Ford Super Duty (1999-2016) :: 2004 F250 - New Pads And Rotors Still A Horrible Shutter
Nov 2, 2013
As the title states I just finished putting pads and rotors on the front of my 04' f250. I have had a terrible shutter almost a bouncing effect while braking over the last week or so, finally got around to doing the work and still no satisfaction! My question is where to go next? Wheel bearings and tires are good, I do get a pretty good wobble/vibration in the pedal while braking. Should I be looking at a brake booster or master cylinder? Or is it possible it's a caliper? Truck goes down the road fine until and brake is applied.
View 4 Replies
Advertisement
I've replaced the pads and rotors on my 97 f250 HD, only to have constant squealing. I've replaced ranger rotors before with no problem but this has been an adventure. It's squeals constantly up to 35, (I've only went up to 35) and squeals louder under braking. Just looking for some pointers. Probably just need a good cleaning. The truck is parked until its fixed more than likely.
View 6 Replies
Having trouble with a shutter upon take off in there drive train. It only happens when I am going straight. It does not do it when I am turning or anything. I just bought the truck used sat. It has around 18000 miles on it. I haven't had a chance to put a load on it yet to see if it does it then.
View 14 Replies
I just bought a 99 f250 2wd with 290k on it and my only issues are brake shutter and steering play.
The steering has about an inch to two dead space at center while driving. The truck tracks straight and doesn't wander at all. I was wanting input on what i should look at first to fix the dead space in the wheel. Its a little iffy having to steer through dead area to get steering output.
I just need something good so I can do it once and not have warped rotors again.
View 2 Replies
was going to do a brake job on my f250 light duty and the rotors won't come off. At first I thought they were rusted on but after looking at them it looks like the studs are attached to the rotor. Need to confirm this because the new rotors I got don't have the hub attached. Don't know if it's the wrong part or what?
View 9 Replies
I am replacing my front brakes on my 2001 f250 and I replaced the brake pad retaining clips and now I can not get the new pads in place because of the new clips. what am I doing wrong????
View 9 Replies
2015, F250 6.2L, 16,000km , so recently my transmission has seemingly lost its mind. When I start it up cold and drive it down my street I am greeted with a horrible slam of a 2nd to 3rd gear shift. Then while towing my TT this weekend a couple of times it held 2nd waaaay longer than it ever has before. Having issues with Torqueshift?
View 7 Replies
I bought a 2001 7.3L deisil F250 CC short box a year ago. It has an AFE cold air, a 4inch exhaust and an Edge chip in it, Now the tranny was rebuilt a year before I bought it, however I almost instantly noticed a shutter when starting from a stop. One shop said u joints. I replaced them and the carrier with no results. IMHO u joints was a bad diagnosis as it only happens off the line and not through at a certain rpm. When down shifting I find the truck almost goes into to neutral before engaging 2nd gear. I have a 6.0l tranny cooler and my temps get to 215 and above quite easily when towing... 3-6k-lbs. (I try to pull over before that) Also when towing up hills the tranny almost feels like there's a slight grinding. For the first little bit anyway.
View 8 Replies
1997 Super Duty 7.5 has a horrible "whine" when turning the wheels or hitting the brakes. Weird thing is, when I have the front end jacked up it goes almost completely away when turning the wheels. It is still there, and just as loud when I hit my brakes, but the brakes never were as loud as it was when I turned the wheels. I am guessing it is something to do with the steering gear or tie rod ends or something that I have absolutely 0 experience with....
More info on the problem: PS pump was always a bit noisy, but after the truck sat for a while (around a year, drove it every couple months for a few miles) it was ridiculous, so i replaced the pump, cycled all the old ATF out, made sure I had good pressure coming all the way back to the pump, several times. Never ran it dry.
The steering wheel (with wheels on the ground) kicks back on me and has a LOT of play in it before the PS pump kicks in and starts screaming. Jack the front end up, steering is nice and tight, no play, noise is there a BIT (with the hood up and cap off the PS pump) I would imagine under normal driving conditions i probably wouldn't even hear it much, if at all.
With my very limited mechanic knowledge I would assume that something is making it very hard for my wheels to turn, which is straining my PS pump, but what!?!?!?!?
View 4 Replies
My 2000 F350 truck has been getting hotspots and cracks on it's rotors since I've bought it. So, for almost 16 years I have been replacing my rotors every two or so years. I've used cheap ones, expensive ones and ones with holes in them. It doesn't seem to make a difference! What have you done to fix it?
View 8 Replies
I recently replaced all of my brake pads with yellow stuff and they seem to be squeaking a lot. I also noticed when I am driving and I stop and let off of the brakes they don't release immediately so could it be this is the cause of the squeaks or do these brake pads just squeak like crazy? I read somewhere it could possibly be the brake lines but I don't see how this could be the cause for so much squeaking.
My truck is a 2011 F 250 diesel crew cab....
View 7 Replies
Brake issues on 2005 F250. About 3 years ago during vehicle inspection the garage stated I need all for rotors on my F250. I had @40,000 miles at the time. Garage said rotors are a onetime use, no recutting them. So I got all new rotors. Prior to then I never even felt a wobble indicating they were warped. Anyhow now with 15,000 miles on them I have a huge wobble when I get on the brakes and it's 5x pronounced when pulling a trailer. I assume more warped rotors. If so, why? I pull a camper or car trailer maybe 7-10 times a year.
Now currently I am assuming its warped rotors because I have not had it "professionally" checked. I did have one occasion last August pulling the camper where I smelled the brakes being hot. The pedal got soft. After cooling it seemed ok and I flushed the old fluid and put in new. I have about 4100 miles since then and the warped feel just started about a month ago. I hate the thought of new rotors as I paid for new Ford rotors 3 years ago. Didn't want the Chinese crap from the box stores. I can't imagine how these would warp this bad after less than 15,000 miles, they are massive. Why they would so quickly?
View 14 Replies
Just wanting to know what might be wrong truck will not go into 4x4. All fuses in panel looked good. Light on dash is not coming on was working last weekend just fine. Have the hubs in lock position not auto.
View 6 Replies
I'm putting new brake pas on my front and I want to know what is the best type to put on there. I ave a 2006 F-350 Dually.
View 3 Replies
I have a 04 f250 with aprox 95k on it 5.4L I knew I was over mileage for a due oil change I haven't been driving it much it crossed my mind, as I am usually very adamant about changing fluids. I went to check my oil and only a smudge of oil on the dip stick. I know this is not good but the truck runs fine, no noises, no knocking, not a chatter from the valve train. Oil pressure was good everything seemed fine did I get lucky? I know it wasn't good I am not going to let that happen again everyone think I dodged the bullet?
View 9 Replies
I have a 04 ford f250 superduty... I tried to use my 4x4 today and the front wheels would not engage using the ESOF. The light comes on in the dash saying its in 4x4. i do not believe i have a vacuum leak because it doesn't switch over to the automatic setting for defrost. what else could it possibly be I'm stumped at this point.
View 14 Replies
4x4 will not engage. 4x4 light on dash does not come on. Can not hear motor switching into 4x4. Check fuses under dash all looked good.
Truck is a 2004 F250SD V10 ....
View 3 Replies
2004 f250 6.0 4x4 no throttle at all, no cel, idles and runs just fine just no throttle, had a diesel mechanic look at it and he couldn't pull any codes, where to start, checked all wiring, checked connections, changed the EBP sensor and tube (read that was a fix multiple times) no change
View 4 Replies
2004 S/D 4x4 V10 F-250 72,000 miles. Replaced Battery about 6 months ago. I have tested the Battery today and it's fine. I had replaced starter at same time. The issue I'm having now is that the engine will not start. Behaves as if the Battery has low charge state, Which is not the case. Starter engages and will "crank" for a turn or two and thats it. like low charge on battery. I don't know what to look for next, except pull the starter and test it. Fluids at Level.
View 5 Replies
I'm gonna replace my front and rear brake pads. Any tips? Do I need to pull the rotor off and clean the axel? I've watched a couple of youtube videos but they leave me with a few answers. I have all the tools, what kinda lubricants will i need? Any recommendations? I hoping I can do a flawless job without and squealing...
View 13 Replies
03 f350 4x4. New front calipers and pads.
Wondering if there's a 'trick' to getting the front brake pads into the caliper . Those damn springs kept popping out. I'd get three of the four ends into place in the pad holes then one would pop out while I'm trying to get the fourth in.
After about a hour of trying every different way that I could think of, another set of hands came by and with four hands holding things in place, it finally did the trick.
View 2 Replies
