Golf IV / Jetta IV :: 2003 - While Shifting Making Grinding Noise - Clutch Or Engine?
Jul 21, 2016
noticing a few issues with my 2003 jetta 2.0 when driving/shifting....so first main thing I noticed is when shifting from 1st to 2nd gear often times it will make a grinding sound and not shift smoothly from 1st to 2nd....you have to do it real slow/gingerly ...if I short shift from neutral to 2nd its fine or if down shifting to 2nd its fine...I have changed the gear oil...other sounds idk if its my tranny or engine but if going up hill and you throw into 3rd and not going fast enough its makes a rattling sound and is sluggish I know its a old car 177,000 miles so idk just curious if this is a sign of problems?....Last thing after driving and getting home and putting into reverse gear to park it makes a noise like a chugging sound when reversing and can be finicky going into reverse.
View 1 Replies
Advertisement
Just picked up a 2003 Ranger XL 2.3L and notice that I get a little grinding every now and then when shifting into 1st gear. The clutch was replaced 3 years ago according to the PO but had no clue as to how long it's been since the clutch was bled.
I've used my Motive pressure bleeder numerous times in the past on brakes with much success but I've never used it on the clutch. I've used vacuum bleeders as well but it's always a 50/50 success rate with that. The pressure bleeder just works much better for me.
Using a pressure bleeder on a clutch and if so any tips like still needing to tip the master cylinder end up to release any potentially trapped air bubbles?
View 5 Replies
This just started on me not even an hour ago. I hit my switch and the window will go down all the way and the motor will continue running making a grinding noise until I hit the switch again. Same as when it goes up all the way. It stops at halfway and makes the grinding noise until I release and press the switch up again. Is this just the motor teeth going bad or are the cables getting frayed out possibly? Haven't had time to tear down and inspect yet.
View 4 Replies
2000 GTI
260,000 miles (60% highway)
2.0L 4cylinder AEG
All stock.
I have a new issue developing on the clutch of my car. When I fully press the clutch pedal to change gear, I hear cacophony of grinding, hissing and whirring noise, probably coming from gearbox. When I take my foot off of the clutch pedal completely, the noise is gone. half clutch has reduced amount of these noises. I had this symptom briefly one night two weeks ago and when I topped up oil, this was gone. Tonight, it is back.
View 10 Replies
Our 05 Corolla, 160,000 miles, has started making a grinding sound when we upshift into 3rd, unless we let the rpms fall to below 1000. My husband said the clutch needed adjusting, but the dealer said this clutch is not adjustable. The dealer found nothing wrong and could not get the car to make the noise while in the shop. (It did actually get better for a while but got worse again almost immediately after the visit to the dealer.)
Our other car (a Saturn) has over 250K miles on the original clutch, so I don't think it's our driving. What could be wrong, and is this something that needs to be addressed soon lest we damage something irreparably? Also, this car has, since purchase, been nearly impossible to shift on the coldest mornings. Really, sometimes it is all I can do to get the lever in reverse to back out of the drive in winter (in Kansas). Warming up works, but it seems to take an inordinate amount of time before shifting is"normal."
View 3 Replies
My 04 GX has about 113k on it and the A/C clutch is shot, making a ton of grinding noise when its engaged (when the A/C is on).
Need to repair or replace there unit because of this? I see online the ability to buy just the clutch pack for the A/C compressor. However Lexus and other sites want to sell me the whole A/C compressor.
Question being, can I get away with buying the clutch pack and installing it onto my OEM a/c compressor? Or do I buy a new compressor?
View 2 Replies
I have a 1987 Camaro with a 305 TPI V-8, with a 5-speed manual transmission. I rebuilt the transmission, and installed a new clutch, pressure plate, throw out bearing, and had the fly wheel ground (which the machine shop said that it took very little material off to get clean-up). When we first got the car running when the car is moving in any gear (even in neutral) with the clutch peddle down, I get a rotary grinding noise (but only about 30% of the time). If I let the clutch pedal up the noise stops immedately. The transmission shift smooly, in all gear selection. I thought that I had gotten a bad throw out bearing, so we installed an other new throw out bearing, but I get the same noise. Is there something that could cause this noise inside the transmission?
View 8 Replies
I have about 350 miles on my new jetta and i will like to know if its just me or did everyone with a manual go through the same, i feel that up shifting at higher rpms like 4k i feel like the clutch is grinding i actually feel it in the pedal, I haven't gone higher than 4k due to break in period. I also notice that there is no engage while getting out of first almost like its slipping but it is not, i have driven manual most of my life so i know i am not slipping the clutch.
View 4 Replies
I have a 2003 1.8t jetta. I got it in the fall and never really needed to turn on my AC until this week. It works, fans work at all speeds, blows ice cold air.
But i noticed today that my fans can be on and nothing. But when I hit the AC button there's a loud rattling sound. Everything works. It's just making noise when the AC is on. Whenever I turn it off the noise goes away.
I tried looking it up and couldn't find anything.
View 1 Replies
My car has 130k miles and has recently developed a worrying noise. It makes an extra whirring sound, like another set of gears spinning, but I don't think I would describe it as a grinding noise. I live in VT and I thought maybe it was my (studless) snow tires making more noise in the warm weather because I noticed it about a month and a half ago when it warmed up. Now that I have my all season tires on, it's still making the noise. The tire guys didn't notice anything wrong when the swap happened (but they only do tires there and I didn't ask them to look for anything).
As far as I can tell it is dependent on wheel speed, not engine speed. It starts at about 20-25mph and gets louder the faster I go. At about 65 the normal road noise is louder than the new noise. If I turn the wheel to the right to any degree the noise goes away. I can't tell if it is completely gone, but it seems like it is. There is no real change if I turn the wheel to the left, though it might get slightly worse. When the noise is going I can feel a vibration in the floorboard that matches the sound. The sound seems like it is coming from in front of me, but I can't really tell if it is left, right, or center. As far as I can tell that is the only new noise, no clicking/griding when I turn the wheel etc.
I'm taking it in for normal 130k maintenance in a week....
View 3 Replies
2003 vr6
Belt squeal but when I have clutch pushed in no noticeable noise.Abs kicks in at low speed stops. I sprayed the belts with dressing noise went away momentarily actually sounded like it could have killed it almost. Right now I have the and fuse pulled to just get me by.
View 2 Replies
I found out that the bearing in the compressor clutch is the one making my car sound like crap... but I have been looking for it and everywhere I call they only sell the whole compressor that is expensive. I was thinking on get the clutch out and lube the bearing up or something but I don't know if I have to discharge the freon for doing it ... How to remove the AC clutch ?? Its an mk4 btw....
View 4 Replies
My 05 Jetta TDI is intermittently making a rubbing/grinding noise. Not in stop and go traffic but when I come to a stop at a stop sign, but only just before I come to a complete stop, not as soon as I hit the brakes. The shop that put the brakes on (about 18000 miles ago) looked at pads, rotors and pedal but said it's all fine. Could it be the booster, abs, or something else completely?
View 3 Replies
Searched through old threads but didn't come across these in particular, a lot to look through so may have missed in Car has 270 miles on it.
1) When clutch is in all the way and the car is revved, I can feel it in my left foot. This can be felt when car is stationary or in motion - Is this common for MK6/R? I don't recall being able to feel this in my MKV GTI
2) When the car is in motion, I hear a knock noise right after the clutch is pressed in. I can only hear the noise if windows are open and stereo is off, and this only occurs while the car is in motion. - Is this a standard clutch noise for healthy clutch/pp/flywheel/throw-out bearing on this platform, or should there be no noises? It sounds like something I'd expect to hear with a messed up throw-out bearing.
View 7 Replies
The other day I hit a good size bump at speed, slightly bent a wheel which I didn't even notice at first. The car drove straight and had no other symptoms, thought everything was okay. A couple days later I heard a weird grinding noise while making a left hand turn, it was so faint I honestly thought it was the fender liner. After the noises continued and further examination I noticed that the carrier is rubbing the rotor on the lower drivers side corner.
View 1 Replies
I have a Subaru Baja 2003 with only 48,000 miles. It is a manual transmission.
My question has to do with the clutch (I think). If I am driving with the windows down and have something beside me that reflects noise ( a big hill, a wall, etc.) when I shift from first into second or second into third I sometimes here a "Creek" sort of grinding noise. I do not have to be moving the shift hence why I assuming it is the clutch. The noise is not bad, as I said I can only hear it occasionally and when I am next to something that reflects sound.
My questions are: Is it the clutch? Is it something I should have fixed or should I wait until it gets worse? I am not sure if fixing a clutch is expensive period or if there are some interim steps to a repair that prolongs the clutch and saves money.
View 2 Replies
My car is a VW golf GLS 1.8L Turbo 4dr Hatchback with a manual transmission, and has had modifications to the intake as well as the exhaust. Recently the clutch would grind every time I shifted gears and let go of the clutch. When I would let go, there would be a grinding noise that I could feel at my feet, but the car would still go albeit a slower rate. I could eventually reach a higher gear and then drive normally around because the grinding would lessen as I shifted to higher gears. In addition to the grinding, there was a faint smell of burning coming from the front left wheel. I was wondering if this is because I need to replace my clutch?
View 2 Replies
Here is what happened. I bought the truck used a few years back. The A/C clutch always made a clunking noise when it engaged first thing in the morning but then when restarting later in the day no noise. No noise either once it started up, the compressor ran quietly.
Then I recently went camping, it was just this past weekend and we had a bunch of rain. So I had on the front defrost mode on the heater for the windshield. I let the truck idle for about 15 minutes. The wife noticed that the truck was overheating (I have a Taurus fan installed and the fuse blew on the controller thats another story for another time, I got that fixed. I think it was because the clutch was trying to engage but couldnt and it made the fan controller overheat and the fuse blew) So I popped the hood and it was smoking under the hood. So I turned off the defroster and hear some noise under the hood. The AC clutch was not engaging when on the defroster mode and is making a clunking/grinding noises all the time now.
When I returned home I checked the fuse for the AC clutch and it was blown. So I replaced the fuse and it engaged the clutch by turning on the A/C, the clutch engaged and the compressor sounded fine and the clunking noise went away, it also blew cold air all the time the A/C was on, with this it looks like the compressor is fine.
Then I tried the defroster setting again to simulate what had happened at the campground and the clutch was engaging at first then started to slip and I could smell it burning. So I shut it off. The A/C clutch is still making a clunking /grinding noise noise and wont engage at all now even when turning on the AC.
So for a second opinion from all of you, does it look like I can get away with just replacing the clutch assembly? Also does the clutch assembly come with the new magnet, bearing, and plate?
View 6 Replies
I have been doing some research on why my 6sp MT makes a weird almost "Plastic Grinding" noise when shifting from 1st to second on cold days when it sits overnight. It has been getting under 40 degree that last couple days and it seems to go away after just a few minutes of driving. It only happens from 1st to 2nd. I have been told its normal and just because the trans fluid is thicker when cold.
View 3 Replies
I have a 2013 golf r and I usually shift gear at 3 rpm when driving normal but for some reason it doesn't feel right, I can hear the clutch making a weird noise whenever changing gear at a low rpm, it feels so much smoother when shifting above 4 rpm but I dont always wanna punch it so hard especially when there's always traffic from where I live. Any advice on a smoother shift at a low rpm.
View 22 Replies
I have a 10 year old 2003 Subaru Forester in "very good" condition....except that the transfer clutch assembly is starting to make noise and the repair shop (at the dealer) says, housing has to be replaced also. The car has 130K miles and has had all its regular maintenance for 10 years. The only major mechanical problem we've had are the head gaskets (which on this year's model were NOT part of the recall). Those were fixed 2 years ago. Some of what I see in the online chatter about transfer clutches suggests that this is a slippery slope and the next thing you know there's the "next thing" that needs to be worked on. We were hoping that the 2014 Forester would get really good mileage (this one got 30 when it was younger) but we hear it will only be 32 mpg so we're inclined to "keep waiting" if this car can be kept happy. Is a transfer clutch repair a big deal?
View 7 Replies
