Ford Wiring/Electrical :: 4x4 Light On The Dash Has A Small Delay
Jul 6, 2013
When the 4x4 switch is moved to 4x4 high, what is the sequence of operation?
I note the 4x4 light on the dash has a small delay. Does the switch engage the transfer case and draw a vacuum to the hubs or does the transfer case engage first and then close a relay to light on the dash and engage the hubs? I have hubs that are not working, but no detectable vacuum leak, a dash signal lit for the 4x4, but a wheel still turning freely. My vacuum hoses are all soft and pliable.
I'm trying to figure out what my dash signal is telling me, if anything, before proceeding. Fuse for transfer case is good.
View 5 Replies
Advertisement
My Viper 2 way alarm, instead of the brain being wired to each of the 4 doors individually. The installer ran 1 wire to the dome light. Seems to work fine as far as arming/disarming/locking/unlocking, but since the dome light stays on for 10 seconds or whatever after the door is shut, when i arm it.
The 2 way remote says "door open" because the light is still on so it thinks a door is open. this eventually times out and all the sensors arm, but there's a long delay. it arms fine and no alerts pop up if i lock the doors first from the outside keypad on the door, making the lights go off, then hit arm on the viper, and everything is good to go.
Can I change it so no matter what, as SOON as i shut the door, the light goes off? I want there to be NO delay, if possible. If not, I may need to just have the installer run a wire to each door and take the single run to the dome light off, as it is sorta annoying to me.
View 1 Replies
The battery light is on in my dash. To test it I probed the car battery with a multimeter. Car off the battery reads 12.5 volts. With the car running and no headlights on, heater fan off, etc the meter reads 15-15.5volts. When I turn everything electrical I can think of on the meter reads 14-14.5volts. Is this normal or is the second scenario overcharging the battery? What else can I test that may be keeping the battery light on in the dash?
View 6 Replies
What the code "32" means for the airbag? Lately my airbag light on the dash will blink 3-2 for several cycles then stays on solid til I shut down the truck.
View 12 Replies
Okay, my 1986 f150 with a 351w (non-feedback carbed) Has no lights on the cluster, and none of the gauges work (haven't tested the speedo yet, truck is not registered yet).
I also have a minor issue with the turn signals... Fronts work, no rears. The left turn indicator light on the dash does not come on but the right turn one does. All my "primary lights" (markers, tail, headlights) work fine. I have not yet tested the brake lights.
Fuses all look good, truck did have some roof leaks. I've done some research, does this sound like the dreaded voltage regulator issue for the gauges?
My assumption for the left turn indicator light is that there is a replaceable bulb in the dash (probably blown), is that right? Rear signals might be wiring (PO installed his own trailer wiring) or bulbs? haven't gotten that far into it yet...
View 8 Replies
I have a 1981 F100, lately when I've been driving at night I notice my headlights, dash lights, and charging light will flicker at the same time, and even sometimes my headlights will flash on and off by themselves.
View 2 Replies
So heres the deal 1989 civic dx hatchback 106k on the odometer automatic 1.5l d15b2 engine . It's been having delayed starts taking 3 to 6 cranks before firing up then running fine, suddenly it dawned on me maybe it was the distributor , so I swapped it with a spare I had because sure enough the old one had red death red dust in the cap. Cleaned the contacts set the timing reassembled, some wires broke on the back of the wiring harness to the distro. Rewired them, the car kept getting worse I jumped it and took it to my friend a vw mechanic it drove 49 miles there fine after the jump, new plugs new wires new fuel filter we did the wire job set the timing checked the timing belt got the battery tested and the alternators new and did a oil change also did a coolant flush a few weeks ago.
It started right up drove it back to Chicago , in the morning I was getting off the highway it stopped running no noises I pulled over 8 cranks later it started parked it 3 blocks away, went to test drive it when I stopped at a light it shut off cramming it and hitting the gas pedal got it to start drove it a block down it shut off at a stop sign and I parked it. What it is I'm throwing code 8 which is a top dead sensor which I think is in the distro which I replaced a month ago. Fuel pump sounds like its priming but you have to gas it and crank it to start it which is odd for a automatic , it is girk injected is this tds sensor going to do that by itself? Or could it be a ignition module? ( what I read online) starter? Main relay , fuel pump switch?
View 6 Replies
1980 F-250, 351M. Battery tests OK - 500 cold cranking amps. New starter, new starter solenoid. When I turn the key to ignition, small click under the hood on driver's side. Turn to start, the starter solenoid clicks once, but no turnover. After that, all electrical is dead - no lights, no horn, no radio, no clicks. Turn the key to accessory, gauges work, but no radio, etc. Turn the key to ignition, nothing. Tried jumping from another car, and the cables melted.
View 7 Replies
My beloved 1995 Dodge Ram Van has intermittent dash panel electrical issues. The gas gauge an speedometer are intermittent, coupled with lights and radio on off too. It It all started when I had the transition services years ago. It has less than 100k mileage.
View 1 Replies
I have a '95 dually and it has small yellow running lights on the rear fenders. The only time those lights will come on is when the headlights are on (or parking lights) and I put it in reverse. Not sure, but I would have guessed they are supposed to on when the lights are on and go out when the truck is put in reverse.
View 5 Replies
Need a wire diagram. I have a connector in the cab that has red,blue,lt green,white wires. It's causing my brake lights not to work. I need a wire diagram that shows were they go. I can't find these wires in my Haynes manual.
View 3 Replies
I am trying to add courtesy lights to the existing reflectors in the front doors of my supercab. I can't find a wiring diagram that shows where to connect the light sockets. 1999 F250 SD...
View 2 Replies
I have a 1991 idi diesel f250. My dash lights have entirely gone out and i cannot seem to figure out why, i checked the fueses under the driver dash and under the hood for that matter and nothing is blown.
At the same time, the dome lights, door lights, cab lights, stereo, windows, ever the light in the ash trey etc, work perfectly fine. Could a wire have come loose behind the dash cluster and shorted out everything in the driver area?
I still get the high beam signal, check engine, engine, wait to start, and water in fuel light in the cluster. but no back lighting (when turning the key to the on position)...
View 1 Replies
I have a '84 Bronco and before I redid all the ignition wiring when I turned off the key the engine would stay running for about 6 seconds and then turn off. Now when I turn off the key and turn off a switch about 6-8 seconds later I here a click sound that comes from under and about center of the dash. And sometimes it clicks on and off in rapid secession kind of like when you flip a light switch on and off quickly. Some days it does it and some days it don't.
If I leave the battery hooked up then it drains the battery overnight or within a day, and sometimes its just fine. So to be safe I unhook the battery whenever its not being driven or started periodically. I am wondering what is in the center of the dash that needs power and that controls the ignition stuff?
View 5 Replies
Dash lights are not working in my 78 F150. The climate control lights come on and are dimable with the headlight switch. I pulled the cluster and the Blue/Red wire has voltage. Which might be the ground? The Seat belt light comes on at start and the left turn signal will blink. What am I missing. Oh the cluster is deteriorating. some of the bulb holes are chipping out.
View 1 Replies
I have an 2015 450 chassis Class C motorhome. The backup camera is integrated into the Pioneer stereo in the dash. The stereo is wired into the headlight switch to automatically dim the display when the lights are turned on. Since I always drive with my headlights turned on, this makes it nearly impossible to see the screen during the daytime.
I learned from Pioneer what to do to disable this feature, but need to install a switch in the circuit to do this. I'm hoping to install a simple on/off toggle switch into the dashboard's existing space. In the picture below, I'm wanting to put the switch into the "round" hole marked Audio Jack.
My question is how do I get the "round plug" out of this hole? And need to know the diameter of the existing hole?
View 4 Replies
In an attempt to bleed my drivers side caliper today I noticed clicking coming from the #2 relay switch under the dash. The clicking stopped once I pulled out the relay. I continued to bleed my caliper which I've been having issues doing so. It was kinda odd how I was able to bleed the caliper after pulling the relay. Is it possible that the [email protected] system could be causing issues with the pcm? 2000 f 150 4.2 v6 232,000 miles .....
View 9 Replies
I have a trans temp gauge on my 1996 F350, I have it all hooked up and functioning except for the light. I have searched without success looking for where to splice in to get the light on and have it dimmable. I have a wire routed from the gauge to the center of the dash behind the stereo. What wire I can splice into?
View 2 Replies
Really need diagnosing an on going electrical problem I'm having. It's on a 05 X 4x4 V10 with almost 113k miles.
Background : Last summer took a road trip and alternator went out and was replaced. On that trip started seeing problems with my cruise control, when the headlights(HID's) turn on they dim the dash, and hi's cause the speedometer and other gauges to quickly flux and then go back to proper readings.
Everything was "alright" in the sense that the only problems were those stated above. Well tuesday night on my way home from school, I was driving on the surface streets, stopped at a light.....then all of a sudden the battery symbol on the dash flashed and no more than a second later, the car stopped. All dash lights/radio (double din) still on and headlights still on, but couldn't start the X at all.
Was able to wait a bit and once my parents got there it did start and I was able to pull off to the side and diagnose it a little better, dad looked at it and at the moment couldn't really tell what would be wrong. I had him drive it home for me though. It's been starting fine again but I have NO CLUE as to what to look for and really would like to find out what's happening.
View 2 Replies
2003 f150 supercrew with 166,000 on it. Daily driver. Keeps randomly blowing 10A fuse under dash that controls ABS4X4 urn signals. No routine causes. Just blows at random times. Fuses were blowing instantly upon replacing then stopped. Doesn't blow when turning switches for turn signals or when turning it to 4x4. Just does it randomly. Sometimes will go months without blowing. Tore dash apart and can't find any wiring issues there. Could be somewhere else? Is ABS4X4. Turn signals going bad?
View 6 Replies
Looking for a schematic on this truck,standard cab diesel. I have a dead short on exterior lamp fuse. I have no tail lights, running lights, door ajar light is also on.
View 4 Replies
