Ford Super Duty (1999-2016) :: 2011 F250 - When Start To Accelerate In First Gear Truck Goes To Idle For About 2 - 3 Seconds
May 15, 2013
I have a 2011 F250 with the 6.2 gas engine. I have been having a problem that the dealership says there is nothing they can do and have never heard about.
After the truck sits all night I get in and drive it for 10-15 min. It gets warm and I get out turning it off. When I come back about 15-45 min later I start it up and go to leave. As I pull out and start to accelerate in first gear the truck goes to an idle for about 2-3 seconds. I push the gas pedal and get no response. After a couple of seconds it picks up wherever you have the gas pedal. If you have the pedal to the floor it jumps you forward. This is not putting on any lights and the computer is not throwing any codes. According to the dealership the computer is telling them there is nothing wrong.
This has happened 12 times in the past 6 months. It has happened since I bought the truck. I have just started documenting it as of 6 months ago. It is not something I can make it do on command. After it happens once it doesn't seem to do it again for a week or two. I have 31000 miles on the truck. The dealership has had it for 4 days now and can't seem to get it to happen for them.
View 2 Replies
Advertisement
My 2000 F-250 6.8L V10 has a choppy idle during the first 30 or so seconds after a cold start up in the morning then it smooths out and drives perfectly. If I were to place the truck in gear during the choppy idle, it would not die and throttle response would be fine.
I cleaned the MAF sensor and checked the PCV elbow for cracks (no cracks). It idles at about a 1000 rpm during a cold startup then drops to about 750 rpm according to the dash tachometer. The truck has 187,000 miles on it.
View 4 Replies
Just picked up my F250 a few days ago and it's been great up until yesterday when I hopped in to start her up and nothing. It's a brand new battery and all lights worked, but the dash was dead. I attempted in vain for an hour or so to diagnose as to why this was happening and just happened to open the door with the key in the ignition and hit the door lock button....all of a sudden the truck starts beeping and the message on the dash said "to disable alarm start vehicle". I turned the key, the dash lighted up and away I went. What I may have done to cause this or has it happened to you? I'm thinking it's something with the key fob but not sure.
View 6 Replies
2003 f250 crewcab 6.0 auto 4x4. I all of a sudden started feeling a vibration under the truck near the back when I accelerate and when I let off the gas no other time. No noises or clanking just vibration. I can wiggle the driveshaft inside the carrier bearing do you think that could be it or is it the rear end.
View 14 Replies
2011 f250 gas 4x4... I bought last year with 65k miles, now has 105k. sometimes when accelerating it slips for a second like a manual would if you jabbed the clutch while pulling. I had the 100k trans flush done. I noticed it a couple times before but more frequent recently. How concerned should i be?
View 6 Replies
So after this weekend's hurricane my 2011 f-250 started to making a noise when I accelerate. I don't know if water got in some where. But there's no MIL light coming on.
View 11 Replies
Well I just bought a 2011F250 6.7 on Friday. The truck has 42000 miles when I picked it up and now has almost 42800 4 days later. I love the truck so far. But anyways its an early build so is there anything I need to look out for? I noticed today I pulled into a parking spot and went to back up and as soon as I put it in reverse the truck shook pretty bad. It did it a few times as I sat there and went from drive to reverse. Is this something that is normal?
View 9 Replies
My truck all of the sudden started overheating when running idle or at low speeds. No towing or anything with 89 degrees outside it can hit max water temp in matter of 2 minutes once at running temperature and standing on red light. I checked the coolant level - looks good and changed the thermostat just in case, but the problem is still happening. The fan is running/kicking in as well when it gets hot.
I'm waiting for OBD2 plug to read the stats from the computer, but what else would you suggest I can check for issues ? Oil temp gets to about 222 and transmission to about 194, but it doesn't keep on increasing. One another thing I noticed is that when I have AC running it will actually pop a overheating message on the display (I don't continue to drive it at that point) and when it gets hot it seems as if it didn't have much power.
I don't know if this is connected, but about two months ago it started blowing black smoke when starting from red light or stop sign or when accelerating with gear reduction. It is a 6.7 diesel one and only has 60k miles on it, so I'm hoping its nothing major.
View 2 Replies
We have replaced 4 fuel pumps on a row.
Voltage is good...even ran a fresh circuit.
Ran new supply lines
But, can't seem to understand the continued drop in pressure. It usually takes about a day of driving to crater after a new pump/filter is installed.
It never dies, just loses power and drops the truck to an idle. Funny thing...if I shut the truck off and turn it right back on...full power for a short period!
The truck is used on a ranch that has plenty of rough roads...thought inertia switch maybe but i believe that would stop fuel completely right?
I am totally stumped and so is the mechanic.
View 5 Replies
Ok I bought this truck with a bad engine 5.4 3v had rod knocking. I rebuilt engine got it all back together and in truck. I did replace cam phasers and solenoids. After driving 20 mins or so it would start the phaser knock at idle in gear so I put a oil pressure gauge on it and cold had 55 psi after running 10 mins or so had 15 psi at idle then would drop to abought 9 psi. I am thinking I got bad cam bearings or something for some reason don't know why. I did it but I took oil cap off where you pour in the oil. Had to force it off it was pulling that much vaccum ones cap was off oil pressure jumped up to 25 psi. What could be causing this.
View 2 Replies
I just bought a 2000 F250 SD, 4x4, 5.4, Quad Cab. I drove it off the lot, stopped to put air in the tires, jumped back in and it wouldn't crank. All of the dash lights worked fine. Tried jumping at the starter solenoid and got nothing. Got under the truck and jumped it off the starter, vroom, fired right up. Replaced the starter solenoid and had no issues for about 2 hours. Then it did it again. This time it wouldn't start at all. I towed it back to the dealer and they had it for 3 weeks.
Then yesterday I called and they said it was done. Picked it up, drove to the barber shop, got my hair cut, came back out and it did the same thing AGAIN. After jacking around with the shifter and turning the wheel back and forth 100 times it started. The key is kind of hard to turn sometimes in the ignition, so I'm thinking that the ignition cylinder needs to be lubed real good, but that shouldn't stop it from cranking the motor over, right? I was going to swap out the ignition switch, but I don't know if that will do any good either.
View 3 Replies
I have a 2008 f250 with 5.4v8. The truck starts intermittently. Put key in turn if no dash lights it doesn't even crank or hear a click. If u put key in and turn and dash lights up to starts and runs. U can watch the different lights (instrument cluster) light up independently like a xmas tree. When truck doesn't start if u disconnect battery when touching power wire to battery. Post truck lights will flick on/off if u tap cables to battery and leave on. Lights flicker on/off and then stay off. (Don't know why shouldn't flicker at all) after disconnecting and reconnecting battery truck will or will not start still depends on if dash lights come on before cranking.i replaced battery, starter, alternator, all the ground cable connections and wire cleaned. I haven't replaced the power side but are clean.
View 3 Replies
I have an 08 f250 with 6.4. when ever it rains the truck will not start. None of the gauges will work, door chime doesn't work and the only error light is the airbag light. Lights, radio, turn signals, horn all work. There is no clicking of the starter relay, the truck in dead. There is no water on the floor board nor is the floor moist. If I place a ceramic heater on the driver side floor board and blow hot air towards the firewall the truck will start in about 30 min to an hour depending on how long it sat in the rain. I've removed the air intake vents and there is no debris blocking the drains.
View 3 Replies
My 2011 F350 has HIDs in it. When I start the truck with the lights off everything is good. But when i put my truck into gear the HIDs start to flicker. (the switch is still in the off position.) If i set the switch to AUTO the minute i start the truck the HIDs start to flicker. The only way I can avoid it is to leave my lights in the on position and let the auto timer kick the lights off when I Park. But it takes a while and I'd honestly rather not leave them on like that.
View 2 Replies
My 2011 F-250 diesel will not start when it gets to be about 85 to 90 degrees. In cold weather (I live in South Florida, so by "cold" I mean 50 to 70 degrees) it starts up just fine and gives no problems whatsoever. However once the summer months hit it more often than not it will not start. I've taken it to the local Ford dealer and when they run diagnostics it doesn't report any problems. I admittedly don't use the truck very often and it will at times sit for a couple months without use. Could that be a cause of the problem? What the problem might be?
View 1 Replies
I have a 2002 F250 7.3l with an aftermarket alarm. I can't read what the third letter is on the decal MV? 2000 Modular Vehicle Security. I added a pic of the alarm decal below. The key fob it had was aftermarket for the alarm and stopped working about a year ago. Today I unlocked the drivers door with the key and the lights started flashing and I can hear a clicking sound. It done this a few times back when the key fob still worked and I just kept hitting lock and unlock until it finally stopped. It won't let me start the truck at all and I have tried unhooking the batteries with no luck.
View 4 Replies
I have a 2010 F250 V10 4x4. about every 3-4 times when you start the truck....it seems as though the starter "sticks". If I catch it and shut it off and then turn the key right back it fires up and does not stick. Its as if the gear is staying kicked out into the flywheel. Are we thinking the starter itself? I'm thinking starter...but looking for input before I crawl under it.
View 1 Replies
I have a 2001 F-250 XLT 4x4 with V10. Truck will not start. No fuel pressure. My Haynes manual does not show ignition or fuel delivery wiring. I have found the relay box behind the radio/dash. I need a wiring diagram and info on which relay is the fuel pump relay. Want to know so I can jump relay to see if fuel pump is okay.
Truck had sat for a few weeks being ran very little, so had to jump start yesterday. Ran for about 15 min, the shut off, re-started and ran for 30 min. Truck sat for about 1.5 hours then would not start. Charged battery overnight and it is 100%.
View 3 Replies
Ok truck shut down wouldn't start back. Put fuel filter o. Frame cranks but won't start. Was told has high pressure oil leak in engine?
View 8 Replies
I have a 2002 F250 7.3L and it wont start. Its been sitting for the past few days in the cold because the batteries were shot but was plugged in the whole time. I replaced the batteries today and even poured diesel 911 5 hours before trying to start it in case the fuel was gelled. It cranks fine but just wont turn over.
View 2 Replies
I have a 99 F350 with a V10. I just replaced all the spark plugs and a bad coil which solved the very bad misfire I had going on. I also just changed the fuel pump and fuel filter.
When I start the truck, it idles just fine, nice and smooth. After sitting there for a short bit, maybe a couple minutes, it starts to idle rough, not so rough that it's about to shut off, just a little rough. This lasts maybe a minute and then goes back to nice and smooth and stays that way.
I've thought maybe the EGR valve or Idle air control valve but I'm not sure if I'm way off or sort of close.
View 1 Replies
