Lexus RX 2004-09 :: Yellow Light Indicator Is On After Replacing Combustion Engine
Jan 5, 2016
RX 400H 2006 model. After 130k km, the car suddenly stopped with check hybrid warnings. The one and only lexus dealer in Greece replaced the hybrid unit due to failure of the power module. ( the car was on recall but they have never contacted me). After the replacement there was a rattle sound coming from the combustion engine when it was running on the morning for 3-5 min.The new inspection of the dealer showed a crack on the head gasket of the 4th cylinder.( I have post it here under a different username) .
The options that I was given was either to have the engine replaced with a used one or to fix the old engine. The cost of fixing was triple of finding an engine. So I purchased a used one (via ebay!) , it was from a car issued in the United Sates. The one and only dealer refused to put it on my vechicle because it was not going to fit and work due to different electrical wiring . So I found a mechanic who managed to put on the us engine easily and with no issues except from a yellow light that goes on seconds after staring the ignition key.On the diagnostic tool shows a warning about ABS system although the brakes are ok and ABS works fine. The car is running after engine replacement for 25k km with no problems. I attach a photo of it.
View 1 Replies
Advertisement
My last ride was as 1988 Ford pick up 275,000 miles ... the poor thing finally died ... but it gave good service right to the end. I replaced the Ford with a 2009 Prius and it's a great car. So far no problems just routine stuff until a day or so ago. The little yellow "Windshield air flow indicator light" can on. I checked my Bentley book and it doesn't tell me anything. So what I should be look for to fix the problem. Other than "Take it back to the dealer"
View 4 Replies
diagnose the problem with my wires 2007 Lexus GX470. The Check Engine light and the VSC Trac/Off as well another light that looks like someone is driving there car drunk came on today. I took it to a repair shop and the read the codes. I have the following codes:
P 1441
C1201
C1223
C1241
First, is it safe to drive? Second, what is the indicating the problem is? Third, any way to fix this myself?
View 14 Replies
I have recently installed a pair of HELLA LED tail lights for my MKV R32 and there is a yellow indicator light showing in my dashboard telling me that both my tail lights are not working, but they are working.
View 9 Replies
Today all of a sudden my yellow engine indicator lighted up. I tried turning off the vehicle and start it back to see whether it goes off. No luck in that effort.
I have Prius 2012. I serviced it last on 10/31/2014 and I have now run 8000 Kilo Meters after the last service. I am using 0W-20 as my engine oil.
I see the vehicle going to EV mode and Engine mode depending on the way I drive and I've even achieved 20Kmpl in the last run. Could this be a sensor or a serious issue.
View 16 Replies
My '06 Prius just started making this noise. the check engine light is NOT on. I haven't really heard this noise before in my recollection. I just got an oil change 3 days ago and when I got the oil change there was no indication from the dealership that there were any issues. The engine only makes this noise when the combustion engine is engaged. I can't see any wobbling on the belt drives or and loose parts in the engine. The spin appears to be coming from the engine block or around the pullys for the belt. My first thought is that it could be dirty gas because I first heard this sound after filling up. I am 300 miles from home and have to drive home today.
View 1 Replies
I have a 2005 Prius with around 115,000 miles.
I have the following warning lights on:
1) Check Engine
2) Yellow Indicator, looks like exclamation point inside a circle inside parenthesis.
3) Red Multi-information display (exclamation point inside a triangle)
4) Hybrid System Warning Light on display screen, looks like exclamation point through a car
The engine cranks up just fine and drives forward and backward in the driveway fine. Battery level indicator is blue (see image). I checked for turbulence in the inverter reservoir with the engine off and fluid was flowing.
I checked the 12V battery (using the car's measurements by holding Display and turning lights on and off 3 times) and its value was 12.1 volts without engine and A/C on and 11.8 volts with them on.
The fan in the back right passenger seat is always on now though (I don't remember ever hearing this fan noise before), regardless of engine on or not, even though it's only about 80 degrees outside and it's been sitting idle all day and all last night. It comes on pretty much immediately when the power button is pushed.
View 12 Replies
2006 Prius with 164,000 miles.
First in the morning, starts fine, 500 feet later I'm turning out of neighborhood and I get lit up with:
Red triangle master light
Yellow brake warning (went away after I did signal check)
Check engine
Maint required light
The maintenance light is on because I'm 5,000 miles out of an oil change. I checked the stick, it did appear low, so I added a half quart of mobil 1 5w-30.
The inverter pump was changed due to recall in 2012, and I do still see turbulences in the fluid.
I have 3 pips of gasoline in the tank.
The 12V is a newly replaced yellowtop from elearnaid. Replaced about 1 year ago.
View 15 Replies
2004 Golf, manual transmission. The yellow check engine light comes on when it's driven on the highway for more than 10 miles or so (60-70 mph).
The light goes off on it's own after about 36 hours of suburb driving - 1-2 miles at a time on suburb roads, lots of lights and not going over 40 mph.
1) Why the light is coming on? No other signs of trouble occur - oil looks good, temp stays fine, no smells, etc.
2) Why the light goes off after 4-6 miles/36hours?
View 4 Replies
The little mark on the control knob to select air flow is unlit at night with the headlights on in my 2007 Camry LE. Apparently there is a bulb in there somewhere which needs to be replaced. How to change that bulb and get an indicator at night so that I can position the knob in the correct position?
View 1 Replies
I have a GX470 and just had the timing belt replaced. Now my "airbag light" stays on all the time.
View 12 Replies
I just bought a 2006 gx that has been lifted about 3" with old man emo springs. The ride height adjustment was removed and the adjustable shocks replaced with a larger non adjustable model.
The rims and tires were also replaced. I think the rims are 21" and the tires 33". The running boards were also removed and the wheel wells opened up a little.
The tire pressure indicator light is on all the time as the new rims and rubber don't link up to the sensor. This I can live with.
I tried it out today on a dirt road (Ophir Pass, Colorado) It worked great but about 200 yards in the check engine, and all three ride/safety system warning lights came on. (stability and slip sensors).
The car performed flawlessly, but the lights remained on even after I got to pavement. I did stop and check, oil, temp, coolant, etc when they came on and all seem to be fine.
I suspect it has something to do with either the oversized tires or the disconnected shock and height systems. How to get the lights to turn off?
View 5 Replies
2005 GX470.After returning home my wife parked the GX470 in the garage. She returned 30 minutes later and noticed the headlights were on. She also noticed the immoblizer light was blinking.
We always keep the headlights in the "auto" position. Headlights staying on is a little strange. but I recall the lights staying on once or twice before. Immoblizer light flashing has never happened.
I inserted the key and turned to start the car and the light went out and the GX started fine. Once I remove the key, the light starts blinking again. I tried this with both keys to make sure it wasn't a transponder issue--all keys did the same as above.
I checked battery voltage--12.4v. Charging--13.6v at idle Some light corrosion around the negative cable but not too bad. cleaned anyway Wife did say she came out of work and noticed that two different car alarms were going off that were right next to her car. Possible kids messing around. Maybe our car was going off as well?
View 3 Replies
I know a few days ago all of my blinker lights were working properly since I had the car serviced at the dealer and they made me test all the lights before I dropped it off. But yesterday my "check the lights" yellow lightbulb indicator came on, so I thought, ok, probably one of lights burned out. But then, when I needed to turn left, I saw my blinker on the dashboard blink with twice the usual frequency, but the only turning light I could see from behind the wheel, on the left mirror was blinking normally.
So, I stopped, got out of the car and looked around to find that neither of my front or rear left blinkers were working at all. So, here come the questions. How likely is it for BOTH lights to burn out at exactly same time? If they did, would this cause the dashboard blinker to blink at twice the usual rate? And if so, why is the mirror blinker blinks at normal rate? By the way, the right blinker is not affected by this strange affliction. Continuing, what is the best way to find out if this is
(a) capacitor problem,
(b) burned-out light(s) or
(c)(worst possible case)problem with a very expensive control board.
View 2 Replies
I have a 2005 F150 with the 5.4L V8. It has 70,000 miles on it and until yesterday and has been a great truck. While driving in traffic yesterday the truck started running rough and hesitating. It through two codes - misfire cylinder 5 and misfire cylinder 6.
In response, I purchased two new coils and 8 new autolite plugs. The plug installation went smoothly and the coils all went on without incident. However, this didn't fix the problem!
The next day I found that cylinders 5, 6, 7, and 8 were all having issues. At this point I also had an "O2 stuck lean" code so I pulled the plugs and found all four brand new plugs fouled and smelling like gas and an exhaust that smelled like raw fuel. This led me to replace the O2 sensor on the drivers side. With the new O2 my lean code disappeared but I still had a rough idle.
Further troubleshooting found that injector 6 was stuck open (which presumably fouled my O2 causing it to read lean and dump fuel thus fouling all the plugs on one side). I replaced the injector and the rough idle disappeared and all seemed really well as the truck idled in my driveway.
However, as soon as I hit the road I noticed a major hesitation. The motor is also noticeably louder and has a very hard time accelerating. I'm thinking that I've plugged up my cat by dumping so much fuel in to it and the hesitation is caused by a lack of breathing - does this sound possible? How would I confirm this without replacing the cat? Anything else I should look for? I'm fairly confident I have combustion in all 8 cylinders now so I'm leaning towards intake/exhaust issues.
View 5 Replies
My Lexus was working fine till yesterday, but today when I started (button press) it, it started giving me a Check VSC error and Check engine light along with Slip Indicator started showing up
Took it to Autozone for the codes and got
P0015
P0304
C1201
B2799
View 7 Replies
Great car, Love it! It's a big improvement from the 2006 Prius.
When applying the brakes and holding the pedal down, I notice that the indicator for slippery/traction yellow icon appears in my dash when completely stopped.
There is no map option on the steering wheel that allows you to switch back to the Nav/Map system on the HD display. Is there a voice command?
View 16 Replies
I have successfully gotten Techstream running properly and just bought a new brake position sensor and will be putting it in which I am hoping will fix the problem with all the lights.
View 19 Replies
My wife said she had to slam on the brakes this morning to avoid someone pull out in front of her. She said the small yellow engine light came on right after.
Could it be low brake fluid? Not sure how that works.
It's a 2009.
View 11 Replies
My 2006 V8 Phaeton has had its yellow engine warning light on for a few weeks. Around the same time, the cooling fan in the engine compartment stays on after I stop the car - even though its Winter here in Montana. So I got the fault code read: P2181. Seems to be linked to cooling system?
View 18 Replies
I started the car and was reversing from the drive when I noticed the car was in neutral instead of reverse and had rolled back itself on the incline I stuck it in reverse whilst rolling and a warning light came on. Although the car runs fine every time I start the car, a red square picture of a car with an exclamation mark in the middle of it flashes with the word problem underneath it. and on the dash there is a red triangle with an exclamation mark on the right and a yellow lit engine picture on the left side of the dash.
View 5 Replies
