I just noticed the other day that one part of my cluster is darker than the rest. my 0mph-25mph is the dimmest part of the entire cluster. I do know that these clusters are LED illuminated, but wanted to know if taking the cluster apart and what the replacement of this LED all consisted of.
View 2 RepliesI just noticed the other day that part of my instrument cluster is darker than the rest. Everything is nice and bright however my 0-20mpg area isn't as bright as the rest of my cluster.
View 1 RepliesThe backlighting on my instrument cluster is dim behind the 10mph area and bright everywhere else. There is a light bulb or LED burned out. On most cars you can just replace a bulb back there. Is this possible on the GX470? I can not find the part number anywhere.
View 8 RepliesI have not been here in a while. Sold my IS250 and picked up a 2004 GX470 for the family. Installed a new double DIN head unit a few months ago and finally got around yesterday to installing the backup camera. Since I had the rear hatch open I decided to replace the rear hatch lock actuator motor as well. Hooked everything up and turned on prior to closing the interior panels and everything worked fine (reverse lights, locks, backup camera, started up fine). So I closed up all the panels and go to start the car and I get nothing but random flashing from the dash once I get ignition to ON. I also get a steady clicking from the fuse area.
Checked the fuses and I also tried to hookup to Techstream to see if any errors, but of course I get nothing (it can't connect to the vehicle). I disconnected the negative for 20 mins or so and tried starting again with the same outcome. So I disconnected the camera wires from the reverse light (thinking maybe the GND wire was shorting somewhere to chassis?) and disconnected the negative battery cable for a while and tried once again... same flashing instrument cluster lights and no luck . Gotta get the wifes vehicle back up and running.
Started my 2013 RX this afternoon and it indicates these two alarms on the instrument cluster, Engine Check Light & Track Off. Found out that my gas cap was not tightened (let my son fill the tank when he borrowed it the night before). Hooked up my OBD II scanner to clear and it shows two codes P0441 & P0445. They reset but my scanner says they are permanent. What does that mean? Will stay as an error until the ECU says otherwise?
View 13 RepliesThe information screen is out on my '04 instrument cluster, and I hear that I have to replace the whole cluster. Can I replace it with a used cluster, or does it have to be new. The dealer is telling me that it needs to be new in order to do the reprogramming of the keys, etc.
View 5 RepliesSomewhat frequently my wife's 2003 makes this sound. It sounds like it's coming from behind the instrument cluster. It can last for several minutes. I did a search on the forum but couldn't find anything.
View 3 RepliesI have a 2012 F350 XLT that came out of Canada. So of course the speedometer is in KM. (Large numbers are km and smaller numbers are mph). I am trying to find out if I can simply change out my cluster with a mph cluster???
View 4 RepliesThe instrument cluster screen in my 2004 phaeton suddenly stopped displaying anything today, I've tried removing and replacing fuses but still nothing, not even the backlight for the display is on, everything else is working fine its just the display. I need the car for a 600mi trip in 2 days.
View 3 RepliesI recently traded my 2012 GS 350 for a 2015 GX 460. It's more my type of vehicle, and I am loving it except for a noise under the dashboard that seems to be somewhere behind the instrument cluster.
The noise is more of a ticking sound, and if I had to guess, it seems to be a wiring harness in that mesh-type wrapping that's moving around. I hear mostly over bumps in the road, but it also shifts when I accelerate from a stop. Unfortunately, the area where I'm hearing this is inaccessible without removing the dash.
Below is a link to a dash cam video I shot with the noise.
Lexus GX 460 Dash Rattle - YouTube
I found a instrument gauge cluster out of a 2005 XLT that I would like to put into my 2005 XL. It has the tach that I miss. The mileage is less. Will I have any problems switching them - i.e.,: lights not working, etc? Will the onboard computer correct the mileage?
View 4 RepliesI recently had my alternator and battery replaced due to my truck dying out randomly on me, tested the alternator and failed, replaced battery, and still got the same results, battery gauge seems to drop quickly, what could be going on, I have been told to replace the fusible link that goes from the battery to the alternator....
View 1 RepliesSo, went to drive the truck (2004 F250 6.0, 145000 mi) yesterday and the right half of my instrument cluster was not working (tach, trans temp and water temp), CEL and check gauges lights on. My scan gauges gives me readouts of all 3, so I know the computer knows the right values. Pulled all three fuses related to the cluster, all looked good. All gauges, including those not working, did full sweeps with key on after putting fuses back, so I know they function. Also, the glow plug light stays on way longer than normal.
View 2 RepliesMy right side of my instrument cluster is not working. the Tachometer, Engine Temp and Trans Temp gauge are non responsive, and the CEL and Check gauge light is on. I have seen other posts with people that had the same problem but no solution to what fixed the problem. 2004 F250 Lariat.
View 4 RepliesI have a 2004 F150 (New Body Style) with 5.4L 3v and about 266k miles. My Alternator finally bit the dust and my instrument cluster went from reading speed, temp level, odometer, RPMs to being blank and all needle gauges bottoming out on the "0" side. Removed Alternator and had it tested, found Alternator Failed tests. Ordered and Installed New aftermarket 110a Alternator. Battery was fully charged (13v) and passed load test out of the truck. After installation, started the truck with no problem, instrument cluster gauges all read normal when turning key to on position, after starting and let run, instruments and gauges blacked out and returned to "0". Battery was reading 13v and with truck running read about 17v. What could be causing this?
View 3 RepliesI have a 2004 f 450 cab and chassis truck that the problem started out with the radio not coming on. So I asked the local dealer and he gave me a wiring diagram. I pulled the fuse box out and checked the wire from the fuse box to the radio and it works. Great. But he also said I could take the fuse box apart and check to see if their was a broken connection in it. So I did and could only get so far with it. It has a lot of pin on one side that go all the always through and are soldered on both ends. So I put it all back together and reinstalled it. Now the instrument cluster does not work. Not even the warning lights. The interior light doesn't come on either or the door chime. Is it possible to melt the solder off and open the fuse box completely and check all the connections.
View 1 RepliesOne of my headlight is burned out and I would like to replace. I don't want to go with OEM. Looking something better and brighter. 2008 GX....
View 1 RepliesLooking for a source for a wiring diagram for the 2003/4 f350 instrument cluster, specifically the wiring/connectors to the gauges? A link to a PDF file would be nice. I would like to try and disconnect the PCM control to the transmission temperature and engine temperature and drive the gauges from my own sensors to bypass the non-linear behavior that ford decided was in our best interest. I am NOT interested in installing any more gauges, just want to control the ones already present with my own signals. It is possible that these gauges are all addressable devices on a common bus, instead of individual controls.
View 8 RepliesWith DRLs enabled and a Euro switch in Auto, I get HIDs, city lights and side markers during the day - no DRL indicator on instrument cluster.. With switch in Off, I get only HIDs, but with DRL indicator lit. In Auto I expected only HIDs as DRL and DRL indicator lit. No city lights or sides.
View 2 RepliesTurned my lights on in my 2001 VW Passat and my instrument cluster lights are no longer working. The area showing MPG and Outside temp is functional but nothing else is. The lights for the radio, fan hazard sign etc are all fine.
View 1 RepliesThe speedometer, tachometer, fuel gauge, battery meter, temp gauge and idiot lights went out. The car works fine. Dash is just dead. I did a quick look at the fuses in the glove box but it doesn't have the little card to tell fuse locations. So, I can't narrow it down but I don't see any blown fuses.
View 4 Replies