My 2008 Elite has a door that won't open. The rear door on the driver's side.
It is an Australian Elite model. I can hear the click when the remote is pressed. How can I get the door open to remove the intyerior trim?
As long as we are mentioning things, the trim/gasket around my rear doors on my 08 Santa Fe does not fit right. You can see it in the attached photo. The gasket is one piece, and there is no way to arrange the slack so that there is not a gap. Maybe someone used the wrong one at the factory, or is this a common/known problem? I'll ask about it the next time I'm in the dealer.
View 18 RepliesI just got myself 07 santa fe. Have small problem though. When I open the door interior lights are not going on, doesn't matter which door are open it is not working but I can turn them on manually, so fuse is fine I guess. What my be a cause of it?
View 16 RepliesI have a 'new to me' 2007 F-350SD super cab and need to run some wiring inside. What I don't know is how the heck the trim pieces are attached and how to remove them without breaking them! If it ain't held on with screws, nuts, bolts...
View 2 RepliesI am driving a 2012 Sante Fe with a bit of a problem. A rear door does not open from inside nor outside. Is there a way to remove the panel to gain access with the door closed?
View 3 RepliesDriver side rear door will not open by key, key fob or internal handle, 2007 model. Also is there an Haynes manual for this model....
View 6 RepliesI've got a 2006 F250 5.4l Super Cab. When I bought the truck the rear interior door trim panels were missing. I tried to order them straight from ford but it turns out they no longer carry them, and I can't seem to find them anywhere online. I've also looked at the salvage yards in my area- nothing. Where I would be able to find these elusive creatures?
View 3 RepliesHow do I remove the interior rear door panels?
My passenger side rear door handle does not work. My mechanic fixed it once, said the cable had jumped off the pulley. I figured it can't be that difficult to fix if I can get the door panel off.
When I close my rear, driver side, door there is a lot of movement at the top of the door panel. I can pull it away a good bit so I think there may be a broken clip. I searched the FAQ but could not find instructions for removing the rear door panel?
View 2 RepliesOn my 2.2 2008 SF the rear door sometimes refuses to unlock randomly. All others are fine. Rear passengers cannot then get out!
Tried taking inner door panel off. very little access and liberal spraying of WD40...............
Looking for a process to have the interior lights 'shut off' with the doors open?
I do a lot of camping, and having the doors open with the music playing is a real nice feature of my truck (2007 F-150 Super Crew 4X4), vut the fact that every internal light stays on just beats the heck out of the battery.
I would love to know if there is something that can be done to have them 'dim off' after the doors have stayed open for a certain amount of time.
I just got this 2008 santa fe a month ago from the dealer with 80.000 miles , and then yesterday the check engine light came on, i took it to auto zone and the put the computer and this 2 codes came up:
P2187
Fuel trim system lean at idle
explanation
the average long term fuel trim values at idle are more than 30% for 10 seconds
probable cause
- low fuel presure
- failed MAF sensor
- large vacuum leak
- cylinder misfire due to ignition system failure
P2189
System too lean at idle bank 2
explanation
failed MAF
probable cause
- low fuel presure
- vacuum leak on engine
- failed HO2S ( heated oxygen sensor-bank2 )
My 04' FX4 rear door locks hesitate to open with the key fob or the door switch. I can get them to open sometimes but not every time. Why this is happening?
View 6 RepliesI'm looking for the process to remove the exterior black glossy b pillar trim on the front door. My wife decided to open my door against a ladder and it has a 3mm scratch that's going to big the piss out of me so I'm looking to replace it. Also looking for the PN as well.
View 2 RepliesNow that I have the audio upgraded in my LS, we have uncovered a slight issue with the drivers rear door. The installers will work with me, but I thought there is so much knowledge up here, why not ask.
Everything else on the vehicle works perfect, its just this one door as if all the power is off or disconnected.(ACC or ON power it functions fine) I have checked the fuses under the driver side and the ones in the trunk, they are all fine and we took the front driver door apart to make sure any connections were good. everything seems secure, we even looked over the ECU in the door to make sure it didn't seem fried or anything, all functions on front and passenger doors are perfect.
Here are the symptoms: passenger rear door light wont come on with the door open unless the ACC is on. the other 3 turn on, with or without ACC.
The door lock actuator from the outside on this door wont lock the doors or with the sensing when you approach with the fob and grab the handle (as in the lights there wont light up).
The door closer that finishes off the door being slightly open wont grab and pull it in.
The trunk lights wont come on and there is no fuse or connection issue we can see. Its puzzling.
I've been trying to find information on how to remove the backseat to my 2008 Santa Fe?
Its really dirty back there where my vacuum can't reach, and I'd like to clean it.
How to remove the rear side interior trim? I want to install a rear view camera. I need to pull the trim to run the wiring along the left side to the floor and to the front of the car.
My understanding is I need to get access to the left rear side of the hatch, then underneath the carpet along the rear door trim, etc. I've seen some posts on the 2 door, but there appear to be differences between that and the 4 door.
I've got a 2003 camry LE/V6. The interior trim fabric to the right and left of the rear window is curling back on the trim panel away from the glass. This has been happening slowly over a year or so and now has reached a point of requiring repair. I've searched the site, but haven't found anything directly related. These panels appear to be separate from the headliner and the rear window shelf. How these panels come out? If these snap into clips and can be removed, I might be able to match fabric closely enough to be OK.
View 2 RepliesI have Santa fe 2009, I was in a 5 days trip, now I'm back home and it seems like that the car's light was on so the battery is goes dead, now I can not open the car's door neither by remote nor by the key! why I can not open the car door with key?
View 37 Repliesjust notice my interior door lights of driver rear and passenger front aren't working well . Driver front and passenger rear is working.
View 4 RepliesI'm trying to upgrade my speakers. I got the ones in the front and rear doors installed. I hoping there is a way I can access the speakers without having to completely remove all of the rear panels.
View 8 Replies