I have a 2.7L Santa Fe 7 seat automatic in Shanghai, China, imported new from Korea in 2007.
When it is raining outside with the air conditioning turned on and then I turn the headlights on, the A/C goes off. there are no lights on the console and the fans stop blowing. If I turn the headlights off again the A/C works again.
2004 Santa Fe 2.7L
When the headlights are on the left turn signal stays on(but does not blink). The right turn signal functions ok. With the headlights off both signals function normally. The headlights work correctly.
This issue happened once a year ago but just started reoccurring two days ago.
Looking for a tip on how to remove headlights. I have followed owners manual for my '08 Sante Fe Ltd on removing the two screws on top and retaining nut on back of light and unplugging the wire harness but the---- thing doesn't want to slide out. Is there a clip or screw that I am overlooking? I have watched the video on the Sonata. It feels tight on the tapered side(turn signal). I afraid of muscling it too much because there is so much plastic.
View 12 Replies2007 SE. When the car downshifts the head lights dim for a few seconds. I have a 2007 santa se. one mechanic i know says it could be a ground problem or a electronic transmission control.
View 3 RepliesI have problems with my SF 2002. When i turn on my headlights, the instruments panel (odometer, shifts indicator and others) has no lights. Turning off them, the shift indicator lights again.
I have notice that when days ago, i have changed my radio the problem began. Maybe the problem is related with this.
My headlights worked on Tuesday. Wednesday night driving home I put my headlights on and neither is working. My brake lights, directional and highbeams work. The only thing that doesn't is the headlights.
I replaced both headlights and still not working. I purchase fuses 15A and switch the fuses which were blown and it resulted in my horn going off. I had someone check with a gauge and there is power in the light socket. We tried to replace the fuse again and the horn went off. We removed the fuse for the horn and replaced the fuses for the headlights and the horn still went off even though the fuse was missing.
The mechanic, checked my fuse box and wires around it and was not able to determine the issue.
I am trying to figure out how to adjust my low beam headlights. i just need to move them up a little bit.
View 42 RepliesI have a 2008 Hyundai Santa fe and have recently had both low beam headlights go out. The running lights and high beams still both work. I read both bulbs as sat 0.5ohm(left) and 0.5ohm(right). Connections were right. I also read fuses in engine compartment HLP LO for both RH and LH. Still I swapped them both with the HHP HI and both worked for high beams but no change for low,on,either side. My next idea is the switch but I am not sure how to test it.
View 5 RepliesI have a 2008 Hyundai Santa Fe and wonder if the instrument panel lights only come on when the headlights are on? It sure is annoying not to have the instrument panel lit up.
View 3 Replies2008 Santa Fe Limited .... Car won't start. It has a new battery and alternator, new wires running to the battery. When I try to start it, there is no click and the headlights and dash lights go dim (they were very bright) then go back to bright when I stop trying to start the car. The same thing happens when I try to jump the car (using a car I have jump started this one with before). It has a Viper remote start and car alarm. When I first try to open the door it sounds like the factory alarm is going off, not the Viper one (and the Viper way of disabling the alarm with the valet switch doesn't work). The alarm seems to stop when I try to start the car, but not always. What could be wrong?
View 24 RepliesThe normal lo-beams won't turn on no matter what I do, but the brights still work. The bulbs are good, the fuses are good. I've tested and changed those. They're good. 2008 Santa Fe ....
View 13 RepliesBoth of my 2011 Santa Fe's headlamps (high and low) are not working. The fuses seem to be ok (ohm meter checked) and so do the relays (swapped with other relays). When I switch the lights on to the first position, I hear the relay for the 'parking' lights switch on and those lights work. When I move it to the headlight or auto positions, I don't hear the headlight relays click in.
Is there a schematic/parts location/troubleshooting diagram anywhere (they are not on the HMA web site)? Is there a known connector/wiring issue? I just found a diagram for the multifunction switch on steering wheel, with a pin out of the connector, but that's all I have. This will be hard to trace without some idea of where the wires are going.
I'm wondering if it's possible to turn on the foglights without the headlights on the 2013+ LS460. I understand it's not possible without modification on 2007 - 2012 models, but I'm wondering if anything's changed.
Ideally, I would want to run the foglights as "daytime running lights", preferably without modifications.
I have a 2007 and I've just developed my first problem since I purchased the car new in 2007. While driving, my headlight(s) will turn off by themselves.
Sometimes it's the right one, sometimes it's the left one, and sometimes they will both stop working. Turning the headlight switch off and then on brings them back to life.
What part in the headlight system is causing this?
Had the following problems with my 2009 Santa Fe: Audio system would randomly reset when playing MP3 from USB drive, Headlights would dim/flicker when bakes depressed, LED lights on dash would flicker, random stalling while driving. Finally just died and would not start. The Hazard lights would not work only a bit of buzzing from the relay. Checked Battery, connectors, etc. All looked good. Measured voltage at fusebox (inside) and found it dropped from 12v to 4v when I put the hazard switch on. Showed there was a connection problem of some kind.
Finally used a jumper cable from the battery negative terminal to an ground point inside the cabin. Bingo that fixed all the problems, car started, lights were good, hazards worked. As a permanent fix I ran a wire from where the negative terminal of the battery connects to the frame, then drilled a hole in the firewall and ran the wire into the cabin. Connected the wire to a ground point in the cabin. Used a heavy gauge stranded wire. you can try this out with lamp cord as a temporary fix, but I'd use something heavier for a permanent fix. All problems have gone. No flickering, no stalling... This may be a problem on other models from what I've read in some forums (unexplained stalling - check the grounding in the cabin..).
Just had both my low beam D4S headlights replaced at an auto shop. Once I turn the car on or flick the low beam headlights on, they turn on for about 10 seconds and then the driver followed by the passenger low beam headlights turn off. Why this is happening as both bulbs are brand new. Before I had the bulbs replaced only one bulb worked so I elected to get both replaced.
View 2 RepliesI have Prius 2007, base model + package 2 & no upgrades. Not sure if it came with HID. It does not have a fog light.
I parked the car in front of a restaurant and waited. Turned off the headlights while waiting with engine running. Fiddled with the interior panel brightness dial a bit. When I turned on the car again the headlights wouldn't turn on - both of them. Drove home with hi-beam.
Checked the fuses H-LP LO for both RH & LH sides. They seem fine.
Asked wife to turn on/off headlights from stick - I could hear the click in the relay - so DIM relay is ok. With stick knob set to headlights and car running asked for the stick to be pushed to turn on/off high-beam- Could hear the relay engage + high beam on/off.
I looked closely to see if the mirror is moving - no movement. Just found it is possible for the same bulb to be High & low beams when there is no mirror movement with dual filament bulbs.
Below in this photo-shopped picture the camry headlights have clear reflectors for the turn signals ..
I am going to be doing a HID retro , and I want to swap out my reflectors for some clear ones. Anything or anyplace I can get large non-vehicle specific reflectors and i can manufacture my own ? I want to keep the car as legal as possible, after my illegal retro (all retro's are illegal )
I am currently driving a 2012 Santa Fe Sport (Canadian). Over the weekend I encountered a problem with the ignition - the key would not turn. It happened once in the morning but it turned after I jiggled it a few times. It happened again in the afternoon but this time it would not turn at all. I had to call roadside assistance. They had me try a few things (pumping the breaks, shaking the steering wheel) but I couldn't get it to turn. They had to send a tow truck. When he arrive he fiddled with it for 30 seconds and got it to work but could not really explain why - only suggested that I take it to the dealership to have it looked at.
The vehicle is only a few months old (5200km).
I have a 2009 Santa Fe Limited with 47,000 Km on it.
Over the past 2 weeks I have noticed that when I go to start up the car, the ignition doesn't sound the same. Meaning, that typically when I start the car, I hear a quick turn of the ignition and away I go. When I now start up the car, the ignition does not turn over as quick and I'm now hearing a bit of a hesitation.
I'm not sure whether it's real or even possible. Starting this summer, when it's hot and I turn on AC, I feel loss of power from the engine. When need for speed, it's slow to accelerate. The engine is less powerful than when it's cool and no AC running. Is this possible? It's 2010 V6 AWD.
View 6 Replies