I just installed my brand new coil overs. I went to drop the car from the jack and as it lowered I noticed my strut mount fully popped out of the strut mount housing. I can't even close my hood. Did I do something wrong?
View 1 RepliesWas tinkering on my car this morning, and at first noticed one side had a bigger gap than the other. Ok, I really need to change strut mount bushings, no big deal. Then I actually looked closer, and they both have some lean to them, but the drivers side is much more than the other one. Is this normal? I've never noticed any play in control arm bushings or anything. So what could be causing this? I would assume they are meant to sit flat but maybe not?
View 8 RepliesLong story short, over torqued the top two stretch bolts and destroyed the threads. We helicoil'ed both holes and put the bolts back in. That was about 4 months ago.
Today both bolts snapped not while moving. We dolly'd the car home and bought a replacement bracket, however all three bolts along the bottom that go into the transmission housing broke off inside.
I'm a tad stuck at this point. I could drill and tap new holes over the existing, but i question whether that is a good idea. My other thought was to get 3 of the larger stretch bolts that go in the top, completely drill out the three that are broken and tap the big ones in. This thought would also require drilling the bracket to make the larger bolts fit.
Setup: WRD Street Advantage Coilover kit. Installed and sit at 24.75" all around. 034 Density mounts and new bearings. 19,xxx mi.
7 weeks ago I installed WRD Street Advantage coils. The install went great, no problems. Drove a week or so and decided to replace the strut mounts with 034's density strut mounts and new bearing to get rid of the creaking sound at low speed. Ordered them and put them on this weekend. After driving it I realized the creaking of the old weaker strut mount was gone. However, I inherited a rough clunking or knocking sound (as if something is loose and moving around), which seems to be coming from my passenger side. This happens at all speeds and not specific to turning the wheel. I unistalled/reinstalled everything in the front 4 times and went through everything with a fine tooth comb, but can't find anything loose. All bolts are torqued to spec.
I even removed the sway bar end links and drove it, still there. So it's not the end links. I also tried using the OEM endlinks which are longer than the ones from WRD to increase the space between the axle and the sway bar, possibly thinking it was hitting and causing the noise. No luck, still there. The only thing I noticed is that with the car on jack stands the strut mount is tight to the body but I still have slight play in the spring and it's perch. Is that normal? I'm assuming under load it's tight again. So the only variable in my situation is the new Density Mounts and bearing, can these cause heightened noises due to the increased heardness of the mounts?
My upper strut mounts have been failing after a year (about 12,000 miles, typical highway and local street driving, no off-road!). This seems to have started when I replaced shocks with Bilstein slightly stiffer variety. I also put a stabilizer bar on it at that time. Do you think the shocks are the fault? What else might I look for?
View 1 RepliesI have purchased an UltraRacing strut bar for my hyundai accent 2005... The problem however is that my intake manifold sits higher than the throttle body and as a result of this i am unable to mount the bar... The bar has been made for an 03 accent but all points are identical, the only difference that i was able to see is that in the previous accent the throttle body was NOT plastic and sat FLUSH with the throttle body, whereas mine IS plastic and does NOT sit flush with the throttle body.
View 1 RepliesI have a rear rattle that I cant figure out had the wheel off and levered and pounded on links bushings etc. How can I access the top strut mounts to check them? Nothing found on youtube. Original struts on rear show no leaks or broken spring. Bouncing car does nothing neither does grabbing the tire at 12 and 6 or 3 and 9 position.
View 3 RepliesMy Kia Optima side view mirror popped off when it hit a trash can and I was wondering if there was any way to reattach it? I was thinking of using some really strong epoxy, but I don't know where I would apply it since the mirror rotates when it comes in contact with other objects and if I used epoxy I might lose that functionality. I attached an image .....
View 6 RepliesI have had the LF strut mount fail three times in the last three months. The strut has pushed through the upper mount. The guy a bought the car from said he had the struts replaced about a year ago. Could it be a bad strut?
View 1 RepliesI have to replace the torque strut mount in my 2008 Avalon XLS V6. I can't find the torque specs for the two bolts in my Haynes manual or at any online sites. Also, should I use either threadlocker or anti-seize on them?
View 1 RepliesI hear a a series of "clunks" rather than "rattles" (not high pitched) when driving slow over bumpy roads. The noise is coming from the rear only. I think it is more evident in cold temperatures, but I'm not sure. I'll find out if it ever gets above freezing again in MN. Strut mounts? If so, DIY project?
View 6 RepliesIs this possible? I recently installed raceland ultimos and I get this weird muffled noise from the top of the rear suspension. Took it all apart, cut the bump stops shorter, and lubed the strut mounts. Sound went away for about 10 mins of driving, went for another drive and the sound was back. The next day the weather was warmer and the noise was gone. Should I just get new strut mounts?
View 6 RepliesI had my ST coilovers installed a while back. I love the ride, but a really annoying squeaking/groaning sound developed several weeks ago from the front strut mount area. The noise is heard at low speeds as I roll down the road (most likely high speeds, too) and sounds like its coming from both sides of the upper strut mount area. If you lift up/push down on the car, you can also hear the sound.
I purchased a set of 034 Density upper strut mounts from AMI Motorsports in hopes of eliminating the sound, but the sound got worse!! I still do not have a resolution. At this point, I'm thinking about putting the stock strut mounts back in, as the sound wasn't near as bad with the OE mounts in place.
I've lubricated the sway bar bushings and installed shorter end links (thinking the sound may be sway bar related), but the noise is still there. I even disconnected the end links all together - sound is still there. Could this be faulty coilovers? I tried to file a warranty claim through ST - they don't think their strut is faulty, and even if they did, I'm having a hard time with warranty coverage (long story). If it's the struts, then why did the sound get worse when the new 034 Density upper strut mounts were installed? Could it be faulty mounts?
At this point, I think it's either the mount or the strut, as I did not experience any issues prior to the coilovers.
So I just picked up this mk4 it had D2 coilovers I believe and I'm putting racelands but I'm having trouble actually fitting the strut to the beam it doesn't want to go in because it's too small? So how would I open it up ?
View 11 RepliesAre the bolt and nut holding the strut to the wheel bearing housing the only things that need to be replaced when removing the strut? Anything else I should change while I'm in there? So far I'm just doing 034 strut mounts and bearings.
View 3 RepliesI have a set of ST coilovers, installed on my tiguan s4motion they ride great but have noticed clunk noise coming from tight strut and I'm pretty sure it's the pillow mount plate, is there anywhere to get replacements or a better plate? ST website doesn't have them separately...
View 1 RepliesI have a 1999 cadillac Deville that my mechanic says needs a new front strut mount. My symptoms are mostly in cold weather a very slight groan when parking the vehicle or turning into my driveway. It seems like it happens when the steering wheel is on its return back to center and it can be felt slightly in the wheel and heard as the sound a zip tie makes when pulled together with a slight groan. The car has been recently aligned and rides pretty good but sometimes can be a little noisy over bumps.
View 6 RepliesI just got a H&R Sport Cup Kit installed along with new strut mounts and bearings on my 2001 GTi. My front right side strut is making a popping sound whenever I accelerate or brake slightly hard and sometimes when hitting a bump in the road. What's causing the sound? Could it be I have a bad strut? Also the left side is fine and doesn't make noise at all..
View 10 RepliesSo I just had my transmission replaced because my cv axle popped loose and tore a hole right into my old one spilling all the tranny oil all over the road. I was able to find another used one and then bolt it up and now I have a small issue. Its been leaking a little bit of tranny oil through the one piece on the bottom that has two bolts on it and a VW logo on it.
View 5 RepliesMy 2 door Golf has an issue.
Door closes, latches, door switch is activated (no chime, no interior lights on, all seems normal.)
From the outside it is not sitting flush to the body. From the inside I can hear a lot of road noise.
I inspected the hinges, weather stripping, door jamb, no obvious problems. I have slammed the door and pressed very firmly. At best I can get it closed, but I can pull it back 'open' very easily.
Sounds like I have a faulty door latch but need to confirm this before I start tearing into it??
Finally got around to replacing my Thermostat because the DIY here made it look so much easier than removing the alternator and such. Did everything exactly as described and after assembling everything with the new t-stat and O-ring I am getting a constant leak from the housing. I tried removing everything and reassembling...all the bolts are tight. Plastic housing isn't cracked and seems to be in great shape. Everything lines up properly but coolant is just running out of the bottom of the housing. Am I missing some magical trick here?
View 15 Replies