Santa Fe (CM - 2007-12) :: Transmission - Gear Indicator Disappears From The Screen On Dashboard
Apr 24, 2015
My 2010 Santa Fe has some transmission issues.
Now and then I notice the vehicle is kind of slow and every now and then when going from P to R, or R to D, it enters with a bang and after that the Gear indication in the dashboard disappears. At that moment the car is completely sluggish, like if it is some kind of lock mode. I have to turn it off and on again and all is back to normal, however, after an episode that it enters with a bang the transmission doesn't react as well as normally, it takes a while for the car to behave normal again.
The fact that the gear indicator disappears from the screen on the dashboard suggests to me that this is a computer problem more than a mechanical issue.
View 2 Replies
Advertisement
2010 UK Santa Fe manual box, suddenly will not set Cruise Control. At same time gear change advisory indicator also stopped working. OBDII tester will not initiate to check things out but first time I have tried this. Fuses checked all OK (I think).
View 1 Replies
The small screen in the middle between the speedometer and the RPM has not been functioning ever since in bought my Automatic 1.8T.
Now, to set some things straight, my transmission works fine. The small screen lights up in blue when the lights are lit, but the actual gears are not shown both with light or without light.
I checked my Fuses and all seem well. What could be the issue?
View 9 Replies
My 2010 Santa Fe's transmission has been smooth since the TCM update except there's always a clicking sound when the speed first reaches 30 km/h. The sound only happens once during each trip. It seems like it only happens when the fluid is cold. Once it's warmed up, it's fine.
Yesterday all of sudden I feel something is dragging my car. I noticed RPM is over 2000 when the speed is only about 60 km/h. (not mile). And the ECHO light is not ON. So I shift to '+/-' mode and the display shows 4. I guess it means it's in 4th gear. I shift up to 5th gear and RPM drops right away. ECHO light comes back ON. So is this a symptom of 2010 Santa Fe transmission?
I also feel my brake pedal is very stiff when this happens. And the brake pedal has not much travel distance. If the brakes are dragging car down, can this cause the transmission stuck at low gear?
View 2 Replies
Finding a solution to my problem with Santa Fe, the gear gets stuck up on the 3rd gear. I have changed all the solenoid and it is still the same.
View 2 Replies
My transmission got stuck in 3rd gear on the way home recently. I tried disconnecting and re-connecting the battery and that didn't work. Looks like there's fluid around the casing, but I wasn't sure if that was already there or not. What it could be? '07 Santa Fe (3.3L)
View 4 Replies
We have a 2010 Santa Fe AWD LTD with about 140, 000km on it. It recently came back from front suspension work. The suspension is fine now, but we notice harder shifts in the transmission. Also, there seems to be a vibration just before shifting gears and when under load (like going up hill) seems to slip (like on ice) about once every second until the shift is made. Once the shift is made it drive smoothly until put under pressure again. Even stepping down a bit on the accelerator will cause this slipping feeling (or maybe its loss of power). Just had new plugs put in and a tuneup so it's not that. Could something from the suspension work cause these symptoms?
View 29 Replies
Seems lately when driving up a long incline the Trans seems to slip back to third gear from overdrive. I watched the tach and it jumps up like it's went to another gear. But goes right back into overdrive. It will keep doing this as long as we're under load, like going up an incline. If I put it manually into 3rd and keep it there it won't do it.
We went on a long trip last summer and it kept doing it and it threw a tourque converter code. I can't remember which one tho. I did a drain and fill and it made it better but it's doing it again. We have 167,500 miles on it. I was told by Hyundai that it would be around $2800 for a rebuilt tranny. If I was to need one. Don't think the TPS would cause the shudder right? Seeing it doesn't do it when I keep it out of overdrive.
View 4 Replies
2010 ES350... Was detailing interior of car, and didn't realize headlights were on. Eventually, battery drained and car would not start. Had OEM, original battery installed at the time. No dashboard lights lit prior to this.
From what I recall, shortly after replacing the battery and getting vehicle started, my slip indicator was solidly lit on dashboard. No other lights are illuminated, and vehicle appears to behave the same.
Fast forward to today, my OBD II scanner (Innova) does not pick up any current DTC's. There are readiness codes stored, but I understand that these are merely emmission related. However, there are historical codes stored which I am concerned may be possibly contributing to the dashboard light. The codes are P1604 and B2799. These appear to be related to the immobilizer system on my ES. I've tried to clear these codes, but they won't go away, so I suspect something is still tripping this. Keys are fine, just changed the FOB battery out a couple of times. I may try my second set of keys to see if it fixes this mess.
Since my OBD scanner doesn't support ABS, I'd like to see if AutoZone or something of the like can detect if there are any codes being thrown by the ABS system. Not sure if this is what is tripping the SLIP light.
View 4 Replies
I bought a 1996 Lexus ls400 last July to extend the life of my Santa Fe. So during the summer months, I've hardly been driving the SF. My problem is that if I don't drive it for 4 to 5 days, I get a tapping noise on start up and it continues for about 3 to 4 minutes and then totally disappears. As long as I drive it every other day I never hear that sound. Not sure if this is a recent development or has always been there as the SF used to be my DD.
View 8 Replies
I drive a 2010 Santa Fe and have had this issue for a couple of months. After driving for approximately 20 minutes my ESC indicator light comes on and stays on. I'm not braking at the time or doing anything other than driving in a straight line on a clear road at about 80 km/hr. Drives fine for the rest of the trip even with the indicator on. After I shut the car off and then restart the indicator is off. Later in the day when I drive for another 20 minutes or so the indicator comes on again and stays on until I shut the car off and restart.
View 16 Replies
I have a 2011 F-150 with the center console shift lever. I mainly drive the truck during the day so it's possible I never notice this but do the gear indicators illuminate when the lights are on? I happened to look down when I put the truck in gear and noticed that the selector has a red light showing its position but it was really hard to see what gear you have selected.
Normally I just pull it down until I hit D, knowing it clicks 3 times, and I'm off. If you do happen to go into M then you see it on the dash. So I don't know if I've never noticed it or if I have a burned out bulb and its no longer lit up. It's not a big deal but I always like to replace burnt out dash lights just so it looks good but I don't know the answer to this one.
View 7 Replies
After rain my SF indicators in dashboard become crazy. Engine check, 4wd, reductor, TC stayed on when i start engine. Engine working is no good. I unplugged battery for 5 sec, and after that all is ok until next rain. If there is only one light on i know than there is a problem but 5 of them it looks like shortcut on some point.
View 10 Replies
Just got my 2011 Ecoboost FX4 on June 15th. For most of the time I had it, the in-dash LCD showed the 6 gears (on the right side of the display) for the trans & highlighted which gear it was in at any time (in Automatic mode, not select-shift). It disappeared & I can't figure out how to get it back?????? Nothing is listed in the manual.
View 9 Replies
I have a 2011 Santa Fe 3.5L automatic with AWD. I have had a issue with the traction control indicator locking up. The traction control light on the dash goes on and cannot be canceled by the on/off control. It will reset when the engine is turned off and restarted. It is my understanding that the indicator should be lit when the system is actively meeting a traction control issue.
The dealer has performed service on the vehicle twice for this issue, and on a recent trip the system triggered again. It has engaged and locked on dry surfaces during a moderate turn while accelerating (merging from exit ramp). I have seen it engage under slippery conditions (snow... we live in Wisconsin) while turning and then return to normal once the conditions are stable.
My concern is that since the traction control affects braking in order to achieve stability under unusual conditions, that the possibility exists for a malfunction under braking conditions that might cause more problems than it solves.
View 32 Replies
Month ago the malfunction indicator turned on. On checking it was found that wires over the engine were eaten by rats. Reconnection of wires solved the problem.
Today the malfunction indicator light is blinking. Could it be the same wires going loose?
View 10 Replies
2012 Santy V6 GLS Stock 17"
Lately in an intermittent fashion my TPMS indicator light will blink when I first start the car. It goes away within a minute of driving (might even go away if I just idle but I am always in a rush so I don't know...). At first I thought perhaps it was the cold weather but it happens even on warm days. I've checked all the pressures all around and they are good (not even borderline).
In the manual it says a malfunction is when the light blinks and then stays on. What would blinking then non persistent light mean? Communication issues?
View 25 Replies
2001 Accord, 6cyl. 3.0, automatic transmission. The last few weeks its been shifting a little rougher, but nothing thatd alarm me. Then last night, the check engine light popped on and the little green light around the D4 on the dash began blinking. I turned it off for a minute, restarted it and blinking light was gone but not check engine. Sat there and shifted through all the gears and the only thing I don't like is when i go from D3 to 2 and back. It shifts real hard there. Not as hard shifting back from 2 to D3 though. All other gears shift fine.
Also, I checked the fluid on the dipstick and it was right under the lower dot. Its my wifes old car and she "doesn't remember" if shes ever had the tranny flushed and a buddy said if it hasn't been flushed regularly by this point(125K miles), not a good idea to flush, just drain and refill. (Green blinking light around gear indicator) and what was the fix? Is it difficult to drain/refill the tranny and can I refill this model through the dipstick or do I have to get underneath? Do I REALLY have to use Honda ATF only or can I use whatever??
View 1 Replies
2007 Sante Fe Limited original owner. 87000 miles, great car. Having a problem with battery light coming on and then going off, also seat belt light off and on but no sound. The other night my ESC light came on for a while. New battery, alternator and serpentine belt installed a few months ago.
View 25 Replies
I have a late 2010 R 2.2 (the new motor)and have had a problem with the trafficators (indicators) not returning after making a right turn. They do return if the turn is shallow and if the turn is sharp but not in between. I've raised it with the dealer and workshop foreman 5 times but just get told it is normal with these and it's because of the airbag placement.
View 2 Replies
I recently bought a Santa fe 2007 Limited 3.3L, it has 101500 miles. The issue is that when i run the scan it has 3 minor sensors that needs to be replaced but my biggest concern is that the check engine light does not come on in the dashboard even when i turn the ignition to on.
I need to know if there is a fuse that can cause this or a bulb in the dashboard that i can replaced for myself or if it is something else.
View 7 Replies
