How to replace the parking brake cable from the pedal down to the connector on the frame? We got a 2000 F350 in the shop with a bad cable, and i never did one. And I don't really want to mess this thing up trying to figure out how to change it.
View 6 RepliesI'm re-doing the parking brake as part of a rear brake job on my 2009 F250. I need to disconnect the intermediate brake cable at the equalizer, but am having trouble. I've got slack in the cable, but can't push hard enough to get the swaged cable end to move within the connector that's between the equalizer cable and the intermediate cable.
Is there a special tool or some trick to this? If push comes to shove, I can cut the connector (assuming I can get a replacement), but would rather not.
Also, any particular trick to disconnecting the cable to the parking brake lever at the wheel? With that huge spring between the cable bracket and the end of the lever, I haven't been able to move the cable end enough to disconnect it from the lever. Since I don't have the intermediate cable disconnected, could that have something to do with it?
I'm working on an '05 F350 King Ranch dually, and I'm pretty sure the pb cable is stretched. I recently replaced the shoes in the pb assembly and adjusted the tension while I was in there, but it still barely holds. My next culprit sounds like a stretched cable, and I have a complete set for a new one, but I'm having a hell of a time getting the old one out. The link that holds the front and intermediate cables together won't pry open with any tool I have, and I've broken two drill bits trying to drill out the nub holding the front cable in.
View 5 Replies1999 F-250 ... How does one replace the emergency brake cable? The cable in the '99 F-250 I recently bought broke.
The cable was sticking when I got the truck. I like to use the emergency brake every time I park. The previous owner(s) didn't use the emergency brake and the cable had frozen up.
I tried using it every time I parked. I could tell it was frozen, but I was hoping it would loosen up. It held a little bit when I used it; but soon it just broke.
The problem is I haven't seen one for a recent (2011+) SD. I don't see anything that resembles a rear drum. They look like 2 huge regular disc brakes.
I live on a hill. My old man taught me to put the trans in neutral, autos and manuals, put the ebrake on and make sure it holds the vehicle, then put the trans into park or 1st gear. This way the weight of the vehicle doesn't rest on the transmission.
How do I adjust the Ebrake? It's ALMOST holding the truck, just needs a minor tweak. I don't see the dust cover the write ups described at all. The one that reveals the Star Wheel. Are they different on these years then prior SD's?
How to replace the 2 "drop down" rubber brake lines on a '13 250. They appear to be secured to the bracket that looks like is the bracket that's holding the DEF tank on. And by the quick look without much digging in appears as though I have to take the DEF tank out or significantly loosen it to get at them. I'm no neophyte when it comes to this stuff and will take the DEF tank out of necessity, was just wondering.
View 1 RepliesI plan on replacing the brake lines on our 1999 Ford F-250 Super Duty. The rear line blew out right by the hose, on the framerail. All five lines, all five hoses. What size lines? Looks like front two are 3/16", rear two over the axle are 3/16", and the rear line in the frame is 1/4".
We are removing the bed (2013 bed) to make things easier. I am thinking fuel lines and parking brake cable while the bed is off. I have stainless steel hoses from KLM performance and I am also planning on replacing the rear rubber hoses. Obviously I'm using nickel copper line. There shouldn't even be an option for other brake line.
[URL].....
The '99 F250 has the parking brake release under the dash, way down low. While I was in the wrecking yard, I noticed many Excursions and Econolines have them on the left, by the parking brake. Whether one of those might work, if I installed it on my '99?
View 3 RepliesWhen I parked my truck at work this morning, I pushed the parking brake pedal down like always, but it popped back up. I didn't pop all the way back up, it stayed down about 1/4 of the way. Several tries yielded the same results.
Since I'm at work, I didn't have any time to crawl under there are investigate. I'll do so tonight when I get home, or maybe tomorrow. Kinda sounds like the locking "teeth" mechanism may be misaligned?? Since it doesn't come all the way back up, I'm hoping the mechanism isn't totally broken.
How do I adjust the parking brake on my 08 F250? It's not holding when my truck is parked on a hill.
View 1 RepliesI have a f250 super duty. I blew a brake line the main going to the rear. So the genius that I am I replaced the line an simple enough I decide hell why not replace the master cylinder too, so I did an I bleed the brakes an everything works jst fine but now the the brake light won't turn off I have tried everything not sure what could possibly cause the light to stay on. I will eliminate some suggestions, I bleed the brakes, the brake fluid is full, the level sensor is completely attached, the parking brake is not on, I pulled the parking brake completely out, even completely disconnected the sensor thinking it would turn off bu it didn't.
View 1 RepliesI have a 2008 f-250 2 days ago all light stopped work except the head lights found a blown fuse replaced with a new fuse and now all the lights work except the right rear brake and signal but the running light works so i know its getting power looked at the wireing and it all looked good to me oh ya pulled my trailer in and same thing everything worked but the right brake and signal ....
View 4 RepliesParking brake light stays doesn't come on when the parking brake is engaged. The light DOES come on when starting the vehicle and the gauge cluster cycles through its start up procedure. Couldn't find a fuse that would fix my issue...does one exist?
Truck is an '02 F250 w/ 7.3TD and 6 speed manual.
Are the parking brakes on rear disks adjustable at all? Mine doesn't hold very well anymore, but I'm not quite ready to rebuild the whole thing. If there are adjusters (similar to drums), which way you turn them on which side of the truck?
View 6 RepliesWill leaving the parking brake on burn up the axle seals? My parking brake isn't working well at the moment. I need new ones from all the fluid my bad seals leaked on them. So, at the moment they just scrub a bit while its engaged. However, today I found out that my parking brake light for one reason or another is not working and I got in a hurry and didn't release the brake. by the time I got to where I was headed (about 15 miles), I could smell gear fluid burning and my driver side rear was smoking. I'm hoping its the fluid that was already soaked into the shoes. I did find a drop of fluid on the bottom of my brake caliper.
View 5 RepliesThe parking brake audible warning is going off along with the parking brake light. I tried disengaging the brake multiple times and it went off once, however now it will not go off. I found some older pictures of a switch on the arm that swings with your foot when you engage the brake, but I can't find it on my 2004.
Is there a switch down there that needs to be kicked, contacts cleaned or replaced? I checked the fluid level and vacuum hoses and do not see anything obvious.
Noticed a burnt rubber smell while driving today. Stopped at a gas station and before I could get around to the other side of the truck, a guy stopped and told me there was smoke coming from the passenger rear wheel well. The truck seemed to run and drive fine. Didn't seem to be any noticeable drag, but once I got home I felt that wheel and it was a bit warmer than the others.
My parking brake pedal is all the way out and pulling on the release doesn't seem to relieve any pressure or "Pop" like it normally would if releasing the brake. We've got a good downpour of freezing rain right now and I'm not able to start pulling things apart. Anything easy I can try for now? Pretty sure it's seized by the way it's acting but I really don't use the parking brake. Auto trans and I live in a really flat area.
Parking brake lever for the park brake on my 2001 F250 srw. Both are rusted up but im having trouble finding the part.
View 1 RepliesI have a 2001 F-350 Diesel 4x4 crew cab 8ft bed dually 7.3 diesel 6 speed. The issue is that the parking brake pedal is extremely hard to push. One day it pushed down and ratcheted into a locked position as normal and the next day I couldn't push it more than an inch down. I have rear disc brakes with internal drums in the rotors for the parking brake assembly. I replaced the shoes and hardware (which were fine) and I still have the same issue. I removed the front single cable from where it splits into the two rear ones and the foot pedal depresses smoothly and with the touch of a finger with no load on it. What else is it? The only other thing is one of the rear cables unless I am missing something?
View 5 RepliesI'm about to install a Undercover swing case and my locking cable mechanicism is in the way. I've taken everything off besides one bolt completely dead middle of the reel. I don't see how in the world you get to this bolt at all without destroying the reel. Any input?
I'd like to keep the bed lock cable in-tact so i can install it in the front.
What is the procedure to remove the parking brake cable from the axle? It looks like the cable has a locking device like the fuel lines but heavier. How do you get that thing out of there without destroying it?
View 9 Replies