Passat (B6) :: Code For Airbag Igniter - MIL On
Mar 22, 2009
Got this DTC for the third time now, just a few weeks between each other:
Address 15: Airbags Labels: 3C0-909-605.lbl
Part No SW: 3C0 909 605 F HW: 3C0 909 605 F
Component: 01 AIRBAG VW8 029 2421
Revision: 08029000 Serial number: 0039USC5GVEJ
Coding: 0012337
Shop #: WSC 05311 000 00000
1 Fault Found:
01217 - Side Airbag Igniter; Driver Side (N199)
001 - Upper Limit Exceeded - Intermittent - MIL ON
Is it a poor contact, bad wiring or must the igniter be renewed?
View 2 Replies
Advertisement
I have 94 SE camry with the 3.0L V6 1MZ-FE engine and has individual coil packs. I'm getting a P1300 Igniter Circuit Malfunction. I have checked it out per the procedures EG2.pdf. I'm down to step 8 and the voltages are little different between the 6 points. started checking out the ground at the ECM per IN36 instructions. it appears that from pin #27 & 28 are not grounded to the ECU case.
View 5 Replies
So a couple weeks ago my passenger headlight started flickering. After a couple days the bulb was out. I bought a new bulb and opened up the headlight to install and found the bulb melted into the igniter. Ok, bought a new igniter. Installed everything. And still nothing. Checked the fuses and wires, nothing loose. Headlight still didn't turn on. Went to my mechanic and he said it's the ballast. I buy a new ballast and he just called and said the ballast I bought was defective. The light was turning on, but no high beam.
Does the ballast control the high beam? If it's not the ballast, what could be the problem?
View 2 Replies
2004 Chevy Suburban 4wd
My airbag light is on and my code reader, Innova 3160d, is telling me that the B0083 code is the Second Row Left Seatbelt Load Limiter Deployment Control (Subfault).
I Googled the code and came up with 1) passenger seat position sensor, and 2) front impact sensor 1 (driver's side).
Which one is correct?
View 1 Replies
My 09 Camry was involved in a frontside impact crash about 2 years ago, I've had the car fixed since then by a body shop. However, my airbag light has been on for several months and will not go off. I've even had someone at a local garage try to turn it off, but it did not work.
Today a friend of mine used a clip to read the airbag code, and we got the code 31. I'm not sure what this means though.
View 4 Replies
I have suddenly acquired a new value added feature to my X. An airbag warning light flashing code 18. Through the research I have found it is either a pretensioner issue or a short. Would like to know for sure what it is.
It is a 2001 LTD 5.4L.
View 5 Replies
I have a Air Bag Light on and Code B1811 2007Camry, same thinking clock spring?
View 1 Replies
I have a 2009 Toyota Prius. The airbag/srs light came on a couple weeks ago and would come and go. Eventually it came and did not go. This didn't really bother me as I don't drive it much anymore and I figured it would be gone by the next time I went to start it up. (I also heard about connections under the seat being loose and hoped that was the problem.) Well I was wrong. Today I noticed it was still there so I decided to start diagnosing. I jumped the connector as my obd2 scanner only reads regular and abs codes (not srs apparently).
The only code that came up was 51. Which is the driver side squib circuit. Many say that code 51 usually just ends up being the spiral cable. I simply find this odd as every button on my steering wheels works. Cruise control works fine etc. Idk how only 1 or 2 wires get messed up in that thing and how they turn out to be the ones for the airbag but I suppose its possible. My next step is to take a continuity tester to the 2 plugs that connect to the airbag to see if they are getting power.
View 8 Replies
My airbag light went on so i scanned for codes and I got:
00592-seatbelt switch:right (e25) 32-00-resistance too high.
What I need to do to fix this and make the light go away?
View 4 Replies
06 Camry, ~130K miles.
So the Airbag warning light in my Camry has been coming on (and staying on) intermittently, but would turn off if I turned off the car and restarted it. May take a cycle or two, but it would turn off.
Took it to the dealer, they isolated to the passenger side seat. They cleaned contacts, reseated connectors etc.. and the light stayed off for a while. By the way, there appears to be no relationship to anyone sitting in the passenger seat, or not, at the time.
Happened again maybe 3 weeks later. Same thing was done at the dealer.
Took it in today with light on, they pulled the code B1826 (Description: OPEN IN SIDE SQUIB (P SEAT SIDE) CIRCUIT)
This is my wifes car (and kids) so no airbags isn't an option. According to the documentation I got from the tech at the dealer, the Detecting Condition is:
The airbag sensor assy center receives an open circuit signal in the side squib (P seat side) circuit for 2 seconds.
Side squib (P side seat) malfunction
Airbag sensor assy center malfunction
The "Trouble Area" information:
Front RH seat assy (Side squib (P seat side))
Airbag sensor assy center
Floor wire No. 2
View 6 Replies
I recently received an airbag fault light so I figured that I would scan the module for error codes. This is what I came up with:
Control Module Part Number: 3D0 909 601 C
Component and/or Version: 05 Airbag 8.4E++H01 0352
Software Coding: 0012341
Work Shop Code: WSC 31414
Additional Info: 7L0959339B BF-Gewichtsens. 005 0006
Additional Info: Geraet 00000
2 Faults Found:
01217 - Side Airbag Igniter: Driver Side (N199)
001 - Upper Limit Exceeded - Intermittent
01316 - ABS Control Module
004 - No Signal/Communication - Intermittent
Has scanned the car while had the airbag fault present and if so, is this the usual harness that needs to be changed?
View 11 Replies
What airbag code 29 on a 2001 ranger means? I have not seen that number on any code lists. I triple checked the code and it is 29.
View 9 Replies
Ok I have a 2004 F150. The airbag was flashing 42, I have since replaced that sensor and now its flashing code 16. I have searched everywhere and cannot find the answer to my question. Any clue as to what this code is trying to tell me. Lost 1, this is lost 3, are you lost 2?
View 4 Replies
I have a 97 Ford Explorer and the air bag indicator started to flash a code 45. What is this code and what do I need to do to clear this problem?
View 5 Replies
Several weeks ago my 2010 Prius (actually bough 8/09) started displaying an intermittent airbag warning light. This is the red one on the right side of the display. Brought it in to the dealer, as the warranty on the SRS system is 5 years. They charged me a diagnostic charge of $96.00 because they claimed that although the SRS is covered under warranty, the diagnostic system was not. They did the work, and should get paid, but I am still after Toyota to pay them, and refund me. In any case the diagnosed code was B1826, which is an open in the side squib left hand circuit. In other words, a poor connection, or one with more resistance than the computer expects to see. They recalibrated the system and claimed it was fixed. However, two weeks later, it's back again.
View 6 Replies
Airbag light came on. Finally got a scan tool that will read it. Comes up with an active code of B1481 (Driver's airbag 2nd stage resistance too high). The scan tool shows 1st stage resistance at 2.6 ohms and 2nd stage at 6.6 ohms. My understanding is that it could be a faulty airbag or clock spring. How to further diagnose the condition?
View 6 Replies
I bought a used 2005 Elantra a couple years ago for my teenagers. The airbag light came on, so I took it to the dealer. The code they found is B1448. They said they need to replace the passenger side seat cushion module. (I think the value of the whole car can't be much more than that!).
View 2 Replies
2003 Santa Fe GLS 120K mi. 2wd, 2.7L, AT.
Been having for some time an intermittent problem where the air bag light will come on and not clear. I can clear it sometimes by removing the neg. batt. term. and letting it sit for a few minutes. The "air bag" light always seems to come on when someone sits in the passenger seat. The dealer reported a trouble code of "B1382-- PSAB harness improper pin tension" They said that they re-seated a connector and it was good to go. Now the "air bag" light is on again. Does the description refer to the pin tension in a connector? which connector does it refer to and can I just tighten up the female part of the connector such that the male pin makes better contact? Is it the yellow connector under the seat?
View 7 Replies
Corolla has this code : B1801
When i erase it comes right back!
Open in (D) Squib Circuit. What to start looking for?
View 1 Replies
The airbag light on my 1995 Ford Ranger is flashing a code 41 (four flashes, pause, then one flash...does this a few times when I start the engine, then goes to a solid light which stays on while I drive.) It has been doing this for several months, and to be perfectly honest, this has not been a concern for me but now that my state inspection is coming up in December, I need to do something about it. Just before I noticed it to begin with, I had a major repair done--the dreaded heater core replacement--which involved removal of the dashboard. I never associated the flashing with that repair and the possibility that the repair shop might have inadvertently neglected to reattach something when reassembling the dashboard and now so much time has passed, that I can't just go back to the repair shop.
View 4 Replies
2006 F150, FX4, 5.4, super crew. Had the infamous airbag code 42 flashing at me the other day, replaced the sensor in the front of the radiator support, and am still getting the same code. The old senser had some corrosion inside the sensor itself, but the connections were clean on both the sensor and the pigtail. Is there something I may have missed?
View 3 Replies
