What could the cause of the rear wiper on an '06 RX330 not gripping well to the window be? Could it need a new spring, or could the entire assembly need to be changed? What troubleshooting can be done in this situation?
View 3 RepliesI bought replacement blades for Drivers side and rear window.
I'm half-way mechanical... OK , maybe 1/4. It appears that the blades themselves are not replaceable; only the refill (squeegee) portion is. is this correct?
Front-drivers-side actually looks like the complete blade may come off, but it's not obvious how it releases.
The rear appears to have no way to easily remove the complete blade.
Awhile back I did get my battery replaced and I did reset my windows so they could be used from the driver side panel. As of now, I can roll down all of them from the driver side except for the passenger side rear (window diagonal from driver). The window does roll down from the door itself so the window isn't broken. The light on the driver window switch is lit green, not blinking. However, the light on the window switch on the passenger door is NOT lit and not blinking either. And yes, I did make sure the window lock was not on.
Could the switch, either passenger or driver door, be bad? Should the battery be disconnected and reconnected??
The far end of my passenger side wiper has been leaving about a 2 inch wide arcing streak lately. I figured I needed new inserts, so I replaced them yesterday. The passenger side wiper is still streaking in the exact same place. I know I put the new inserts in correctly, including installing the little metal clip at the end of the insert. What could be the problem? Could I need a new wiper blade? Do those things go bad?
View 14 RepliesI figured out how to remove the front wiper blades you lift the clip then slide them off but the rear wiper blade I cannot figure out how to remove from the arm.
View 19 RepliesI have a 07 ES 350. Several days ago, I went to auto car wash without turning off the auto wiper blade. When I came out, I saw the wiper blades were higher than before. Then I loosen the nuts, and put them a little lower trying to make them back to original position.
But now I realized that it does have Summer/Winter mode. Is there any way to make sure which mode is it now? Should I pull down the blade after starting the engine, or before?
I recently purchased a '09 LS460 SWB. I noticed the driver side windshield wiper arm sitting up high enough to be in my field of vision.
I'm aware that there is a "winter mode" that allows you to raise the arm up a few inches, but from everything I've read....usually the driver and passenger side arm raise together.
In my case, my passenger side arm sits nice and low near the hood, while the dirver is sitting an inch or two higher.
I tried pushing the driver arm down (with success), but after cycling the windshield wipers once, the driver side arm goes back to the higher position.
I have a 2006 RX330 AWD. I took it to get inspected and was told I had a bad O2 Sensor.
Are they easy to replace? What should the average cost be? I was also looking for the part number. I was told that "Bank 2 Sensor 1" failed. I was looking for the part but I am not sure I found the correct part.
I was also told that the front inner and outer Tie Rod needs replaced along with both rear wheel bearings. I found the parts for the tie rod but not sure about the rear wheel bearings. Wondering if i need to get just the wheel bearing or if i need the wheel bearing and hub assembly also.
It seems like my wife's 2006 RX330 does not get as cold as it used to. At times, it will even blow warm and humid air, even though it is set to max cold, although this is intermittent, which to me, creates a harder problem to diagnose.
For example, if I put the AC on Auto, at 70 degrees, it never gets cold enough for the fan to drop below the Medium fan setting. To me 70, is not that cold, and it should be able to reach this temperature, and then slow the fan down to just maintain the temperature. I can even put the system on Max AC, and it the fan blows at the High setting, but it never gets really cold.
I have a 2006, RX 330 with approximately 130,000 miles. I was driving up a hill today and my engine seemed to stall. I pumped the throttle a couple of times and it seamed to take care of the problem. I am thinking it is a dirty fuel filter. Would a pressure test on the fuel line give me the answer ? And yes I did check and there is plenty of fuel in the tank.
View 5 RepliesI have a rear wheel bearing type of noise that appears to come from the rear. My vehicle is front wheel drive and has 135K miles.
I checked the rear wheel bearing/hub assys on both sides and they had no play but I changed them anyway. Noise did not change at all. Rear tires have normal wear, no cupping or anything. Noise gets louder with increasing speed up to a point and then remains a constant level.
My next thought is to check the front wheel bearings/cv joints.
I have a 2006 RX 330 with 116,000 miles. I noticed that i had a leak and the power steering oil level was low. I went under the car and looks like the power steering hose is leaking. The dealer wants $352 for hose and $325 for labor. I called auto parts stores and they say its a dealer item only. Someone told me I could have a hose company rebuild it for a lot less.
View 5 RepliesI have a 2006 rx330 with belt squeaking noises on after warming up for say 10 mins on cold mornings, while reaching home I could hear the noises on cold days, the outside temperatures usually 35 to 40 F happens. While driving no noises, only happen on cold days when temperature is above 50 no problem. Should I replace the belts, how many belts are involved ? Tensioner problems ?
View 1 RepliesNot real happy with stock blades. Leaves streaks. Bought right size Goodyear hybrid at Costco. But it seems the push button adapter will not work. Toyota has always used J hook before. So now they switch to push button but apparently some non standard version. Checked Rain-x, Bosch, Goodyear sites. Nobody lists 2016 Prius.
View 3 RepliesI was unable to find a related thread for this topic. I thought there was an old one.
Anyways, having issue of the drivers side wiper leaving an area unwiped at eye level?
New wipers fixes this problem, but for only two days
I have replaced the wiper motor and the wiper blades stop vertical on the wind shield. Readjusting the position of the wipers does not work. The wipers wipe the hood when that is done. I have done something wrong.
View 1 RepliesI don't know how to turn on rear wiper on my lexus rx350 2007.
View 1 RepliesIs this easy to do? I can get the part fairly cheaply, but if I can save on the labor I would like to. I bought my prius new in 2005, and I still have it, even though I also have a tacoma. Because the Prius is my "second vehicle" now, I am trying to save on repairs.
View 2 RepliesThe rear window viper is stuck straight up, What to do???
View 2 RepliesI have a 2013 Toyota Avalon Hybrid Touring Model.
The vehicle is great, however the clicking noise from the wiper relay is obnoxious. It is only when the intermittent wiper setting is applied that the noise is apparent. You can also duplicate it by manually moving the wiper knob up and down. I showed the dealer this twice, and both times they say it is normal. I will take a video later today and post it to show.
Passenger side wiper blade extending over the glass? Asking the dealer to see if this needs adjustment.
View 8 Replies