Ford Super Duty (1999-2016) :: 2003 F350 V10 - No Dash Lights / No Start Or Crank
Dec 22, 2015
2003 f-350 had no dash lights and no start or crank. Found battery cable junction on left fender broken fixed, replaced starter. Drove it sunday, went about 15 mi and just shut off. Towed home was a battery, replaced battery, now I have lights but turn key and nothing? Was starting fine, all summer seems like a cold weather issue. Any relays I should be looking for? I was going to check power to started but raining too hard this am ...
View 4 Replies
Advertisement
So I just purchased a 2011 F350 6.7 this week...I've had absolutely no problems until I drove it to the dealer just to get it detailed...I give the salesman my key and he comes back and says it won't start...we tried numerous time to start it...put jump boxes on both batteries and nothing...had full power to all accessories but when attempting to crank it would black out on the dash screen and give me a "stop vehicle" warning....does this deal with security?....also after hassling to get rental for a hour or so,we tried agian and it fired right up?!?...also it started double honking when locking. ..is that due to the hood being up?
View 3 Replies
I have 1999 f250 powerstroke, batteries are fully charged but when you put key in ignition and turn you get nothing. No dash lights, no crank, nothing. I cleaned the battery terminals on both batteries, checked all the fuses under the dash and the hood.
View 9 Replies
Drove to work had no issues, went to leave & noticed that the dash lights didn't light as normal when I turned the key over, then tried to start but it just cranked, checked the fuses all good under the dash & hood.
View 1 Replies
So I 2003 6.0 F350 that is a Dually. Been sitting in my yard for about two years now. I turn the key it just clicks and it doesn't crank. The starter solenoid is not on the firewall so I use the trick with the battery connected positive straight to the starter with the whit The starter solenoid is not on the firewall so I use the trick with the battery connected positive straight to the starter with the wire on the engine bay. It cranked for a while and that started ran rough. Then it just died. I did not start again. I did this during winter so the engine have time to cool off it was about below freezing. Done this multiple times and drove up and down in my backyard but not on the road. What could be wrong with it. Either way I put in diesel 911 and more fuel but and I change the filters with Motorcraft OEM filters. Sure that the caps were right.
View 14 Replies
I have 99 f350 single rear wheels 4x4 . I went to start it this morning and it would crank but not start b/c it was cold. I plugged it in and still wouldn't start then it wouldn't even crank. I checked all fuses swapped relays and I have new batteries. The last thing I did was hit on the starter a few times and it started. So I went and bought a new not remand a new starter and put it on and now it won't crank!? I get 12v at the little wire on the selenoid on the fender. So now what?
View 4 Replies
I have a 2000 F250 7.3 manual tranny that was put away for winter storage and now will not start. Need it to get my weekend work done now that the snow is finally gone. Symptoms:
- not cranking
- no dash lights (no oil light, battery light, etc.)
- radio works
- head lights work
- key buzzer works
- can hear clicking when turn key (assume solenoid OK)
Put in two new batteries, fully charger and terminals are clean. Where should I start looking?
View 11 Replies
We just bought a 2000 F350 knowing it has some issues. The #5 fuse (generator/secondary) under the hood consistently blows fuses the second it's inserted, meaning there's a dead short. Truck will crank but not start. As well, theres a 5 amp fuse under the dash, which when inserted, keeps the instrument cluster on as if the key was on, even with no key in the barrel. We cannot hear the fuel pump running, the fuel reset switch is fine, all ignition wires at the column are showing 12 volts at the right times. What could be wrong? I'm a 12 volt specialist, but not a ford tech.
View 6 Replies
Having an issue with my 04. Wife got in the truck to move it and no dome lights no crank nothing. Swapped the battery for a new one. Still nothing.
I checked all fuses. I literally was just driving it 10 months prior to her getting in it. Said dome came on for a second then shut off. 2004 F350 5.4 ....
View 3 Replies
So here's the deal, crank no start its getting fuel. Has base oil pressure and i put a ficm on that test good with a voltage meter key on engine off and cranking. I haven't hand any trouble finding info on this issue so. We can keep picking away. Just cant find anything about this.
A buddy of mine who has been trying to figure it out for me, Got it to start using a starting fluid. And it would run if someone was pushing the gas peddle but wouldn't idle. Or start without the starting fluid.
View 2 Replies
I have checked the fuses on my 2000 f- 350 for the dash lites. They are ok. I have turn signals n all but no dash lites ?
View 14 Replies
I've got a 2005 f350 with a 6.0 starts when it wants. I have checked the ficm and 48 volts when key is on and cranking! How do I know if my icp is bad? Some days it will start no problem but most days it will just crank over. When it does start i run it for a while shut it off and try to restart it and it wont!
View 3 Replies
I have a F350 2000 crew cab srw with 7.3 diesel. I removed the HID that was installed by previous owner. The factory wiring harness was still intact but now I don't have running lights or dash lights. I still have head lights, brake lights and blinkers... I replaced the head light units with factory replacements......
View 3 Replies
2010 ford f350 super heavy duty diesel...
View 1 Replies
I'm just a shade tree mechanic try to diagnose a hot crank no start condition on my 2006 F-350 6.0 that I purchased second hand about six months ago. I first took it to a diesel shop to have them fix it and the mechanic told me that the stand pipes and dummy plugs needed changing out but couldn't tell me 100% if that would fix the hot no start problem.. I have been reading a lot about this problem and it seems that the snap to connect fitting on the HPOP is the most common problem on these trucks. It seemed easy enough to do so I went after it only to find it was already replaced with the updated part.
I went ahead and changed it anyway but it obviously didn't work. So today I pressurized the system through the ICP port with my small harbor freight compressor up to 80 psi and forced the IPR valve closed with 12v. I then listened for a leak in the passenger side valve cover with a hose stuck in the oil fill cap, the driver side cover from some drain hole under the air filter housing and in the oil filter housing. I could hear a mild hissing from the driver side and the oil filter housing but it was clearly louder from the oil fill on the passenger side. This leads me to believe I have a top seal leak from one of the injectors on the passenger side, but not 100% sure. Should I be hearing anything at all from the driver side and from the oil filter housing if its a bad seal in the passenger side?
Another problem I just found out I have seems like maybe fuel in the oil. I done a oil change this week after 3500 miles since last change and drained out five gallons of oil!! The oil seemed really thin. My coolant level is still good so the only thing I can think of is fuel dilution. Could this possibly be the same o ring or injector that is causing my hpo leak or something else? Will a bubble or balloon test diagnose this?
I bought a cheap OBD2 reader that works on my Ipad with a app called Dashcommand so I can see what codes were stored. The codes are...
P0401- Exhaust Gas Recirculation A Flow Insufficient Detected (EGR has been deleted)
P0528-Fan Speed Sensor Circuit No Signal
P0670-Glow Plug Control Circuit/Open
P0683-Glow Plug Control Module to PCM Communication Circuit
P2290-Injection Control Pressure Too Low
So far my thoughts are to replace the injector and nipple cup seals to take care of the hpo leak. Once I have the valve cover off, clean the injectors real good and cycle the fuel pump with turning the key on and inspect the injectors for a fuel leak. Is there a better way than this?
View 8 Replies
This is my "03 F350 single wheel 7.3 automatic 4x4. For quite some time now I have to manually lock the front hubs. Maybe it would work automatically, maybe not, and now I always have to manually lock the hubs.....but I can live with that. The problem now is that the selector switch on the dash isn't working or something else is preventing the transfer case from going into 4x4. The 4x4 light on the dash also does not come on.
I have checked all the fuses and they are good, I do not have a owners manual so I don't know what to look for in the fusebox. Perhaps it is on a relay? Also, I would like to check the dash switch for power coming and going but how do I get the switch out of the dash? I'm afraid I'll break the bezel around the switch if I pry too much.
View 1 Replies
How to take the panels off? I need to remove the passenger srs module for the light bulb repair. It's a 2003 F350 XLT SWR 4X4.
View 3 Replies
Truck wont start with key. It has a brand new battery, brand new starter & brand new solenoid. When I turn the key to the on position the lights come on but it wont start. The truck will start when I jump the solenoid. Im wondering if its the ignition key cylinder or the ignition switch, or maybe something else like a relay or faulty wire. Where I should start or what the problem could possible be?
View 6 Replies
Bought a 02 F250 5.4L a few weeks ago. i have replaced the coils and plugs, put in some fresh oil and some other minor things. Last weekend i drove over to my neighbors and back with no issues, until i went back out to start the truck an hour later.
The dash lights come on, but the engine wont start up. i hear a kind of whirring sound coming from a black canister under the hood on the drivers side. I cant use my code reader and I have pretty much exhausted my little piece of diagnostic knowledge. i originally thought it may have been a starter and got a fresh one ready to install but after thing about it i don't feel that's the issue.
I live in a very rural area and bringing it to a dealership would be a 150 mile round trip. What that black canister is? Why it won't start up?
View 5 Replies
Interior lights will not turn off when parked. Probably related to this I commonly, but not always, get a door ajar indicator on the dash. But usually this is all temporary. And usually if i lock the truck with the fob, they shut off.Tonight the interior lights, as well as the bed light, stayed on. I looked at fuses to pull, but of all the fuses and relays, not one is listed as "interior lights" . So I disconnected the batteries and figure I'll tackle it tomorrow. 2003 F350 Lariat....
View 6 Replies
I have a 2003 f350 v-10 drove it yesterday to get fuel, went to start it after fueling. No start, no lights dash was gauges were acting odd, and clicking under dash from behind fuse box. did get it to start after a while, put my foot on brake to go into drive, never made it ... truck died I do have remote start system thought it was that with the brake pedal issue. disconnected complete system. no change
Had it towed, home now no nothing, connect battery and just clicking from under dash no start ? not battery, wont even jump
View 8 Replies
