Ford Super Duty (1999-2016) :: 1997 F450 Idling Rough / Died And Would Restart But Has Zero Power
Mar 14, 2015
It has 100k on the clock. I bought it about 2 years ago and only put about 500 miles on it. It is only used as a farm truck. Historically it would periodically die at idle in park. Would always start up immediately and run fine. Plenty of power.
Today the truck started up and idled a few seconds and started idling rough. It died and would restart but has zero power. Put it in gear and it would die. Did this a few times now can't even get it started.
I checked all fuses. I checked the dist cap and rotor. Don't look the best but don't think this is the problem. I get the same result on both front and rear tanks. From what I have read sounds like a fuel pump or regulator. Where is the regulator located?
1997 F450 superduty 7.5 gas ...
View 1 Replies
Advertisement
I have a 2001 7.3 ford the seal in the turbo went and oil went in the exhaust. lots of oil like 10 quarts. I had a rebuilt turbo installed ran great for 2 weeks then one day out of the blue started idling rough and then downward from there no power stalling etc I have my super chip scanner it read dtcs of 1249 478 1211 and 238. Is it possible the muffler is plugged with oil? or is it and ipr? 193000 miles....
View 3 Replies
It's a 2004 F450 super duty, no power steering. The pump seems to function, no pump whine. I was told that it may be the steering gear box it's self.
View 2 Replies
1999 Ford F-150 V8 5.4L... The other day I was attempting to fix my 4wd. I discovered that the vacuum tube by the 4wd solenoid had become disconnected. I reconnected it and in an effort to see if my fix was successful, I drove my truck up one of the canyons nearby. I got to an area full of loose rock and popped my truck into 4wd. As soon as I began to drive, the truck started idling very rough and died. I attempted to restart it for the next few minutes unsuccessfully. I got it started once and it continued to idle rough for a few seconds and died. I have not been able to start it since. It turns over but will not crank. It is not throwing any error codes. What I have checked so far:
Spark plugs are working.
When turning the ignition into the ON position, I am able to hear the fuel pump working.
I have not seen any cracks in the vacuum hose.
All the fuses are still okay.
What the culprit may be?
View 2 Replies
I am working on a 2006 f450 6.0l. My problem is when I take key out of the ignition the power stays on in truck. Radio stays on and windows. I swapped out relays checked door jam switch I am stuck. Looking for wiring diagrams so I can trace the wire.
View 5 Replies
2002 F-250 SD V10 Auto Trans 140K miles.....
Engine ran fine until battery died. Vehicle then sat from Nov to May with no battery in it. On start up now after install of new battery, engine initially surged at idle and seemed to miss (run rough) in gear/under load. No CEL or codes. After a single short drive idle and running under load seemed to have improved a bit, but not yet back to what I would call normal.
QUESTIONS:
Is this simply a matter of the computer having to relearn after battery disconnect?
Will driving restore things back to where they were/should be?
How much driving/How far?
View 7 Replies
2005 5.4l... Its giving me a code p0506 rpm to low idle air control system called for new one they said my truck don't have one said only up to 04 so what now truck idles rough n when u step on it it misses so bad its not funny feels like its laying over...
View 3 Replies
I have a 1999 F450 that was bought new as a cab and chassis. The truck belonged to my dad who passed away two years ago and now I have it. I am wondering if it has 4.30 or 4.88 gears. The rear end is huge! It has an aluminum cover with cooling fins on it, not sure if they both had that or not. I looked online and I think it said all cab and chassis had 4.88?
View 10 Replies
My 99 f450 7.3 runs bad on first start of day. I checked the codes 3 codes p0475, p0470 and p1247. Now here is what I tried I plugged it in over night and it will start and run as should the next morning with out side temp 47. Drove the truck late yesterday evening didn't plug up tried it this morning with a outside temp of 47 truck starts but missing and like of power. My problem seems to be temp related. Will low boost pressure cause this problem what do I need to do?
View 4 Replies
Purchased new 2016 450 platinum. Has less than 800 miles on it and has a terrible vibration between 70-80 mph... Already have taken to dealer who stated there was a wheel out of balance and that they fixed the issue. But still present.
View 14 Replies
I have a 99 F450. I have an ABS light on. No codes (at least not that my code reader can pickup), but I am also not having any issues. Brakes work fine. What to swap out or where to look?
View 7 Replies
Can an f-450 with a blown 6.4 diesel received an transplant from an f-350 V-10.
How much would need to go over from the f-350 to f-450?
View 1 Replies
I have an 03 with a 6.0 diesel, going down the road and started losing power and then died. Won't start, and I don't have a scan gauge. Several sources said ipr valve, and from videos on youtube I thought may be a good place to start. I bought a socket and pulled the valve, to check the screen. There is no screen whatsoever on the ipr. The oils clean, as I had changed it about 200 miles ago, and I ran a magnet in the hole looking for a screen, couldn't find anything so I used my fluid pump in the hole. No trash, screen or anything. Do some ipr valves not have screens? What would be my next step??
View 2 Replies
I have an 02 F450 with a dump bed an just under 45,000 miles (was barley used by the first owner). This maybe unrelated to my problem but is worth mentioning. This past week I noticed a small puddle where I had previously parked at a customers house so I checked the oil. I was about 2 quarts low. I followed the oil trail up and found a pool in the valley. One of the high pressure lines were loose and the seal was chewed up so I replaced it and tightened it. No more oil leak.
Now my new problem. Two days later, after about 45 minutes on the interstate driving about 75 mph the truck started to rapidly lose power as if it was running out of fuel. I heard a loud ticking sound coming from the engine and the more I tried to accelerate the worse it got. I pulled over and the truck stalled. I thought that maybe my fuel gauge had crapped the bed on me because it still read a little over 1/4 tank. I called a buddy and got more deisal in it and it started right up. We'll after about 5 minutes of 60 mph it started to happen again. So to fast forward... I opened up the tank and found the the strainer had crumbled in the bottom of the tank.
So I cleaned out the screens in the sending unit and replaced the strainer, replaced the fuel filter, and reverse blew out the lines. I read about checking the hpop reservoir for oil and it is present. So to sum up, as long as I stay under 60mph or so I can get about 5 minutes of run time before the truck starts to stutter and stumble. If I shut it off for about 5minutes I can go back up to 60 again but it the cycle continues. 5 on and 5 off. If I start the truck after say 30 seconds after shutting it off it sounds like it's going to die and has no power at all. I have worked on a lot of vehicles but none with anything like this and this is my first deisal. What do I do to get this beast back to normal?
View 3 Replies
I have a 1999 F450 Diesel dump truck. Automatic. The problem that I have is that the truck will drive VERY SLOWLY while the rps go up.
You can hear the engine revving up, and a strong air sound when doing so (do not know if intake or exhaust, but its like a strong wind sound. And not like a hiss, so I do not think its a vacuum leak).
The transmission goes through gears fine, but it does the rev up thing through every gear. So I am wondering if something like the torque converter might be broken or slipping.
For example, if you go with the loaded truck up a hill, you have to really push it to keep any type of speed. Or when you get off a red light.
When I bought it used, I thought that it might have a really short final gear. But that would not explain the high RPM and no push.....
No codes at all.
View 10 Replies
I've got a 2004 f450 6.0 diesel. This thing will start and run great when it's cold. Then when it gets to operating temp, around 190, it will shut down. This is getting worse and worse.
A little history, it was doing this for awhile and a had a few other issues before this. Puking antifreeze, stiction issues, and bad exhaust manifold. Since it wasn't running great I figured why not pull that cab and take care of these issues.
As of last week she got new head gaskets, new exhaust manifold, new injectors, updated standpipes, updated dummy plugs, new o rings on hpop (yellow on the bottom), and a new pipe to the oil pump. I have the old style it's not the stc fitting.
All that work, it still stalls when warm. I monitor with a scan gauge 2. ( Big diesel tech Ron's fan) ...
First thing, give here two second crank start right up, runs better then ever. Gets to operating temp, rev it up, then stalls. Ipc is at 85% ipr gets up to 180 psi.
Unplug ipc, shows 765 psi on the ipr still no start. Put shop air to her and I can't hear any leaks ( probably 15 mins or so).
View 4 Replies
I have a F450 that I bought a few months ago and have been having trouble with Fuse location 35 blowing. When I purchased the truck the 4x4, tow/haul, and reverse sensing system worked because I had to use it loading and unloading my boat this fall. Since then the snow fell and when I tried to put it into 4x4 I noticed it would not. I checked the passenger compartment fuse (loc. 35) and it was blown.
So I figured it was an easy fix, changed fuse, and it immediately blew again, and again. So then I started checking components related to fuse 35. First i checked the tow/haul switch in the shift lever and thought it was that, so I replaced it, and it still blew fuses. Next, I unplugged the reverse sensing systems and still blew the fuse. Next, I turned my attention to the transfer case shift motor. I replaced it and still blew fuse. So at this point I am stumped.
It is probably worth mentioning that when I replace the fuse initially and turn the key over, all systems work. I can switch the dash switch to 4x4 and it will shift, also the illumination light on the dash comes on. I can also toggle the tow/haul switch and the illumination light on the dash comes on as well. The reverse sensing system also works as well and the light in the switch works as well.
Now and important thing to note is that it seems to hold the fuse for a minute or more with the engine off/ key on, when I start the engine, it works briefly but then the fuse blows. I am not a service tech. by any means but am very comfortable under the hood and have a fairly good understanding of electrical components and their operation. It seems to me that somewhere in the circuit that there is a short to ground or a faulty component(module) or something completely different.
The fact that it takes a minute or so to blow the fuse as compared to an immediate blow when the key is cycled to power on. I would like to fix this myself as with anything I do, I like to educate myself through diagnosis/repair. The last piece of information with mentioning is that before I purchased the truck(30,000 miles ago) it had a factory reman engine installed at a ford dealer. If worse comes to worse I will have to take it to a Ford dealership for service but would like to keep it in house if I could!
View 4 Replies
I tried to take my tailgate off my 08 F-450 today.
Did it the same as every tailgate Ive taken off in the last 20 years...........it wouldn't come.
Is there a trick to it?
View 6 Replies
Im working on a 03 f-450 that has a front end vibration, it starts when you hit 25 mph and its a humming / vibration that seems more to the passenger side than the drivers side. You can also hear it decrease when you come down in speed and it dissappears below 25 mph. Its a 2003 F-450 CC 4x4 DRW with the v-10.
View 7 Replies
I hit a Turkey running across a back country road the other day . Never took flight. Shortly after that I lost my AC. I took a quick look at the front of the truck and saw no damage. The next day I found the grill lower chrome bar cracked and the AC condenser bent and leaking.
I had to replace those items plus the plastic support frame that all the chrome pieces are attached to. And recharge the AC. Hard to imagine the damage done since I could not stick 2 fingers thru the support grating. Been looking at Grill Guards but not thrilled with the look .
View 13 Replies
I have a H&S mini max. Controller and have installed the mild download and run on the street setting for every day and tow setting while towing my fithwheel, when I just took it out for a test drive towing the fit wheel going up hill it kept shifting up and down which sure felt like 3rd and 5th because rpm would go from about 3500 to 1500 back and forth so it sure felt like it was not hitting 4th, could this be a controller issue?
View 4 Replies
