Purchased my 2012 6.7 about 3 weeks ago. Driving yesterday the CEL light came on. I took and had the code read and it was determined that EGT sensor # 4 was bad. Also how far can it be driven before it leaves you stranded since the closest dealer is 35 miles away.
View 2 RepliesTruck is 2012 F250XL single cab 6.2. Where is the pitch sensor on this truck? There are times the hill start assist will keep the brakes applied on level ground, and occasionally I will crest a hill onto a level stretch and the truck doesn't want to upshift. So I am thinking the pitch (incline) sensor needs recalibrated. Where it is?
View 7 RepliesI have the 2012 XL F-250 6.2 v8 , I have an ambient (outside air) temperature sensor that needs replacing, I ordered it and was told it is located in the passenger side mirror from the parts guy, there is a tap in the bottom of the mirror to access it, looking for a replacement type video link of how to do this, as I am not finding one via youtube, pulling the tab off on the bottom of the mirror I am not really seeing the part I have as a replacement in the mirror.. This is the XL version/work truck so ALL manual mirrors....
View 1 RepliesSo I just replace my Cat. Converter with all new sensors in them. I just replaced my spark plugs. (I'm knocking out these check engine light problems) and I think I'm getting close to the root as to why these other parts went bad. Why my o2 sensor would be stuck on "lean" ....
View 5 RepliesMy Bank 2 Sensor 2 oxygen sensor is faulty and I need to replace it. The guys at the parts store were pretty certain it is downstream driver's side, but I just want to make sure before I PB Blasted and removed it. 2008 F250 SD v10 ....
View 1 RepliesSo I had an ABS light going on and off on my 05 250, finally got it read, and the computer said right front speed sensor. I changed it and the light stayed on all the time then. I had someone plug it in and drive it and the left front sensor was reading nice and flat on the graph, while the right front was spiking all over the place. I then assumed I got a bad sensor. I changed it one more time and now the light still won't go off. Now what?!
View 11 RepliesAny way to disable the reverse sensors by maybe adding a switch to turn off power so it does not constantly go off while plowing and the sensors are snow covered? i thought maybe by just unplugging the switch would do it, but that did not work. truck is an 02 diesel with auto trans.
View 6 RepliesI have been trying to find a new sensor after my truck popped a P2285 code. I can't find ICP sensor at any auto parts store. I found this but it was labeled as a fuel pressure sensor on RockAuto: More Information for Standard Motor Products ICP103... Is this the same thing?
View 2 RepliesMy engine light came on a friend of mine did a scan and came up with o2s12 showing low voltage.we need to know which side and location of sensor..the truck is a 2005 ford f250 super duty 5.4l.
View 2 RepliesCode was showing for the knock and climbed under the truck and checked to see if it was plugged in grabbed the wire and to my surprise the wire kept coming and so did a piece of the knock sensor, is this going to affect my truck badly?? worst case?? 97 f250 4.6 standard
View 4 RepliesI was driving into the night a couple days ago and noticed first that the dash lights are not working. As it got darker I then noticed that my tail lights and running lights were also not working. I have a 2002 F250 powerstroke extended cab. I pulled the fuse panel cover off but can't find a blown fuse.
What fuse number would be suspect, and also if there may be a bad relay in the mix? The daylight sensor on the dash does not seem to be functioning either. In good light the headlights stay on (when switched to automatic mode) no matter if it is covered or not when the ignition is on.
2007 E450 Van. Dash light came on. OBD2 reader indicates: P2196 Ford - Lack of HO2S-11 Switch Sensor Indicates Rich
I need to find out which sensor to replace. It looks like I need to replace Bank 1, Sensor 1, but I am not sure where it is located. My guess it's located on the manifold, but I'm not sure if it's driver or passenger side.
A friend says, "Look in the owners manual for the van and find out which cylinder is cylinder number 1. Cylinder 1 is always on Bank 1."
The owner's manual has no indication of where cylinder one is located. I do not have a service manual.
I am not highly technical, but I do think I can replace the sensor myself, or at least I would like to give it a try.
Where are the door sensors located?
The ones that turn the light and off when you open and close the doors.
It use to be switches on the old trucks and cars.
But on my 2006 F-250 I can find anything that seems to do that function, nor is anything mentioned in the repair manuel.
So, recently acquired my grandpa's "old" 2000 F250 with the 5.4. I am a pretty mechanical guy, not a mechanic, but not dumb and change my own parts for a lot of stuff. Anyways, when I got the truck, I noticed it didn't like to get warm, or so the gauge said. It would go a little above cold, but you could tell, not a normal reading. I did a coolant flush because the system desperately needed it, changed the tstat, and a few days later, changed the Coolant Temperature sensor.
I pulled the old one out, it was covered in amazing crud from many years of being in there. Slapped the new one in, nothing. Doesn't register on the gauge at all, in fact the gauge acts like it is a dead gauge. I thought it might be the sensor, so I popped the hood again and found I had managed to break the plastic plug on the sensor. Figured that was probably the issue and went and got another. Same result. Checked the connection, it is in there snug. Didn't reset the PCM when I changed the sensor and some vehicles can be finnicky about that.
Ok I ended up buying a 2011 F250 XLT. it has the reverse aid sensors. it worked great till i washed it after plowing. what should I look for or diagnose? also mt my dash says my tires need air. I filled them and reset but it comes back.
View 7 RepliesToday I ran into a person I use to work with and was informed he had bought almost the same truck as mine. He also informed me that his has spent most of the winter in the shop. Reason being he claimed the transmission had a sensor that malfunctioned when it's cold out. This sensor lets the truck turn over but it blocks the truck from starting. Now it has got to 10 below zero only once this winter so far, my truck is kept outside, no problem yet.
View 3 RepliesI went to have the code read, and it was no signal from the rear ABS speed sensor. I replaced the sensor, and the light is still on. Also my speedo is off a bit. It is reading about 7-10 miles an hour faster than what it should. The mechanic can't seem to find the issue. I have a 06 F250, Powerstroke.
View 2 RepliesI need a replacement driver side door, towing mirror for a 2011 Ford F250 SuperDuty with turn signal, heated, electrically adjustable manual-extend and manual fold options. The truck VIN number is 1FT7X2B67BEC96261. The truck also has an Outside-Air-Temperature indication which is what I'm not sure about. It is my understanding that the Outside-Air-Temperature sensor may be in the side mirror. Looking for any info on the temperature sensor located on this truck? I found an aftermarket mirror while I can not afford Ford. However, the aftermarket mirror ad says it does not have Outside-Air-Temperature and I would like to keep that working.
View 1 RepliesWhere this sensor is? I am trying to mount a front bar and need to know if I can drill thru the tube behind the bumper ( this is the one that is right behind the plastic trim piece.)
View 2 Replies99 5.4 F250
Well, this truck i have had many many codes before. I cleared them and all went away except for p0155. I fixed my manifold leaks and cleared the codes. It came back on and i changed the o2 sensor, twice. Still on.
Ive checked the heater and input wires to the pcm and have .6 ohms each, so they are good with what appears to be no shorts. I dont know how to check the other 2 o2 sensor wires.
What exactly does the sensor on the rear axle do? 08' f350. I know it's a speed sensor of some sort, but what does it do or control exactly.
View 3 Replies