Santa Fe (CM - 2007-12) :: 2009 GLS - Code P2422 / Evap Vent Solenoid Stuck Closed
Oct 9, 2014
My 2009 santa fe with the 2.7 has a check engine light. p2422 evap vent solenoid stuck closed. I replaced the charcoal canister and the light came back on. I replace the solenoid by the throttle body and the light came back on but took longer to set. My wife said that she was having problems filling the tank but when I changed the second solenoid the problem was gone but the light had returned.
View 6 Replies
Advertisement
I have a 1999 Ford Explorer with the V-6 SOHC that is stuttering and stalling when I try to accelerate. A very slight acceleration will get the vehicle moving, but anything coming close to normal gas pedal pressure causes immediate stuttering and/or stalling. Check Engine light came on when problem started yesterday.
Where is the EVAP System Canister Vent Solenoid? I bought a code reader after beating my head against the truck all afternoon and got code "P1451 EVAP System Canister Vent Solenoid Circuit Malfunction". My Haynes book says on the left side frame rail... can't find anything along there that looks like it (based on picture from Rock Auto for replacement part) and found some people online talking about it being in the engine compartment on the passenger side...
Just crawled all over the truck and I think I found the charcoal canister, but couldn't trace it back to the vent solenoid... There was something right next to the canister, but again, it looked nothing like the replacement part listed on Rock Auto...
View 14 Replies
I'm not too knowledgeable about wiring and electrical systems. I'm getting a P1451 code (EVAP Control System Canister Vent Solenoid Circuit Malfunction) on my 99 4.2. I've read that it could be a bad solenoid, bad wiring, or a blown fuse. So far I've;
- checked (and changed) the related fuse
- checked the wiring for damage at the connector
- checked voltage at the connector (12 volts)
- checked the resistance at the solenoid (around 60 ohms)
- actuated the solenoid with a 9V battery (can hear it opening and closing)
I haven't had a chance to check the wiring all the way back up the frame to yet, but I noticed that the ground at the trailer wiring harness has broken off the frame. Would this potentially cause a fault in the upstream wiring? I'm going to slap a new connector on and bolt it back down anyway, but as it's Labour (Labor) Day I'll have to wait for the stores to be open tomorrow.
View 12 Replies
I have a 2006 Hyundai Azera that is coming up with the error code P2422. I have figured out that the code relates to the EVAP system. I have cleared the code a few times but it always comes back within a few kilometers. Also I have started to notice at some gas stations that the gas stops pumping around every $5 i put in the tank. This only happens at some gas stations but not all that i go to.
View 3 Replies
2009 santa fe 67000 miles. Replaced fuel senders approx a month ago. All was fine. On about the 3rd fill up the cel came on. Code was for small leak evap. checked the gas cap, no problems. Replaced the purge valve and disconnected the battery while doing so. Cel light went off and stayed off thru one tank of gas. Filled up again and thought I detected a little fuel smell shortly after and cel came on again. I only smell fuel when its full and down to just before 3/4's. The light came on right before 3/4's. My husband is beyond frustrated and wants to smash the car lol. Once I get him calmed down where should we be looking for a leak and how to fix it? We can't afford a dealership bill right now and of course it's due for inspection next month.
Code was p0456
The only answer I got in the DIY section is to check around the fuel senders again but I'm leery to do it as I can't see how there would be a leak there, the covers go on SO hard even with that tool.
View 39 Replies
Getting OBD code P2422...Evaporative Emission Vent Valve stuck closed?? Had it once went to dealer they inspected...Happened again and they said they will replace a valve and possible the canister....I own a 2011 Santa Fe SE 3.5.......4000miles
View 7 Replies
I have a 2004 Santa Fe 2.4L the check engine light is on and says about the evap canister solenoid. I am trying to located it but I can't find it. So, where would it be located at so I can take it apart and where is the Canister located as well...
View 1 Replies
Just received a P0441 CEL (Evap Emission System Incorrect Purge Flow). I have a 2.7l engine, 2WD. I've read other forums and it seems it's most likely the purge valve or charcoal canister.
View 7 Replies
I've had the check engine light come on and was told it was probably from topping up too much and that it would go off on it's own... I should say I have no issues with idle or rough starts.
I had it scanned at Auto Zone. The print out shows: "EVAP emission system incorrect purge flow probable cause
1) Faulty purge control solenoid
2) Faulty vent solenoid
3) Blocked vapor canister
Previous posts suggest if it were a blocked vapor canister I'd have trouble completely filling the tank so I am hoping it's one of the others. Almost everything I see suggests the purge control and that looks like an easy fix. My concerns are a) if it is the vent solenoid - how hard is that to get at and b) what is the part number as I can't find it listed anywhere? I want to have both on hand before I start trying to fix this. Lastly if it is the vent solenoid should I just give up and see a dealer??
View 3 Replies
A buddy of mine has a 2003 Ford Ranger Edge V6 3.0L, he got the code P1450 the other day and asked me to look at it. Got all the info on what it could be but where ex actually is the EVAP canister and CV solenoid located? And what is the problem?
View 1 Replies
So... p1451. Vent solenoid. I pulled the part and put 12v to it. Opens/closes just fine. Checked resistance on part, 55ohms like it should. Pulled vent canister, no apparent leaks or blockages. I traced wires back to cab. Cannot locate anybroken wiring. I looked up the pinpoint test on this dct and all thats left to test out is the pcm itself. Before I buy the obd2 scanner with all modes I wondering if I am missing something.
I did find a broken ground wire in my searching. Frame to body. My thoughts on a bad ground are that that would cause more than one monitor to register one fault code.
View 14 Replies
I have another CEL : P1404... I know what this is, EGR Valve Stuck Closed. I just have one question about this. Is the valve the pintle? If not, what is the valve?
View 14 Replies
I bought the car with 117k and never since my possession bothered to service it. Why? I kept putting it off well at 165k I said heck ill do it. Currently at 170k my gear wont shift past third and its reoccurring almost daily. When I first bought it it was intermittent. I think the late service messed it up. Here's the thing, aamco will open up my pan and look at my solenoids which is 250ish.
View 14 Replies
I have two codes P0760 and P0755, malfunction shift solenoid B and C, today I took it to Hyundai here in queens ny, I was told that It would cost e 2684.00 to fix my issue, I can't believe that if those two codes are the problem why would it cost 2684.00 ? Where are these solenoids located?
The car feels like your one of the flintstones, it's stuck in 3rd gear and cant get out, then it jerks when it tries to shift, tranny oil is fine not burnt like if the clutches are gone.
View 2 Replies
Dealer said 90% bad ECU, 10% shift solenoid. ECU replace at dealer .. got code from auto zone, P0756 shift solenoid S2 blocked oil passage, stuck open. tranny shop took 2 days to confirm shift solenoid, changed out shift solenoid #2 35240, still have problem.. now they say it's ECU, rebuild my ECU.. what to do??!!
View 14 Replies
Check Engine Code P2006 intake manifold runner control stuck on closed? Taking it in to have it checked out.
View 10 Replies
I have a 2009 Santa Fe and last night, out of the blue, the engine wouldn't start. The shift lever was stuck in park and the brake pedal was very stiff and wouldn't move much. I popped the cap off the shift lock and moved it to neutral at which time the car started without a problem. I could drive but shifting was difficult and the lever didn't really click into a gear. I noticed that when shifting gears. the indicator on the dash would change from N to D and to R in reverse but when I moved up to park, the indicator went blank and the lever locked up again and had be released manually. I also noticed when I got home, since my driveway is a slope, that when the car seemed to be in park is rolled down the driveway, so I had to engage the emergency brake.
View 13 Replies
The CEL is on for a evap leak. I replaced both packing O-rings for the fuel pump, which I should have done when I replaced the fuel level senders. I have driven the car for a week with no resolution. I did try a new gas cap before I replaced the O-rings, but it didn't resolve the problem. I realize that I may have more than 1 issue, so I'll put the new gas cap on shortly. Just wondering if there's anything else I should check before I put the seats back. Are there any other common areas to fail that I need to check?
View 10 Replies
I was driving down the highway tonight and slid the sunroof back. When I went to close it I heard a loud click and got concerned. When I touched the butt to slide it again, it didn't move. I tried the other button and it didn't do anything. Just clicked. So, I finished my trip home as it sounded and seemed sealed. When I got home, I tried the buttons again, and only the told function worked, but only to the point of raising it.
Now I can't lower it.
2012 King Ranch completely optioned out. Never had any issues from it until last month when I had the A/C replaced at Ford. They broke my original factory windshield in the process and ended up replacing it, with another original, free of charge. I don't wanna jump to conclusions, but could they have damaged the sunroof intentionally to try to get me back there to recoop their losses?
View 6 Replies
We have a 2007 Hyundai Sonata Limited Edition. The problem started when the rear diver side door window stopped working. we took apart the door and saw that the cable was all twisted. We found the part at a junkyard and replaced it. Window worked. We closed the door and didn't think twice. A few hours later we tried to open the door and it's stuck. Both inside and outside handles move but nothing happens. The door won't open at all, what to do. We obviously can't get the door off without it opening. What may be causing this??
View 2 Replies
2012 Santa Fe all of a sudden won't engage starter. First thing in morning it usually cranks. But once I turn it off it won't crank again. When I turn the key I have full power so it's not the battery or terminals. There's no cracking or popping sound, just a whine like the starter's not engaging. Never had any problems with this car so far. I'm thinking maybe it's the starter solenoid.
View 5 Replies
