I have a 99 lesabre cold start rough idle but smooths out . Warm no start. Trouble codes P0171, P0300, P0336. Had plennum replaced 2 years ago but I'm seeing coolant around the base of the plennum so I'm going to have to do that again but I don't think that has anything to do with the warm no start.
View 14 Replies1994 Buick LeSabre Custom 3.8 Litre V6 with 103277 miles.
It runs smooth when idling in Park, rough when I put it in gear when I am stopped (either drive or reverse) has hesitation when accelerating, it smooths out again when driving then it starts to drive rough at about 55 MPH.
Mechanic told me it was the plug wires. I replaced those and the plugs. This fixed the hesitation when accelerating issue, but the other issues remain (now even seem a little worse) I thought the plugs and/or wires were bad, so I rechecked the gauge on the plugs and traced to make sure I had the wires hooked up right. Everything seems in order.
I have added fuel injector cleaner, and changed the oil, oil filter, spark plugs, spark plug wires, air filter, flushed the radiator, and changed the thermostat. (For a tune up since it has admittedly been a while)....
I have a 2006 Ford 150 with about 120,000 miles on it... For almost 9 months now I've had a really rough idle and I can't seem to get it to smooth out. I've tried new plugs, tune up, new fuel filter, higher octane gas, fuel injector cleaner, octane booster, cleaned my mass air flow sensor and nothing works... I've checked the trucks ECM for any codes but it comes up clean every time...
View 6 RepliesI have a 99 silverado with the 4.8 w/186k on the clock. I am having an issue with rough idle and hesitation on cold start up. Once the truck warms up the idle and hesitation go away. I have replaced the PCV valve hoping this fixed it, but it did not. I have also cleaned the TB and the MAF.
View 2 RepliesMy 2007 TrailBlazer with 84K stumbles for 25 seconds when I start up cold. After 25 seconds I hear a click and then it runs perfect. No engine codes present. Have new plugs, new O2 sensor, new thermostat.
View 5 RepliesI got the fuel pump and fuel pump control module replaced. Now I am still getting a cold start delay (5-10 seconds to start) and it has a rough idle sounding like its misfiring. This happened when i picked it up at the dealership after a new fuel pump BUT! keep in mind it has been doing this for a while so i figured it was the fuel pump.
New oem plugs and the coils were replaced when i bought the car because the coils failed during a test drive I need to scan the codes but i will post. Also this only happens during a cold start. if the car is warm and i go into target or something then start it shortly after its fine.
TSB'S I think will fix this. [URL] .....
2000 Sierra 1500, 5.3L engine. When he starts it in the cold (below 40 degrees) at first hits 1000rpm, then immediately drops to 400-500rpm. The idle is rough and wants to die if he tries to drive it. However after 10-15 minutes and the eng warms up, its fine no problems at all. There is no codes, so the scanner we had didn't tell us anything. He had cleaned the TB and intake system with cleaner, no dice. He also disconnected the IAC while it was idling rough, that didn't change the way it ran at all. We would like to toubleshoot it more before we start throwing parts at it.
View 1 RepliesI have a 2003 Camry 4 cylinder. The problem we are having is the car has a slight rough idle only at cold start. After she warms up she is smooth as glass. What would cause this?
View 14 RepliesI have a 2003 Camry 4cylinder. On first start of the day the engine shakes a little untill it warms up and is driven for about 2 blocks. After that it is smooth. I cleaned what I could of the throttle body on the car, changed spark plugs and PCV. All that worked but cold start shake still there.
View 9 RepliesI'm having this cold start issue with my 2001 SF, but it doesn't seem to be fuel related like as the car starts fine but after about literally 1-2seconds the RPMs drop below 1k and the car will stall if I don't put my foot on the accelerator and keep it around 1000-2000 RPMs. But if I happen to make the revs go too high and let them drop again it seems like it wants to stall even easier. After about 30 seconds it smoothens out and drives almost perfectly except for a slight lack of power than normal going uphill (A.T drops to 2nd gear, sometimes 1st depending on the incline). We have had the coolant temp sensor and the fuel pressure sensor replaced. Could it be the MAF? We did clean it one time but it didn't seem to work much at all. Recently out of curiosity, I disconnected the MAF sensor and started the car it being started for a few days. No issue with idling whatsoever!.. ??
View 4 Replies2008 VR6 Touareg with 71,000 miles. When he starts it cold the idle jumps around and is very rough. After 30 seconds or so it calms down, but you can tell it's still just not right. It also makes this puffing sound especially around the exhaust. At least puffing is how I'd describe it, maybe I can take a video of it at some point. No visible issues anywhere in the engine bay or anything that looks out of place. I ran an auto scan with VAG-COM and I pulled absolutely no faults. I found that puzzling.
View 2 RepliesMy 07 F-150 5.4 has a rough idle during a cold start for about 1 minute. It happens mostly when the weather is chilly or cold. Also after the first start it doesn't do it the rest of the day. Of coarse they can't find anything wrong and tell me there are no updates for anything like that.
View 3 RepliesI have been debating if i should use seafoam engine treatment. My truck has been having issues with the first cold start of the day. I've noticed the rough idle that accompanies the cold start. I live in Denver so this truck sees alot of stop n go traffic. Will seafoam do anything about the dirty fuel injectors. They have to be replaced here soon but will adding seafoam solution buy me more time. If so, what are the steps on how to add. The can isn't very detailed on instructions and Internet isn't being useful. I have an 04 F250 Lariat Power Stroke 6.0L diesel
View 14 RepliesI've been having trouble getting my 2001 toyotoa echo to start in the cold weather and STAY Idling. All I can do to keep the car going is hold my foot on the gas until it warms up, then it stays running, low idle, but running. It starts fine the rest of the day, but that first start in the morning doesn't take. The check engine light comes on and stays on, and the car seems to idle rough at stops.
At first the Mechanic I took it to (good guys) cleaned out my throttle body (physically and chemically) and this seemed to solve the problem for a couple weeks. I'm located in Toronto, Canada, and we're heading into cold weather and I just want a car that starts. It started up again recently and I'm now being told (on my second visit to the mechanic) that it's my throttle body/idle control and that this part needs to be replaced, to the tune of 627.00 + labour.
1991 Buick Regal, 3800 V6
Having a rough idle on a cold start. After some research and closer inspection of the vehicle, I'm quite certain I have at least one leaking injector that is flooding a cylinder and causing the car to misfire on a cold start. I'm also not at the gas mileage I should be at.
So I'm wondering, is fuel injector replacement as straightforward of a job as it looks? Any major issues I could run into in doing a replacement?
I'm planning on replacing all six injectors (I can get them for $50 each buying online with a discount code), but given that the vehicle is so old am I better off just replacing the faulty ones? I'm assuming pulling the spark plugs and seeing which cylinder is wet will tell me which I need to replace.
And one more question: Is there a way to depressurize the fuel system when I park the car for the night, thus preventing fuel (or most of it) from leaking into the engine until I get this fixed? I've read that just unscrewing the gas cap can depressurize the system.
My 2001 V70 24T runs smooth when cold as it warms up it runs rough with delayed acceleration reaction ....
View 1 RepliesMy truck runs very rough and lacks power when cold, even during the Texas summer. Once it warms-up, everything is fine. It's almost like turning on a light switch. If it's plugged in for a couple/few hours, it's smooth as soon as it starts. I'm assuming it likes the oil once it reaches a specific temperature. What my problem is?
View 14 RepliesTruck has been doing this and now getting worse. 06 f250 6.0 147,000 miles. Runs like crap when you first start and truck has trouble shifting when I first take off in the mornings until it warms up then it idles fine and runs like a champ no problem shifting. Not in a cold climate 40F at the least. Not trying to take it to the dealer and get raped. Been doing research some people say get the inductive heat flash, some say needs new injectors, some say could have a bad gasket on the injector idk. I'm trying trying to get it resolved....
View 4 RepliesMy '05 Excursion recently started having rough idle and some loping when started cold. It seems to run good and idles pretty good when it warms up. I'm also getting a P0488 code (EGR Throttle Control Circuit A Range/Performance). I do have a BPD EGR and I don't recall if that would throw a code alone? I'm taking a trip next week and want to get it straightened out. Does it sound like an EGR valve issue?
I also thought about a battery issue, I know that can cause weird problems. I have Duralast batteries and they always seem to fail at about 2-3 years. I took it in and they say it tested good but I'm not always sure with them. Long story, but when cranking for longer than normal, the cranking power would drop quite a bit. Checked battery and had some corrosion. Cleaned and upon further inspection, the positive post is a bit eroded at the base and sunken in. The voltage was about 12.35 after sitting all night, a couple of the cells were reading lower than the others (about 50%, other 75%) when checked specific gravity. I tested voltage after batteries had been in the truck overnight, then unhooked from truck when testing.
I also thought about a glow plug/harness issue. The truck cranks for awhile before starting, 5-6 seconds sometimes, but not all the time. It starts up pretty quickly when warm. That's been going on for some time. Anyway, I will try to get a video of the rough start after cools down.
I'm new to diesels. I just bought a 2004 F250 with the 6.0 V8. I have the high and low circuit, contribution codes on cylinders 4 and 8. I've only had the truck for a few days but I've been reading a ton. The symptoms are hard start, rough idle/shaking, no power when cold. When it heats up and I'm over 2000 RPM it seems to be just fine. Even when hot and below 2000 RPM it does ok. I've check the FICM. It reads 48V with key on and 48V running. My plan is to do the following:
Change the Fuel Filters
Change the oil filter
Change Air Filter
Change oil with 5-W30 synth and I have both Hot Shot/Rev-X
If that doesn't work, I'll replace the two injectors. How does that sound.
I have a 1997 LeSabre with 180000 miles. I can drive the car for 4-5 miles before it stalls and then dies. the car will start to idle fast, then bottom out a couple of times before it dies. It also makes a horrible noise under the hood and sounds like the rods are all clanging together. Once it dies, it will not restart until it has sat there for 30-40 minutes. After sitting for some time, it will crank right up and then repeat the process again. My oil pressure is off the chart high and it stays there all the time. Does this have something to do with the problem of is that another problem all together? What is causing my car to die like this and how do i fix it?
View 5 Replies