Santa Fe (CM - 2007-12) :: 2008 - Front Passenger Side Clunks When The Road Is Not Smooth?
May 19, 2015
I am getting a clunk from the front passenger side when going over bumps or when the road is not smooth.
It seems to happen at lower speed, so when I am on the highway, I cannot hear anything. The sway bar link seems to be the common thing, but when the car was lifted, there was oil on one of the struts.
2008 3.3 Santa Fe ... The car has 115k KM. Is this a normal thing for it to fail at this point? Last time I had clunks in the suspension it was a sway bar link that was repaired at the dealer under warranty. I can't remember if this is the same sound or not.
View 8 Replies
Advertisement
I have a 2012 Santa FE 2.4L, I have a knocking sound happening in my front passenger side once I go over bumps. Would like some info on the different parts that can cause this.
View 10 Replies
At 60 mph + and on a smooth road, this 2008 CR-V presents with what seems to be an out of balance issue. You can feel it bumping when it reaches this speed and beyond. The car just turned 100k, had four new tires about a year and a half ago, but when this began occurring (and it was pulling to one side), the dealership recommended two new front tires due to something they couldn't pinpoint as to why the tires were wearing as they were. Replacing them fixed the pulling to one side problem but did not correct the bumping problem. The car has never been in an accident or been driven over a curb/bank, etc., is driven by the same person, has always been maintained at the same Honda dealership. It has been to them 3 times is about to go back for the fourth time. Could it be a bearing? An axel problem? Bad replacement tires?
View 1 Replies
My wife and I recently purchased a '01 Santa Fe. We noticed that the gap between the passenger front door panel and dashboard is wider than the gap between the drivers door panel and dashboard. There is road noise that enters from the passenger side door. I believe the door latch is contacting the striker before it is fully closed.
What would be the best way to correct this? Move the striker or the latch? My wife will be spending about three hours a day everyday during the week in this vehicle and the road noise will annoy her until I get it fixed.
View 1 Replies
I've got a 2008 santa fe limited 3.3 awd with about 170000 km on it. Lately when I brake I've been hearing a clicking noise coming from what sounds like the driver side front wheel area.
Had it in to my mechanic who checked the brakes and said that pads/calipers/rotors were all fine. They replaced the passenger side front bearing on the lower control arm a few weeks ago and said there is no play or noise coming from any other suspension components.
Where to look next? My mechanic isn't sure what it is so I was going to take it to the dealer and see if they can fix it. Also had new tires installed about a month ago
View 7 Replies
The closest thread I found was this [URL] ..... The straight rod that goes into the windshield from the roof, on the passenger side, does look a bit worn. should i tape it up? I started having this problem recently. Never heard this noise the past.
My sc430 is giving a loud pop right over passenger's side from roof, whenever my car goes over a bump or rough road. I think it's where the front hardtop latches are. Only on the driver's side. It's a loud pop sound.
Does this have something to do with the latch, or latch motors, that closes the power roof ? Would it work if I tighten the retractable top by turning the rubber button in the center back of the car, the one that exposes during roof operation as outlined by other posters here?
View 4 Replies
I am driving along on Interstate 26, smooth road, no weather going on, clear night, about 7:30 pm, and the rear window on the driver's side just exploded.
Oblong hole in window, rest like a spider web. All fell out as I drove home.
Nothing hit it, had not been raised or lowered for hours, there is NO reason that I know for it to have happened. Bought car in March, 2012. 12,000 miles on it. NO other damage to car, inside or out.
View 15 Replies
I have a 2008 Santa Fe Limited. Today I briefly turned the heat on since the outdoor temp was cool. Later in the day, I resumed the A/C AUTO setting at 72 for BOTH sides of upper vent outlets. I soon noticed that the driver's side blows warm air and the passenger side blows cold air as it should. No amount of adjusting the temp control either up or down had any effect on the driver's side except for constant warm air. Now I know the passenger side can be adjusted separately but both sides were set for the same temp. Never had this happen before. Always before, if I wanted warm air, the warm air would come through the floor outlets. What's causing warm air to come out the top driver's side vents when it should be cold? Could a diverter door be stuck?
View 2 Replies
I have a 2007 hyundai Santa Fe GLS. When the AC is on the drivers side blows hot air and the passenger side cold air. Both actuators are working driver side and passenger side. I watched them engage as I changed air flow and temp. What I should look at next? Also, the rear ac button light will not come on and it blows hot as well.
View 3 Replies
I have a 2011 Santa Fe - I have noticed it is quite a rough ride. I guess I am used to the suspension in my Passat, but I still find it is not as smooth as it should be. I thought maybe giving it a bit of time would work, but so far at 25,000km it is still the same. Find it's a bit of a rough ride? Or should I look into it?
View 39 Replies
Never seen this problem before. Thought I had a leak in the system and had to have it serviced. The AC did not seam to be blowing cold. It would take forever to cool off. Was trying to get as much air on me as possible so I decided to point the passenger side vents towards the drivers side to cool off in the mean time. I noticed the passenger side was cold. Air is blowing out of the drivers side but not cold like the passenger side.
View 2 Replies
I have a 2010 Santa Fe. The passenger front door does not close well. It needs a very firm push to latch completely. Regular push and it only catches first click and bounces partially open. I loosened the catch on the jamb, but it seems this is not adjustable.
View 2 Replies
A few weeks ago my passenger side low-beam failed to come on during a short road trip. After a failed attempt to find a replacement at 9PM I had no choice but to continue on my way, about an hour later, as I was driving along, it suddenly came back on with no trouble since. I haven't touched any wires or fuses.
View 3 Replies
My santa fe was pulling to the passenger side and i got it aligned again at shop but after that was done its still pulling to the right side. What could be a cause of that? it only has 17 000 km.
View 10 Replies
So I was driving yesterday and my roof was still covered in snow. Came to a stop sign on a hill and all the snow from the roof decided to come off all at once onto my windshield. I turned the wipers on and only 1 wiper moved so I turned them off and then had to get out and clean all the snow off. Now my passenger side wiper arm doesn't move or moves randomly but not in sync with the other at all. If I lift the wiper arm up so the blade is in the air the arm moves no problem but the second I put the blade down it acts up again. It doesn't look bent or anything but it is loose and wobbly as in I can move the arm up and down where the drive side one seems pretty firm. How I can even take off the arm in the first place to look at it?
View 13 Replies
When I start the car for the first time of the day, the shifting is not as smooth as when the engine is hot. Is this normal ? When I checked the trans fluid, it was between 25 and 75...(the second little mark on the dipstick) but I just drove about 5min so maybe the engine wasn't warm enough..
View 6 Replies
I drive a SantaFe 2005 2.7 engine....lately it has a gas smell coming out of the passenger side- front... how is this coming from?
View 1 Replies
I have a strange problem. My driver side low beam dont work and my right side high beam dont work. Try different relay (switching), check fuse, bulb etc. Also in my dashboard the right green arrow for the flasher always still on(solid).
If I activate (with the control arm) the right turn flasher the flasher light blink in the dash board and my outside flasher bulb flash but my left high beam also blinking in the same time!
View 3 Replies
My son was hearing a bit of a squeaking on the passenger side. So I decided after some time to pull the front wheel. (most important brake). Well the pad wasn't moving on the outer guides (serviced it as required and lubed to get it moving). But the lower guide pin wouldn't move in/out. Needed to drift it out and it was very well rusted end to end. I put new pads on early as year I am sure and all was fine. I cleaned the pin on my wire wheel grinder. That lower pin had a collar near then end. Turns out its rubber, I thought it was a metal spring collar. Oh well the wire wheel did a number on it. I don't know the significant of that piece nor whether the pin is in the right place since the top one is different. I do these one at a time so its almost impossible I swapped them in the number of times they've been out.
I never seen so much tightening on any vehicle of pads and pins rusting in as on this vehicle. One has to wonder why. My vehicle also seems to have or what sound like a gear slap upon engaging in reverse or forward from front and back which is most notable after sitting and first engaged. Not every time but this is built in 2007 and there is a TSB for some washers. Hyundai Canada does NOT use the same TSB number they have their own. I talked to a dealer about it but he never indicated it would be the cause only its a different number. I am not impressed in this AWD drive power train. It needs a lot of TLC and the slap I hear is typically due to power train engagement play/slack being excessive most likely due to wear somewhere.. Even my rear sound off not a howl but noisy running which doesn't change with road surfaces so its not the tires. Maybe the AWD bearing or unit going. No of this should even remotely close to needed anything for at least another 100-150k at least.
View 29 Replies
My 2012 Santa fe crdi2.2 has 150000km. At the speed of 90km/H and faster there is a vibration coming from the back (passenger side I think).
There is no play on that wheel when it’s in the air, but it doesn’t turn smoothly. It turns smoothly until a point where there is obviously friction, once past that point it turns smoothly again for 3 quarters of the way until it reaches the same point…
The back wheel on the passenger’s side is the same story. Although the vibrations seem to come mainly from the driver’s side (at the back). Is this a wheel bearings problem or can it be something else?
I put a winter wheel at the back (driver’s side) to see if the problem was caused by the wheel. There is less vibration when driving, but it also starts at 90km/H. This winter tyre is higher, so probably it absorbs the vibrations better.
It's not a 4x4.
View 19 Replies
I have been noticing some kind of a oil/water mix wet spot on the floor every where i park. It looks like some thing is leaking near rear passenger wheel, close to struts. I have a 2008 Hyundai Santa Fe SE with 19K miles....
View 5 Replies
