I just bought me a 2006 Ford F350 Lariat. A sticker in front of the radiator says says that my truck is equipped with remote start. How would I go about using it? I only have one fob. If it is in fact something that I can utilize I have seen guys on youtube program their fob to do it by clicking three times.
View 2 RepliesI have a 2011 F350 Lariat diesel crew cab. All of a sudden my remote start will not work, sometimes i can do it 5 times and it will finally but most of the time I just hear a lot of clicking noises in the engine like relays or something. Also when I exit my vehicle, if I use either the key fob or the outside keypad on the door to lock the vehicle, the stereo system turns on and stays on. When I open the door it shuts off. The only other thing that might be related is the other day when I put my windshield wipers on, the worked in super super slow-motion, stopped and then started again but at like 1/4 of the normal speed.
View 2 RepliesI went to start my 2006 F350 6.0 this morning. 20 degrees outside. It nearly turned over, then it appeared that the batteries would not support another start - a slowing of the pre-engine start revving....
So I let it sit a while, now it won't start at all. When I try to start it, the dashboard flashes, clicking sounds occur and even after pulling out the keys, the needles on the gauges shake for a few seconds.
Is this more a battery issue or an alternator issue?
So here's the deal, crank no start its getting fuel. Has base oil pressure and i put a ficm on that test good with a voltage meter key on engine off and cranking. I haven't hand any trouble finding info on this issue so. We can keep picking away. Just cant find anything about this.
A buddy of mine who has been trying to figure it out for me, Got it to start using a starting fluid. And it would run if someone was pushing the gas peddle but wouldn't idle. Or start without the starting fluid.
Just got a new 15' 350 XL and going thru the 'setup' button on steering wheel, there is a toggle option for power windows. got out the old owners manual and heres what it does. when toggled to 'on position' and you unlock doors with the ignition key, you can immediately press and hold the unlock button again and both front windows go down automatically. this of course is for models equipped with power windows and door locks. dont know why we need this option but it'll roll your windows down for you from afar.
View 14 RepliesI'm just a shade tree mechanic try to diagnose a hot crank no start condition on my 2006 F-350 6.0 that I purchased second hand about six months ago. I first took it to a diesel shop to have them fix it and the mechanic told me that the stand pipes and dummy plugs needed changing out but couldn't tell me 100% if that would fix the hot no start problem.. I have been reading a lot about this problem and it seems that the snap to connect fitting on the HPOP is the most common problem on these trucks. It seemed easy enough to do so I went after it only to find it was already replaced with the updated part.
I went ahead and changed it anyway but it obviously didn't work. So today I pressurized the system through the ICP port with my small harbor freight compressor up to 80 psi and forced the IPR valve closed with 12v. I then listened for a leak in the passenger side valve cover with a hose stuck in the oil fill cap, the driver side cover from some drain hole under the air filter housing and in the oil filter housing. I could hear a mild hissing from the driver side and the oil filter housing but it was clearly louder from the oil fill on the passenger side. This leads me to believe I have a top seal leak from one of the injectors on the passenger side, but not 100% sure. Should I be hearing anything at all from the driver side and from the oil filter housing if its a bad seal in the passenger side?
Another problem I just found out I have seems like maybe fuel in the oil. I done a oil change this week after 3500 miles since last change and drained out five gallons of oil!! The oil seemed really thin. My coolant level is still good so the only thing I can think of is fuel dilution. Could this possibly be the same o ring or injector that is causing my hpo leak or something else? Will a bubble or balloon test diagnose this?
I bought a cheap OBD2 reader that works on my Ipad with a app called Dashcommand so I can see what codes were stored. The codes are...
P0401- Exhaust Gas Recirculation A Flow Insufficient Detected (EGR has been deleted)
P0528-Fan Speed Sensor Circuit No Signal
P0670-Glow Plug Control Circuit/Open
P0683-Glow Plug Control Module to PCM Communication Circuit
P2290-Injection Control Pressure Too Low
So far my thoughts are to replace the injector and nipple cup seals to take care of the hpo leak. Once I have the valve cover off, clean the injectors real good and cycle the fuel pump with turning the key on and inspect the injectors for a fuel leak. Is there a better way than this?
Where the ICP is located on a 2006 f350? I have a no start condition after the truck warms up, everything else is fine. Started fluid works to crank, I suspect the ICP and /or Orings.
View 4 RepliesI just bought a 2008 F-450 Crew Cab 4x4 .
Whats the correct way to use the remote start?
The lights flash and that's about it.
Where and how can I get the code for the door pad?
I bought a 2016 F-250 Lariat, Crew Cab, Short Bed, 4X4, 6.2 a couple weeks ago. One thing I had to have was remote start. My truck was not manufactured with remote start so the dealer installed the Ford 1 way remote start system. The system works fine however the air conditioning fan runs on the lowest speed when remote starting until I put my key in the ignition at which time it reverts back to wherever it was set when I shut the truck down. The whole point of the remote start for me is to get a head start on the truck cooling off but with the fan on low when remote starting it defeats the purpose. How I can change the setting so that when I remote start the fan runs on high? Dealer is clueless and the settings in the truck only allow to turn the system on and off and run time duration.
View 7 RepliesHave an 08 F350 with V10 automatic. Keyless entry with factory alarm. I want remote start. What is the best route to go? Read somewhere on this forum that the truck has remote start and just needs to be enabled. Is this true? I have installed remote start a couple times on older vehicles and it was a major pain. I can't believe it is already on my truck, what do I need?
View 7 Repliesthe stealer says that since I already bought the truck that it would cost a lot for them to put one on for me. i figured it would be a cheap mod for a stealership to do on a new truck. i guess it shouldn't be too surprised. thoughts?
View 14 RepliesI've got a 2012 XLT that I would like to add remote start to because I'm tired of getting into a truck that feels like a freaking oven.
From what I see on Ford's site, looks like this should work:
[URL]
Are there any aftermarket systems I should be considering?
My remote start/entry on my 2013 F250 won't work outside of 25 or 30 ft from the vehicle. On my 2011 it would work close to 100 yds away. My dealer has no idea why. And yes, I changed the batteries
View 12 RepliesIt is starting to get cold where I live in Idaho, 22 this morning, and when I use the factory remote start on my 2011 the heater is not coming on as the owners manual says it should.
View 6 RepliesI can't seem to get my heated seats to come on when I use the remote start. Is this possible? I assume the supplemental heater comes on behind the scenes. Is there a temperature differential between the climate setting and the outside temperature? If so what is the delta? If it's 40 degrees outside and my climate is set at 60 degrees...will the supplemental heater come on? How about the rear window defroster and heated seats, can I make them come on when remote started? Same question for the seat cooling...in a few months.
My truck is a 2012 Ultimate Lariat 6.7L ......
I have a factory remote start. Not sure if I have an issue or not but at what point does the fan come on automatically to clear the windshield? It was -9C this morning and when I went out after about 5 minutes there really wasn't any air coming out of the vents.
Does the truck have to warm up to a certain temperature before it starts to blow air to clear the windshield? Doesn't tell me much in the manual.
2011 SD 6.7 with factory remote start will start normally when the temperatures are above 20F or the vehicle is warmed up. If the temperature is near or below O F and the vehicle is cold soaked for 12 hours the remote start fails to work. Push the lock button and the lights flash, push remote start twice and the lights flash once and nothing happens. Subsequently can manually start vehicle with key without any delay or problems. Once vehicle is warmed up can remote start normally. Only recently have the temps been low enough in the area to experience this problem which has repeated 3 times. Unable to find any troubleshooting in the service manual for this.
View 7 RepliesThe factory remote start is not working on my 2009 F 250. The red light is lit when I push the button, the doors lock and you can hear something engage in the engine but it does not crank it. If I keep holding the button the alarm starts to go off. When I walk up to truck the radio is on and I need to hit the remote start button to shut everything down before manually staring.
View 4 RepliesI am looking for a site that i can download a service manual with good wire diagrams. I want to install an alarm with remote start and need to know what wires go to what.
View 2 RepliesJust bought the truck and when remote starting it i noticed it is turning on the heat. Having read a bunch of different posts it sounds like the climate control would be set to automatic which i would like to have it just use were i set my controls. Problem is i do not have any options on the instrument cluster for climate control and no auto button the the heater controls themselves. I would think that means i do not have automatic climate control but it is doing it. How to turn it off?
View 6 RepliesJust this morning I tried to remote start my '13 F250 6.7 and all i got was the doors lock and a two honks. The two honks are usually when there is a door left open when you click the lock button two times but all of my doors were locked. After I started the truck with the key and took it out to go run a errand I noticed the check engine light turned on. Could this be connected or just a coincidence?
View 4 Replies