I can't seem to get the engine temp to middle range on the marker, but yet my heater blows "to me" hot air. Even while sitting in idle for extended amounts of time I cannot get it to "operating" temperature. I would think if my thermostat was stuck open my heater would blow either cold or slightly warm air. I have the 5.4L engine with knn air filter and no cats.
View 14 RepliesI have a 2006 f250 and the heater will blow cold air unless you are driving in like highway conditions. If you stop or drive slow it blows cold air only. What is causing this???
View 3 RepliesSunday I bought a 2001 f250/5.4 to replace my 91 f250. I didnt drive it yesterday, but this morning on my drive to work the heater was very weak, it seemed to blow warm for the most part, but was barely pushing air even on high. I flipped it over to A/C to see if it blew any harder and it did. Does the blower motor need replace? if so why does the AC blow harder than the heater?
View 14 RepliesMy 2000 F250 SD 5.4 AWD's A/C wouldn't blow cold suddenly the other day. I confirmed the A/C relay (engine compartment, 3rd down from firewall)was "clicking" but compressor clutch was obviously not engaging with dash switch on Max A/C and engine running. When I take of the 2 wire connector to compressor to see if it is getting power, the truck won't start..if I disconnect the A/C compressor plug while running, the engine similarly quits. I have never had another vehicle do this on me before..I could unplug the compressor on my Jeep GC, for instance, measure 12+ volts with A/C ON w/car running and no problem with Jeep engine turning off.
I have searched for A/C wiring schematic w/o success. I checked every fuse in cab/engine for continuity since I don't know which ones might deal with A/C..jumped hi/lo pressure switch connectors with engine running/A/C ON w/o compressor clutch engaging. Clutch turns easily, have banged it a few times, and air gap looks good. More bizarrerly, I hooked the compressor to a 12V/ground via its 2 male prongs and didn't get the clutch to engage.
I have a 1999 F250 7.3 Diesel and my AC isn't working properly. On Max AC as you're driving it would be ok and then it would be warm and then cold and then warm and then cold and so on. I've noticed that the clutch stays engaged as well. I've never seen it disengage. The freon is at the level it needs to be. Then just a few days ago, if you have it on Max and High the air disappears from the vents and you hear a noise somewhere in the dash on the passenger side. I think something might have come off?? What's wrong with my AC with it going from cold to warm constantly? I heard that maybe clutch has too big of a gap?? I have almost 200,000 miles on it.
View 6 RepliesI have 1700 miles on my truck and the A/C cycles between cold and warm air. I have taken it to 2 Ford dealers and they agree there is something wrong but their tests are apparently up to Ford specs. They logged complaints with Ford and they were told this was by design with the new trucks and it was normal for the compressor to constantly cycle. New 2013??
View 2 RepliesI am the proud owner of a 2002 F250 Super Duty 4x4, which has 158K miles on it. I live in South Florida and use the truck as my daily driver and also from trips up into the Blue Ridge Mountains.
Recently, I noticed that when I have the A/C on it blows nice and cold for about 15 minutes, but then the air gets really warm. I had the system checked and the Freon levels are right where they should be. A bit of experimenting reveals that if I turn off the A/C for about 10 or 15 minutes after it starts to blow warm air, the systems blows cool air as it is supposed to.
Therefore, I suspect that something is freezing under the hood and preventing the system from operating properly. Since A/C is pretty well essential for us in south Florida, this is a problem, when I have the family or customers in the truck.
The heater blows cold air from the driver side only. Very cold. Vey hot on passenger side.I have read that this is likely a blend door issue. Comments? Fluids are full. I hear slight noises from under the dash like "click click" like a door is trying to activate?? Truck out of warranty. If it is the door I heard the driver side is not as tough to install. Again comments? Instructions?
View 2 RepliesCold no start goes nowhere. I have a 2001 7.3 that will not start in the cold if I forget to plug it in....like last night. I have to plug in the block hater and give it a while before it will start. I tested the glow plug relay,it works fine. I can not find a test for the fuel bowl hear, and I'm not one to throw parts until I accidentally fix it. Any test procedure for the fuel bowl heater? Why this POS is so bad in the cold? Glow plugs tested fine at diesel shop in December, and this problem has been around since before that.
View 14 RepliesI have an 06 F-250 Lariat with the crew cab. Even though the windows are tinted, the A/C struggles to keep the cab at 70 degrees on any given sunny day oer 80 degrees outside.
As long as you're driving on the interstate, it blows cold, but when slowing down (like a traffic jam or a stop sign) the air gets warmer and has a funny smell (like it's wet).
When I got the truck it had just gotten a new A/C compressor (160k miles). It stopped working last summer (180k miles) so I had the truck at the Ford dealer here and they replaced the A/C compressor, condenser, pressure regulator and dryer...basically all A/C components under the hood.
They tell me its working fine, but I find that hard to believe. No Ford I've ever had has had trouble keeping the cab ice cold even on the hottest days... How are your air conditioners working? Do they keep the cab cold? What I should look at?
2007 F350 Dually, 6.0L
AC will blow cold, then shift to blowing warm, muggy air, then back to cold. Seems to be some relationship with throttle movement. Cruising steady ac seems normal. Multiple throttle shifts in changing traffic seems to trigger the warm air. Once accelerate back to normal cruise, can feel clutch/compressor shift and blows cold again.
Any ideas? I have read a possible cause can be the ac clutch can wear and need to remove spacers? Is this a DIY job? What about the ac clutch relay switch? On reading an online repair manual, seems that the clutch is magnetic, and if no battery power to clutch, it removes itself from compressor?
Just had an EGR delete kit installed. Any relationship to this and ac problem?
I've got a 2005 F-350 PSD KR. At highway speeds I get heat coming out everywhere it should. In stop-and-go traffic or at idle, the fan just blows cold air. Once back up to speed, hot air starts blowing again.
The fan stays running and the heat position (lower/upper-vents/defrost) stays the same. Just the temperature of the air blowing thru changes.
Things I know it isn't, thermostat is fairly new, anti-freeze is topped off, and the radiator cap is both good and on like it should be.
It sounds like maybe the blend-door or a vacuum leak according to a few of the posts I found with similar symptoms.
My '01 Super Duty 5.4 has an overheating/heater problem that the dealer can't seem to fix. I noticed my heater was blowing cold then a few miles later it overheated pushing coolant out of cap. Next day drove fine to Ford dealer who replaced my heater core, thermostat, reservoir cap and a hose. Drove it for a day till the exact original symptoms occurred again with a gurgling sound in dash. Dealer kept for a week pressurizing system but no leaks found. Replaced my thermostat again and gave it back. I drove it 300 miles over a week before the exact same symptoms occurred. Brought back to dealer who said that air was in the system, added a bunch of coolant and supposedly got all the air out. Same symptoms still. Brought back to dealer that finally changed the water pump they said had a leak. Guess what, same symptoms. Heater will work fine for days then it will blow cold, then hot, then cold and sooner or later truck will overheat then just as fast cool down and heater will work again. Still hearing gurgling. Dealer said I don't have a HCV.
View 6 RepliesSo the heater on my 2001 f150 will only blow through cold air. I thought that I may have a heater core clog so I back flushed it with water until it was coming through clean and unrestricted but that didn't solve the problem.
Now, some things to note are a potential coolant leak. I can't seem to find one but I filled up the antifreeze about two months ago and when I checked it the other day it was more or less empty. I've filled it up again and I will monitor it for the next couple of days.
Another thing to mention is that no matter what setting I have the heater on (ie 'panel' or 'defrost') I get cold air blowing at the passenger side's feet. Is this indicative of a hose leak or something?
Also worth noting is that the intake hose to the heater core gets hot after driving but the outtake stays cool. This is why I originally thought I had a core clog.
Should I be checking my blend door? If so how to I access it?
I have an 03 f250 6.0 150k milage and lately my A/C has not been working at its best. Its intermittent, and for some reason it will work fine until i get on the highway and it just blows hot air. Would this be a leak or clutch issue? One thing I have noticed if my oil/coolant is above 200 the A/C will blow hot air but not return to cold when the temperatures return to normal. I haven't done any trouble shooting so my first thing ill check are the fuses. As far as the compressor goes its an alien object to me I have never had A/C issues with any vehicle i have owned.
View 6 RepliesI have a 2002 f250 superduty 5.4 4x4 around 317xxx original motor and trans. When it's cold out it won't start at all I have to use starting fluid but once started it will start right back up. Did the plugs fuel filter cleaned the intake and sensors still have a problem plenty of fuel pressure plenty of cranking amps brand new battery and Alternator. It just cranks and cranks when it's warm out fires right up. Runs smooth no lack of power or misfire no codes are being thrown also.
View 14 RepliesI have a 2011 F250 with ac problems. When you start it in the morning and turn the ac on it only takes a small amount of time for the air to start cooling. If you turn the truck off then start it again after driving to town the ac blows hot air out up to 4 minutes (yes I timed it) before it starts cooling. I took it to a local repair shop and the first time they said it only had half the freon it needed. The charged it and off I went. Same problem. The second time they informed me the fan clutch was not engaging and replaced it. I picked it up and the first time it was turned off and back on it had the same problem. I am scheduled to take it back to the same repair shop on Monday.
View 1 RepliesIts a 2001 f250 with a 5,4. I just recently put a new shot block in it, the short block is a svt short block for an 01 lightning. every thing off old motor went on new svt block just fine, and it drop in just fine. only it will not warm up i let it run for 45 min the other day and on the gauge it would not come past the c. and i do believe the gauge to be accurate because the heat in the cab sucks and the top rad hose is just warm, not as hot as it should be. I've already put 2 new thermostats in it so I don't believe that to be the issue either.
View 14 RepliesI just bought a 2000 f250 diesel truck and am having problems with the ac. When I first turn on the ac it blows very cold and works perfectly but after about 5 or 10 minutes it will start blowing warm and slightly humid air for probably around 5 or 10 minutes and then suddenly the very cold air will come back. This cycle repeats over and over again and I'm not sure what is wrong.
View 5 RepliesOur 7.3 won't fire. After a few weeks of thinking we had glow plug issues on firing we feel we may have another issue instead.
In cold morning of past say -1 to -7 we have had a lot of trouble firing the old girl, we would preheat 3 or 4 times and it would wind over and over. Stop repreheat and try again and it would turn over quicker. Preheat again and it would fire.
We have a diesel leak as well and was thinking that the pressure maybe low because of it. It is now with the mechanic and he can't find the diesel leak but it pools on top of the engine and drains down the back of the motor over the belt housing.
He cleaned it all up and checked the ICP sensor and it was full of oil, he cleaned it and refuted it and it fired. He then ran it for around half an hour to see if he could spot the fuel leak, he turned it off and now it will not fire at all just turn over.
I have been having hard shifting from 1st-2nd when cold. Rpms up to 2000 and let off then goes into 2nd. After that, she shifts fine and shifts well until next morning when she sits overnight. Build tag is August 09, 2001, so no old mechanical diode? Took a sample of fluid and it is dark red (pic attached) and smells like hydraulic fluid...I don't think it smells burned. Does it sound like the calve body 1-2 shift or solenoid pack or needing rebuild?
View 3 Replies