I have a 2004 3.0 V6. The dash temperature gauge doesn't move just sits at the bottom 50C. (Canadian metric)...
I would like to locate the sender for the gauge to do a little testing. I removed a whack of plastic but nothing was obvious.
I have been battling this for some time. The check engine light comes after a period of time from reset. I have changed the thermostat, temp sensor, coolant flush and added per MFG.
I am down to clutch fan. The temp gauge sits right at 210.
From what I can tell is the check engine light comes on because the engine reaches operating temp to SLOWLY. Im guessing because the clutch fan is spinning to early in the game.
02 6.8 4x4 excursion. When I start the truck cold, the trans temp gauge immediately moves to "running" temp. Not really sure how this happens, I'd figure that if the xducer was trash it would ride all the way high or all the way low. What's happening here? I'd sure like a functional gauge...
View 6 RepliesThe oil pressure gauge in my 04 v8 treg doesn't move until I drive it for about 15 minutes. Is this normal?? When THE BEAST is idling it takes about 15 minutes to pass 60 on the oil pressure gauge. I find this very odd.
View 3 RepliesTemp gauge not working stays at C doesn't move at all. And smelling anti freeze while driving. The heat still works and not wet on carpet of passenger side. Does have an oil leak I think since I've had to add more oil again. Would that have anything to do with an antifreeze smell tho? Just checking before I have it looked at it. Also the gas gauge just floats that hasn't worked in a while though.
View 5 RepliesThis weekend I was one a trip in my '98 Civic, and I noticed some movement in my temperature gauge. It didn't really overheat; the needle never got near the red, but it did go a little higher than usual.
Normally, once the engine heats up, the needle on the temperature gauge doesn't move, not even a little. It sits right under the squiggly lines on the temperature gauge icon. However, on Friday, when I got off the highway, the needle rose into the upper part of the icon, to the part with the thermometer.
As soon as the car started moving, the needle on the temperature gauge went back to its normal spot, so I assumed it was a problem with the radiator fan and I kept on driving, prepared to turn on the heat if the needle on the temperature gauge started going up.
Saturday morning I took the car to a local shop in Jacksonville, and it turns out the engine needed a new fan and a new thermostat.
The first lesson that comes to mind is that keeping an eye on my temp gauge might have saved me an engine. It certainly saved me a head gasket. Since a head gasket or new engine would have been worth more than the car, catching this before it became a problem saved me from having to buy another car.
The next lesson is that my Civic had two things wrong with the cooling system, and yet it barely showed any symptoms. The air conditioner doesn't work I guess since a working A/C would probably have made it overheat. In any case, I've probably been driving without a working radiator fan for some time.
The final lesson is that if I had tried to diagnose this myself, I'd probably be driving around with a new radiator fan and a bad thermostat. I paid about $435 for a new fan, thermostat, and fresh coolant (I declined the cooling system flush) and it was worth every penny.
My launch scanner reported a bad oil pressure switch, but I've replaced that, and when I did the oil pressure light went away, but my gauge still didn't work. Could it be a faulty switch? Or is it common for gauges to stop working on these fords seeing how there's a resistor to trick the gauge from the factory anyway? If I smack my dash the gauge will raise and lower. But I think that's normal.
View 7 RepliesI have a 2001 Miata. It's been over 100 degrees daily lately. The AC will blow sort of cold for about 30 minutes and the temp gauge will move towards the H hashmarks. If I turn the AC off, the gauge will slowly drop. I've also noticed that the amount of cold air is decreasing as time passes. In fact, the other day, the system was blowing air hotter than the outside temperature after about an hour drive.
The viewing glass has bubbling stuff flowing thru it. The recently flushed radiator is full as is the overflow reservoir.
I have a 2005 v6 ford mustang with 134,300 miles on it. About three weeks ago the fuel gauge started to misread and now it doesn't move at all and it dose have gas. Two days ago the check light came on so I connected to to a code scanner and it gave me the code P0460. Under the code it gave a short discretion, (Fuel level sensor A circuit). What issue might be?
View 3 RepliesI picked up a '08 TSI wagon recently and noticed the bottom half of the rear defrost doesn't work & the lines are broke all on one side.
View 3 RepliesI have a 1991 Silverado C1500 and when I push the heater button to on, the thing just goes absolutely crazy. Instead of one little indicator light, that is suppose to show hot, it lights up all the way across, like a pinball machine that has tilted. The heater air does not get hot and the temp indicator on the dash (separate guage) will not move off of cold. I am going to replace the thermostat, but what is going on with the darn temp gauge?
View 1 RepliesI Have a 2003 Honda Civic EX that is running rough and the windows stopped working and the temp gauge doesn't rise. Would this be do to a bad/failing alternator or something else?
View 7 RepliesI have a 1992 Aerostar 3.0L end my temperature gauge on the dash doesn't move at all. Stays all the way to the left. I read on other forums that to make sure the gauge and the wiring are ok, i need to connect the wire that goes to the sensor unit to the negative of the battery. Gauge should go all the way to hot when the ignition switch is put to on position. That was exactly my results. So, i replaced the temp sensor unit but still gauge doesn't move. I didn't use any sealant on the threads when i installed the sensor. Connector looks ok. The engine warms up fine. I really don't know what else to think or do.
View 11 RepliesI just picked up a Black 20th tonight. All stock with 48,000 miles. I'll get some pics up asap. But for now I'm gonna be lurking around trying to work out the kinks of the car. The Temp gauge doesn't work and the passenger door only opens from the inside when first unlocked.
View 15 RepliesSo recently (past few weeks) I've noticed my temperature gauge on the dash cluster doesn't jump up to 190 as it had before. It just sits there when I start the car, and then eventually builds up as I start driving. Reason this concerns me is because I don't remember this ever happening.
View 9 RepliesI have a 2006 Jeep Liberty 3.7L that has a temperature gauge on the dash that reads an overheat when driving. The oil looks normal, there is no white smoke, no bubbling from reservoir. I have replaced the following:
Radiator
Thermostat
Water Pump
Coolant Temperature Sensor
Coolant Reservoir Tank
I am not leaking any coolant and the reservoir level has been fine. I have let the vehicle idle for 20+minutes, with no overheat. When I drive it around, the temperature gauge will read an overheat. When I stop the car and pop the hood, the engine is not overheated and both rubber hoses to/from radiator are flowing the coolant. The only thing that will bring the gauge down is turning on the heater full blast. Could this be the gauge itself being bad? Could it be a short in a wire somewhere? I had thought maybe a head gasket, but have no symptoms of a head gasket.
This past Saturday afternoon I'm out driving on the highway when the temperature gauge on dash maxes-out and the overheat warning light comes on. I get off at the next exit and stop at the nearest repair shop. (Which happened to be not too far from the exit.) During these moments of driving the car is not behaving as if it were overheating. No steam/vapor coming from the engine, it's performing okay, A/C runs cold, running heater on full-blast seems to do nothing to ease the gauge and the temperature in the engine bay feels about "normal."
So, since this is a Saturday at almost 5PM most of the repair shops are closing (it's a known fact cars don't break down past 5 o'clock on Saturdays.) So they say the'll look at it on Sunday.
I get a call on Sunday and I'm told that as near as they can tell the car is not overheating, the overheat light or check-engine lights weren't coming on and the car is behaving normally. The thermostat is "gunked up" and they recommend new coolant or a coolant flush." I just opt for new coolant, forgoing the flush, as I didn't really have the funds for it, an additional $100 or so. They say there are no codes in the system.
They do it and end up having to keep the car overnight so that the... air bubbles will work out of it? (?!)
I pick it up this past Monday evening and on the drive home the temp-gauge does as it was doing when this process began. It started creeping "hotter and hotter" meanwhile the car is behaving otherwise fine. (No overheat light this time.) Get home, open the hood, no vapor, no excess heat. Nothing.
They spend quite a bit of time running it, hooking it up to a diagnostic machine, etc. While the temp-gauge is sort of "floating around" between normal and "hot" it doesn't reach an "overheat" and the diagnostic machine registers normal temperatures. This time they find a code in the system, though the check-engine light has never come on. They recommend, again, the coolant flush so I go ahead and do it (they give me a discount), and drive the car home, again the temp-gauge "floats" around the dial, never quite getting to "overheating."
I drive to work just fine Thursday (today) morning with no real trouble with the gauge. (Though, FWIW, I had to tap on the dash to get the dash-light on that side of the console to come on.) This brings us to Thursday afternoon.
I make a couple of errands and as I'm stopped at a pharmacy drive-thru the temp-gauge is "floating." Driving home on the highway it reaches "overheating", turning the light on (again, car is not behaving in an overheating manner. A/C still cold, running heat doesn't ease gauge, no vapor from engine compartment.) When I pull in my parking spot the A/C and the car starts to "stall" some and NOW the check-engine light comes on. I shut the car off and I see vapors coming from under the hood.
I open the hood and the engine is covered in the anti-freeze/coolant and the coolant reservoir is empty. The various hoses and such that are clipped on to parts of the front engine cowling are loose (the plastic screw/"snaps" came out of their holes) and pushing on the upper-radiator some and it seems awfully loose. (Like the upper mounts aren't properly seated or something.)
Call the shop ask them what they are doing to me, they say they'll have another look at it and pay for the tow to get the car back to their shop. Awaiting word on what is going on, likely sometime tomorrow.
All of this strikes me as very, very odd and all seems to pile up quickly from taking it to this shop. With a replaced thermostat and flushed coolant I have a hard time understanding how the engine could genuinely overheat. All of the hoses and such seemed fine, and running the engine for a while at the shop the other day generated no problems to the techs working on the car. Yet, they're the only ones who have messed with it. Assumptions on their part Tuesday afternoon were something to do with the water pump (replaced at 100,000 miles with timing belt. Car is now at 145,000 miles.) Or a faulty temperature sensor (or what passes for it on the car) sending false readings to the gauge.
Car is a 2000 Ford Focus ZTS with a 4-Cyl, 16V, 2.0 Liter engine. It has 145,000 miles on it, timing belt and water-pump were replaced at 100,000 miles have had regular oil-changes on (more or less) every 5,000 miles or so. I will admit to not getting coolant changes/flushes as often as one should but the car never really had an overheating issues or problems starting in the winter.
I have a 2003 Excursion 6.0. I didn't post this in the 6.0 section because it may not be just a 6.0 issue. (See what I get) On cold starts, anything under 150 degree water temp reading on the SGII. I get a CHECK GAGE light on accompanied by the check engine light. No codes read on the SGII pending or stored. Just some of the time I get a water in fuel light too. This tends to go out fairly soon after driving. (Even after I just drain the fuel pump it still happens.) other issues that accompany the lights are as follows.
The trans temp does not give a reading to the dash. The oil temp does not give a reading the dash. Both show proper temp on the SGII. When in reverse the back up alarm beeps as if something is behind me. And the auto door locks will not activate after 10 mph. The tach also will not show a reading in the dash. SGII shows the numbers. Now the kicker, this ALL gets resolved the instant the water temp hits 150 degrees. The only lingering issue is the that the tach will surge or drop every now and then. The tow/haul light does not come on when this is going on. I've checked the battery terminals all are clean. Both batteries are brand new.
My outside temp gauge will go down to -33 degrees cutting off the A/C. A little later it will go back to normal and the A/C comes back on. Could this be a sensor etc...
View 1 RepliesMy temperature gauge on my car sometimes ill notice is being a little over the middle and sometimes till be a little under the middle is this normal for it to do that or should it stay in the middle ?
View 2 RepliesI recently purchased an 03 GLX wagon 4 motion from a dealer as is. It had 84,000 on it when I got it and needed a timing belt. The work was performed by a VW dealer and all has been well until today. I was on the highway, had been working the car pretty well for about an hour and i noticed that the temp gauge which is at 190 religiously is now dropped down as low as 120- 130.
I continued to drive, thinking maybe just a bad sensor/gauge considering I had no check engine light yet. I still have good heat but when I got home I noticed that the coolant reservoir was bubbling pretty fierce. Couldn't tell if it was boiling or if it was compression coming back in from perhaps a head gasket failure.