Ford Super Duty (1999-2016) :: 2004 - Changing Shift Motor - Transfer Case Stuck Due To Broken Bolt?


Oct 15, 2014

I'm in the process of changing my shift motor on my 04 f350. I can't get it off because of a broken bolt. The previous owner must have done this before, and snapped the head and some of the shaft off, so it's basically an alignment pin that's recessed into the hole on the motor. For some reason it's holding the motor on, even though I don't think the hole is threaded. Any way to get it off. I'm thinking that taking a MAP gas torch to the casting on the motor may be my best bet.

View 8 Replies

Advertisement

Ford Super Duty (1999-2016) :: Transfer Case Would Not Shift In To 4 Wheel

Originally it would light up on the dash, the hubs would lock, but the transfer case would not shift in to 4 wheel. Followed the troubleshooting I've found, was receiving power at the connection on the shift motor but it was not turning.

So I went and bought a new motor, installed it, still wouldn't turn. (with the motor off the transfer case but electrically connected). So I found a few more replies about the relays, swapped them, nothing.

Removed the covers and manually flipped the connection, nothing. Now my hubs are locked, transfer case is not, and I get nothing when I change the switch on the dash. (no lights, no hub click shift, no 4 low, nada). All the fuses are good, just doesn't work.

View 4 Replies

Ford Super Duty (1999-2016) :: 2003 F350 Sounds Like Shifter Motor On Transfer Case Is Trying To Engage

Truck is an 03 F350 with the 6.0. It sometimes sounds like the shift motor on the transfer case is trying to engage. It has the vacuum system which is blocked off. Warn aftermarket hubs. Switch on the dash with 2wd, 4wd and 4 low.

It's kind of an off and on thing. Try to engage for a few or more seconds then nothing for awhile then repeat. It sounds like it's at the transfer case. It could very well be coming from firewall/engine bay area as well. Is there anything between the dash switch and the motor?

View 2 Replies

Ford Super Duty (1999-2016) :: 2004 F350 - Transfer Case Blowout

The transfer case on my 2004 F350 6.0L 4WD DRW, 230K miles, just blew to pieces Sunday night. See images below. What could cause this?

I just had the front drive shaft rebuilt with new universals and ball. It was making a metallic squealing noise after this.

I noticed that the front drive shaft did not spin freely when parked in nuetral and set for 2WD. I thought the front drive shaft would only engage when in 4WD.

View 14 Replies

Ford Super Duty (1999-2016) :: 2003 F350 - No Power To Transfer Shift Motor

I have a 03 f 350 6.0. My 4x4 wont engage. I checked my fuses all are good except 31 no power. Is this the culprit?. I get power at the 6pin pig tail on shift motor, but the 2pin pig tail doesn't get any power at all. I pulled shift motor off manually put power on it and it works. I also replaced both 30amp relays under hood...

View 1 Replies

Ford Super Duty (1999-2016) :: Transfer Case Is Engaged / Won't Disengage

For about a week or now i have been trying to track down a sound from my truck, i had another post up and was finally with jhl3 able to determine that the sound is coming from my transfer case. The other thread with video of sound is located here : [URL] .... I've got a little bit of time to mess with i now

Quick rundown, began hearing odd sounds about a week ago, determined that it is transfer case. Front hubs are unlocked, esof switch is set to 2wd. Can not turn front drive shaft. I just put some zip ties on front drive shaft and went for a short spin, determined front drive shaft IS turning. Hubs are not locked and 4x4 is not engaged, did the sharp slow turn test, no feel of pull from front end.

Im not quite sure where to go from here, going to check connections at tcase motor and some relays.

View 14 Replies

Ford Super Duty (1999-2016) :: Heavy Duty Rubber Floor Mats With Transfer Case

New floor mats. My truck is going to be 10yr old and has the original King Ranch floor mats. I want some heavy duty rubber ones that will fit around my manual transfer case lever. I ordered the Weathertech digital fit liners and I am not happy with them so they are headed back tomorrow. They have a heavy duty all weather mat but not sure how it will work with my shift lever on the floor. Husky liners/mats look nice and heavy duty but won't accommodate the floor lever.

View 6 Replies

Ford Super Duty (1999-2016) :: 2000 F250 - 4x4 Won't Disengage At The Transfer Case

We have a 2000 F250 7.3L Diesel. A few years ago we switched out the auto hubs for manual Warn hubs. We've had no problems with 4x4 since that time, until now!! The 4x4 Hi light is on and the transfer case is engaged. Since the hubs are manual we have them unlocked, however we can't get the 4x4 to disengage. At one point, tried changing to low and it hesitated but finally went in to 4 Lo, then we had a hard time getting it out of 4Lo and back to 4 Hi. Here's what we've tried--checked fuses, checked and replaced relays, checked wiring connection at the transfer case. Husband used volt meter to test power at transfer case wiring connector--showed 0.5 volt of power with the key on. No change in reading. Checked power at relay--about 14.5 volts there. Took truck to repair shop but their computer could not communicate with the GEM.

View 7 Replies

Ford Super Duty (1999-2016) :: 2011 F350 - Transfer Case Fluid Change

Trying to stay up on my maintenance on my '11 f-350 diesel. It just turned 59k. I can only find Ford's recommended service interval for changing the fluid in the transfer case listed in the "Special Operating Conditions" section of my Scheduled Maintenance Guide for towing, delivery, off-road and dusty conditions at 60,000 miles. I tow some, but maybe 20% of the time, I end up driving a lot of stop and go though.

So I found this nice how to online "Guzzle's Transfer Case Fluid Change" - it's for a 02 heavy duty, is it about the same on the newer diesel trucks?

View 1 Replies

Ford Super Duty (1999-2016) :: Overfilled Transfer Case Or Leaking Transmission Output Seal

I just changed transfer case fluid on my father's F-350 for the first time in 13 years. (over 230k). Removed fill plug first and fluid gushed out of the fill hole unexpectedly. Did not have catch pan ready, so made a mess. I thought it was just over filled form the factory, but too much was coming out to be simple overfill. Almost 2 qt came out of the fill plug.

Did some google search and found many Ford trucks have failed transmission output shaft seal and transmission fluid leaks out to transfer case, causing transfer case to overfill. I am yet to check transmission fluid level, but considering how much came out of it that probably is the case.

Now, how bad of the problem this really is? Will overfilled transfer case cause some serious problem? 4x4 is rarely used (once or twice a year in winter) on this truck and from what I understand transfer case doesn't really do anything in 2WD other than just passing output from transmission through.

There are no fluid leaking outside and repairing the seal would be a too much of work for me.

Also changed rear differential fluid for the first time and I was surprised how clean the fluid was. There were thin layer of black sticky residue (sludge?) covering everything, but the fluid itself looked clean and no visible metal shavings. I guess that is why Ford said it does not require change under normal condition.

View 10 Replies

Ford Super Duty (1999-2016) :: 2001 F250 - Power Feed To Transfer Case Relays

2001 F250, 7.3L ... After much diagnosis, I've found that the 4 positive feeds to the transfer case relay base have no power to them. The fuse that feeds them (#17 CJB) is fine and when I jump from the fuse hot side directly to the transfer case motor contacts on the relay base, it shifts fine. As far as I can tell, there is only one wire leading from that fuse so there must be a junction block somewhere that splits it into the 4 wires that feed the relay block. I've looked underneath and found nothing. How the 1 wire gets split into 4? On diagrams this junction point is labeled, but I don't know where to find that.

View 2 Replies

Ford Excursion :: Transfer Case Shift Motor Change

My TC motor picked today of course with the snow to go bad. Luckily I hobbled to advance right as they were about to close and got one. I laid in the snow and changed it. Needless to say I got soaked beyond belief. Anyways now it changes in and out well but still seems way to loose in the rear. Not sure if something else is malfunctioning or if these things are like that. Right now I don't feel nearly as safe as I did in my expedition and that was without even using 4hi or low just the A4WD. The excursion is sliding everywhere. My tires have great tread but are highway tires so maybe that's the issue. They are Dura Grapplers. I'm going to try throwing some weight in the rear to maybe gain some traction.

View 2 Replies

Ford Super Duty (1999-2016) :: 2011 F250 - Oil Leak At The Rear Of Transmission In Front Of Transfer Case

Made a short run to get lumber yesterday and when I got home the truck smelled hot I checked it out and found a transmission oil leak at the rear of the transmission in front of the transfer case. can not really see what is leaking only has 22,000 miles. What may have happen. 2011 F250 4x4 6.7....

View 14 Replies

Ford F-150 (2004-2008) :: Front End Shake After Changing Transfer Case Oil

On my 2007 f150 5.4 last week i changed out the driveshaft and it smoothed things out. This past weekend I dropped the transfer case oil and refilled it with motorcraft transfer case oil as per ford but now the front end seems to shake more than before. It just seems to come through the steering wheel but the wheel seems tight almost like a death wobble with solid front axles except obviously this truck doesn't have that. There are no leaks and I filled it up to the top fill hole with between 1.5 to 2 liters of oil until it started running out. I should also mention that when i went to check the level it was overfull on the top plug but it was that way for the last 90,000 km or so.

View 3 Replies

Ford Super Duty (1999-2016) :: 2008 F450 - Driver Side Exhaust Manifold With A Cracked Abd Broken Bolt

I got a 08 ford f450 sd in the shop with a cracked abd broken bolt in the driver's side exhaust manifold, any tips tricks on getting it out,I have everything loose but I can't for the life of me get the egr cooler out of the way to access the top bolts to the manifold so I can replace the manifold, or a link to a service manual would be great.

View 3 Replies

Ford 7.3L Power Stroke (1999-2003) :: Transfer Case Motor Replacement

Do we need to drain the fluid to change the transfer case motor?

View 3 Replies

Ford F-150 (2004-2008) :: Removal Of Transfer Case Shift Knob?

I've read a few posts of people trying and they say the cant be removed but I just don't believe it! I cut off some of the rubber on the with a knife and its all white plastic underneath.. I just don't believe that its actually impossible to remove this.

View 3 Replies

Ford Super Duty (1999-2016) :: Excursion Won't Start After Changing Shift Tube

I changed the shift tube in my Excursion today. I'm trying to put the key switch back in. It will go in and rotate fairly hard. I can not get the key to release. When I hook the battery back up, everything functions as it should but it won't start, the key won't release and it still turns hard. The dash lights come on and such when the key is turned to run. I tried a different key with the same results. Everything looks good.

View 1 Replies

Ford F-150 - 1997-2003 :: 1999 - Manual Shift Transfer Case / 4x4 Only Engages In Reverse

just bought the truck first time out hit some snow and it was not engaging low or high range, but I noticed that when I was backing up it was engaged again works in high and low range, i had to reverse about a mile up the road but it worked ? 99 4.2 standard with manual shift transfer case....

View 1 Replies

Ford Super Duty (1999-2016) :: Stuck In 4Lo / Won't Shift Back Into 2Hi

I was taking my boat out of the lake last night. Shifted T-box into 4Low and removed the boat. I then tied everything up and when to shift back into 2Hi and it wont. I have a 2001 F350 diesel w/ automatic and the auto locking hubs.Hubs are not engaged atm. I have never had this issue before and was wondering if a shift solinoid is stuck or something might be wrong with my Transfer case??

View 14 Replies

Ford Super Duty (1999-2016) :: F250 - Gear Ratio / Changing Trans Shift Points

I have a 99 f250 with some procomp (325s) that are 12.5 wide with a 6in lift my superchip tuner can change the trannys shift points but I am pretty sure a new gear ratio is needed. I dont do a whole lot of off roading with it its mainly my driving around and highway rig whats a good gear ratio that would work for me

View 9 Replies





Copyrights 2005-15 www.bigresource.org, All rights reserved