My low beams won't work. High beams and fog lights work just fine. We just replaced both bulbs a few months ago so the chances are pretty slim that it's a blown bulb.
I've checked the fuses and relays. I switched the low beam and high beam relays with no luck. Still no low beams.
Replaced bulbs and checked fuses ... if u bump high beams they will flash ...
View 9 Replies08 SANTA FE, NO HI OR LOW BEAMS. Daylight running lites work, fog lites work, checked all fuses, relays, and bulbs,& connectors.
View 9 RepliesThe normal lo-beams won't turn on no matter what I do, but the brights still work. The bulbs are good, the fuses are good. I've tested and changed those. They're good. 2008 Santa Fe ....
View 13 RepliesI recently installed new halo HID headlights in my 2003 f150 with HID bulbs and ballast the passenger side worked and the drivers side didn't nth lights wired exactly the same. I switched everything from the passenger to the drivers side still nothing I switched everything back to passenger side and they don't work now. I tired regular bulbs in the passenger side an it worked then on the drivers side and it worked for a split second and went out and then I retried t on the passenger side and it worked for a split second and went out a now neither are working. I checked all the fuses and their good. What the problem could be?
View 5 RepliesDriver side bulb does not work on low beam but does work on high. Replaced the halogen bulb but problem persists. The dealership checked the fuses which were fine. No further diagnostics done as I already spent more time at the dealership than anticipated.
View 4 RepliesI'm talking about the flash to pass feature, not turn signals.
View 2 Replies2004. Hazards and brake lights work.
View 6 RepliesMy front right caliper does not work. was changed ( both sides) also hose from right side because it still did not work. Found that fluid gets from reservoir to abs but does not come out to front right wheel. Place air pressure from hose to abs, and runs fine, from reservoir to abs and runs fine from abs to out from abs to front right and air does not go in.
But when pressure goes from out of abs to in abs from reservoir air flows fine also. What is going on...
Ok so my santa fe is doing some weird things. No dashboard lights work the car wont turn over, it has new battery new starter new ignition and no fuses are blown. Basically it seems electronically dead.
My mother in law was driving it and it just killed, my brother in law changed the starter and battery first then the ignition switch.
I have been working on cars for 15 years and i've never come across this problem.
2004 santa fe, 2.7 L engine, temperature control doesn't work, it blows out hot air only. All fuses look good and I tried a new A/C heater control unit with no luck.
View 5 RepliesFor some reason my back brake lights on my 2006 santa fe are all goofy. The two in the rear window work fine. The turn signals work fine but the right and left brake lights don't work. I replaced the10 am fuses and the lamps. It did not work at all. I don't understand how the top lights would work but the right / left wont. I even tried the flashers and the brake lights are not on either. I don't see a fuse in the box in the engine compartment labeled for rear brakes, so I am at a loss.
View 9 RepliesI just purchased this car and the low beams do not turn on when you turn on the lights. Right now I am driving with te DRLs at night. The high beams works perfectly. The fog lights do not work but I have not checked the bulbs (although the indicator lights on the dash works.)
Also looking for diagram of relays. I looked at the fuse panel and see a lot of empty slots. I have relays numbered 18, 21, 99, 36, 110, 53, 167 on the fuse panel. Could I be missing any?
my 1992 olds 98 low beams do not work. However they high beams do along with the parking lights. I used a test light and am getting no electricity at the light socket. Bulbs are good. I check all fuses under the dash not a bad one. What this is or the next step?
View 5 RepliesI just purchased this car and the low beams do not turn on when you turn on the lights. Right now I am drivig with te DRLs at night. The high beams works perfectly. The fog lights do not work but I have not checked the bulbs (althought the indicator lights on the dash works.) Also, any diagram of relays. I looked at the fuse panel and see a lot of empty slots. I have relays numbered 18, 21, 99, 36, 110, 53, 167 on the fuse panel. Could I be missing any?
View 1 RepliesSo I lent my santa fe to a buddy to do some hauling, I got it back yesterday and the turn signals and the brake lights don't work...notta. Regular running lights are working without issue, but no turn signals, no hazards, no brakes. Even the "tick, tick, tick" of the turn signal is gone, it's just dead.
View 1 RepliesIt seems as though whenever I turn on the AC in the car (and sometimes even if I don't engage the AC) all the windows lock and only I can control them from the driver's control panel...
View 2 RepliesJust replaced my headlights within the past 4 months. Last night, I go to turn on headlights and nothing turns on, not even the parking lights. High beams work just fine. Checked fuses this morning - fuse for low beams is fine. Not sure why all 4 lights would fail at the same time. A fuse was all I could think of besides pure coincidence.
View 4 RepliesMy headlights don't turn on but everything else does DRL turning signals. I tested the resistance to ALL the fuses. I have two new ignitors and two new 10k light bulbs. The only way my high beams work is if i hold the lever in to bypass the resistors but like I said they don't turn on when I turn the HL switch. I just bought a new HL switch two .. the issue remains, what it could be?
View 3 RepliesI have a 1984 BMW 733i and can't figure out why the Low Beam lights do not work when the light switch is on. The Low Beams work when the High Beams are on. I've replaced the Low Beam lights and checked the fuses.
View 1 RepliesI recently got this car from a friend, and when checking all the lights I noticed that only the high beams work, not the low beams. I replaced the lamps, and checked all the fuses, but the low beams still don't work.
View 3 Replies