3 Replies
I just bought an FX4 and pick it up tomorrow. When you are in 2wd does the whole front end spin like the axles? Or does only the wheels spin when you are in 2wd? Reason I am asking it seems like with chevy the whole front end spins in 2wd.
View 8 Replies
2014 crewcab lariat 4x4. Here is the question. This is only when I'm backing
it up and only after putting truck back in drive do I get the steering wheel whine. It sounds as if it is low on fluid. Only last for a seconds or two. Could this be the start of a steering problem or possibly a brake issue? Just throwing this out there.
View 8 Replies
Have noticed lately 2012 4x4 sc with 42,000 k has a slight vibration I guess you would call it you can feel through your fingers at certain speeds. I looked and felt tires which are at approximately 4,000 k from being new and they are wearing on the inside, going to rotate and have it aligned asap.
View 7 Replies
My steering wheel coating is wearing off and the under material is wearing out. 2009 ltx f150. How many others have this also?
View 8 Replies
Just bought a spotless, low mileag
View 9 Replies
I just inherited a 2012 F150 Fx4 Super Crew. Nice looking truck, but the wheels are stock 17" steel. Need upgrading to nicer looking wheels/wheel covers w/o breaking the bank?
View 14 Replies
Is there a way to move the wheel higher than the highest setting? I like to keep the seat at its highest and its difficult getting in and out of the truck.
View 9 Replies
Is the steering wheel on the Ford F150 Platinum leather and wood, or is the top portion of the steering wheel plastic?
View 1 Replies
Having intermittent clunk felt in the steering wheel? It happens at random and not necessarily over bumps. You don't hear it as much as feel it in the wheel.
View 3 Replies
2009 FX4... Every once in a while, I'll feel a vibration in the gas pedal. It happens under acceleration, and typically if I'm pushing down and it has not downshifted yet. Then once it downshifts the vibration is less noticeable.
I have had the mechtronic unit replaced due to harsh shifting and the vibration was there before and after that was replaced. The drive shaft was also replaced due to a click/clinking noise and the vibration was there before and after as well. The harsh shifting and clinking noise was fixed with those repairs, but the vibration is still there. I notice it more when I am towing.
View 13 Replies
My neighbor has a 2010 or 2011 Screw with only less than 10K miles. He complains that the steering wheel vibrates when he applies the brakes; not all of the time, but most of the time. Could it be pads/rotors? With this mileage, and no stop and go traffic, I cannot believe it would be the pads/rotors.........
View 6 Replies
I have a 2014 FX4 Ecoboost with 2K miles. While driving in a straight line on smooth roadway I feel a slight 'clunk' in the steering wheel. Feels a bit like slack or something. It only happens when the steering wheel is in perfectly neutral position ( straight up) with no turn to either side. Oddly I feel it more when I hold the steering wheel in the lower half as opposed to the upper side. Could it be 4X4 play or splines or loose something in chassis?
View 14 Replies
