I am trying to add courtesy lights to the existing reflectors in the front doors of my supercab. I can't find a wiring diagram that shows where to connect the light sockets. 1999 F250 SD...
View 2 RepliesNeed a wire diagram. I have a connector in the cab that has red,blue,lt green,white wires. It's causing my brake lights not to work. I need a wire diagram that shows were they go. I can't find these wires in my Haynes manual.
View 3 RepliesAny COMPLETE headlight switch wiring diagram? Everything I find online only shows 2-3 wires in each sub connector, nothing with all wires and colors, and what they do. and of course the factory service manuals no longer work on my new computer. the switch and associated wires went up in smoke 2 hours ago, and this truck is my only means of transportation rite now. what i need is headlight wiring with colors so i can temporary hook up a toggle switch to have lights until the new switch and connectors come in next week. I went to pull the switch and connectors out of the parts truck, but of course that does not have fog lights so it uses different switch and connections.
View 14 RepliesLooking for a source for a wiring diagram for the 2003/4 f350 instrument cluster, specifically the wiring/connectors to the gauges? A link to a PDF file would be nice. I would like to try and disconnect the PCM control to the transmission temperature and engine temperature and drive the gauges from my own sensors to bypass the non-linear behavior that ford decided was in our best interest. I am NOT interested in installing any more gauges, just want to control the ones already present with my own signals. It is possible that these gauges are all addressable devices on a common bus, instead of individual controls.
View 8 RepliesLooking for a wiring diagram for a F-150 XLT LARIAT 5.8L 4BBL, all the books I have looked at show the wiring for this year with fuel injection and this truck came with a 351W with a Holley 600 4BBL, I have a few wire's in the engine compartment that melted away all the insulation, they are located close to where the harness passes the firewall before the ignition module. Is this a common problem on old models ?. Need a clear copy of the correct diagram for a f-150 1987 with carburetor, how I can get a copy so I can fix this problem before it gets worse.
View 3 RepliesI am curious if it is possible to make a stand alone controller for the electric shift transfer case in a 2000 F-350?
The reason I ask is, this is swapped into a 4x4 conversion in a van and I would like the transfer case to work like the factory, but I don't want to swap over the whole GEM module. I have the high to low and low to high shift relays and wiring, the selector switch from the dash.
I know that powering up the relays will shift the transfer case, but the GEM module tells when the relays need to shut off, and that is where I am not sure what to do. I am assuming that the other plug on the shift motor (6 pin plug) is the sensor that tells the GEM module where the shift is at.
What needs to be done (with a bank of relays).....
I'm trying to find the wiring diagram for the power windows in a 96 f150. I've got a set of these that i need to fab a harnes for to install in my 82.
View 12 RepliesWhere can I find/buy a wiring schematic for a 2012 Ford E350 with the 5.4 L V8?
View 1 RepliesI have a 97 F250 HD. Wiring the rear tail lights. When we bought it the had cut off the wires going to both sides of the rear lighting assemblys and I was wondering what wire went to what i have the left turn signal working just can't seem to get the brake/back up light to work on that side and i can't figure out how to get the right side going either.
View 8 RepliesI have a 99 f450 and my door ajar light is on. Where is there a door sensor for that so I can turn it off.
View 7 RepliesI just bought a hard to start 1990 F250. Per the board, just replaced all 8 glow plugs with Motorcraft. Still wouldn't start (it turns over but will only start if you use either). I attempted to install a new BWD brand (Borg Warner I believe) glow plug connector relay today...I removed the old no problem, but am unsure what wires to plug where....the only connection that I'm sure about is the blue wire that works the WTS feature...it plugs in easily but I don't know if there are other connections that need to be made or not? All the wires run from the posts and into the bottom of the unit.
View 2 RepliesMy door will not lock..when you hit the remote, the door button or try to push it down..it goes down a little and there is resistance and then it comes right back up. If I use the key it will lock easily, but once you turn the key to get it out it comes right back up. I can hear the motor working, but it feels like there is something stopping it from going all the way down.
View 1 RepliesI have a new to me 1999 F250 with the 7.3 engine. The previous owner installed a push button start to get around the ignition actuator being broke. Over the weekend I pulled the column and replaced the actuator but the truck will still not start with the key; with the push button it starts just fine. I'm not getting any power on the starter relay signal wire, so I suspect something in between the key and starter relay. I searched around a bit, but could not find a wiring diagram for a 1999 diesel super duty.
View 3 RepliesI have a 98 F250LD the problem I'm having is that my door dings when open and no key in the ignition. It only stops if I put the key in and turn it to run.
View 1 RepliesFirst, need a wiring diagram for the outputs on the back of the brake controller module? I want to check and see if there is a problem with the connection to the rheostat. I can activate the trailer brakes with the slider bar but not with the brakes.
Second, where I can get a new OEM controller that will replace my old one if I can't "Cypher it out"?
Only numbers 1,2,5 match the diagram below. my 6,7,8 are BK/W, PK/B, BR/PK. My Sony CD player came with bare wires. So I could cut off the truck oem plug. How hard is it to find a plug that goes from my OEM plug to my Sony CD player?
View 10 RepliesMy dome light does not work and door ajar light is always on. I cant even turn the light with the switch on the side. Just don't know where to start. Do you think it is a switch on one of the doors? I have tried spraying cleaner and WD40 in there but it has not worked. Its been this way since I bought the truck but it is starting to drive me crazy....
View 2 RepliesI have a '97 F250 diesel and the battery light keeps coming on and off. The volt meter shows a good charge. How do I fix this?
View 4 RepliesMy 02 F250 is killing batteries. Also, when I try and lock the doors with the door lock switch, the doors lock then the driver side door almost immediately unlocks.
View 6 RepliesI just purchased a 2006 E-350 15 passenger van. ~85000 miles. As soon as any door (except the very back door) opens, the dome light comes on, as expected. However, when you close the door, the light doesn't go off. There are two ways I've found to make the light go off:
1. Reach a speed of 10mph
2. Wait several minutes (i haven't timed it yet, maybe 10 min?) without opening a door
I've read that the keyless entry remote can control this, but this van isn't equipped with keyless entry. There must be some factory setting that can be adjusted. Also, any thoughts on adding an aux jack to the stock AM/FM/CD stereo? Maybe I should bite the bullet and install an after-market deck?
I have a '99 psd f250 crew cab lariat, I just purchased seats from a 2005 F350 that are lariat heated and power. My seats are power but non heated is there a way to hook everything up.
View 3 Replies