I drive a 1998 B5 1.8T passat. This happens when i go up a hill, i mean i can go up the hill fine but then when I go straight my rpms go crazy before changing gears, idk if this is normal but I doubt it.
View 9 RepliesI own a 1996 Corolla DX with an auto transmission which has a few issues I would like to fix. The biggest issue is that sometimes it stays stuck at high RPMs (somewhere near 3,100) without changing gears which makes me have to give it some extra torque momentarily to change gear and drive at normal RPMs. But sometimes it does the opposite, when slowing down it sometimes stays at a higher gear and won't change to a lower gear until I've slowed down almost to a stop.
Another issue is that it is very slow to accelerate, it just feels real heavy and I regularly have to give it a lot of torque just to be at equal speed with the rest of the cars on the road, does this have a fix? Other than that there isn't any major issue that I actually know about, for this reason I'd like to know what place you would recommend me taking my car to get a full checkup to find any issues I don't know about.
About twice a year I am noting a too soon change of gears on automatic mode. This may be the fourth time it happens is just coming and going by itself.
I notice that when driving on constant traffic and going about 40mph I'm doing 5th gear so when traffic clears up I have to really step on the gas so car downgrades to catch up with traffic. What may be happening?
I have an early model year 2004 Touareg which has lately developed what appears to be a slipping problem when changing gears from 5th to 4th when decelerating or the same when accelerating strongly and downshifting. When switching over to tiptronic mode, its not clear if that apparent slipping goes away or changes. It definitely isn't as severe but that could be due to perception or the RPMs where the shifting is occurring.
The only real interesting characteristic of this clunk and lurch that is experienced is that it only happens when the car is warm -- I've been watching the transmission oil temperature, and it appears to start happening as it passes through 200 degrees. When it starts, the lurch/clunk is small and not too bad. As the car reaches temperature, it reaches if full lurch/clunk potential.
I have taken it to the dealer once and they have "upgraded software" that was supposed to clear up the problem, but did not.
I have a squeak when I change gears, especially from 1st to 2nd. I have a twm short shifter with bronze cable bushings. My first thought was that the bronze bushings were causing the squeak, but I eventually narrowed it down to the shaft that comes out of the back of the transmission with the weight bolted on it (not sure what it's called). I took out the intake filter box so I could get at it and confirm that it was where the squeaking was coming from. That's definitely where it was coming from so I pulled back the boot seal and greased the shaft with some white lithium grease. That has worked a bit, but the squeak is still there.
View 8 RepliesMy wife always chastises me for not coming to a complete stop from backing up before I shift the car into drive. I do not shift when the car is still moving more than 1-2 MPH, in fact it is barely moving when I change gears. My wife insists that I come to a complete stop and wait 1-2 seconds before shifting from reverse to drive. She is convinced that I am doing damage to the transmission the way I shift. I insist that no damage is being done and point out that with over 100,000 miles there have been no transmission problems with the car. Am I damaging the transmission by shifting before I come to a complete stop in reverse?
View 9 RepliesI have a 2002 Impreza Outback Sport. Since moving to Tucson, AZ, from Flagstaff, AZ, the car jumps when changing gears (I have a manual) as if I was back in the day of learning how to drive a stick shift. This only happens in the summer, when temperatures get up to 110. Also, the idle is very rough and the car almost stalls when stopping quickly (this is infrequent). What's happening with my car?
View 2 RepliesMy 2002 Dodge Grand Caravan transmission suddenly does not changing in gear This happened when I was driving. The engine light came one and transmission seems to stuck in a gear. Acceleration is fine but the van slows down quickly if I let go the gas pedal. Seems like it stuck in a gear. How to I troubleshoot and is there anything I can do at home?
View 19 RepliesBought a 2009 Chevy HHR with 35,000 miles in July, 2010. In the summer of 2011 the ignition was replaced, as the key would not turn. (The engine was running at the time. It was necessary to disconnect the battery to turn off the engine.) At 55,000 miles the transmission suffered "catastrophic failure" and the entire transmission assembly was replaced. (The engine light never came on, although the transmission was slipping frequently.) After driving the car with the new transmission between 100 and 200 miles, the engine light came on. The error code indicated a faulty transmission fluid pressure switch. The transmission changed gears harshly at times and the automatic door locks stopped working properly. Sometimes they would lock when the car was taken out of "park" and sometimes not. Likewise, they would not always unlock when the transmission was put in "park." After replacing the switch, the technician said that for no reason the security light came on briefly as did the passenger airbag "on" indicator light. Once again, after having driven between 100 and 200 miles, the engine light is on again, and gears are sometimes changing harshly. No diagnosis yet. Do I need an exorcist?
View 7 RepliesI own a 2000 Jetta auto with 200k on it. I have the same problem. It wouldn't change gears till 4000 rpm i scanned it. And got the cods g38 and g68. So I changed both. It was working fine then again same thing it works then stop works. So scanned it again and got same codes changed them again worked fine then stopped working so I took it to vw and they told me same thing same sensors and the wire harness so I changed them again got the parts from VW this time. It was working then stopped. And when I turn on the car and drive my gear box display goes all black for at least 10 min driving then goes back to normal. But sill doesn't change gears. Now not even after 4000 rpm. Ps. When I do it manual 1st gear 2 and changes fine once I put it on drive doesn't not change gears.
View 7 Replies2015 GTI, 6sp, Coupe, 3000km.
When changing gears from 1st to 2nd and 2nd to 3rd, I get this faint THUMP thump noise coming from what seems to be the driver side foot well area, on the other side of the firewall.
Other ways to replicate is by simply clutching in as if changing gears, but not actually shifting. It can be prevented by shifting/accelerating very slowly (not practical).
Nothing can be felt in the clutch pedal OR the shifter. Can't be replicated in neutral, or by simply letting off the gas under boost. ONLY when the clutch is engaged about 2.5k RPM in 1st, and 2nd.
What it could be. Dogbone bushings? Engine mount? Gerbils? Also, went to dealer and they said it wasn't "enough" for them to start pulling stuff apart. Was told to wait until it gets worse.
2004 Dodge Neon SXT ... Let me say first, I know very, very little about cars. But it all started when I was driving down the road and my car was bucking around 40-45 mph, it stayed that way up until I put some gas in the car the next day and the car started shaking violently when I turned it on. Ever since then my car has been not able to change gears. Reverse works normally however. Now the speedo doesn't work at all and somehow the has gauge will fall or rise depending on whether I'm stopping or going.
So I ran to AutoZone and got a diagnostic ran on my car. It gave me codes P0700, P0731, and P0720. I kept calling around and got horrific quotes around a thousand bucks and mechanics saying my transmission was out. However, I turned it over to a close friend who could work on it for free and has some mechanic experience. The first thing we did was replaced both the output and input speed sensors, which didn't fix it. Then I got a new transmission control module, which for my car I assume it is the TCM and solenoid. Still. That didn't fix the problem. Those were some common fixes I found online for neons. But what else it could be.
I have 3.73 gears now on a lifted 02 excursion with the v10 and 315/75/16 bfg tires. Motor is stock. My first question is I get about 8mpg right now, what will the 4.56's do to that? I pull a 6500lbs trailer alot. Should I just try to find a 4.30 axle and swap them or just change gears?
View 14 RepliesI have a 2004 Hyundai Accent 1.6 DOHC 5-speed Manual Transmission ... so here is my problem;
Regardless of whether I am going from a complete stop or if I am simply changing gears the acceleration is practically non-existent, sometimes taking up to 3 minutes to accelerate just 5 mph. While I am driving at a consistent speed of 65 mph, the RPMs will randomly jump from 3000 to 4000 or 5000 with no apparent cause.
I have been told everything from putting air in the tires to replacing the clutch. I do not have the time nor the money to try every option of fixing this issue. I need to attempt to narrow this down to as few probable causes as possible.
I have a 2010 SEL with auto transmission (obviously). When it changes gears both up and down shift there is a clicking noise. I don't remember hearing it before about a month ago, but that doesn't mean it wasn't there.
View 5 RepliesGot a 02 Jetta 1.8T 5spd auto tiptronic with 100k miles. Having issues with shifting. Trying to determine if its electronic or mechanical. Had a short in solenoid 10 N283 which melted the TCM. Put in a used N283 to see if the trans is still ok mechanically. Plan is if its ok to put new fluids and solenoid pack. What do the experts think does is need a full rebuild or will new electronics do the job?
After putting the used N283 solenoid the trans works but not correct. The problem is in the shifting only. Feels like its out of time. When you start moving from a stopped position from 1st to 2nd the car takes off good but when changing gears it reves and feels like its slipping then it hits hard into 2nd. Then 2nd-3rd is a fast shift and not hard. 3rd-4th slips and revs a little then changes gears 4th-5th is fine. all down shifts are fine. Does not mater if the car is hot or cold its the same.
If I disconnect the MAF 1st to 2nd shifts fine with no problems. 2nd-3rd little rough but not bad. Problem with disconnected MAF when going in Drive at 30-40mph all of a sudden it jumped into 1st gear and felt like I was slamming on the brakes.
With the MAF connected and I shift manually in tiptronic mode each gear runs real good with no slipping at all. But same problem happens when switching gears. I can drive it smooth if i accelerate to 3000 rpm and then left off the gas a little and it shifts fine.. Same with the other gears.
I got a used TCM to rule that out and the problem is close to the same. It tries to shift at lower rpm but still does about the same problem. I did recently had a MAF go out. Put in a new bosch and no change. Did my VCDS scan and only codes I get is "17840 secondary air". I can get operational data on some solenoids but not sure what parameters to look for.
I have a 2011 Tiguan 125TSI with the 7 speed DSG. When it starts cold, you can hear a noise that sounds like a bad gear change when going from 3th to 4th, and 4th to 5th. It almost sounds like changing gears in a manual car without clutch completely depressed. It has been there since I got the car brand new, but recently it seems to be getting worse.
Once the engine gets warm, the sound goes away and gear changes are smooth.
I've asked the VW dealer about the sound and they tell me it is normal. Is this right? The problem is it is very hard to demonstrate to VW the issue since it may happen only once when the engine is cold. I've left it with the dealer overnight and they were able to reproduce it in the morning... but again, they tell me this is normal.
I have a 1999 Honda Civic DX hatchback with a 5-gear manual transmission that I have been driving since the day it left the dealership. This morning, on my way to work, I was shifting from third gear to fourth gear and the car stalled. This has happened three times in the last month or so. I recently had my transmission fluid flushed. I'm 95 percent sure this started after the transmission fluid was flushed.
View 8 RepliesI took my car to a shop today to have some engine stuff checked out. One of the mechanics noticed the vacuum levels would drop to 28-30 hg when changing gears or going into neutral. Is this normal?
View 2 RepliesMy Mustang is an automatic. The shifter in the console sticks when changing gears. At times, I have to keep it half way into another gear or else I hear grinding or the car won't go into gear. Is it my transmission or my console?
View 2 RepliesWhen I accelerate i get a loud squeal until my truck changes a few gears. Its only when I accelerate and only if my trucks warm and has been running or a few minutes. Cold start it wont happen right away. What it is or could be. Changed my serpentine belt that didn't work...
View 7 Replies