Golf IV / Jetta IV :: A/C Low On Freon - Compressor Turns On Then Shut Off Repeatedly
Jul 12, 2016
So I bought a 2004 Jetta with the 2.0 engine yesterday. I got the car pretty cheap and was told that the issue with the A/C was because it was low on freon. I've never owned a Volkswagen before, but I assume A/C units are all similar. So I go to put in some freon into the low end of unit. I get about half of a 12 oz can or so in and I hear a loud Psst or shooting of the propellant. I look down and it looks like the the side of the compressor shot the oil filter with the coolant. I'm not sure if I sprung a leak of if it was just a valve that releases when there is too much pressure. I've only driven it for about 10-20 mins since and I can still occasionally hear the Psst sound. It is 96 degrees in my area if that makes a difference or not?
Some other information, I noticed that the compressor kicks on, but only for like a second or two and then it shuts off for about 15 seconds or so and then repeats itself. What could be wrong?
View 8 Replies
Advertisement
My ac stopped blowing cold. The compressor turns on when I turn the ac on. When I pressure tested the low line port, it showed it was too high to add any recharge. 2001 jetta wolfsburg 1.8t....
View 2 Replies
Was driving just a few hundred feet up the road to local mini mart. On the way home after pulling out of the shop, my battery light flickered once and twice before staying on. I circled around the block to see if it would go away, but it was still on when I parked in my driveway. I noticed a ticking noise in the engine bay, but decided to turn it off.
About 10 minutes later, I turned the car back on. Battery light still on, noise still evident in the bay. I popped the hood and it's coming by the serpentine belt. That seemed to be running fine over there and couldn't see anything that looked out of the ordinary. I went in the car to rev up the engine a bit and turn on my lights, and that's when the symptoms got weirder. My RPMs jumped to about 1,000 and stayed there (even when I let on the gas a bit); my blowers would work (but not the screen showing the temp); CD player turned off; and I got a cluster full of lights on my dash. The car would idol rough when turning lights on and off.
It eventually shut off, and now there is no crank or nothing. All lights still work, alarm works, but no turn over or clicking. I'm going to try and get it jumped when able to, but I'm not sure what the problem could be. I can't find the exact paperwork, but I had the alternator replaced at around 85,000 miles.
Car Specs:
2003 GTI VR6 24V
110,000 miles
View 9 Replies
I had to replace one of my Ac lines. The skinnier one.I have never seen the air work in this car. That line was broke since I have owned it.
I went to try and fill it today with r134. I have as much pressure on the low side as I can put in. (55 says the cheap gauge) But when I turn the car on the clutch does not engage to cycle the freon so no cold air. What I know,The fans do not turn on when Ac button pushes.The connector to the compressor only read 4v. I cannot get any number on the high pressure switch connector. (3 pin)
I don't know if it just doesn't turn on because nothing in the high side? Is there a way to bypass? I read jumping the switch is a bad idea.
View 2 Replies
Ok, '99 F450 has had a/c problem for couple years and finally getting around to fixing it(co. truck and enough people complained).
When dead cold, compressor will cycle quickly, like low on freon. Low side goes from 40 to 20 and back again as it cycles. Put a set of good gauges on it today and I can't get it to turn on at all. Even jumped both hi and lo switches.
Originally I was thinking it was the clutch, but when cold I was able to jump switches and make it run continuously. I didn't have gauges then and didn't want to burn it up so now I have gauges and it won't come on at all(when warm). Will have to wait a couple days til I can try it again when cold(like in the morning before it gets used).
View 4 Replies
I got a 2001 f150 leaking freon on the back of the compressor, can't afford to fix this summer. When I add freon should I get the freon with oil in to get oil in the system or just add regular can of freon, it took about 6 weeks before I need to add any.
View 7 Replies
OK, until I figure out what to do with the other truck I overheated, I've got another ambulance that needs some work, and I got to have a truck running.
This is the same config - 2006 E450 6.0 dually ambulance with 122K. Starts and runs; I drove it all the way to Houston from Minnesota when I bought it and made several shorter trips since with no problems except the AC compressor leaks freon. Then, I found oil in the degas bottle. A tech said it needs an oil cooler and he says there's some leakage at the rear main seal that's "common with this engine."
Can't recall reading a lot of rear main seal issues here. Is that right? Is oil cooler the obvious diagnosis for oil in the coolant?
View 14 Replies
Of course my freon all leaked out of the AC compressor and it is squealing pretty bad. I did not want the serpentine belt to break due to a seized compressor so I looked for a bypass pulley kit. Naturally they make one for both gas engines, but not for the diesel. So out comes the string and sharpie, and trips to 2 different auto parts place to get the correct length belt after trying several that were too short. It's 103 inches (8 groove) for future reference to bypass the ac compressor and upper extra pulley. 7.3 diesel.....
View 7 Replies
Battery kept dying. Had the battery tested. Bench tested as OK but kept dying. Replaced the battery with a new OEM. In a week, that battery was dying too. Alternator was putting out 13V but would dip down to 11V. Also did a parasitic current draw test. Car is only drawing 20mA at rest. Replaced the alternator with brand new. New alternator putting out 14.4V. Battery keeps dying. Still no parasitic current draw.
I did two things right around the same time I started having the issue. I put in a new head unit. I already had an aftermarket head unit and I simply upgraded. I know this isn't the issue because I ripped the thing out completely, including wiring harness, and I still kept having a problem. The other change I made was going from a MFSW to a 3-spoke. I removed the MFSW relay and switched the pins in the column so that the horn and airbag work properly. I tried the cruise control and it doesn't work. When I try to turn on the cruise control, it blows the horn fuse. Replaced the horn fuse and I just don't use the cruise.
What I'm wondering is if I messed up the CCM when I did the steering wheel swap. I've read that bad CCMs can kill batteries. I'm not having the typical faulty CCM issues. The only issues, besides the battery dying, are that the unlock on the keyfob will stop working at random, and the "door ajar" light on my dash flickers at random.
View 24 Replies
Seems like my 2001 f350 7.3 has an ac freon leak on pass side near compressor. AC is blowing coolish air but not cold like is should be. There is green like oil around main line leading out of ac compressor. I have attached several pics to illustrate situation.
View 7 Replies
I have a 2006 Expedition with 90k miles. I am the original owner. don't drive the vehicle much just mostly when the family goes somewhere or when I'm putting the Jet skis in the lake.
About a year ago the air con went out and since I don't drive it that much I decided to fix it later, well now is later. How to diagnose the AC system. what I am looking for is a methodical step by step procedure for trying to find out what is causing my AC to not work.
the symptoms are, the compressor turns on runs for a few seconds and then turns off. inside the cab I can hear hear a hiss noise during the few seconds that the compressor comes on and fades away slowly when the compressor shuts off.
I bought a can of 134a with the gauge, I adjusted the gauge for the correct ambient temperature hooked up to the low side and was surprised to see that the Freon was only a little low. I topped it off but still no change in the compressor running.
I bought a set of manifold gauges from Harbor Freight (I know I know you get what you pay for) in any case I hooked up the gauges to see what the pressures are when the compressor turns on but only seeing a little change.
Any way I took my Speedy (expedition) to the local auto air conditioner shop the mechanic hooked his gauge set up to the vehicle, watched it for a few minutes, made some phone calls, came back. He did tell me that he was going to have to replace the compressor, condenser, dryer, expansion valves both front and back and flush the rest of the parts that did not get replaced. I suppose this is a good price if all that work really needs to be done???
However I would like to exhaust all of my options before I dump half the vehicles blue book value into the air conditioning. so I've been searching the internet and found that it is possible the problem may reside in a control valve that may be present in the type of scroll compressor that is in the expedition.
View 6 Replies
I have a 09 camry 2.4. I have a problem with it starting about 5 times a year. It will start and shut back off and just keep doing this or just crank over. Then if we let it sit for about 15 minutes it will start and be fine for months. It's been doing this about 2 years. It has about 104,000 miles on it and there has never been any lights come on like the check engine light.
View 2 Replies
AC compressor won't kick on at all. I know the system doesn't have much refrigerant (just replaced the line that runs from the expansion valve to the bottom of the drier, the drier itself, and the condenser)..
Evacuated the entire system with a pump. Tried putting refrigerant in and the pressure on the gauge goes up immediately into the yellow/red...jumped the connector on the high pressure switch and the fans came on, shouldn't the compressor kick on too?
Checked the 14 pin connector on the fcm for 12V...PIN number 8 is barely seeing any power which leads to no power getting to the compressor...
View 11 Replies
The dealer diagnosed my a/c as needing a new compressor and clutch. I had an a/c specialty shop install a remanufactured compressor and clutch. however, they could not get the compressor to kick on. I checked all fuses (all are good).
I checked the compressor continuity (good, 0 ohms). I checked the plug where the compressor clutch plugs in (it reads 12 volts). the funny thing is, it reads 12 volts anytime the engine is running (even if the climatroinc is turned off). I am definitely not an a/c expert and really don't know how this stuff works.
View 7 Replies
In my 2001 2.0, my AC has been blowing hot air for a while now. It was intermittent at first but now is constant.
The compressor runs without going off when the AC is switched on. I can tell because I see the compressor clutch engaged and spinning.
I tested with AC manifold gauges and these are the readings I got.
Engine off : Low is 0, High is 135
Engine on, AC on full blast after running 10 min at 1500 RPM:
Low is 4, High is 135
Looks pretty bad.
View 1 Replies
I am trying to figure out why my AC is not working. Both fans are coming on and the AC button is light up but it is not blowing cold. The charge was checked and it has a good charge. The compressor appears to not be engaging. I checked for power at the electrical connector for the AC compressor and my voltmeter is showing voltage between 3.1-8.3 volts. It jumps around between that voltage every few seconds. The fuses have all been checked and are in not broken. What else should I be checking?
View 2 Replies
2000 jetta 2.0
so far i have replaced 2 fans ; thermal switch in radiator ; ran all the tests i can find ; all fuses and relays seem fine ; jumped compressor and it engages .
key on & car NOT running there is no power to the compressor.
I wanted to check the low pressure switch but every test is for a 2 wire set-up.... mine has 3 wires. which wires do i jump?
View 5 Replies
I have a 2004 Jetta wagon 2.0. About 2 years ago my compressor was replaced with a used one and the a/c was working perfectly fine. Last year the air from the a/c began to get warmer until it completely stopped blowing any cold air. A couple of weeks ago we checked the freon lines and they had plenty of pressure in them. We also checked the fuses in the car and on top of the battery along with the fan control module. The compressor spins from the serpentine belt but the clutch does not engage and there is no power in the wires going to the compressor. There is power at the high pressure switch but the condenser fan does not come on unless the switch is jumped. Could the culprit be the ambient temperature sensor?
View 9 Replies
Ok My Ac doesn't work on my 05 Jetta 2.0 blows hot air. These are the steps taken so far to no avail
_Function test A/C System_ A/C is not cold_ Recover A/C, System was low
_Pressure test system with nitrogen for leaks_No Leaks Found
_Charge system and add dye
_Test operation
_Found compressor not cutting in_ Inspect for ground at compressor_OK
_Test for power at compressor_NO POWER GETTING TO COMPRESSOR
_Inspect fuses_OK
What's going on with this and what the next steps might be?
View 3 Replies
I have an 02' 2.0 Jetta Wagon, and the A/C is having some issues. Since I know close to nothing about A/C systems, I took it in to a few places to have it looked at. I've had the whole system Evac'd and recharged, and have had the low pressure fitting replaced (apparently there was a slight leak there), and the system is still not working.
The A/C worked fine when I first purchased the car a few months ago. Shortly after my 800 mile trek from Oregon, back to home, the A/C started to only work intermittently. The compressor would engage, then disengage, repeat...It seemed like a bad idea to keep trying to use it in its sad state so I stopped using it altogether. As I said, I had the system emptied and recharged, but it still only works intermittently. It sort of follows a pattern where upon start up it works longer, and switches on and off at shorter intervals, until it doesn't engage at all.
There are no strange noises from the compressor, and when it was hooked up to the machine, it proved to be performing its function well.
View 5 Replies
Compressor does not engage, and my fans do not come on when I turn on the A/C. They do come on low speed when I jumper pins 1 and 2 on the temp switch plug, but they do not come on high speed when I jumper pins 2 and 3.
I have replaced the FCM with a new one, as well as a guaranteed working used one; neither one changed anything. I assumed right away that it was the fcm because my original one has a hole eaten through it from battery acid.
Compressor clutch ohms out within spec, and it will engage if jumpered.
View 3 Replies
