After changing my radiator support, my fuel and temperature gauges don't work. I looked to see if everything was plugged in and I don't see anything unplugged. I do know the older trucks used the V-R regulators, but I don't know about this model.
View 2 RepliesMy radio, all gauges and windows aren't working. Fuse 17 did not seem blown but I changed it anyway and still no luck.
View 2 RepliesI have a 2011 Ford F150 FX4, And for a while now i have been having a issue with the gauge cluster.
while driving once in a while all of the gauge cluster turns off then back on within a couple of second. all the lights for the traction control, air bag, engine.... turn on and then turn off just like when you start the truck.
The issue only last for a couple of seconds. And it can go for a day before doing it. Brought it to the Ford dealership and they said unless the gauges are completely off there is nothing to go on by. Also once in awhile the check advancetrac comes on and will be off next time i start the truck. Same thing dealer said there was no codes and nothing then can do.
I checked all the connection at the fuse box, gauge cluster. and no issues. had the truck running and try wiggling all of the connectors, in the truck one by one with no success in duplicating the issue.
Also notice that once in awhile my signal light will flas extremely slow when having the blinker on.
OK, I just got done replacing the alternator on the wife's 05 escape 3.0 V6, after it started on fire. The 3 wire plug was melted onto the alternator, so I had to replace the pigtail. I'm 99.9% sure that I got the wires in the right place. But now, after putting it all back together, it idles sporadically, when I drive it seems almost like it's trying to start out in 2nd gear, and shifts oddly. And there are no dash lights or gauges. Headlights work fine. And everything worked normally before I took it apart.
View 1 RepliesWe have a 1999 F-350 V10 super duty. The alt was over charging and the gauges stopped working. Replacing the alt, the guages still don't work, and the new thing is the charge light and selt belt light comes on. The fuses 29 (5amp)and 30(30Amp) which are supposed to be key on hot only are hot at the same time. With these on, it causes a drain killing the battery. Also if the truck is started, the lights go out, but when you try to turn the vehicle off, it stays running, one with the battery disconnected. The only way to shut it down is pull the fuse box power fuse, 50(amp)Some one had been in the dash before we got this vehicle and busted, burned out or removed the check engine light. I can read codes and their vehicle runs fair and does operate. Could this be a dash board? Also this problem appears when the truck is sitting, and the key removed nothing on. No fuses are blown either.
View 3 Replies2004. Hazards and brake lights work.
View 6 RepliesMy beloved 1995 Dodge Ram Van has intermittent dash panel electrical issues. The gas gauge an speedometer are intermittent, coupled with lights and radio on off too. It It all started when I had the transition services years ago. It has less than 100k mileage.
View 1 RepliesMy father in-law gave us a 1996 explorer AWD with a 5.0 for my son who is 16. A couple of weeks later he's out learning with my wife and a very strong electrical smell took over the cabin. They came right home and when I got in I found all of the gauges not working. The instrument lights work, blinkers work, but all gauges do nothing. Pulled cluster and wires look O.K. behind it from what I can see. They saw no smoke, just smell, fuses look O.K.. What could cook on this vehicle that would wipe out just the gauges?
View 5 RepliesOkay, my 1986 f150 with a 351w (non-feedback carbed) Has no lights on the cluster, and none of the gauges work (haven't tested the speedo yet, truck is not registered yet).
I also have a minor issue with the turn signals... Fronts work, no rears. The left turn indicator light on the dash does not come on but the right turn one does. All my "primary lights" (markers, tail, headlights) work fine. I have not yet tested the brake lights.
Fuses all look good, truck did have some roof leaks. I've done some research, does this sound like the dreaded voltage regulator issue for the gauges?
My assumption for the left turn indicator light is that there is a replaceable bulb in the dash (probably blown), is that right? Rear signals might be wiring (PO installed his own trailer wiring) or bulbs? haven't gotten that far into it yet...
Here's the breakdown. I have a '95 Ford F150 that I bought the previous year and it has been nothing but a problem. The most recent problem is the attempt to turn on the headlights. I will pull the plunger to turn on the headlights but I will only get the parking lights and when attempting to turn on the high beams I still get nothing. The only way that I get any sort of lighting is if I pull on the turning stick (almost like doing a manual override on a tripped wall plugin). Now here's the kicker. I still have parking lights, brake, tail, cab, and dash lights. Winter in quickly approaching and the nights are already getting dark, pretty soon the days will be just as dark.
View 3 RepliesI have a 95 powerstroke and every powerstroke I've seen stock on youtube has a bell instead of a buzzer when key is in ignition or lights are on. The buzz is VERY annoying but I'm bad for leaving lights on so I need something. any way to change buzz to a bell?
View 1 RepliesWhile driving home after replacing a dead battery, clearly I didn't tighten the negative cable enough as it popped off while I was driving (I only found this out after I got home though). But even after popping off, the truck kept going, albeit with the battery gauge maxed out and the dashboard/headlights flickering. I turned off what I could (it was night, so I needed headlights!), but it still accelerated well, and there were no noticeable performance issues at all. When I got home, I tightened the cable, started it up again just fine, ran it for a minute, then turned it off and restarted it fine again with no problems.
My concern is: am I looking at serious electrical issues long term, or should I be ok? I'm just trying to make sure that driving without a negative cable for less than a mile doesn't fry certain parts of the car, and end up causing big issues down the road. (Truck is a 2000 dodge dakota slt)
After replacing my battery cables (Pos and Ground),My Truck stalls every time I turn on the headlights. The truck stays running with the parking lights on or if no lights on at all. Could I have mixed up the 2 positive accessory wires?
View 13 RepliesI got my Alternator replaced last week. Last night, I hit a very small bump, not even large enough to really cause me to slow down, and as soon as I did, my battery and brake lights came on. My RPM gauge also jumped around and eventually went to 0 until I stopped and put the car in park. (The bump might just be a coincidence who knows). So after all this happened, I turned off my car, tried to restart and got nothing. Sometimes I get a click, sometimes 2 clicks up to 4-6 consecutive clicks. Every few times I won't even get a click, just a slight attempt to start, then the car dies, then 2 seconds later all my lights and radio etc. come back on. My problem here is a few things:
1. I've been told it could be the starter. If it's the start, those dashboard lights shouldn't have came on right? just the STARTING portion of the car.
2. I've been told it could be the battery.
Well If i got my alternator tested and Advance said it was working, Why would my battery be dead? And if it WAS dead, wouldn't my lights have went dim or something else happen to the car?
95 ford f250 with 5.8l. I have currently replaced the battery, alternator, distributor, cap, rotor, icm, coil, plugs, wires, act sensor, ect sensor, fuel pump, fuel press regulator. I got it to start today by messing with timing at distributor it ran to operating temp and died. Would crank but not start.. So I replaced the act tensor today.. Now it still won't start... koeo test gives code 327... I am stumped and about to tow it away...
View 11 RepliesThe red wire coming from my fire wall is not connected to anything and I need to find what it is supposed to connect too it come out of my firewall near my steering column ... This is and 95 f150 with a 302 engine ...
View 1 RepliesI don't know if this goes here but I ha a ford f350 king ranch 2006 I got it 5 months ago the fog lights never did work. One of them was burnt out.
I replaced them both today and checked the fuse and they do not come on. I checked the fuse under the dash kick box. What else could be going on here hat I can look into?
I recently purchased a 95 F150 regular cab. The door jamb switch on the drivers side was broken. I removed the inside kick panel and found the switch badly burned and the wiring also burned. I purchased a new switch and found the socket with wires at LMC. The question is where do the wires go? Can I splice them in somewhere?
View 3 Replies03 F250 Instrument panel does not work. Have checked all fuses with a meter. Have already fixed broken wires from the OD button on shifter handle. and also the alternator is not charging. I need wiring diagram that shows the wires coming out the back of the fuse box so I can see if the fuse holder is burned out......
View 8 RepliesI recenty was having some problems with my 2003 6.0 liter. My FICM connection was not seated all of the way which casued my truck to just die without warning....... AFter I had fixed that, my stereo died. Just dead??? Nothing...EVERYTHING ELSE WORKS???
So, after I had messed with everything I could think of, I thought, OK new DVD/Stereo time.
I checked fuse #32 which was the fuse to my stereo. The fuse is fine...BUT...There's no friggen power to the fuse via my test light. Test light works on other fuse spots so I know i"m not getting power to the fuse #32.
Since I don't have any power to this fuse....WHAT NOW???? How to trouble shoot this problem?
I recently bought a 92 F250 and love it but the blinkers will not work. I have replaced both flashers and the multifunction switch. (the wipers had issues too that were fixed by the switch...) Now what? Im at a loss..
View 7 Replies