Truck is a 1999 F-250 with manual climate control with A/C.
Heater core issue:
Heat is not very warm after engine is fully up to temp. Would like to back flush the heater core without damaging or making it leak. How should I do this safely?
Secondly, if I do make it leak, how hard is it to change out?
My 2008 250 suddenly lost ability to adjust temp control of heat and A/C. I can adjust the fan speed and the defrost/dash vents/foot heater position controls, but no matter how far I turn the cold/hot dial left or right, the temp is the same. Even in the Max and Norm A/C setting, it's the same temp, which is stuck in the hot range.
View 10 Replies2005 F250 6.0L ... My truck is running really rough when the engine isn't all the way quite warmed up. once the truck is fully warmed up to normal running temp it runs good. I am getting four engine codes. P0672, P0673, P0674, P0676 These codes say 2,3,4, and 6 glow plugs have a open circuit. Can this be the cause of my problem?
View 7 RepliesIts a 2001 f250 with a 5,4. I just recently put a new shot block in it, the short block is a svt short block for an 01 lightning. every thing off old motor went on new svt block just fine, and it drop in just fine. only it will not warm up i let it run for 45 min the other day and on the gauge it would not come past the c. and i do believe the gauge to be accurate because the heat in the cab sucks and the top rad hose is just warm, not as hot as it should be. I've already put 2 new thermostats in it so I don't believe that to be the issue either.
View 14 Replies2001 f250 5.4L v8. Engine temp seems really low. The gauge is reading barely above the cold in normal range. The heater is only blowing out 75 degree air at the warmest. It gets to its normal temperature with in 15 minutes even when its real cold out. I live in Minnesota and its been a really cold winter so having hot heat would be nice. I just bought this truck at the beginning of the winter. Whats going on?
View 14 RepliesMy manual heat/cold adjustment dial is working fine and transitions from heat to cold readily. However when in max heat, it is blowing luke warm. The higher the RPMs going down the road the warmer it blows (still not near as hot as normal), then idling at stop lights or in park it goes back to warm only.
My engine temperature is running normal at all RPM levels while driving and idling. Partially clogged heater core maybe, where higher RPMs force more water through it? I assume its not the water pump or thermostat since my operating temperature is staying normal...
I have been having an issue with my blinker for the past few months. When the blinker is fully engaged, the right front blinker doesn't work. If I just push up on the blinker so it doesn't fully click into place, the right front blinker works fine, so it is not a burnt out bulb. I have also checked my blinker light in my mirrors and they work fine. Left blinker works fine. I am stumped on to what this can be and I need to get it inspected. 2005 F-250...
View 3 RepliesI have been having a problem with my 2002 F250 Super Duty 4x4. It started about 2 months ago. I was in traffic (truck hadn't even been on for 15 minutes). The temp gauge spiked, so I pulled over and turned the truck off. I turned the ignition on and the gauge was normal so I started it and all was fine.
Fast forward a little and every so often about every 3 weeks it would overflow (coolant) but not get to the point that it would overheat. I changed the thermostat and all seemed good to go. Fast forward to yesterday morning. Got in the truck and left to go hunting, and I didn't even make it 10 minutes down the road when I turned the heat on and it blew cold.
I started to see the gauge creep up so I pulled over and shut it down. Upper hose was cold, lower is cold and both heater hoses are cold. After some time of waiting, I started it but the gauge kept creeping up and no heat, so I kept shutting it down. After about 5x of this, the heat worked and the upper hose got hot and all was right with the world. SO I drove it home. Coolant is new, flushed about a month ago and was running great since then. Thermostat is new. Do I have a blockage somewhere? Water pump bad?
I can't seem to get the engine temp to middle range on the marker, but yet my heater blows "to me" hot air. Even while sitting in idle for extended amounts of time I cannot get it to "operating" temperature. I would think if my thermostat was stuck open my heater would blow either cold or slightly warm air. I have the 5.4L engine with knn air filter and no cats.
View 14 RepliesHaving problems with no heat at idle or low heat in the cab. I just bought this truck a couple weeks ago and have a limited warranty on it. The truck makes no heat at idle. I start it and let it just run, engine temp gauge goes up to normal operating temp in 15 min or so, still nothing from the vents but cold air. If I drive it I get a "little" heat, at idle, cold air again. I believe the thermostat is working because like I said, engine temp stays right in the middle.
Brought it to local ford dealer, their diagnosis was heat core clogged and needed to be flushed, had that done. truck has been running 40 minutes in the driveway now, engine temps nice and warm, no heat. What could be the issue? I took a picture of what I believe are the lines running to the heater core, just barely warm to the touch, not hot by any means. It looks like there is a vacuum actuator on the line running in but there is no hose attached to it, what this it, should it have a line running to it?
I have a 1999 F250 7.3 Diesel and my AC isn't working properly. On Max AC as you're driving it would be ok and then it would be warm and then cold and then warm and then cold and so on. I've noticed that the clutch stays engaged as well. I've never seen it disengage. The freon is at the level it needs to be. Then just a few days ago, if you have it on Max and High the air disappears from the vents and you hear a noise somewhere in the dash on the passenger side. I think something might have come off?? What's wrong with my AC with it going from cold to warm constantly? I heard that maybe clutch has too big of a gap?? I have almost 200,000 miles on it.
View 6 RepliesI have 1700 miles on my truck and the A/C cycles between cold and warm air. I have taken it to 2 Ford dealers and they agree there is something wrong but their tests are apparently up to Ford specs. They logged complaints with Ford and they were told this was by design with the new trucks and it was normal for the compressor to constantly cycle. New 2013??
View 2 Replies2004 F250 V10, runs good until it warms up whether it's hot or cold outside. While on freeway, it really shakes while cruising, but of you get in the gas enough for a kick down, seems to be pretty smooth. I've changed the coils, and 9 plugs (one wouldn't budge, but the others I took out looked fine) to no effect. Where else should I look? Also, no CEL, and no codes, which seems odd as bad as it feels...
View 11 RepliesMy idle goes real fast 2500 rpm special when is warm can't get idle to go down for nothing took truck to camping on dirt road with the vibration idle came back to normal and stay for while and over the soon start again. No code...
View 1 RepliesI have a 2003 F250 Super Duty 5.4L V8 with no heat. It wasn't missing, running funny or blowing white smoke out of the tailpipe and there were no coolant leaks nor did it overheat. Thermostat has been replaced twice, heater core flushed twice, water pump replaced, fan clutch replaced and blend door works...Cabin airflow gets colder when turned from hot to cold. This thing is sitting in my driveway and I am about to push it over a cliff. Did I mention it only has 56,000 miles on it?
Coolant was drained to replace water pump and flush heater core (again, water ran through in both directions with no stoppage). 3 gallons of undilluted antifreeze was put into the overflow bottle to be topped off with water...the coolant went in and stopped. Engine was started to force coolant from bottle...coolant backed up into the bottle and out the top. Heater core inlet hose is hot and outlet hose not very warm if at all. Upper radiator hose is soft. Didn't check lower radiator hose as I was a bit peeved and slammed the hood closed and called it a night. I have been throwing money at this thing that I do not have and am at my wits end with it.
I am the proud owner of a 2002 F250 Super Duty 4x4, which has 158K miles on it. I live in South Florida and use the truck as my daily driver and also from trips up into the Blue Ridge Mountains.
Recently, I noticed that when I have the A/C on it blows nice and cold for about 15 minutes, but then the air gets really warm. I had the system checked and the Freon levels are right where they should be. A bit of experimenting reveals that if I turn off the A/C for about 10 or 15 minutes after it starts to blow warm air, the systems blows cool air as it is supposed to.
Therefore, I suspect that something is freezing under the hood and preventing the system from operating properly. Since A/C is pretty well essential for us in south Florida, this is a problem, when I have the family or customers in the truck.
Sunday I bought a 2001 f250/5.4 to replace my 91 f250. I didnt drive it yesterday, but this morning on my drive to work the heater was very weak, it seemed to blow warm for the most part, but was barely pushing air even on high. I flipped it over to A/C to see if it blew any harder and it did. Does the blower motor need replace? if so why does the AC blow harder than the heater?
View 14 RepliesI have noticed my trans temp gauge needle is dead center of the gauge even on a cold start. I thought my sensor was under the pan so I pulled it and did not see any sensor at all. Is there a external sensor?
View 5 RepliesI got in my 06 f250 tonight and my digital read out on my temp control not working. My heater and A/C works but when I turn it off my outside temp is not on. Whats going on?
View 3 RepliesI have the 2012 XL F-250 6.2 v8 , I have an ambient (outside air) temperature sensor that needs replacing, I ordered it and was told it is located in the passenger side mirror from the parts guy, there is a tap in the bottom of the mirror to access it, looking for a replacement type video link of how to do this, as I am not finding one via youtube, pulling the tab off on the bottom of the mirror I am not really seeing the part I have as a replacement in the mirror.. This is the XL version/work truck so ALL manual mirrors....
View 1 Replies2006 F250 with the dash controlled 4x4. I typically keep the front hubs locked on this truck. I have recently noticed that when shifting into 4x4 that the a/c or heat will switch from blowing out of the vents to blowing out of the defrosters. Any clues how to fix this?
View 1 Replies