Ford Super Duty (1999-2016) :: Location Of Park Assist Module (PAM)
May 9, 2010
Problems with the Parking Assist/Reverse Sensing System. I have found the troubleshooting that everyone has done very useful. I have a 2007 F350 Lariat Crew Cab with problems with the Park Assist. Whenever I put it in reverse the system shuts off( Off Light illuminates). I have checked the wiring harness and all connections, Parking switch, and Reverse Sensors. I have done everything except check the Parking Assist Module. My maintenance DVD tells me that it is located behind the glove box. I cannot find it in there anywhere. Where it is located. The trucks manufacture date is June 2006....
View 14 Replies
Advertisement
I got a 2013 f350 lariat long bed. Had a flat bed put on and now my check park assist is always on.. Dealer didn't install sensors. Is there any module or anything I can do to turn this thing off?
View 1 Replies
Where is the SYNC module in an '11 F250?
View 3 Replies
02 f350 5.4L Where is the body control module located?
View 1 Replies
2009 F250 Super Duty 4X4 auto lock hubs not working. Indicator lights on dash come on but will only go into 4 wheel drive when hubs are locked manually. Vacuum is present at lower of the two vacuum lines when engine is running. I attach the lower line to the module, rotate switch to 4X4 high or low and module doesn't allow vacuum to reach upper nipple. Which fuse operates this module?
View 3 Replies
I have a 2002 F-250 Super Duty 4X4 triton V-10. Where the security control module is located? my keyless remote system does not work even after programming a new remote. The Ford dealership charged me an hour labor to diagnose the problem and they said it's the security control module which I just ordered.
View 14 Replies
The #8 fuse under the hood was blowing on my '00 F-250 every time I turned on the healights meaning I would lose power to my park lights. The brown wire coming from the back of the headlight switch showed a dead short to ground that I traced to somewhere between the switch and the firewall.
Anyway, I got tired of trying to pinpoint the ground fault, so I cut the brown wires at the back of the switch and under the hood at the top bolt-on electrical plug and replaced the bad section with a new wire. It works fine now with the only exception being I do not get the park light flash when I hit the remote lock button the second time. I do still get the horn chirp.
My Haynes manual indicates there should be a relay box with a Park Lamp relay, Driver Unlock relay, All Lock Relay, and All Unlock relay. The park light relay looks like it sends the blip of power to the park light circuit. Where this relay box is? I'd like to splice into the brown wir coming out of it to restore the light flash when I lock the truck since sometimes it's too noisy to hear the horn.
View 10 Replies
So, I'm tired of this crap power steering. Since I just blew up my lpop on my 6 blow, apparently a thing with manual trans, replaced and she runs fine, I decided it is time to fix the screwed up worthless sloppy steering, and almost lack of any power steering at stop or slow drive. Picked up a rebuilt pump., and took out my old box with 220k.
I almost bought a cardone box, but frankly my input shaft had less play than 2 I ordered in. The only problem with my box is it has a tiny amount of play on the sectorshaft which translates to a lot of slop.
I've been looking into hydraulic ram assist steering, as I run 6" lift with 37s on a crew cab long bed. The thing has sucked at life since I bought it with wider 35s a few years back.
Is hydraulic assist worth it and if I go drop 500 on a redhead box, between this and the ram, am i going to be looking at decent steering on road in the future? I have no plans to offroad this boat anchor of a truck. I have a nice fun light 2 door turbo montero for that.
Do I do it, or just stick with a rebuilt box and pump?
View 1 Replies
I own a 2012 F350 dually King Ranch with 6,600 miles on it as of today. I noticed that on slight inclines, I can see and feel the hill start assist feature activating and working as before. I was not towing anything today. Starting today though, I hear this loud creaking noise both in forward and reverse directions with quite a bit of shutter from front of the truck lasting one to two seconds as I transition from the brake to accelerator. I checked the front hubs to make sure that they are not in locked position. I tried activating 4WD auto mode, then deactivate it to 2WD mode as I watched the diagram/figure on the dashboard. Nothing would make the loud creaking noise and shutter go away. Is there anything else I can try, or should I take it back to my Ford dealer again (now for another different reason. I had problem with injector #8 failure with CEL come on earlier this week which appears to be fixed for now)???
View 13 Replies
I have a 2002 F350 7.3 Powerstroke with approximately 200,000 miles. Recently I have been having an issue with what I am told is my airbag control module heating up to the point it is too warm to touch when I am pulling a heavier load. It is located just under the dash on the center hump. I removed the black plastic cover revealing the module itself in order to determine that indeed is where the heat and smell of hot electrical equipment is originating from. It gets too hot to touch when pulling a heavy load and making the motor work...once I lighten up on it or am not pulling it immediately cools back down. If it is an option I would just disconnect it but I havent yet for fear of creating more of a problem.
View 1 Replies
I have been trying to hunt down the issue with my 4wd. I have thus far done the following:
- Check and clean all fuses under dash
- Checked the underhood relays
- Check for proper operation at switch
- Opened relays under how and manually switch them, transfer case motor and lights on dash work as they should.
So my though is that I have power going everywhere. Something is not sending the signal to the relays. I would narrow this down to the 4wd control module behind the glove box. Is there any way to test this for sure? I'm about ready to just buy on and slap it in. Spending way too much time on this issue.
View 6 Replies
Im getting this almost every time I start it up. It happened once about a month ago, then more often. Now almost every time.
Truck has 1700 mi
I hate to have to bring it to Ford so soon
View 8 Replies
2010 F250 Lariat, cab and a half, PSD. 5600 miles.
Sunday I started the pickup and received "trailer brake module fault" in the message center. I wasn't pulling so wasn't too concerned - hit the reset and continued on.
Sunday night I started the pickup again and received the same message followed by "check brake system". I also lost illuminated gear selection, the traction control active symbol was displayed and the traction control "off" (PB) was illuminated. After several attempts it reset, everything returned to normal and I was able to get home without incident.
Monday morning it wouldn't start. It indicated "trailer brake module fault", "check brake system", traction control active and off, no gear indication, the odometer indicated "-------" and it did not react to the key in the start position.
Tuesday morning I attempted to start and it was the same as the previous attempt. I noticed that the theft prevention appeared active (flashing) so I removed the key, locked the doors, unlocked the doors, tried again - no joy.
I kept trying while holding my mouth in different positions and finally by the grace of God it fired. I delivered it to the dealer.
The dealer called yesterday afternoon and reported that everything is a result of a bad trailer brake module. The new one is to arrive today, they will install and everything will be peachy.
I asked if they could just unplug it and reprogram the truck to believe it never had one - the service writer said it can't be done, different piece parts on trucks with or without trailer brakes.
I really have no choice but to push the "I believe" button and carry on but I am slightly concerned. The fact that the trailer brake module can cause catastrophic failure doesn't seem too cool, I don't have a real warm and fuzzy feeling associated with venturing far from pavement, reliable communication or alternative transportation.
In the meantime I suggest that no one take "trailer brake module failure" lightly.
View 14 Replies
Besides the window tag and the door tag, where are other VINs located? The VIN tag in the window looks suspect and there is no door tag. (I covered the first 11 digits of the VIN.) Also, I found a tag on the front pass side of the bed that I've never seen before (mounted between the bed and the cab). What this is?
View 12 Replies
My engine light came on a friend of mine did a scan and came up with o2s12 showing low voltage.we need to know which side and location of sensor..the truck is a 2005 ford f250 super duty 5.4l.
View 2 Replies
As luck would have it I'm leaving out in the morn for 600 miles , Noticed a nail in my L/F tire yesterday went too Goodyear they pilled the tire patched it inside.. Then this morn went to fuel up my ABS light stayed on .. Did this last yr. went off after a few days but since the tire was pulled maybe its a bad connection ??? ..Jut want to be sure and scan codes
I want to scan it now to check and reset any codes But looked under the Drivers side dash can not find the OBD connection port looked on Passenger side nothing there either.. Looked under hood around fuse box did not see anything that kind of looked like a port with a cap I'd assume they cap them if under the hood .. Its a 05 S/D 6.0 locate this OBD11 port
View 2 Replies
I have a 99 F350 with a 7.3 diesel that will not shift into park.
View 10 Replies
2004 super duty crew long bed 2wd, v10 auto SLT.
Manual says not in fuse block.
Looked behind radio, nothing, not even a space or the blue one there.
There are some on the firewall, driver side not marked. No pink wire.
Where else??
View 2 Replies
Where the battery junction box is? I've been all over under the hood, and dash, and not seeing it. It's not small, since it's full of relays and fuses, and should have a large wire bundle going to it.
View 7 Replies
Where is the door chime? I just want to remove it. My truck is a 2014 e350.
View 1 Replies
Where are the door sensors located?
The ones that turn the light and off when you open and close the doors.
It use to be switches on the old trucks and cars.
But on my 2006 F-250 I can find anything that seems to do that function, nor is anything mentioned in the repair manuel.
View 8 Replies
