Just noticed the other day the Passat was idling significantly rougher than usual, most of the time it's smooth as butter but not so much lately. It's not rough like a bad misfire, just not very smooth anymore. This could be indicative of the dreaded oil-pump bolt failure rearing it's ugly head (finally)?
View 1 RepliesI have an 08 Passat 2.0T with 44k on it, just did the 40k service around 42k. This past Friday I filled up from almost completely empty, and later that day and ever since the engine has been idling rough and the CEL came on. Gas cap has been checked already.
Should I wait to go to the Stealership until I've burned this tank of gas out? Is there anything else I can do that you can think of?
Weird problem on my Passat today. First the engine light came on...followed by rough idling. It smooths out when moving, but rough again when stopped. Noticed that turning ON the AC makes it a little smoother...but when you turn off the AC, resumes the rough idle.
Already made an appt with the dealer tomorrow...but wanted to see if this problem is familiar to other owners. Either way, I will update once the dealer finishes diagnosing the problem.
The car has been perfect up to 30k miles...now 2 problems in the last month.
I just got my first dub, and it is a project car. I have had it serviced and it still idles rough when in drive with foot on the brake but idles normal when in park. a
View 2 RepliesI haven't started my passat for the winter and I finally did today. It was ruff start/idling and I pretty sure it was misfiring on one of the cylinders. I turned off the car and start it again...same thing, ruff idling like 3 cylinders were running. I waited five 5 mins and started it again, then it was a normal start on all cylinders. But the engine light came on, even though it started properly. I know I have to clear the code to get rid of the engine light. But I want to avoid any future misfiring. So I'm thinking new spark plug/coil overs.
View 9 RepliesOnly thing I've noticed is the idling is a little rough but the car has 88k on it so that's expected. I haven't checked the cam follower yet and know I'll probably need to change it so that's going to happen in the next week.
I had a code for P000A & P2293 for a few months that would throw a MIL and I would reset it and it would come back after a while. I finally replaced the cam sensor and I didn't see a MIlL for about 6 weeks and one day it came back. Once I scanned the car it showed P000A again. I cleared the code and everything seemed fine until yesterday. I went to start the car and the car wouldn't turn over.
I pulled the key out and tried it again and it worked. More and more I think about it, the car doesn't turn over smoothly over the past few months but maybe I'm just looking for things. I ended up scanning it last night and it had a code for P2293 & P0011. I cleared them both but what could be causing all this and cannot afford to bring the car in to the mechanic. It's out of warranty and I'm broke and X-Mas is around the corner.
2006 Passat 2.0T
Ok, I have owned my 02 Passat with the 30V 2.8L V6 since may. I got it with 115K and now its just under 129K I had the timing belt done at Jimmy's in Provo UT at 126K and up until then the engine ran great. Since the belt was replaced <along with the water pump and such> . The car has a tendency to feel like its idling rough, and when you start it up first thing on a cold morning it sounds like the valves are rattling. It does this for a brief second then goes away until the next time you start it in the cold morning. It wont do this if its warm outside, or after you start it previously that day. So far I have replaced the plugs with Bosch Platinum 2 prong plugs, and replaced the fuel pump. I replaced the fuel pump when it dead on me without warning about 2 months ago.
View 1 RepliesI was just at work tonight and went out and started my car for it to warm up (it is -20) and go back inside for about 15 mins, I come out and as I am walking back to my car. I notice tons of exhaust is blowing out from the bank puffing like a steam engine and idling insanely rough with the RPM gauge at about 900 RPM with a EPC code. I immediately shut off the car. Cautiously turn the car back on. Car is idling normally, EPC code is gone, rev it a bit. Everything seems fine.
View 20 RepliesOur '02 Toyota Camry with 92,000 miles has been idling rough for awhile. I tried cleaning the throttle body which actually seemed like it made it worse for awhile. I do need to replace the valve cover gasket and I don't think the spark plugs have ever been replaced. Is that a good place to start?
View 6 RepliesIt could happen once a month or 3 times a day. No pattern and never the first time I start my car for the day. But I will be running errands, park the tiguan, run into a store for 5, 15 or 30 minutes and when I get back in my car and start it up and go, it dies when shifting from 1st to 2nd. I know how to drive stick. This doesn't happen every time. I have called/taken it to the dealer 5 times and they have no clue because it never happens with them and I cannot predict when it will happen again. Also, on occasions, when i start my car, halfway through the day, the engine will idle really rough then the RPM's will spike and the car gives itself gas and my foot is definitely on the brake. These little issues are starting to piss me off, especially since the dealer just shrugs its shoulders.
View 12 RepliesJust picked up my 2004 Prius from the Toyota dealer body shop. The driver's side was scraped by someone who wanted to be in my lane. Fortunately, we were only going 35 mph. The rear door skin had to be replaced, and most of the side had to be prepped and painted. There are a few silly mistakes: they forgot to replace the driver's door plug, forgot to replace a lower clip, and smudged a tiny area new paint on the bumper. I brought that to their attention and they are going to take care of it... they have to order the plug and clip.
However, as soon as that conversation was complete, it was time for them to close shop. I sat in my Prius, started it, and the check engine light was on. Wasn't on when I dropped it off for the repairs. Also, on the way home, I noticed the engine wasn't turning off when I came to a complete stop (even though the animation says it was off). At idle, the engine is also rough. Looked at the charge bars, and well, there were only two bars showing.
I thought perhaps, though it's not done this before without the animation screen showing it, the engine was on merely to recharge the traction battery. On the way home, the traction battery returned to full charge (green), but the engine still was not turning off when the vehicle was at a complete stop... not was it turning off when coasting... and when arriving home, even with the car in park... and still idling rough. All the while, the animation on the screen is indicating the engine should be off.
When I replaced the traction battery three years ago, I also replaced the 12v with an yellow top Optima. I wouldn't think the Optima is already going bad. I also do not believe in coincidence. I wonder if perhaps some bad fumes have tainted the MAF, or who knows.
Today I went to the gas station and after I gased up and turned the car on my car started idling rough, almost to the point of cutting out. I started out on the road and my check engine light started blinking. After some time it stopped and just stayed on. The whole front end shakes pretty bad when at idle. The car has trouble accelerating till roughly 35-40 mph then seems to ride ok. I'm not very car knowledgeable, but I do take care of my car. I know I need to replace some of my hoses and spark plugs soon, but am worried that it may be more serious.
What I would like to know is: 1. What could possibly cause these issues and 2.
2003 Mazda Protege
So I bought my accent used a couple months ago. It is a 2007 SE 3dr 5spd manual. It ran nice during my test drive and the price was right so I bought it.
Now I'm wondering if there is any way to find out the service history on the car...at least the major one's (30k, 60k)?
I ask because recently the engine was idling a little rough and it threw a P0302 code so I changed the spark plugs and holy-cruddy-deposits-batman those things were black. Gapped the new ones and popped them in and its a noticeable difference. My CEL keeps coming on and throwing a P0496 code as well, virtually once every tank of gas. Its not the gas cap so my next step there is to check the PCSV and hoses.
With these little problems, it makes me wonder about any larger issues. I know the timing belt on these things is supposed to be replaced at 60k. Additionally I would be willing to bet that my ECM software is out of date. Would Hyundai have records for any of the big maintenance milestones since they are required for warranty work?
How much does it cost to have a dealer check your ECM software and update it if needed?
My car is idling rough and the Service Engine light blinks on/off continuously. I ran the codes and they are P0301, P0401 and P1258. What this could be? I changed the plugs, wires and ignition coils about a year ago. Catalytic converter was replaced around the same time but the O2 sensors hasn't been changed. Could that be the cause?
View 1 Replies2001 with the 3.1 6cyl. First thing that started this nightmare is I was noticing a bit of a hiccup after driving for a couple miles. We've only had the car a few months and not sure what maintenance was done so we thought maybe it needed a tune up. Before I got the parts the check engine light came on so I went to parts store to get it read, it was P0302.
Did the wires and plugs and it got worse, the code wasn't p0302 now its just p0300. But after the plugs it also started idling really rough and would be slow to shift. Once it tacked up high and wasn't speeding up. That was only once tho. Also now it has no power its like driving a 2cyl ...
Anyway we decided since the first code said 2 we replaced coil 2, no luck..ok, fuel filter and fuel injector 2, no luck. Also has cleaned various things Im not sure of the technical name for..sensors and air filters and other things.
None of this has worked the car still idles very bad and doesn't have the power it should have. Also cleaned things on fuel rail(?). He is in the process of replacing the crank sensor as someone said if it was all the way bad it would throw a different code but it may just be faulty.
I changed timing belt and water pump DIY back in Oct 2015. Ever since then, I get rough idling (car kind of vibrate and engine kind of struggling) after warm start (no problem with cold starts, it did stall once after the warm start).
Two days ago, I got a P0000 code, I thought it was due to low oil (happened before, I topped off oil 2500 miles ago), so I changed oil and filter. No problem yesterday, but today on my way to work. I got the p0000 code again.
I replaced the heater core in my truck this weekend. The only thing I was worried about was pulling the dash. The truck is a 1998 f150 with the 5.4.. Everything went fairy well and decided to replace the AT Shift cable as well. Got everything put back. Truck runs, no leaks, no antifreeze smell. After running about 20 minutes, it started idling a little rough and my check engine light came on.
The codes are p0136, p0156, p1131, and p1151. I know these are related to the OS sensors. My question is could it be as simple as I miss an electrical connection when putting the dash back in? Was thinking possibly somewhere on the passenger side under the kick plate or possibly something while hooking up the heater hoses? Maybe even a ground that didn't get connected back when putting the das back in?
This problem has been getting worse over the last 2 years. When the car starts it idles fine at about 1000 RPM. As soon as it warms up, it starts to idle rough, between 500 and 750 RPM. It almost quits running. As soon as you give the car some gas it runs just fine. About 3 weeks ago I got a "Engine Lean" check engine light error. I reset the system and have not gotten the error again. Since then I have: changed the MAF cleaned the EGR (made sure it closes completely and ohm out the coils in the actuator) changed the O2 meter on the exhaust manifold cleaned out the throttle body Ohmed out the air idle controller. What I should check next. I was planning to check the fuel pressure in case it is a fuel system problem. It is a 1999 ....
View 5 RepliesAre these cars supposed to be this noisy? I have an 06 passat 2.0t its rather noisy. I'm not sure if its supposed to be this way or what. Any videos with your car idling?
View 5 RepliesI posted earlier about my car idling roughly, the dealership is now saying it may be my engine or transmission mounts. I have a 2002 Passat wagon with 41500 miles.
View 2 RepliesEarlier this winter and last year, the forum had discussed the occasional fast idle in the 3.6L. Symptoms include the engine idling at 950-1000 RPM and the car feeling like it wants to surge forward. I had the problem twice during heavy snowstorms in February, but nothing really since...until this past week.
The weather here in Chicago has been in the early 90s and I've had the AC cranked. At the same point, I've had the fast idle event occur at least 5-6 times in the past week. Almost every time it has occurred while moving in very heavy traffic. Have others seen something similar in very hot weather?