Ford Super Duty (1999-2016) :: 2014 - Brake Feel Like Spongy?
Aug 17, 2015
My 2014 F-350 SRW always seemed to have spongy feeling brakes since day one and the e-brake has never been set-up to be very tight. Even though my truck has less than 25,000 miles on it, I'm half tempted to power bleed brakes to try to get a better brake pedal. All I know is that if I press the brake pedal on my '82 F-350 SRW as hard as I need to press the one my 2014 SD, it would try to put me through the windshield.
View 12 Replies
Advertisement
I replaced all the brake pads on all 4 wheels. Pretty standard procedure. I now have a very spongy brake pedal. It stops but the pedal will be almost to the floor. I did not break any of the lines open during the procedure just used c-clamp to spread the calipers. No ABS light. Have a Snap-On power bleeder and bled the system several times with no change. Checked the power steering fluid level and inspected entire system for leaks.
2002 F-550 V10
View 8 Replies
I noticed last week that my brake pedal seemed more spongy than usual. The next day the pedal would go down about half way to the floor before I had pressure. And then the next day the pedal would go straight to the floor. Pedal comes back up once released. I still have brakes pressure about an inch before the pedal bottoms out. Its been like this a couple days now. The vaccum pump works fine. I'm gunna try bleeding the brakes on it tomorrow.
View 5 Replies
Ive got a 2002 f250 Sd 4x4 with 93000. Im getting severe vibration from the front drivers side at highway speed. I thought it might be a warped rotor but i cant feel it in the brake pedal, when I put the brakes on. How can you tell when the hub bearing assembly is going bad? The truck doesnt pull to that side either. I can hear it, and feel it more when i'm going around highway corners. When im driving through town, I can hear a "clunk,clunk,clunk" noise coming from that side also.
View 14 Replies
I have a 2002 f350 Super duty, 7.3. After I changed out the power steering box, I did bleed the system, I have now power steering and the brakes are very spongy. Any thing to check prior to replacing the booster? I have been told the power steering is probably just an alignment issue and I should bleed the brakes.
View 3 Replies
I'm not exactly sure what's going on but it feels like I'm missing some brakes - the pedal is extremely spongy, I have to push it nearly to the floor. And when they do engage, it isn't with the same vigor as they did before.
It's strange, it just sort of happened - I drove to a friend's house, everything was fine. But when I left all of a sudden, there's this problem.
It's not like the pads have come apart and destroyed a caliper - I had that happen to me a few years ago and I definitely felt it happen, plus once it did I lost almost all braking ability as the lines would just leak fluid.
View 2 Replies
I am looking at a 2014 f250, if has all of the options I want on a truck except the brake controller. Can a brake controller be added to this vehicle ? is it already wired for and do you just remove the blank plastic and pop in ? one ?
View 3 Replies
My truck is intermittently pulling to either side when braking. Sometimes its the right, sometimes its the left, sometimes its hard, sometimes its soft.
Its a relatively new truck. 21K miles - 2014 F-250 Super Duty 6.7 Powerstroke.
I don't want to go to the dealer yet, because its emissions deleted, tuned, and lifted. I don't really want to hear their bull rhetoric.
I have unplugged the ABS sensors for a few minutes while running, plugged them back in and its gone away for a period of time, but now its back again.
Just trying to figure out what the problem is and see if its something I can just fix myself.
View 14 Replies
I tow a 5th wheel with my 2014 F-250 that has an factory TBC. I just installed Electric over Hydraulic disc brakes on my 5th wheel and was trying to see if there was a setting I needed to change on the TBC to tell it that is now E/H versus E. In the Information section of the dashboard display it talks about the controller actuating electric drum brakes but the manual talks about it being able to do electric AND E/H. What I need to do here...if anything?
View 6 Replies
only have clearance lights at plug no output for brake and turn signals
View 1 Replies
I have a 03 F-350 and I started getting a bad vibration in the front end and I can feel it in the dash when I hit 60 mph. It happen after the other week I took some back roads they were flooded pretty good and pretty much the whole under carriage of my truck got wet. It didn't start right after that but then about 20 miles later it started happening. I also get a chirping noise on my LF when I give it gas going over 30. I been checking my truck and the only thing I found wrong was the front different vent hose got ripped off but I fixed that. I read it could be a bad u-joint...
View 2 Replies
The problem is I haven't seen one for a recent (2011+) SD. I don't see anything that resembles a rear drum. They look like 2 huge regular disc brakes.
I live on a hill. My old man taught me to put the trans in neutral, autos and manuals, put the ebrake on and make sure it holds the vehicle, then put the trans into park or 1st gear. This way the weight of the vehicle doesn't rest on the transmission.
How do I adjust the Ebrake? It's ALMOST holding the truck, just needs a minor tweak. I don't see the dust cover the write ups described at all. The one that reveals the Star Wheel. Are they different on these years then prior SD's?
View 14 Replies
I just bought a 2014 6.7 and the dealer claims every 10k. What is your alls opinion for optimum performance and engine life?
View 12 Replies
I have a 2014 ford F350. Was flood damaged, all fixed and running great except a couple of small problems.
Was trying to solve a mykey problem with volume being restricted to 49% and IDS said it had found new PCM and TCM software and should it update.
Me being a dork, (forgetting that the truck is not stock has EGR delete and other stuff that I'm not even sure of) said 'sure go ahead!!'
As soon as it was reflashed, it came up with errors
ENGINE IDLE SPEED
EXHAUST GAS RECIRCULATION ERROR
REDUCED POWER
did some googling and it seems (possibly) that when the truck was modified, the PCM was reflashed. When I upgraded the PCM I screwed it up as it set it back to original factory settings.
Do I need to buy an SCT tuner? Is there any way in IDS to disable EGR (I have a clone and I cannot find it). Am I best to take it to a shop that know what they are doing and have the reprogram the PCM.
View 2 Replies
I have a 1995 Ford Ranger 4 cyl w/ hydraulic clutch, about 95k miles, and an intermittent problem. Normally, my clutch works fine, but a few times a year, normally during the summer, and normally only after driving for a half hour or more, it starts to act up. First, the pedal starts to feel a little spongy. Then, I'll depress the clutch, and when I release it, the peddle comes up, but the clutch does not engage; a few seconds later, the clutch engages fully instantaneously, which usually stalls the engine if I am stopped.
Then, when I try to reengage the clutch so that I can restart the engine, the clutch is very stiff, and I have to pump it a few times, at which time it will depress easily, and then I am usually back to the original problem where the peddle comes up but the clutch does not engage. When I finally make it home and the truck sits for awhile, the clutch then works fine again. I think it is the orig clutch. I have talked to several mechanics about this problem (including the Ford garage!), and they are mystified. One mechanic thinks that it is a problem with the master and slave cylinder combo, and can replace them.
View 5 Replies
What a Brake Code - 4 means for a 1999 Super Duty on the door ID tag?
View 4 Replies
This is my first post on this forum. I have a 2014 F350 standard fleet truck. The headlights are not day time running lights. The headlight switch is the basic off/parking light/on. The headlights come on as soon as you start the
truck. This just started happening about a month ago. When you shut off the truck the headlights stay on for ten minutes. I scanned the truck with a snap on modis. I got into the lighting module and the "command on" is on. The modis would not give me the option to turn it off. Short of taking the truck out of service for a day to go to the dealer. Is there any other fix I can do?
View 3 Replies
I want to remove the 4x4 stickers on my 2014 SD box. I think it looks cleaner without them. Are they difficult to remove or does the hair dryer trick and then some Goo-Gone do the trick without a big time effort? The last thing I want to do is make a mess of the paint finish.
View 13 Replies
2014 f305 rusting out fast. Ford needs to address the problem and fix these issues on the super duty already on the road
View 14 Replies
I have a 14 F250 Superduty with 6k miles, it has started a shudder around 40-45. It only does it briefly if I let off the gas and then accelerate it goes away.
View 2 Replies
I have been having some brake chatter for awhile now. I have changed pads, changed rotors, rebuilt both front calipers, flushed all my brake fluid, and made sure my slide pins were good and free. I have noticed some weird wear on the new front rotors and was wondering if it was normal or not. On a different note, I am having to replace my parking brake pads. When I had the axle out I looked in and saw a bunch of gunk.
View 12 Replies
