Ford Super Duty (1999-2016) :: 2000 F550 Lost Power / Shakes And Dies
Sep 5, 2013
I have a 'new-to-me' Ford F-550 with the vaunted 7.3 Powerstroke diesel engine. The truck only has 120k miles and ran great when I bought it. Last week it began acting up. While driving on the highway, it lost power, began running rough, and once I pulled over, it died.
After a few minutes, I tried re-starting the truck, it started, but had little to no power....I could get up to 30-35mph and then it would slow down and lost all power. I let the truck sit for about 20 minutes while I refilled the diesel tank, it started right up and drove normally for another 10-15 minutes and then the same thing happened again.
The truck sat for a day and then drove normally for two entire days. This morning, it began acting up. It is the same as before..... what to do with this type of issue?
There is not a check engine light lit (yes, it works). The diesel is from a good source that is not causing problems in anything else. The truck is otherwise strong.
View 5 Replies
Advertisement
I'm working on a 2000 7.3 that was running but had no power so we changed out all the injectors and glow plugs and rebuilt the turbo now there is no start ...
View 2 Replies
Recently removed a plow and wiring harness from my 00 F550 and now my headlights no longer work. The headlight plugs have an adapter that the plow harness plugged in to and it now appears I need some type of end plug on each one to complete the circuit. The problem is the dealer doesn't understand what I need and doesn't think there is such a part out there. Perhaps my thinking is all wrong.
View 3 Replies
Having an issue w/ my 00 550. When I lock in the hubs there is instantly a noise, More of a squealing then a grinding. The truck goes in and out of 4x4 no problem and the noise is there locked in 4x4 and not locked in, as long as the hubs are locked in. I can't tell if the noise is coming from the 4x4 driveshaft but there is no noticeable play in the u-joints or the u-joints in the front axle. I did notice when I spin the 4x4 shaft by hand the passenger side joint spins slower then the driver, not sure if that's normal or could be the problem.
View 2 Replies
I am trying to figure out where the relay would be when i look online for the map of the relay box under the hood it says nothing of a horn relay. I don't have a key fob for the doors to unlock so I wouldn't think its tied to the computer. Should mention nothing happens when you hit the horn also fuse is fine. No power at the actual horn when i hit the steering wheel(horn)....
View 8 Replies
Alright i got a 2000 f250 with the 7.3 and its stick, when i let off the clutch to start moving, and at low speeds like mainly 1st and 2nd gear. Right below the cab there's a loud kinda growling or rumble, it shakes the truck a bit til i start moving good. Then it goes away. But what it could be? I think pilot bearing.
View 5 Replies
I have a 2000 f350 v10 ext cab 8 ft bed 4wd,i replaced all 10 plugs all 10 coils at 40 mph the truck violently shakes an vibrates read on a few things that could be crack cylinder or bad pistons,i did a test on it an says low compression in 2 cylinders 1&2 what can I do an what is the best option for me as I just got the truck not even a month ago...
View 3 Replies
I have a 2000 f250 superduty gas v10 6.8L . I bought this truck about 4 months ago. Now when I take off from a complete stop the truck shakes up until second gear, shifts fine all the way up until the last gear it looses power "loosing power" i mean i can put my foot into the pedal and it takes forever to climb speed meanwhile the RPM'S never skyrocket like it the transmission was slipping if anything a couple times the RPM's dropped are stayed the same then as i take my foot off of the pedal once i have my desired speed sometimes not always the truck will give me a little jerk Also Just the other day I was driving on the highway and decide to put her on cruise control at about 70mph, I set the cruise control and the RPM gauge was just over 2,000 and the tach was fluctuating up and down about 1/16 of an inch. I been reading alot of forums and what I got out of them is it maybe pointing me to a misfire maybe the coil packs? Plugs?It's not something major like a transmission rebuilt.
View 6 Replies
I have spent alot of time looking through threads about v10's misfiring and have not been able to resolve my issue. I recently purchased a 2000 v10 f250 with about 220000 miles on it I bought it knowing it had one miss fire but now I have a total of three. Te truck has no problems accelerating but at a little over 40 mph the engine shakes quite noticeably and after 60 i5 seems to smooth out. After alot of reading I replaced all of my plugs and ignition coils, ran a can of sea foam through my gas tank and my intake with no change to the miss fires. I have started my trials with the fuel injectors by switching them from miss firing cylinders to ones that aren't. Some other information is my truck has no egr on my intake.
View 4 Replies
My truck will turn over very strong but will not crank. it cranked one time then died immediatly. 30 min later it cranked and ran for about 5 min then died again. Alternator, fuel pump.
Gas v10 motor, full of gas, new spark plugs.
View 8 Replies
2003 f550 with 7.3, suddenly loses power and struggles while driving. White/blue smoke comes from tailpipe, can smell the diesel exhaust bad when happens, comes and goes intermittently but has been happening more and more often. I uploaded a video onto YouTube to show sound, rough running motor and smoke from exhaust although smoke not that bad in video. Search "shadetreelandscaping" on YouTube in case link below doesn't work.
ShadeTreeLandscaping - YouTube
Took to ford dealer a few diff times for problem and they can't get any codes, can't duplicate problem. After it being in for third time they say had to call ford tech hotline and they suggest replacing injector however can not and will not gaurntee that will solve problem, and obviously dealer isn't cheap for repair. I find it hard to believe that a bad injector(s) would be an intermittent problem as it is or that it would cause fuel pump to make gurgling sound.
View 13 Replies
My 2000 ford f350 will start and then dies on me when i try to put in gear. I changed air n fuel filter. Adding oil i noticed the stick was still reading dry. Noticed a big oil spot under the hood. What should i try to do? Do not want to put in shop cause every time she goes in I come out broke.
View 1 Replies
I have an 05 F-250 with the 5.4 liter motor, 4" lift, 35" tires 4x4. I have not had any problems with the truck and have 110,000 miles on it. the only thing I even did to it was replace an alternator. Recently it seems to have lost power.
I use the truck mainly for hauling my smaller horse trailer which is roughly 7500 fully loaded but most times i haul it at about 5500lbs.
I also have a 2003 7.3 which we pull at 20,000lbs no problem
View 11 Replies
I was driving down the highway and the truck was in overdrive and under a load passing at about 20lbs boost and all of the sudden I lost all power, felt truck shake a little. The tow/haul light is flashing and got only one code P0730. The truck won't go into gear in either forward or reverse now, had it towed home and put a pressure gauge on it and found about 100psi at idle In neutral, in reverse and forward I got strange readings the pressure goes way up momentarily then down to 100psi, and increments back up to over 500 psi and seems to stay there but neither forward or reverse engage. I have no clue what could be wrong at this point. I am attaching a video .....
View 14 Replies
Ok, so I am trying to get are 99 F550 all fixed up and have a few things to ask.
So we have had the ABS light on now for some time. I had it scanned at O Riley's and the scanner said the abs sensor on the passenger side was faulty. So I replaced that and the light was still on. We had taken the truck to ford to get it checked out for a rear end problem we have been having as some of you may know from a previous post I made.
Well ford said it was the rear sensor on the axle that was causing the abs light to come on. So I replaced that. Still have the abs light on. I disconnected the batteries to try and see if that would reset it and it did not. I hooked up the Scan Gauge II and ran to see if it picked up anything. It said it did not pick up any thing. I still did a code clear but it didn't work. If there a tricky way that you have to get the code cleared off?
2nd I was checking the fluid. I noticed that the tranny fluid is over filled quite a bit. Will this hurt it? Should I drain the fluid to where its at the fill line?
View 3 Replies
I don't know what is wrong with my truck. I don't know what this symptoms called, but It felt like it was missing a beat. The engine suddenly lost power for a second or two wile driving. It did this few times. Is it the engine or the transmission? No check engine light is on. 2001 F250 5.4 V8
View 8 Replies
I have a 2011 f250 with the 6.2 liter gas engine. Lost power and the check engine light came on. I pulled the codes and it is a camshaft position sensor and 4 other codes for misfire on all cylinder for that bank. I can't find any info on where the sensor is located or how to replace it.
View 2 Replies
I have a 2010 F250 with the V10 and 42000 miles. Lost*power*while pulling a trailer. Couldn't get over 30 mph. Tried turning back home and lost all*power*and would barely idle. Fuel filter good air filter good. Code P0300 came up. Towed it back to the house and then couldn't even get it to idle. Wouldn't throttle up past about 2800 rpm. Cleaned MAF sensor and nothing. Somewhere during all that P0174 code came up and misfire cylinder 10. Cleared codes and they haven't come back. Now when trying to crank, it barely turns over, yet battery is good. Opened air filter cover after getting it to start one time and there was some light smoke coming out. Also while barely keeping it running for a little bit, the catalytic converter on the driver side was fire hot and the other side I could grab with my hand.
View 6 Replies
So I was traveling thru the grapevine on the 5 Fwy and no problems. Made it to the top didn't over heat. Then all of a sudden it lost power. Pulled over and it stopped running. Won't start. Fuel is pumping, I took off the fuel filter and turned ignition on and it filled up.
View 2 Replies
My 2003 6.0 truck lost most of its power. It has the SCT programmer. It used to run great it would roll coal really well then it slowly started to run worse. Now it runs really sluggish especially when its cold. IT takes forever to warm up. On the freeway when ur going a constant speed it bucks and jerks a lot. It won't roll coal anymore and just runs like crap. A mechanic said I had 3 bad injectors. But I don't believe it.
View 2 Replies
OK, so I have the brake pedal downshifting, but there is no real exhaust brake. Can I have one installed, like the latter model 2015 or even the 2016, with the button?
View 9 Replies
