Ford Super Duty (1999-2016) :: Shift Very Hard After Idle In Gear (stop At Signal) Occasionally?
May 3, 2016
So, in my 99 Bounder RV (F53 chassis), V10
I think it has a 4R100 transmission in it (I have not verified this).
I had the oil and filter changed about 10K ago.
Runs and shifts fine .... then I stop and idle with it in gear (say stopped in traffic for a few minutes).
Now the thing shifts super hard! I actually get rubber in all gears.
So I pull over, shut it off. Restart the unit and everything is fine again.
It does this very consistently!
I went to the local transmission shop. They said with 110K in an RV it could be anything and I should think about letting them rebuild it.
Now that is something I would do ... not diagnose a problem and just rebuild it. I thought a "professional" would actually look for the problem first.
I don't want to rebuild the transmission if there is small item that will fix this.
View 3 Replies
Advertisement
2015 F 250, less then 5k miles. When towing travel trailer, weight 7500lbs, on occasion transmission will not shift out of gear. Happens in first, second, or third. Very intermittent. Take off from a stop engine goes to 6k rpm. Let foot of the throttle goes all the way back to idle, still no shift. Accelerate back up to speed still will not shift. After doing this a couple of times finally shifts. Have had this happen in second and third. Not a lot of fun with cars behind you or trying to merge on highway. No codes
First trip to Ford dealer they re calibrated computer. Still happened towing. Second trip to dealer they put a flight recorder on it and I towed again. Did not hang up in first or second ,but would not shift out of third on highway doing 70mph, even when I lifted from the throttle and coasted. I finally shifted to manual and shifted to fourth and was able to upshift After reading flight recorder mechanic said it appeared normal. I explained that having to shift the transmission manually is not really normal and they agreed.
View 14 Replies
I go out of town for work for a week and come back and my 1999 F250 V10 GAS, is acting up. It started when i tried to drive it and it didn't want to shift, it would rev up to 3000+ RPMs and finally shift really hard into gear along with the speed odo not keeping up and bouncing around not wanting to work. I also had my entire gauge cluster lit up with no key and door closed. all the lights were on and it was "dinging" like the door was open and it wasn't. you would hear it when you put your ear up to the door.
So my first thought was to change the VSS (which I did) no luck. So I started wiggling wire loops under the fuse box in the cab and the "dinging" quit.. i took it for a drive and it works like nothing ever happened. Obviously I am guessing there's a short so i brought it to my mechanic and hes saying he couldn't find anything by the fuse box but he thinks its closer or even attached to the gauge cluster itself. could this be true? Why would the gauge cluster loop throw off the shift points?
View 5 Replies
My '01 recently seized up and a buddy determined it was the AC pump. Replaced the belt with the bypass version. A month later, I moved across the state to Iowa. A couple weeks into living here I turned the truck on and it was idling really high (about 2500-3000) but would settle down to around 1100 when put in gear. However, shifting into gear is causing a progressively worse "jump" into gear. Hadn't really had the money or the time to take it in so I let it mostly sit unless I absolutely needed the truck.
Today, the idle is still high and does seem to cycle a bit in that it will rev up close to 3000 then settle back down around 2200 or so and then rev back up again and so on. I backed it down the drive into the sun for a little warmth and it darn near jumped a foot when I shifted. I turned the heater on defrost so I could clear the windshield and absolutely nothing came out.
I can't get into a garage for a few days to get it hooked up for diagnostics. So I thought I'd try here. My research leads me to think part of my problem may be a vacuum leak and/or maybe a sensor somewhere.
View 4 Replies
2004 F350 6.0 Diesel 2WD, Question is my trailor lights running lights work fine also the electric brake, but i have no stop or right or left turn signals the truck signals are all working perfect. The truck came with factory wiring i have checked it at the plug on the bumper with meter to make sure it was not the trailor. Looked for blown fuses and cant find anything what am i missing it should have seperate fuses for trailor lights ??
View 14 Replies
I have a 2008 for 250 6.4 powerstroke. Issue I am having is occasionally when I shift from drive to reserve it will slam when I shift to reverse. It is an intermittent issue. What causes this and what to do?
View 1 Replies
I have a hard shift between 2-3 that is somewhat violent. It doesn't matter the rpms or how hard I'm accelerating, it will always do it. At wot, it sometimes throws a code that stays on for a few minutes, then goes away. When I hook up a code reader, it shows no record of it and it never throws a blinking OD light ever.
It has an ATS transmission, but I don't know how the controller works, if it is wired correctly, or if it could even cause this issue. Currently the truck has 210k and unknown on ATS.
View 2 Replies
I have a 2005 f350 6.0, my left rear stop signal is not working. I have changed the relay. I only get 5-6 volts at the plug and green-orange wire all the way to the engine bay. Not sure what the problem is????
View 11 Replies
I installed a reverse camera to my new Pioneer in-dash nav head unit this morning. I wired (at the rear of the truck) the power signal lead to the reverse wire at the trailer connector. I also need to wire a reverse signal input into the back of the head unit. I really do not want to run a power lead from the rear of the truck to the cab. Is there a wire under the dash I can tap into, or could I use the wire going to the backup alarm that’s somewhere under the dash (if I can find it). 2010 F350 deisel, crew cab, 4WD, long bed.
View 9 Replies
So it appears as though my shift lever (automatic) will not shift into the 1st gear position? However when I drive the vehicle, the transmission seems to shift through 4 gears, then into Overdrive? What could be the issue?
View 3 Replies
I have a 2005 Ford 6.0L Diesel with the 5R110 transmission.
About a month ago, i started seeing some strange shifting issues with the transmission. While driving normally, it would suddenly hard shift (slam itself into gear), the entire truck would shake it shifted so hard. It would also cause the Tow/Haul indicator to start blinking. (my understanding is that the Tow/Haul light indicates an error code).
I drained/flushed the transmission, installed the larger pan/with the improved filter. I put Mercon LV back into the transmission (what type of fluid was in there before).
The problem still persists, and got a bit worse. The truck is almost un driveable at this point. Still getting Tow/Haul flashing messages. Can the error code be read by an standard ODB2 reader ?
View 9 Replies
Friend parked his well working truck and when starting it up after sitting a few days it won't shift into any gear. Lever moves as normal but the truck won't move. A soft clicking sound is the only difference to be noticed when shifting the lever. where to start? Temps are below freezing here if that matters.
View 11 Replies
I have an 01 f250 with a 4r100. Trans has not been slipping at all and yesterday it started a rough shift between 1st and 2nd. (3-4K Rpms) At the same time 4th gear stopped engaging. Shifts out of 3rd but does not go into 4th. I can hit my od button and it will shift back into 3rd and start pulling. Still no slipping just doesn't want to change 1-2 or engage 4th. I have done a full trans fluid change including new filter and tc. Old fluid looked fine with no metal flakes or garbage in it. So all new fluid still same problem. I was thinking of changing my shift solenoid.
View 9 Replies
So when I try to kick into 'passing gear' in this '01 f250 5.4l, i get no tranny shift. Whether I'm in tow/haul mode or not.
View 10 Replies
The other day I was driving i was driving down the road when suddenly my truck wouldn't shift out of first gear, then the truck died and the motor wont turn over either. Acts like it is locked up. Its an 01 with v10 and 4r100.
View 6 Replies
I may be going to look at a 2001 F250, 4x4 with a V10 engine tomorrow. I think it is a shop truck for a business. The owner said that the mechanics told him that the trans won't shift out of low gear. It is an automatic. Maybe something as simple as a modulator valve (do they still use them)?
View 4 Replies
I took my truck in for a clunking noise in the driveline as I come to a stop and sometimes when shift into park. It is now the 7th and I'm told parts have been ordered and the truck will be worked on when parts come in. I asked to speak to general manager and still no call back. I called customer relations and nothing they can do.
Honestly I think the have me on the back burner since I'm warranty work opposed to marked up repairs. Am I being unreasonable on my expectations of repair time? I called around and a ring and pinion job is quoted at 3 days at the most. Other repairs have been approved as well and parts are in for those, but they have not actually repaired them either.
View 14 Replies
On a 2000 F-350 with 5.4 engine, where does the vacuum line enter the cab? I got a truck in with no vacuum signal to the heat controls, and it has a slight miss at idle. Both of these are signs of a vacuum leak, but i can not find the line going into the cab.
View 5 Replies
2015, F250 6.2L, 16,000km , so recently my transmission has seemingly lost its mind. When I start it up cold and drive it down my street I am greeted with a horrible slam of a 2nd to 3rd gear shift. Then while towing my TT this weekend a couple of times it held 2nd waaaay longer than it ever has before. Having issues with Torqueshift?
View 7 Replies
The tranny is shifting really hard between 2 and 3 if I feather the throttle it can be a little less of a jolt but still enough none the less iv never done a filter and fluid change as I just got it it has 235000 miles 99 v10 super duty 4x4....
View 8 Replies
I need to solve tranny problem, it started out a while back, would not shift back into drive after stopping at stop sign (after driving fine for about 20 miles) thought maybe dirty filter so did fluid and filter change seemed to work for a while then started again noticed it was mostly after using cruise control, but u joints were very bad, so replaced 2 of the 3 and worked fine for about a thousand highway miles, then got really bad. Now when I check the tranny fluid cold and /or hot it is way up on the dipstick. Took to ford dealer in ladoga, lied and said no speed sensor codes, but list on the paper he gave me had all kinds of abs and a p500 code.
View 9 Replies
