GTI 337/20th Anniversary :: Strut Broke - Replace Front Suspension


Jun 23, 2013

I busted a spring and apparently a strut. The mechanic said I'd need to replace the front suspension, and offered to do it for 1000$ which I thought was very high. Now I am debating whether to simply get a cup kit or coil overs. I am leaning towards the cup kit to save money. Now I am curious what you guys think regarding the H&R cup kit and where I could get the best deal on them.

View 23 Replies

Advertisement

GTI 337/20th Anniversary :: Noise From Front Suspension When Backing Out Of Garage

Noticed the other day when I was backing my GLI out of the garage a clunking or popping noise that sounds like it's coming from the drivers side. It only doesn't it once and only when I am backing out and turning at the same time like out of my garage or parking spot at work. My car has roughly 54 thousand miles on it and still the original suspension.

View 10 Replies

GTI 337/20th Anniversary :: Stock Suspension - Right Front Rubbing On Hard Turns?

I have a 20th with 106k on it and I notice mostly my right front rubbing on hard turns. Suspension is totally stock other than a 28mm rear sway. Is it possible that's causing it or is my suspension just getting old? No spacer on the fronts.

View 9 Replies

GTI 337/20th Anniversary :: Tensioner Pulley Broke

My tensioner pulley broke yesterday and I replaced it. But it had broken 3-4 months ago also.

View 2 Replies

GTI 337/20th Anniversary :: Broke Dipstick Sleeve

I was checking my oil level and saw that it was broken. I have to drive about an hour each way home tomorrow. Is this a bad thing to do, or do you think I'll be ok? I have no time to fix right now and only mode of transportation.

View 2 Replies

GTI 337/20th Anniversary :: Water Pump Broke

my water pump broke they other day and then i was lifting up my seat and notcie it was wet. the whole left side of my car under the carpet is wet. why do you think there is water is only on th eleft side. could it be becuase the water pump broke??

View 19 Replies

GTI 337/20th Anniversary :: O2M Shifting Fork Broke Again

Trying to find if any updates to this problem. Just broke a second fork yesterday- only issue I've seen is to simply replace with the same brass fork.

View 10 Replies

GTI 337/20th Anniversary :: Rear Strut Mount Noise When Cold?

Is this possible? I recently installed raceland ultimos and I get this weird muffled noise from the top of the rear suspension. Took it all apart, cut the bump stops shorter, and lubed the strut mounts. Sound went away for about 10 mins of driving, went for another drive and the sound was back. The next day the weather was warmer and the noise was gone. Should I just get new strut mounts?

View 6 Replies

GTI 337/20th Anniversary :: Hood Release Cable Broke

went out after checking out the cheap mod thread (to see what I can mess with), went to pop the hood and nothing happened. I've looked all over vortex and I cant find anything.

View 3 Replies

GTI 337/20th Anniversary :: Coilovers Installation - Lower Strut Mounting Bolt Seized

I am installing my coilovers on my gli and I have everything installed but the passenger side coilover. I cant even remove the old strut because the damn lower strut mounting bolt is seized and I've been trying for hours to remove it at no avail. I have used pb blaster, my heat gun, and my sweat. I dont have impact tools, just my ratchet..

View 15 Replies

GTI 337/20th Anniversary :: 2003 - How To Replace The Running Lights

03 20th anni.... MFing light bulbs are driving me crazy.

View 3 Replies

Prius (2010-12) :: Front Suspension Popping Noise - Strut Replaced?

So I replaced the front strut and the popping is still there. When I removed the old strut it seemed like that would be the problem as there isn't any play in the ball joints and tie rod end.

View 12 Replies

Elantra MD (2010-15) :: 2013 Suspension - Flat Noise Coming From Front Like If Strut Was Out Of Air

Every time I am on the road I get this flat noise coming from the front like if the strut was out of air or something like that. It is a very annoying sound and only on certain bumps of the road.

View 6 Replies

GTI 337/20th Anniversary :: Quack Like Noise When Suspension Is Compressed

The front passenger side is making a quack-like noise when the suspension is compressed. it only happens after the suspension has had some time to warm up, but once it does, i am able to push down on the passenger side fender and hear it, in addition to hearing it over bumps, etc.

I just had the tie rod end replaced on that side, and that was well after noticing the noise (but not intended as a fix for the noise). when i press on the suspension myself, it seems the sound is coming from an area closer to the firewall than the strut tower. i'd say the sound is pretty audible inside the cabin.

What it could be? lca bushings? subframe?

View 3 Replies

Ford Brakes/Suspension :: 1997 F250 - Front Tire Chains Broke And Ripped The ABS Wire

I have a 1997 F250 Light Duty with a 5.4L and 4 wheel drive, 216,000 miles. Last year one of my front tire chains broke and ripped the ABS wire. I have soldered them back together and no longer have the ABS light illuminated in the dash. However, when I apply the brakes at speeds slower than 25 mph, the ABS pulses. Over 25 mph the brakes work as they should until almost stopped and then they pulse.

View 1 Replies

GTI 337/20th Anniversary :: Squeak Noise On Passenger Side Suspension

I have had a bad squeak on the front passenger side suspension. It only happens while you are pulling into a driveway, going over a speed bump, or driving slow on a bumpy road. I brought my car to my mechanic and he thought it was the control arms that were shot. They were changed after forking over some cash. I noticed right away the handling was better due to the control arms which is said were shot. But... the squeak is still there, and has not become lower sounding at all. He said it might have something to do with the suspension but it is not worth it to change all the parts.

View 11 Replies

Ford Brakes/Suspension :: Replace Front Springs With Airbags

I am lowering the front end of my truck 3" using DJM Dream Beams. I have cut out the rear springs and replaced them with a four link lowering it 4" and installing an air bag suspension. I would like to run air bags up front, as well, but haven't been able to find much about that. What size to use?

View 7 Replies

Lexus LS 2007+ :: 2010 - Noises Coming From Rear And Front - Replace Suspension?

I bout a 2010 AWD LS460 in July and immediately noticed noises coming from the rear and front. The rear was a loud thud going over certain bumps and the front is making rattling noises. I lowered the windows and went down a rather bumpy block and the car sound like the bottom is falling out. I took it to the dealer and they had it for 2 and 1/2 weeks waiting on the rear air shocks to come in. They gave it back to me and did not address the front. Now the service manager is going away for two weeks and wants me to come back if I still feel the need to have the from done. The master tech stated the front left suspension needs replacing. I feel they are trying to drag this out so they dont have to pay for the repairs. The car has 80K and was bought from Bay Ridge Lexus and is not under CPO.

View 13 Replies

GTI 337/20th Anniversary :: Clunking Noise In The Front End

well what are the chances that all in one week.. I would get my front end hit in the same spot that i just fixed.

get a crack in my windshield.

get a flat tire.

Have the tab that holds the passenger sun visor in place break off.

Have a new "clunking" noise in the front end.

View 9 Replies

GTI 337/20th Anniversary :: Removing Front Valance?

I got a question..how do u remove the front gli valance?

View 4 Replies

GTI 337/20th Anniversary :: Front End Is Frozen - Cannot Loosen The Nut?

Went to lower my front end today and after trying for 15 min the nut directly under the spring was frozen. i sprayed it with PB blaster let it sit for like 20 min, kept on spraying it during that time. tried adter that and still did not budge a mm. even tried with a flat head and a hammer trying loosen it. did not work. was wondering if there was any other way i can get it loose?

View 8 Replies





Copyrights 2005-15 www.bigresource.org, All rights reserved