Ford Super Duty (1999-2016) :: Visor Mirror And Rear Map Lights Not Working - Code P1260?
Nov 27, 2014
So my driver side map light went out, went and replace the lamp. Now I can't turn on the map light when I depress the lens on both front map lights. Both rear map lights don't work either when I flip the switch and the driver or passenger visor mirror doesn't turn on when I flip the mirror cover. Maps lights do come on when I open doors. Also my Home Link (garage door opener now doesn't work). It's throwing a P1260 code (Theft detected vehicle immobilized). Do this might be related to my light issue? Is there a fuse on relay that controls this that might be bad or something needs to be reset? I've looked at the fuses by the passenger floorboard and every thing looks good. Why this is happening?
View 1 Replies
Advertisement
The rear tail lights on my truck have been out for a while now. I wasn't doing much driving at night so it wasn't much of a bother but the new job is getting me home a little later and having to drive with my hazards on is getting old fast.
My radio wasn't working either and I disconnected it a while back hoping maybe it had something to do with my lights shorting out but no luck. It remains disconnected. Just in the past few days my front running lights have went out as well.
I've tested all fuses multiple times (and replaced a couple of them) and checked and replaced bulbs. My brake lights, headlights, dash lights and hazards all work fine. I have the trailer light hook up on the rear bumper and disconnected it at the wiring harness as well hoping it was the problem but it wasn't.
View 3 Replies
In the last 15k miles, I've replaced the led lights on my driver side mirror twice already, and come to see this morning: they are out again. The turn signal LEDs still work, but the parking lights don't work anymore. Passenger side is fine.
View 3 Replies
These are the non-towing mirrors. The truck was pretty well used when I got it; one tow mirror was broken, the glass in the other wouldn't move when I used the switch.
I found a set of power non-towing mirror locally and installed them. They dont work. I tested the switch and the wires at the connectors and I am getting 12v to the mirrors.
So I was thinking maybe it was a ground problem???? Then I took a 12v test light and probed the mirror wires at the connector (clip connected to ground) and then the mirrors slowly moved. I remove the test light and they don't work. Now I am confused.
View 3 Replies
I've done a bunch of searches and can't really find much. The turn signal in my 03 SD doesn't work, and the back side is loose, probably a broken tab. I have cranked the mirror up, down, right and left, popped the tabs loose yet it feels like I'm missing one or a screw. I read that I may have to "Pop" my mirror off to get to stuff. The dealer said I have to buy a complete mirror assembly just to change a freaking bulb on an 03?
View 1 Replies
What is the easiest way to get the side mirror lights off? I'm not trying to break anything so I thought I would ask first.
View 5 Replies
I went to get my front window tinted and the place didn't have the "tool" to remove the rear view mirror and they did not want to get very aggressive with the mallet in fear of breaking the windshield. Has anyone bene able to get any of the "home methods" to work? I contacted a couple of local auto window repair places and they said they wouldn't do it because the windshield "ALWAYS" breaks.
View 7 Replies
I have a 2006 F250 and the other morning I came out and found the rear view mirror laying on the cab floor. No biggie, I'll just glue it back on. Then I noticed the small black decal looking thing on the inside of the windshield. My question is, does this have to come off in order to re-install the mirror with standard Permatex mirror adhesive, or do I just put adhesive on top of it? Also, is there a different, specific adhesive used here that won't crack the windshield 2 weeks from now, like I read. Took a closer look and realized they used a thin adhesive patch to attach the mirror. I'll get one from the dealer.
View 3 Replies
Why there is an electric cord running to my rear view mirror?
View 5 Replies
I bought a 2011 F250 with nav and backup camera. the backup camera only shows in the rear view mirror and NOT in the nav screen. How to program it to show in the nav screen also?
View 7 Replies
I have a problem with my F250 2006 6.0L. I cant seem to get my both fog lights to work. i checked both bulbs are good. I checked fuse 43 an its good. When I turning fog lights on I see a small light that turning on in the panel but the fog lights outside are off. I hear the sound of the relay when activate the switch but I DONT have 12volts + in the fog lights outside? They worked several days ago but not today
View 2 Replies
Last week I noticed my fogs stopped working. So I figured there may be a chance that they were burnt out. Hooked them straight to a battery and they work. Next I checked power at the plugs and no power. Checked the fuse and blown. The only fuse I had on me was a 25 amp fuse. Big mistake. Smoke started coming from the fuse box (palm to the forehead). Well it didn't blow the fuse but still nothing. I got power at the headlight switch and started tracing wires. From what I had read there is relay but it is inside the fuse box? Is this correct. I'm trying to pin point where the problem lies. There aren't any burnt up wires behind the fuse box and now I'm at a loss.
View 7 Replies
80% of the time my parking sensors are always on, like something is behind the truck. 20% of the time they work just fine.
I replaced all 4 sensors today with ones off ebay and I get the same thing.
Anything else I can try before I have to take it to the dealer?
The originals and my new ones all clicked when I put my ear up to them.
View 14 Replies
I replaced the bulb and it's still not blinking and doing the quick blink on the front and mirror bulbs.
The bulb turns on when on parking lights; it just won't blink.
View 6 Replies
I've got a 99 F-250 6.8L V10 manual 4WD with no speedometer or odometer. The ABS and MIL lights are on. Code is P0500 - VSS malfunction.
This started when the previous owner hooked up some large LED backup lights to the factory wiring. Something smoked under the dash. He then moved them to a relay-switched +12V feed. He reported that the backup light fuse did not blow.
Ive tested the backup light fuse and the recently replaced VSS. Fuse is good and the VSS tests ok for Ohms and gives AC voltage when the tone ring turns. I pulled the fuse panel, GEM, and PCM. There's no visible damage anywhere there. I'm stumped. Tomorrow, I'll dig for any melted wiring under the dash....
View 8 Replies
1999 E-350 Super Duty (figured the problem would be the same for van/truck)
Problem: Backup lights don't turn on when in reverse.
Diagnosis: Changed the fused (because it was bad) but didn't fix it. The bulbs are both good. Brake lights, turn signals all work. I understand the backup lights are connected to the Neutral Sensor Switch. To test to see if the NSS was working, I put the van in Reverse and cranked... Van didn't crank (and likewise for D, 1-3).
So I guess the Neutral Sensor Switch works. The fuse works. The bulbs are good. Haynes doesn't have much as far as troubleshooting for this issue. What should I look at from here?
View 7 Replies
2012 f250, fog lights stopped working and tried fixing yesterday. I'm getting 12.8v at the plug but as soon as you plug the light in it goes to 0. Ran a new ground from frame and the hot from plug and still nothing. High beams off, truck running and switch pulled out. Bulb is fine, hooked it straight to battery and it comes on. I though it was a faulty ground but by running a separate ground and still nothing. I'm at a lose.
View 2 Replies
I have a 2006 F250 6.0L Crew Cab 4x4 that started acting up. It started two days ago when I noticed my windshield wipers were only working at one speed. Then today my wife took the truck to work and she said the radio stopped working on her way to work. Then she gets in this afternoon and the ABS light is on, the A/C isn't working, the windows are super slow and the interior lights are flickering. She isn't home yet so I haven't checked the fuse block. Where would you start looking?
View 3 Replies
I just bout a F350 V10, 2008. All is great except for the clearance lights. I took advice from this site....checked the bulbs....replaced the fuse....still doesn't work. There is no damage on this truck. Is there something special I need to do to turn these lights on?
View 2 Replies
I have a 2012 F250 and am having a problem where the interior lights wont come on with the dash switch or when the doors are opened. I have confirmed that it is not a bad fuse, also the lights will come on when the switch on the individual lights is manually pushed, but not automatically like they are supposed to. I dont see it being a door switch issue because the door chime comes on and the stereo goes off when the doors are opened after turning the ignition switch off. I've read that the dealerships will switch out the BCM. I thought maybe the dimmer switch next to the headlight switch but there is no power to it whatsoever, which also I can't dim the instrument panel lights. What did you do to resolve?
View 1 Replies
I have a 2005 F250 that the brake lights are not working when brakes are applied. The rear blinkers and flashers are working. what could be my problem.
View 2 Replies
