What's up Lexus enthusiasts and fellow owners I own a 08 LS. Today I noticed that my driver side headlight goes out , I turn it off and turned it back on and it's good to go but after a minute it turns off. This could be a bad ballast . How to change a ballast or headlight bulb in an LS before? Is there a link that I can go to and check it out ? Or this is one of those that the bumper has to come off .
View 9 RepliesI have an '07 ES350 with the factory HID headlights. The driver side headlight will start to flicker a few minutes after being turned on and then eventually turn off. Turning the headlights switch off and then back on will turn this headlight back on but it will start to flicker again after a few minutes.
I had this problem last year with the same headlight and took it to the dealer who replaced the HID bulb but now it's back again. I've also noticed it seems to occur during the cold winter months and not so much during warmer weather.
The passenger side HID works fine with no problems. Perhaps it's a loose wiring connection but I'm not sure if this is something that can be checked without taking the entire HID assembly apart.
My driver's side headlight bulb started malfunctioning.
Here's the situation so far: Whenever I turned my headlights on, the driver's side bulb would turn off after 5 minutes.
Replaced both bulbs
Drivers side bulb stayed on for about 20 - 25 minutes at first then started going off after just a few minutes
Replaced ballast (new) on drivers side but same results as above where light stayed on for about 20 - 25 minutes at first then going off again after a few minutes. Each time light stayed on for a shorter period of time
Bought 2 more bulbs and replaced both again in case first set was bad. Same thing still happens and bulb tends to flicker at times.
I am at a loss as to why the drivers side light will not stay on after changing the ballast and the bulbs twice. Also, I've noticed that the drivers side bulb is noticeably dimmer than the passenger side bulb even though both bulbs are brand new.
What the problem might be? I'm at a loss now and not sure what to do next.
Headlight fogging up after car wash or rain.
Driver side window seal folds over badly, wind noise is evident.
Passenger side lumbar broken .
And finally. The front jerk when applying brakes. It's not there in the morning, gets worse as you start driving, feels like strut bar bushings, but all of the control arms were changed in February. Having a tech join me for a ride to show this problem to him. I'm staring to think it's either caliper, or brake actuator.
My driver side headlight is dull compared to 2yr old one on the pass side. Where can I get an aftermarket HID one. I don't want to restore it...
View 4 RepliesMy driver side lower beam (projector) will go out after a couple minutes when its turned on. If I flip the switch to off and then on, it turns back on again. Is this a sign of it going out? I am assuming i have the HID version.
View 9 RepliesAfter detailing my car and prepping for winter I noticed moisture in the driver's side headlight. I know this is a common problem with many makes and models besides Lexus and I've done quite a bit of research to re-seal the light. I want to start with the basics first such as checking the vent tube for clogs. Need to point out that vent tube in a photo? I've looked all over and cannot seem to find this tube.
When I was detailing I was using a high-pressure washer. There was quite a bit of moisture and it dried within a few days. I was hoping it was from the high-pressure washer but now it came back. It seems to have come back just from using the headlight washer when I used my windshield washer.
I double checked the dust cap and o-ring seems to be fine. My next task is to remove the headlight assembly and reseal. I've read that some people have luck with just applying a bead along the seal without completely disassembling the lens and resealing (baking method). I'd rather not have to do the entire baking method although I know that can be more thorough.
Am I missing anything here in terms of other known causes? And would a clogged vent tube really cause this?
Very much enjoying my newly acquired CPO sc430 but there's a strange thing that I noticed: When I go over a short-bump or hit a patch of broken pavement, the driver's side headlight seems to flicker for just a split-second. Sometimes it even seems like the other one flickers too. What that can be? Is it normal for this car?
Also, my car has the dreaded brake-clunk that has been discussed in this forum ad nauseum. Is it worth taking it to the dealer even assuming they know how to adjust the clips and grease the system to get rid of it? How long does the "fix" last? I had a 2004 acura TL that did this from day 1 but only on the initial brake application after starting the engine. The SC does it every time I shift from D into R etc.
My driverside headlight randomly stopped working last night after i came out from a restaurant. the driverside was off the most of the ride home until it flickered on. now it randomly will only turn on for a split second then shut off.
i recently had my headlight / front bumper replaced and i was wondering what could cause this? normally if it was hid instead of led i would say its a weak ballast or so but i do not know how the LED headlights work. also the car is too new to have a weak ballast.
i do not believe its a fuse because the headlight will not turn on at all if it was a fuse. i also checked the box and all the fuses look intact.
My driver's side bulb at times will just go completely off. Is it the bulb or the ballast shooting craps?
View 7 RepliesLately I noticed that my headlight beams are crossed between passenger and driver side....
When I start up the car, the headlights move down and up for the initializing... all seems fine... While I backing my car out of the garage, I notice that my light beam start to drift closer to each other as I back out further and then finally crossed... the beam from my passenger headlight ended up on the driver side.... and the beam from my driver headlight ended up on the passenger side.
My AFS lamps are working and initializing when the car turn on.
I have a question. When I turn my car on the passenger head light comes on, but when i start driving it goes out the low beam.
View 2 RepliesLast few times I washed the car, the passenger side headlight got condensation for days after that. It's taking some time to clear up too. Is there and easy fix for this?
View 14 RepliesI have a 2007 and lately the driver's side headlight goes out sometimes when I'm driving. If I turn the lights off, and then back on, it will light up again and stay lit. Sometimes it will work for weeks and then all of a sudden it will go out. So I'm thinking of replacing the bulb(s)
Are the headlight bulbs in the 2007 SC regular light bulbs that I can purchase at a local automotive store?
My 2007's drivers side headlight is randomly shutting off. I can see it slightly flutter when I inspect it. I'm not sure how to replace it. I've taken off the cap/wiring harness and can see the end of the lamp but it isn't clear to me how to proceed.
View 14 Replieshow to replace the front Highlight.
how to replace my head light, on the passenger side.
We had what seemed like a normal situation with the driver's side burning pink for a minute then going out. I thought it was the bulb, purchased the bulb and the light burned bright, though more yellow than the typical light blue, and then went out.
I replaced the Ballast with a different one, and got the same effect. The HID lights, burns OK for about 20 seconds, starts to pulse a little then shuts off.
My Drivers side headlight points slightly higher than my passenger side headlight. Is this normal or do I need to adjust, and if so how do I adjust?
View 6 RepliesMy 2006 Prius (Model NHW20) has a strange headlight problem. On the passenger side, the high beam light is out but the regular headlight works.
On the driver side, the high beam is working but the regular headlight is out.
I don't think it's the fuses but I'm not sure. No amount of interchanging the following fuses changes anything about the issue:
1. 10A H-LP HI RH
2. 10A H-LP HI LH
3. 15A H-LP LO RH
4. 15A H-LP LO LH
Approach car and grab the handle, car beeps like 5 times trying to unlock the drivers side door. All other doors unlock.
If I go to passengers side and press the unlock button a couple times it opens. Seems slow to open. Greased lock assembly at door. Not sure if it works.
I installed a new ballast and bulb for an 07 ES350. Light, on drivers side, still flickered until I installed the ground screw. This is the screw behind the drivers side quarter panel and it is the only screw on the side of the headlight assembly. Once I inserted this screw, light functioned properly for about 10 minutes. Then it went out and light doesn't come on at all. The fuse is still good. I have tried switching bulbs and light still doesn't work. Also, there isn't any humming from the ballast at all.
View 2 Replies