Passat (B7) :: Squeaking / Groaning Sound From Front Strut Mount Area
Mar 14, 2013
I had my ST coilovers installed a while back. I love the ride, but a really annoying squeaking/groaning sound developed several weeks ago from the front strut mount area. The noise is heard at low speeds as I roll down the road (most likely high speeds, too) and sounds like its coming from both sides of the upper strut mount area. If you lift up/push down on the car, you can also hear the sound.
I purchased a set of 034 Density upper strut mounts from AMI Motorsports in hopes of eliminating the sound, but the sound got worse!! I still do not have a resolution. At this point, I'm thinking about putting the stock strut mounts back in, as the sound wasn't near as bad with the OE mounts in place.
I've lubricated the sway bar bushings and installed shorter end links (thinking the sound may be sway bar related), but the noise is still there. I even disconnected the end links all together - sound is still there. Could this be faulty coilovers? I tried to file a warranty claim through ST - they don't think their strut is faulty, and even if they did, I'm having a hard time with warranty coverage (long story). If it's the struts, then why did the sound get worse when the new 034 Density upper strut mounts were installed? Could it be faulty mounts?
At this point, I think it's either the mount or the strut, as I did not experience any issues prior to the coilovers.
View 24 Replies
Advertisement
my 99 s/w 2 started making a squeaking sound coming from the front right wheel area it goes away when I apply the brakes? is that one of those built in warning features to let you know the brake pads are getting low? the brakes have 86,000 miles on them.
View 2 Replies
Was tinkering on my car this morning, and at first noticed one side had a bigger gap than the other. Ok, I really need to change strut mount bushings, no big deal. Then I actually looked closer, and they both have some lean to them, but the drivers side is much more than the other one. Is this normal? I've never noticed any play in control arm bushings or anything. So what could be causing this? I would assume they are meant to sit flat but maybe not?
View 8 Replies
Sometimes when driving I hear a light squeaking sound coming from the front wheel area. When i drive slow, it is a slow squeak, and when I go fast, the squeaking speeds up. I am thinking about spraying some wd-40 or silicone lubricant behind the wheel to lubricate the area to see if it solves my problem. I will be sure not to get any near the brake area but my question is, does spray wd-40 under the chassis or around the control arm area to stop those annoying squeaking sounds?
View 6 Replies
Having issue with body squeaking ? . I am getting a squeaking sound coming from around the passenger rear door /body area of my 2010 Passat. Car has 10K miles and has been doing this since around 6K miles. Not noticeable unless going over uneven pavement or railroad tracks but it is annoying. Never had any body squeaks from a new car lite this. Have not been to the dealer with this issue yet.
View 6 Replies
So everything is tight and aligned and all good, but I'm getting this deep squeaking rub noise coming from my front upper strut mounts, but all the bolts are tight, yet it looks like the metal ring inside the strut tower moves a little up and down when you rock the car a bit. And I can feel the rubbing vibration and movement of the mount when I put my hand on/in the strut tower while the car is rocked.
View 1 Replies
2011 GLS 2.4L auto, 40K, out of warranty
There is a loud groaning/creaking noise coming from the front suspension area. At low speeds, this noise dominates all other noises and is directly related to hitting the gas or pressing the brakes, which produces a forward or backward force on the front suspension and chassis. I can sometimes hear it briefly just by pushing against the parked car.
My hope is that I can just tighten up some bolts and make this go away, but other posts suggest it may be struts, stabilizer links or other non-obvious sources.
View 4 Replies
As stated in the title, I've been experiencing a creaking/groaning noise originating from the dead pedal/foot-rest area when I release the clutch as I'm accelerating from first gear. This happens more so when I'm accelerating from a stop on any sort of incline (irrespective of the grade) and primarily in the afternoon/early evening when the weather's at its warmest for the day.
The noise itself originated about a month ago. Although I describe it as a creaking/groaning it sometimes sounds like a slight metal on metal friction noise.
My car's stock with the exception of Driver Gear springs and a BSH 27mm sway bar in the rear. Wheels are OEM 16s. I've had the DG springs on my car for about 3 months before this noise began and mileage was around 9,900Km.
View 3 Replies
Any noted 2.0T, B6 experience/solutions for squeaking/creaking suspension noises seeming to originate from shock/strut tower areas? I purchased new in 2009, 37K mi ago. VW dealer service persons think they hear it sometimes. Been chasing this problem for a year or more, mostly notable in cold weather. Condition evident driving on uneven pavement, dips in the road etc. Passengers ask "what is that squeaking".
View 7 Replies
My upper strut mounts have been failing after a year (about 12,000 miles, typical highway and local street driving, no off-road!). This seems to have started when I replaced shocks with Bilstein slightly stiffer variety. I also put a stabilizer bar on it at that time. Do you think the shocks are the fault? What else might I look for?
View 1 Replies
I have purchased an UltraRacing strut bar for my hyundai accent 2005... The problem however is that my intake manifold sits higher than the throttle body and as a result of this i am unable to mount the bar... The bar has been made for an 03 accent but all points are identical, the only difference that i was able to see is that in the previous accent the throttle body was NOT plastic and sat FLUSH with the throttle body, whereas mine IS plastic and does NOT sit flush with the throttle body.
View 1 Replies
I have a rear rattle that I cant figure out had the wheel off and levered and pounded on links bushings etc. How can I access the top strut mounts to check them? Nothing found on youtube. Original struts on rear show no leaks or broken spring. Bouncing car does nothing neither does grabbing the tire at 12 and 6 or 3 and 9 position.
View 3 Replies
I have had the LF strut mount fail three times in the last three months. The strut has pushed through the upper mount. The guy a bought the car from said he had the struts replaced about a year ago. Could it be a bad strut?
View 1 Replies
I have to replace the torque strut mount in my 2008 Avalon XLS V6. I can't find the torque specs for the two bolts in my Haynes manual or at any online sites. Also, should I use either threadlocker or anti-seize on them?
View 1 Replies
I hear a a series of "clunks" rather than "rattles" (not high pitched) when driving slow over bumpy roads. The noise is coming from the rear only. I think it is more evident in cold temperatures, but I'm not sure. I'll find out if it ever gets above freezing again in MN. Strut mounts? If so, DIY project?
View 6 Replies
Is this possible? I recently installed raceland ultimos and I get this weird muffled noise from the top of the rear suspension. Took it all apart, cut the bump stops shorter, and lubed the strut mounts. Sound went away for about 10 mins of driving, went for another drive and the sound was back. The next day the weather was warmer and the noise was gone. Should I just get new strut mounts?
View 6 Replies
I just installed my brand new coil overs. I went to drop the car from the jack and as it lowered I noticed my strut mount fully popped out of the strut mount housing. I can't even close my hood. Did I do something wrong?
View 1 Replies
I've got an '12 F-150 with 7k mi. on it. It developed a squeak/creak noise about 1k. mi. ago. It comes from the r. front suspension area and I noticed it one morning leaving from work. It occurs under suspension loading/unloading and it only happens during cold and dry conditions. It won't make the noise when it's wet or damp outside. I've had it at the local dealer 2 times now and they can't seem to locate it. It sounds like rubber on metal or when the 97 & 98's had the dry tie rod ends or ball joints problem. They are reluctant to throw parts at it to try and eliminate it and I agree with them. What were the findings?
View 5 Replies
Setup: WRD Street Advantage Coilover kit. Installed and sit at 24.75" all around. 034 Density mounts and new bearings. 19,xxx mi.
7 weeks ago I installed WRD Street Advantage coils. The install went great, no problems. Drove a week or so and decided to replace the strut mounts with 034's density strut mounts and new bearing to get rid of the creaking sound at low speed. Ordered them and put them on this weekend. After driving it I realized the creaking of the old weaker strut mount was gone. However, I inherited a rough clunking or knocking sound (as if something is loose and moving around), which seems to be coming from my passenger side. This happens at all speeds and not specific to turning the wheel. I unistalled/reinstalled everything in the front 4 times and went through everything with a fine tooth comb, but can't find anything loose. All bolts are torqued to spec.
I even removed the sway bar end links and drove it, still there. So it's not the end links. I also tried using the OEM endlinks which are longer than the ones from WRD to increase the space between the axle and the sway bar, possibly thinking it was hitting and causing the noise. No luck, still there. The only thing I noticed is that with the car on jack stands the strut mount is tight to the body but I still have slight play in the spring and it's perch. Is that normal? I'm assuming under load it's tight again. So the only variable in my situation is the new Density Mounts and bearing, can these cause heightened noises due to the increased heardness of the mounts?
View 20 Replies
My 2002 Taurus has developed a slight vibration but loud groaning sound in what I think is coming from the right or left front side. It gets louder at around 40 - 60 MPH and its hard to pin point. it actually feels like it's coming from the middle of the vehicle and sounds/feels a lot like a clothes washer machine going on the spin cycle. As I turn the steering wheel slightly to the right and listening for a change of the tone of the noise is go away. What this could be? bearing? CV joint?
View 1 Replies
2003 Jetta TDI 245K miles- owner's records show front bushings were replaced some time ago.
Suddenly started a groaning sound whenever the front driver's side suspension compresses. Started suddenly right after I hit a speed bump but not "hard". I parked and bounced on each corner of the car, no noise on anything but the front driver's side. The suspension's "give" felt similar across all 4x corners.
Of course whenever I'm braking or turning I get that sound. But it's definitely the suspension. And like I say, it's sudden.
I didn't see anything wrong, but the wheel's mostly in the way. The wheel cowling isn't rubbing the wheel. Handling feels fine, still goes straight with the hands off the wheel.
View 1 Replies
