Ford Super Duty (1999-2016) :: Steering Wheel Jerking And Kind Of Stuttering
Sep 14, 2015
The truck. 2005 super d 6.0l. 200,000 miles
The problem. After start and warmup, and then a couple of miles driving, I make a slow 90 degree turn after a stop sign. The wheel in my grip seems to go stupid for a very short time. It responds by jerking and kind of stuttering. Yet it does this only once per trip. Also it does not do this every trip. Just sometimes. After the stutter the steering is Normal. There is no vibration at speed, and no wander from side to side. Everything seems solid and straight.
So what's going on? Should I start by draining the reservoir with a hose and refilling, repeat repeat, to "flush out old fluid". Or is my pump or steering box headed for a fail. Maybe hubs or knuckle joints.
View 9 Replies
Advertisement
the mechanism that locks the steering wheel is stuck. not the ignition key cylinder (already removed that). how do I release that mechanism to free the steering wheel.
View 3 Replies
Seems that after a sharp right turn, for instance turning right at a stop sign I'll get a loud pop that I can feel in the floor pan under my feet.
After the pop the steering wheel and whole front of the truck will shift left and right like someone is grabbing the wheel, sometimes violently. If I drive slowly it will cure itself and sometimes not do it again for several days. I've check ball joints and hubs and they are in great shape. I pulled the hubs and greased the needle bearings about 6 months ago. I checked all steering components and the linkage that attached to the steering arm had some play so I replaced it. Then I found that some idiot took the steel sleeve out of the bushing in one end of the steering stabilizer. I bought a new stabilizer and cured a pop I'd had since I got the truck, but the other issues were not solved.
Alignment has been checked too.
View 14 Replies
My truck has developed a wobble in the steering wheel. I don't mean when you are driving down the road, but the steering wheel wobbles around. It wobbles in any position that the Till shaft is set to. How to repair.
View 10 Replies
just bought this f250 seems to walk on the road alot, had it looked at has new balljoints, he says everything seems tight except there is lots of play at the gearbox, is it recommended to have it rebuilt or buy a reman, was told that even the reman seems to be the same way
View 14 Replies
The steering wheel is locked on my 99 F-350. I messed around with the stupid thing for quite a while this evening and it won't budge! I need it to haul hay tomorrow....
View 13 Replies
Truck is 2011, F350, 4x4 CC Long box with a 6.2, 124,000 km on it. Was driving home last night towing my jet boat when I heard a sudden noise from the front end, kind of shudder, first reaction was a flat so headed to the curd. No flat, nothing running hot, no play in wheels, all looked good underneath the front end. Pulled out and drove away, got about 15 km and it happened again, looked all around nothing obvious so pulled out and drove home (25 km) no issue.
This morning wanted to investigate further. Drove truck down the block and heard a definite rotating type sound. Not a grinding more like a scrape sound. After a minute it went away. Went into a parking lot and drove in tight circles but no strange noise. Found that the auto locking hubs were not working but hub would lock in manual. No strange noises with hubs locked in either.
Jacked up truck rotate front wheels, no sound and no play or wiggle on either side. Pulled the hubs and the passenger side had water in it. Hub was not rusty but it didn't look as good as the other side. Not sure how water got there as I have never driven in water, although I am not original owner but have had it two years and put 25,000 km on it. Could the water have gone in deeper and caused a bearing to fail?
View 2 Replies
06 F250 6.0 CCSB 4x4 163K Truck was in a pass side wreck about three weeks ago. Aside from bumper, head light, etc I had to replace the track bar and then I had the alignment done. Mech said the steering was loose and was either the steering box or column.
PROBLEM: Truck drove and parked fine last night, I went to leave the driveway this morning and I had to turn the wheel full right while backing up. The wheel locked up and wouldn't turn back to the left to straighten out. Hood wouldn't pop either to check anything
I crawled under the truck, the belt was in place and I didn't see any power steering fluid leaking. Thinking it was a PS problem and the hood not opening, I basically floored it and yanked on the wheel and it broke loose. Also, for what ever reason the hood opened after that
Now the steering is heavy and the wheel doesn't center on it's own. It will stay turned when I let go of the wheel. Scared that it would happen I didn't try turning it full lock on the way to work. but it happened again exiting the parking lot, again full right lock and the wheel stuck.
I managed to yank the wheel to the left again and I heard a distinct pop from what I'm sure was the pass side wheel area.
The PS fluid is dark and I'll figure out how to change it. I've read issues from the U-joints, ball joints, Steering box, steering stabilizer, and failing PS pump could all lead to this. Being the truck had a pass side fender bender, and I'm pretty sure the pop sound came from the pass side how do I check all of these items.
View 13 Replies
So I just got my 2014, upgraded from a 2007, and one change that is bugging me is the steering wheel controls for the radio. In the old truck clicking the scan up/down buttons scanned to the next radio station, in the new truck it scans through the preset radio stations. I really don't like that. Can it be changed or am I stuck with it?
View 2 Replies
I have a 2005 F250 6.0.. I'm the third owner, only 146,000 miles on it. Had most of the front end replaced. Ball joints, tie rod ends, track bar bushing, front end alignment done...
Still likes to walk as I call it side to side while driving down the road. Factory size tires, factory rims. A little excessive movement in steering wheel while driving, side to side and not transferring to pitmen arm. So I think the gear box shot. Got to looking closer and the power steering box has a re-manufactured sticker on it, so thought about rebuilding it. I do not know where previous owner got gear box at.
View 2 Replies
Ordered a 2015 f350 CCLB FX4 XLT 6.2 about 2 weeks ago.Tried to see if the control buttons on the steering wheel were lighted couldnt tell in the daylight.
View 5 Replies
This is probably a strange request but I did just get a 2011 F250 XL. The SYNC and audio controls on the steering wheel was an available option, but my truck does not have it. I didn't ask for it to be required in the vehicle search, just one of those "if it has it, awesome" things. I am looking to add the buttons to control the radio and MAYBE SYNC for the bluetooth feature if this is possible.
I know to add SYNC I need a radio that's ready for it, which mine is, and a microphone somewhere and all of that so that's not to be done until a later date. My old F150 had the radio controls on the wheel and I miss that. Can I add the radio controls on the wheel? And maybe SYNC without needing to add a Parrot device for bluetooth? Or am I SOL on both?
View 10 Replies
Yesterday while traveling about 30mph and starting into a slight left turn the steering wheel locked, when the brake pedal was applied it was rock hard and would not engage braking resulting in a single vehicle crash, no injuries. 8300 miles...
How would I make Ford aware of this incident and get them involved? Is it likely that such events may have been logged somehow in the computer? The truck is at our collision repair shop waiting for an insurance adjuster to inspect.
View 14 Replies
How many rounds can you turn your steering wheel each way? Mine goes not quite 2 rounds, I think it's been limited.
View 7 Replies
Today I put a new shifter tube in a 02 f450. Everything works well, but the key won't come out and the steering wheel won't lock. Was told there is a button to push by the turn signal side but don't see any. Looked around top and bottom of column and didn't see anything out of place. Also found a black wire with a pink strip not connected to anything. Touched the wire to the column and key dinger sounded. Where should this wire be connected?
View 10 Replies
Is there a way to grease the steering shaft or whatever is making the squeaking sound inside the cab when I turn the wheel? It's a 2001 F250 CCSB Lariat and it drives me crazy hearing sounds I shouldn't be hearing. This is certainly not coming from outside the cab but rather in the steering shaft within the cab somewhere. How I can lube that up?
View 1 Replies
My 2010 6.4 F250 seems has a loose steering wheel. The steering of the truck hasn't changed nor has there been uneven wear on the tires. It doesn't drift if I let the steering wheel go. Had the front end inspected and was told it's all good under there.
YET, my actual steering wheel is loose. I can grab the wheel and wiggle it front to back and side to side. It FEELS like the bolts that hold the steering wheel to the column are loose. What was the cause/repair? Is this something I can repair myself or a local shop? Or is this a dealer fix?
View 2 Replies
I have a F250 SD with a 6.0 diesel. My steering wheel is loose. I tested and know for sure is not a problem inside the cabin. Fallow the line thru the linkage to the steering box by the left front wheel. I found an adjustable switch there. Just on top of the steering box. It has a lock nut that must be loosen to adjust what it looks like a hex. Very hard to reach. I have watch some Youtube videos but on different vehicles.
View 1 Replies
I've got an 04 f250 4x4 crew cab. I just replaced the upper and lower ball joints on both sides and also the drag link. My alignment was off from the bad ball joints so I had it aligned after I did all of this. Now the steering is really weird. Its like something is to tight. I can barely keep the truck straight because every time I barely move the wheel I seem to be going one way or another and getting it straight is nearly impossible to the point I look like a drunk driver. I can turn the wheel to go around a curve and let go of it and it will stay that way until I turn it back. It won't return itself. I'm kind of lost.
View 3 Replies
I have a 2000 Ford F-250 that I have just replaced the tie rod ends on both wheels. The hole where the tie rod attaches to the right steering knuckle getting wallowed out? When I turn the wheel I can see the tie rod end rocking back and forth.
Now if I keep tightening it down it would pull it down past the cotter pin hole exposing way more threads than any to the other tie rod ends. I've searched everywhere and can't find anything that refers to this problem.
View 6 Replies
So now, what I'm noticing is a bit of a clunk in the steering. It's minor, very minor... but like any problem they usually start that way. The sound is very faint, you can't hear it under the truck, only slightly in the cab but you can feel it in the steering wheel, not so much when driving but when sitting still in a parking spot it's pretty obvious if you rotate the wheel back and forth. You can also feel it in the floor. Sometimes I'll notice this if I hit a bump while I'm driving.
Here's what I know, if you grab the tie rod, either end, you get a slight bit of rotation. Not just one end moving, but the whole thing has a small amount of forward back rotation (I'm not sure if this is normal) I had my girlfriend turn the steering wheel while I checked different components and there didn't seem to be any left right play on the tie rods. The boots look good on the tie rods ends, pic included, looks of similar quality of drivers side.
Then the kicker, here's where I noticed the gobs of grease on the top end drag link, pic also included. This was the last link I looked at, and I guess least expected.
So I guess I'm thinking this drag link is bad, but this is my first stop on the advice train. I wiped off the boot that was covered in grease on the drag link and it looked like its in fine enough condition but I also seriously doubt the shop that added the leveling kit just decided to slob grease all over the outside of this drag link boot. I have my truck oil undercoated before every winter but, that was some bit ago, and this looked more like grease to me.
Truck background: 2012 F250 6.7, I'm at 42,000 miles, 34in tires for most of that, and more recently added a 2 inch leveling kit (40,000 miles) and replaced the suspension all around and added a dual stabilizer. I had some noise coming from the drivers side wheel-well a while back and found that one of the end links on the sway bars was simply loose. Tightened up and all good to go. At 30,000 I got some death wobble. Replaced tires, the stock stabilizer had also gone bad, and had an alignment. Everything good since, but I'm thinking some of these problems now might be remnant of the bad tires.
View 3 Replies
