Ford Fuel System :: Engine Runs For 10 Seconds Then Dies
Oct 21, 2008
I have an 84 Bronco II with a fuel injected 302 in it. I was out wheeling with it the other day, and it was doing great until about 3:00. I got out to see that my brothers radiator had sprung a leak. When I got back in my Bronco and put it in gear, it just stalled. I started it back up and it ran for about 10 seconds then shut off. It kept doing that over and over again. Finally, I got tired of it and had someone get my truck and tow me out of there. Why would it run for about 10-15 seconds only and then shut off like it was getting no fuel (yes, it does have fuel in it)? I have a feeling it might be fuel pressure regulator valve because it was acting up a while ago..
View 10 Replies
Advertisement
I just purchased a 1989 F250 with a 5.8 motor. Great truck for its age. Ive owned other Ford trucks in the past and my Dad had them as a kid. Love them.
When I bought the truck from the 2nd owner it had a problem so I bought this truck with the problem figuring with my past knowledge I could fix it. Not the case. When I got the truck it would start fine and run really great but when it got warm it seems it would die and I would have to wait till it was cooled down to start back up and again it would run fine. Well the problem got worse and worse and now it wont run at all.
It will run on starter fluid so that leads me immediately to the fuel pumps. I say that plural because none of them will run it seems. I did a fuel pressure test at the shrader valve at the top of the motor on the fuel rail and I get no pressure at all when I turn the key. The relay in the engine compartment seems to be working to as I can hear it. I put a new on of those on to to be sure. Leads me back to the pumps again. I replaced the external pump on the fuel rail and I know thats working. I replaced the fuel filter to while I was there.
Is it possible to have BOTH fuel pumps in the front and rear tanks go at once? Seems unusual. My other F150 with dual tanks worked great and when the back tank pump went I could just switch it over to the front tank.
View 2 Replies
This applies to a 2001 F-350 with 73,000 miles on the engine. Engine oil level is good, batteries charged, HPOP reservoir is full and passes Cody test with flying colors. Fuel pump runs for 20 seconds at key on. Start takes about 6 seconds. If I shut the key off and restart immediately it starts in under 2 seconds but if I wait about 30 seconds it's a 6 second start. Here is an AE that I ran on it, it has me stumped. FWIW it seems to start quicker when AE is hooked up. ?? An odd whir type of noise comes out from somewhere under the hood when I first turn the key on and when I clear the codes with AE.
View 14 Replies
Not really sure where to go with this one. Was going to start with the fuel filter but I am not sure where it is at?
View 3 Replies
My 04 Touareg V-6 will start, but will die about 10 seconds after or if I give it gas. I'm pretty sure it's one of the fuel pumps just not sure which one.
View 5 Replies
2001 F-350 7.3L / 147K... Lately my truck has a strange anomaly when I take off from a stop. A few seconds into a routine gradual acceleration the engine gets a little "boost" without changing anything on the accelerator. I typically take off from a stop as if an egg is under my foot. And then bam! It's as if I romp down on the gas pedal. Not a lot of increase in rpm's and acceleration, just a hint. BUT NOTICEABLE! Even my wife wondered why I was playing with the accelerator. And, it only does it that first time you start it and take off. I had the glow plugs replaced last week. And it has done it occasionally before but increasingly since. No other changes other than pulling codes.
View 1 Replies
Why the frame mounted fuel pump might run after the key is turned off? Then when you turn the key on it may or not run. If it does run it keeps running. shouldn't this shut off after pressurizing the line? is their a pressure switch in the pump that's failing? This has the 3 pump system...
View 4 Replies
I have a '77 F250 with a 460. (Under edit) It has a holley 750 carb. (under 2 years old). It ran fine for about 2 years and now all the sudden it seems to not get enough fuel. I have a clear fuel filter on it and you can see that it is full of fuel when I first start it up. Just letting it sit there and idle after about 5 minutes it starts to show air coming through the lines and it gets worst the longer it runs.
If I take it out on the road and drive 55 it will be about 1 or 2 miles and it acts like it's not getting fuel. I stop and open the hood and check the filter and it is empty. What could cause this? I took it to an old Ford machanic and he has checked the fuel pump, fuel lines, sending unit, and gas tank. He is at a loss. I am no mechanic, but I am mechanicly inclined. I can't see it would be that hard to figure out. What do I do?
View 6 Replies
It started out w/ my wife swapping from the front fuel tank to the rear tank due to the fuel qty getting real low. Then the next day when I drove it I had bad fuel qty and amp meter indication, I found a blown fuse on my fuel qty/amp meter gauges. I replaced the fuse and got my indications back. Now I hear my front tank fuel pump is running constantly when selected to its position. Its now full of gas and still runs constantly. The rear tank/pump operates normal. I am wondering if I ran that pump empty and lost its prime? What is the best way to burp it?
View 9 Replies
I recently purchased a used 1999 F250 Super Duty with about 150k miles on it. The truck runs great and I have no complaints but there are a few things that need to be taken care of. It looks like there is a very small fuel leak where the filler neck ties into the rubber hose that runs into the fuel tank. There is a thin film of diesel along the side of the tank, on the leaf spring, the air bag and various other places. Nothing is dripping. I want to drop the tank and replace the hose. The Haynes manual says to depressurize the whole fuel system--is this really necessary if I don't plan on doing anything to the system aside from dropping the tank?
View 2 Replies
I've got a cold start problem. Turn it on, wait until glow plug light goes off, hit the starter and it fires right up. It acts like it runs out of fuel and dies. Hit the starter and it fires up and dies again. Third time it stays running. It's not a long crank either. 1-2 seconds at most. Fuel pressure is 59, HPOP immediately goes 1000+, everything looks good. It will start fine the rest of the day until it sits overnight. This is an early 04.
View 14 Replies
I just had a former Ford tech rebuild my motorcraft 2150 2v on my '77 F250. I took it home, put it back on the truck and it ran kind of rough. I then went ahead and screwed both idle mix screws in untill seated, then back out two turns. The truck ran great, turned off truck then when it the house for dinner. Half an hour later I come back out...truck will not start, just sits and cranks. Finally got it started and it ran good, but crapped out after it warmed up. I have made sure there were no vac leaks when truck was running the first time. Did I adjust the mixture right?
The truck is a '77 F250 400/C6
View 2 Replies
Ok I finally got my truck to start, but it dies instantly. I had a friend of mine who is a mechanic look at it and he said gas wasn't filling up the front bowl, but gas was pumping? Could something have happened when the carb was rebuilt?
View 3 Replies
177,000 miles, fuel pump was replaced just before I purchased it a few weeks ago. Truck has been running like new until today when it started doing this completely out of the blue. If you watch the video, the sound is not off, the tach is moving independently of the sound of the actual revs. Occasionally when doing this, the fuel gauge drops to zero. Thinking this is an electrical issue somewhere.
YouTube.....
View 14 Replies
I just rebuilt the Autolite 4100 on the 390 in the 62 T-Bird I just purchased. Starts up and idles great, but when I apply slight throttle, the motor shuts off. If I apply a lot of throttle quickly, it picks up fine and drives with no problems. No sputtering, or backfiring. I just slightly apply the throttle, the RPMs drop, and the motor cuts out completely. Starts right back up when I turn the key, but does the same thing, at any temp.
I originally thought it was a vacuum leak, but checked what few vacuum lines there were, with no leaks to be found. Hooked up my vacuum gauge and it read at a steady 15psi.
New mechanical fuel pump, haven't checked the fuel pressure yet, but I installed a see through inline filter, and it's filled up and pumps fine.
Timing is at 8 degrees, and vacuum advance is hooked up to the only vacuum line in the carb. New cap, rotor, plugs and wires.
I adjusted the idle mixture screws down until the idle dropped, then turned them out a half turn (I've read on here it should only be a 1/4 turn, so I'll adjust that later today). When I was messing with the carb yesterday, I noticed the inlet check ball retaining screw was leaking a bit of fuel, so I went over the carb and checked all the screws and tightened down what needed it.
When I rebuilt the carb, I left the original needle & seat assembly, since they were in great shape, and the ones in the rebuild kit were much smaller. The choke plate needs to be adjusted, as it doesn't open up all the way at full temp, but the engine did the same thing with the plate held open all the way open.
I've gone through everything else I think it could be, so I'm figuring it's the carb. This is my second carb rebuild ever (first was a Motorcraft 2150) and it went smoothly, and I double checked the floats and measurements.
View 6 Replies
Outside of lawnmowers, this is my first carbureted engine. I have always fixed stuff that broke on the vehicles I've owned, and done some difficult (for me) task such as replacing a timing belt on a honda, and mcpherson strutts and a head gasket on a 4 cylinder SAAB.
I'm the new owner of a '68 F100 that was originally a 3 on the tree inline six. It's been converted to an FE390 with an automatic transmission (C6 I believe). It has an edelbrock 1411 (750CFM). I've recently got it running at idle of it's own gas tank. This is the list of work I've performed since getting it.
Replaced:
old gas
old oil
brake master cylinder
old dot3
plugs and wires
I also added 3-4 quarts of F-type tranny fluid.
Related to the Carb all i've done is removed it and dumped some carb cleaner in the bowls.
The Problem is:
Car starts and idles fine. When I drop it into any gear, the engine bogs down and begins to idle much slower. If i feather the gas pedal, or punch it, the engine dies.
I'm told that the carburetor had some components replaced (springs/jets) to make it run properly, so my guess is that it is closer to a 1407 now, just with electronic choke. I'm intimidated by tearing the carb apart and attempting to rebuild it, but I'm willing to do it if that's what it will take, I'm also willing to buy a new carb to avoid 12 hours of work trying to fix the existing one, but I'm afraid I'll have tuning issues beyond my capabilities even with a new carb. Also, the truck doesn't have a tach to assist in the tuning process.
I'd love to bolt something on and start driving, but I'm guessing it won't be that easy. Is it most likely a carb problem? Any recommendations on what I should do, considering my total lack of experience with carburetors?
View 14 Replies
2006 ... HV battery changed over 4 months ago and car ran fine until last week when the car just stopped and won't get ready. Before that incident, the vehicle was running fine all day, while he was returning from the days chores in the evening, it just stopped, dashboard all lit up. After a while, the car started again, and he was able to move it away to the side of the road...just about 2 meters and it stopped again.
View 15 Replies
My 1981 302 dosent like this 4160 apparently. When i start my truck it shudders on first seconds of startup and whenever i touch the throttle. It runs and operates, but im getting concerned.
View 1 Replies
I have a '92 Ranger with a 2.3 liter engine. She starts and runs a couple of seconds and shuts down. I'm thinking maybe a fuel pump is not putting out thepressure needed. Gotta go to work tomorrow and gotta get the truck running today.
View 2 Replies
Ive been having a problem where the engine cranks and idles, sometimes rough, then I try to accelerate and the car shakes and accelerates very slowly with shaking. I replaced plugs coil and leads and fuel filter with no effect but put on a new egr valve and that fixed the problem for 2 months. The same thing happened again and I cleaned the evr solenoid and that fixed the problem for 1 month. Then the same thing happened while I was out and while limping home it fixed itself. Now a month later, the same thing happened, but when I got home and shut it off, the engine won't idle properly (very rough) for 6-9 seconds then dies. I don't know what to check at this point. Thinking it may be vacuum related or possibly a fuel injector or magic gremlins at this point.
View 8 Replies
I have an 02 X, and it's been giving us trouble for almost 2 years now. We've babied it along, but it is acting so crazy now. Here's the current weirdness...
Truck idles, ABS light comes on, within 15 seconds engine dies. Battery is DEAD, must have a jump to restart. Otherwise, if we catch the ABS light and Rev the engine to 2500 rpm and hold it for a few seconds until the ABS light goes out, then it is fine and does not die.
We have replaced the alternator with a stock Ford brand (whatever their brand is from the dealer) because we were told the ones from the auto part stores didn't have a strong enough or steady enough current. (This thing had already eaten 3 auto parts store brand alternators in 2 years.)
View 14 Replies
