Passat (B6) :: Rough Start - Cylinders Missing For Like 5 Seconds Then Fine
Feb 12, 2008
When I start my car it seems like some of the cylinders are missing for like 5 seconds then runs fine. Sometimes its quite violent and this morning it stalled the first time I tried. The colder it is outside the worse this becomes.
The car is still under warranty, but you have to wait a week to get the car into the dealer here and a battery wouldn't be covered anyway. Here is what I have so far.
Bad battery : The car has 45k miles on it and as far as I know the battery is stock. Also, when I did the 40k service I seem to remember something about the battery on the invoice (I will look), but I was too busy worrying about the bald tires. I do generally leave my ipod plugged into my car stereo (which charges it) over night, so that is putting a drain on it. I am going to take it out of the car tonight and see if that makes a difference. I suppose I could take the battery to O'Reilly's and have them test it, but it seems like it would be in their best interest to lie.
Coolant temperature sensor : The car was recently in the shop and they said they found a small coolant leak and fixed it, maybe the sensor became damaged? Most reports I see about this suggest the car runs rough for much longer than mine and must be fed gas.
View 4 Replies
Advertisement
My 06 Sonata runs very rough at start up when the car is cold. It appears that it is missing on several cylinders. This last for about 15 seconds and then the car runs fine. What could be causing this problem? No check engine light.
View 10 Replies
Picked up a super nice 03' as is with a no start. It cranks over nice and smooth, sounds like it has proper compression, and has proper fuel pressure. Tried spraying either in it and it will almost catch.
Tried putting a known good coil pack on it, no dice. Usually when other engine slip timing chains, it will crank rough, like a few cylinders are zero. This is not the case.
View 12 Replies
So I had 1st rough cold start today on 2010 Prius with 72K. Wasn't too cold low 40s. The fix was to shut it down and then turn on again.
Engine sounded like it was working on 3 cylinders. It is probably ignition or perhaps valve train issue.. with ignition being prime suspect. If it happens again I'll pull and check plugs.
View 13 Replies
1999 F350 & lately if I don't plug it in even if it's like 40 out for like the first 30 sec sounds like its only running on 4 cylinders than it'll just even out & alls good. thinking glow plugs here. I did replace them last fall unfortunately with the cheep ones that I been now reading bad things about.
View 2 Replies
96 civic 120K miles, stock, automatic.
In March I was running low on fuel, maybe 1 gallon left in the tank. It took a few cranks and on the last try i gave it a little gas and it started, albeit very rocky for about 1 minute of driving, filled up immediately and 2 freeway miles later, no real issues. I live in LA so very low ambient temperature is not a problem.
April through May, starting was a little rocky, it was inconsistently rocky too, sometimes there was no problem. Usually it's weak, stuttering, sometimes just cranking but I seem to get it to start. I stopped giving the pedal gas because I read that's bad (I own a vintage bike, so it's news to me). I don't drive that far and figured I'd try some Seafoam and some freeway miles would clean out any debris. Worked for that tank a bit for the next tank before the problem came back.
Still getting the rough starts, but now when I give the car gas as I pull out sometimes it doesn't accelerate for 15-30 seconds, maybe 25 yards then it drive like normal. No dying at all but getting worse with starting up.
I've tried turning the key (not turning the engine over) 5 times and cranking on the 6th and it seems to work. I thought maybe it's the fuel pump or fuel filter but read it could be an ignition coil/ spark plug/ spark plug wire issue. Two different ball games.
My MPG is not really droppingI had a new fuel filter put in in February as routine maintenance (thing was on so tight had to bring it to a shop so no rookie mistakes there). Timing belt &water pump replaced 6,000 miles ago
View 3 Replies
My car runs fine when it's cold, but once it warms up during idle it will try to cut out and start missing very, very badly. CEL came on and it wouldn't shift into third gear, so had the codes checked, and it said cylinder 1 misfire, cylinder 2 misfire, random multiple misfire. So, changed the spark plugs and air filter, but it's still doing the same thing. Almost didn't make it home, but once I turned the air conditioner off, it ran much better. What should I check next? what could the problem be?
View 5 Replies
1995 Mazda Protege1.5 LAuto153K miles.
My car was running fine, then one day it started sputtering while driving, mostly when I accelerated. It stalled and I could not get it started. This happened on a day when it was raining hard, but not sure that had anything to do with it. A few days later when I went to pick the car up it started right up, it had stopped raining and been dry for 2 days prior. But about a mile into the drive back home it stalled and I could not get it started.
Here is what I have tested so far.
- Put in new fuel filter.
- Tested the fuel pressure and pressure regulator
- Tested the injectors with a noid light.
- Tested that the spark plugs were producing a spark.
After I pulled the plugs and cleaned and dried them (they were wet with gas) the car started, but I think not because of anything really related to the plugs. What I've noticed is that when cranking the engine if I give it gas it will not start but if I keep off the throttle it will reluctantly start. But once it starts the idle is smooth and as it should be. Then if I give it any gas it immediately stalls. It seems to me given these symptoms that it is getting enough air to idle but not enough air to match the increased gas.
The only CEL code that I'm getting (which I had before this issue occurred) is the "closed throttle position switch" (I forget the number). If it was an MAF, or IAC, or EGR issue would I not get a code? What this could be and how to test it. Again my guess is its an air intake issue but not sure where.
View 11 Replies
The truck always ran perfect till two days ago. went to start it in the middle of the day , it would barely start, when it did it was missing bad. then seemed to clear up a little after about 30 seconds but still missing. they thought they got some bad fuel. so they dropped the tank cleaned it all out and got new fuel, no change.
Him and a so called mechanic "kid from fire stone" played around switching coil packs around from the injectors with no change. He tells me that the two front cylinders , one on each side are not firing. that those two spark plugs are coming out fuel soaked after running the truck. He thinks it dropped a lifter or push rod popped out of place.
I took my A/E over and came up with codes p0106 - map sensor, and p0135 - 02 sensor. i cleared them and started the truck, shut it back off ran codes again. He also said they pulled the 02 sensor and it still ran the same.
View 6 Replies
I Have a 93 bronco with a5.8 the truck will start up and run fine for a while and then the engine gets really ruff starts back firing and shuts off it only starts with starting fluid or after it sits for about 30 mins.
View 7 Replies
I have a 1999 Ford Escort SE wagon with 112k miles on it. Last week when leaving work my car started very rough. This was unusual so I killed and restarted the car about three times before letting it run it's course (~30 seconds), after which the car ran fine. About a week later on my way to work the car seemed to 'sputter' (for lack of a better word) when I pushed down on the petal looking for some power on two separate occasions. On each side of the sputters the car seemed to respond fine, but when it did sputter there was a severe lack of power. I got to and from work just fine, but while letting the car idle in the parking spot of my apartment for a minute before shutting off the engine the check engine light finally came on. The following morning the car again started rough (as if it were misfiring/running on 3 of 4 cylinders) and this time it took a good minute before smoothing out. However, after the car smoothed out I experienced no issues on the way to work, no sputtering, no loss of power, nothing. Doing some initial online research I feel that the problem may be one (or more) of the following:
-Fuel pump
-Vacuum lines
-O2 Sensor
-Spark plugs (they are original)
-Fuel Filter (it is actually past due for replacement)
I plan on getting this checked out ASAP, but that still may be 2ish weeks away with my schedule. Some similar reports say that I may be having a 'lean mixture' issue (not getting enough fuel), but I haven't had the time to check the code. My question is, how "safe" is it to continue driving my car with the current situation? Is it at a super high risk of failure/random stalling during rush hour? Will it cause any damage to the engine if there is a cylinder misfire upon start up? I was also wondering if the car would be reasonably reliable to drive on a ~400 mile road trip on an upcoming weekend, but I am making plans as if it is not.
Additional Details:-Tried charging the fuel lines (car to 'ON' then 'OFF' position 3-4 times), had no effect on the morning start-up-Commute to/from work is about 20 miles
View 13 Replies
My 2006, 4.2 has been really erratically not starting. Turns over fine but will sometimes fire up and tries to run on maybe 2 cylinders, then stalls. Now it won't even do that, nothing. No check engine light or codes. Guess what the thing started up this morning 7 degrees out and running like a charm. Turned off and nothing again. Replaced relay for PCM ,no change, still no codes.
View 9 Replies
I have a 2000 E350 boxtruck with a 5.4 auto. The motor is a new rebuilt with about 4000 mile, coils were replaced with motor, injectors were rebuilt with motor.Today (500 miles from home) the truck died. I was going up a slight hill on an interstate. It will still start, but runs very rough and when I put it in gear and step on the gas it dies.
So I had it towed to a garage. While pushing it into the garage I noticed my gas cap was missing. I know it was on 45 min earlier because I got gas. Did I forget to put in back on? probably.. But I wondering if the missing gas cap could cause the truck to run bad,vary bad?
View 14 Replies
2012 F-150 5.0 Rough Idle Upon Start up - YouTube
Whenever I first start my 2012 F-150 with the 5.0, it idles rough and if I step on the gas it acts like either an injector is cutting in and out or it's missing. It doesn't really seem like a miss though, more like an injector/fuel issue. What it could be. If I let it sit and idle it won't go away unless I step on the gas and get it > 2500rpm or so.
View 14 Replies
First time ever, my Passat has stranded me. Won't start. 120K. Cranks fine. Fuel pump fuse is OK. Almost new plugs. New fuel filter. No codes. Almost a full tank of gas. No smell of fuel in engine compartment. Disconnect MAF, no difference. This started over a week ago. The car would not start on the first try. Always on the second try. Once started the car ran fine, did not stall or hesitate. Then, just once, it almost did not start; I think it was the fourth try it finally started. After that I replaced the fuel filter, just in case. It's been fine for several days. Now this morning, no go
View 6 Replies
2003 Ranger (4.0 L-2wd)...
Codes - random misfire and cylinder banks 1, 2, 3, reads out lean fuel
Will be checking out injectors and rail pressure, however, trouble shooting in general for this issue.
View 7 Replies
So, I have a 2007 f250 with the 6.0. When she's cold she starts fine but runs rough like she has a miss. When she warms up the miss goes away and it runs pretty good. But if I shut it off it won't start for about an hour or so.
ICP sensor has been replaced.
FICM is putting out 50v
View 11 Replies
I'm having this cold start issue with my 2001 SF, but it doesn't seem to be fuel related like as the car starts fine but after about literally 1-2seconds the RPMs drop below 1k and the car will stall if I don't put my foot on the accelerator and keep it around 1000-2000 RPMs. But if I happen to make the revs go too high and let them drop again it seems like it wants to stall even easier. After about 30 seconds it smoothens out and drives almost perfectly except for a slight lack of power than normal going uphill (A.T drops to 2nd gear, sometimes 1st depending on the incline). We have had the coolant temp sensor and the fuel pressure sensor replaced. Could it be the MAF? We did clean it one time but it didn't seem to work much at all. Recently out of curiosity, I disconnected the MAF sensor and started the car it being started for a few days. No issue with idling whatsoever!.. ??
View 4 Replies
Ever since I've had the car, I've noticed after the gas engine kicks on, it runs a little rough for maybe 10-15 seconds. Only when it's sat for a while, hours or overnight. Replacing the plugs didn't work. Now, its not bad, not really a problem, but I'm wondering if the injectors might need cleaning.
View 19 Replies
I got a 05 Passat I am working on. The car was being drove and my customer when to eat lunch. Came out side and didn't start. Got it to my house threw it on the scanner and it brought up 2 cam sensor codes. Replaced them and still nothing. What to try next. The car cranks over fine and it does have fuel pressure and also has spark.
View 2 Replies
This problem has been getting worse over the last 2 years. When the car starts it idles fine at about 1000 RPM. As soon as it warms up, it starts to idle rough, between 500 and 750 RPM. It almost quits running. As soon as you give the car some gas it runs just fine. About 3 weeks ago I got a "Engine Lean" check engine light error. I reset the system and have not gotten the error again. Since then I have: changed the MAF cleaned the EGR (made sure it closes completely and ohm out the coils in the actuator) changed the O2 meter on the exhaust manifold cleaned out the throttle body Ohmed out the air idle controller. What I should check next. I was planning to check the fuel pressure in case it is a fuel system problem. It is a 1999 ....
View 5 Replies
