Prius (2004-09) :: 2006 - Automatic Key Detection Does Not Work
Aug 13, 2014
The battery in my key for my 2006 Prius died. I replaced it. Now the automatic key detection thing doesn't work (when I approach the car I can unlock the door unless I dig my key out and press the button). Also, I used to be able to just keep the key in my pocket and the car would power up - now I have to place the key in the key slot in the dash to power up. Like I say though, the door lock and unlock buttons on the key work just fine (they didn't when the battery was dead). What's up with all that?
View 4 Replies
Advertisement
2009 Prius all windows stopped working except the drivers window.I have checked fuses,window locks,etc...I heard that the problem is the "bcm" which is located under the drivers seat. One window was half way down when it stopped working so I took the door panel off and ran wires from my laptop power supply and ran it up. I am wondering if i could run a wire from the battery with the correct fuse on it to each window and bypass this '"bcm" thing altogether.
View 8 Replies
Have any control over the fan speed? The temperature? How does it work?
View 2 Replies
My 2006 has 121000 miles and started acting strange in March. I drove it to the dealer and it died. After the dealer ran the diagnostics test they gave the code for "bad cell 5" and "replace battery". The dealer wanted way too much so I had the car towed home and installed a rebuilt battery this week (my car set for almost 2 months). After putting in new battery it wouldn't start due to the 12v battery being dead. So I replaced the 12 v battery and now it still will not start but all of the displays work. I am getting the red triangle, the check engine light and the "exclamation in the car" on the main display. I don't know if this has any bearing on the problem but I did find the dealer had removed one of my spark plugs and left in under the hood. I re-installed it before attempting to start to car. Also, the water pump that has been recalled is still on my Prius and hasn't been replaced (would this effect the vehicle starting?
View 12 Replies
1. Neither tail lamp lights
2. License plate light works
3. Front parking lights work
4. Both tail lamp bulbs are fine (visual and continuity both check)
5. No power at the bulb socket on either tail lamp
6. Tail lamp ground in both bulb sockets is fine
7. Fuse under dash is not blown
8. All brake lights work fine.
9. All other lights working.
View 4 Replies
Purchased used 2006 and the left tail light does not work at times until I rotate the socket as if removing it. This happens frequently and then after about 3 weeks the bulb blows. I've confirmed the there is no socket terminal issue and no intermittent opens in the wiring to the socket. The buld internal glass blackens as if it is running too hot but the voltage measures slightly over 12V when I've measured it. The bulbs are rated at 13V. At this point the only thing I can think of is there must be an occasional high voltage spike that hits the left tail light but not the right tail light.
View 5 Replies
I came back from a vacation of 10 days and tried to start my 2007 Prius and it was not starting when I had the key in my pocket (as it used to before)...The automatic doors, windows etc were not responding as well to the remote...
So I inserted the key physically and it came on with the Malfunction light and then beeped for a few seconds and then that light went away as well...I pressed the on off button to turn off the car...
I ejected the key and then reinserted it and now it is not even showing any indicator light...
View 19 Replies
I have a , 4 door, 5,000 miles... had it for over 3 months now, car has been flawless except for a faulty driver side window switch (rattled bad when playing music) so dealer replaced and it still rattles but it's not as bad, that was about a month ago, now I noticed that the automatic driver window up/down does not work anymore. The window still goes up and down perfectly fine...but it's not one touch you have to hold it, all the other doors work fine on one touch and the drivers used to work until now...
View 16 Replies
I have a problem with our oldest Prius, a 2005 Package V. I have had an ongoing problem with the warning triangle and the headlight icon coming on and off for a few years now. Anyway, after locating the post about repairing the sensor, I finally got around to checking out the headlight height control sensor and when I opened it up, I found it to be badly corroded/ unrepairable. My local dealer wants $500+ to repair the system and I really don't need the leveling function anyway.
My headlight level has been stuck it the same position for a long time, but as luck would have it,. they are at a perfect level....Always pass State inspection, illuminate the road perfectly etc.
The problem that I now have is that the two warning icons stay lit all of the time. Is it possible to disconnect or jump wire the Headlight Level Control ECU or something else in the wiring system to disable/turn-off these two warning lights? I disconnected the corroded Height Control Sensor, but the warning lights stay lit.
View 2 Replies
This is a pretty strange situation. A couple of years ago, my automatic locks stopped working consistently in hot weather. Sometimes they'll work and sometimes they won't, but the worst thing is that they are inconsistent. I only have this problem in the summertime or on really warm days in the spring or fall (I live in Colorado). What could cause this?
View 3 Replies
So my battery had died and just got a new one. But i noticed that my automatic up/down on the drivers side window doesn't work, I have to keep pressing the button for it to go up or down.... the other 3 windows are working perfectly. Is there a way to fix this?
View 3 Replies
I have Toyota Camry 2009 . My automatic lock doors stopped working at all. But it was long process, first all passengers doors sometimes opened, sometimes closed(I mean button on the doors didn’t open or close doors, remote control also didn’t open or close doors). Then they stopped function. 1 month later drivers door stopped working too. Now I can use only old fashion way. I made my research and I think I have to replace body ECU because it response for automatic door locks(but it cost a lot). What it could be?
View 7 Replies
My '05 Prius with just 16k miles on it just started displaying the red triangle with exclamation mark (multifunction warning lamp?). It displays about every 3 times I start the car... The Info screen shows the icon for the Automatic Headlight Leveling System. So Ive been searching, and have found a few threads related to this, but the fix Ive seen referenced I cannot find since the posts referencing the fix are about 5 yrs old. Exactly where on the car I can find the sensor, and how it can be fixed?
View 19 Replies
The gate to the right of the PRNDL gate of the automatic transmission in my 2003 1.8T with the "+" and "-" stopped working. What may be wrong? The transmission works fine and shifts normally. I did replace the fluid recently but did nothing except remove the fluid and refill.
View 2 Replies
I have a 2001 Town & Country with 157,000 miles. The driver rear automatic sliding door will not work. You can hear the motor running but it doesn't totally close...so I open and close manually. I looked in Chrysler service manual...could this be a power latch assembly?? How hard would it be to replace myself. The rear hatch is the same way have to manually open/close...can hear motor and it goes through motions but doesn't open. ???? Then today the rear wiper wouldn't work....
View 12 Replies
] have a 2001 Town & Country with 157,000 miles. The driver rear automatic sliding door will not work. You can hear the motor running but it doesn't totally close...so I open and close manually. I looked in Chrysler service manual...could this be a power latch assembly?? How hard would it be to replace myself. The rear hatch is the same way have to manually open/close...can hear motor and it goes through motions but doesn't open. ???? Then today the rear wiper wouldn't work....
View 3 Replies
Toyota corolla 2013 automatic gear reverse lights don't work after I installed new stereo it's my fault i shorted 12v positive backup (reverse) light trigger camera stereo v12+ cable to ground while backup (gear R) in place. As a result reserve lights don't work beside gear indicator doesn't show on main screen. I can drive without problem but problem still intact.
I checked all fuses and they are all okay I need to identify problem or possible repair too I only find 2 fuses behind glove box i think they call "instrument panel" there are bunch of cable and underneath of cables there is only 2 rectangle shape fuses I could not see anything else, the other fuse box is in engine compartment i thoroughly tested each small fuses they are all okay is there anything else i forgot to check ?
I attached also instrument panel screen shot ....
View 1 Replies
The whole right side speakers do not work on my 2006 gx470, its not the control screen it the speakers. I hear it could be the amp? Any info out there?
View 4 Replies
I have a 2006 King Ranch and right tail and brake lights don't work. The bulb is good. The fuse diagram in the owners manual is not the fuse box I have, so I cannot id the correct fuse to see if its bad.
View 4 Replies
I know the EVAP Leak Detection system is supposed to pop and click on start-up, but from what I've read it goes away after a few minutes (after the system pressurizes?) - however I've been noticing my popping still happening after 10-15 minutes of driving (I believe it sometimes even pops when I shut off the car)... I am not getting any warning lights. Is this normal?
View 2 Replies
97 f250 5.4 L ............. In the torque app main screen hit menu, hit settings ,scroll down to manage extra PIDs/Sensors ,hit menu again , add predetermined set and I choose Ford (including power stroke ) ,now you see a big list of things you can test live ,hit cylinder misfire (whatever cylinder # you like to see) scroll down and hit test ... well you will see on the top results a live misfire count data constantly updating ....I know because I disconnected COP #1( it took 1-2 mins and started counting) ...
View 3 Replies
