Whine that I am getting coming up from below the gear stick ,is certainly seems that it is a noisy bearing as noise stops when car does so I think it may be the bearing mounted in the rear of the casing/gearbox just in front of the rubber coupling but the dealer cant seem to find it in his parts list.
View 1 RepliesI have a Santa Fe Style CRDI Auto from 2011 which is not covered by Warranty and has only done 6000 miles.
The problem is that the Gear Stick Won't Move from the 'Park' position (with the engine on and brake fully pressed down).
There have been issues over the last couple of weeks where it was difficult to move the gear stick at times but it was fine after waiting a few seconds. Now it seems completely stuck.
'07 FWD Santa Fe exhibits pretty loud "'gear whine" with light acceleration.
Recent ATF change got loads of nasty gook and metallic sludge out of trans.. but no change in gear whine.
Dumb question, but do 2wd Santy's have a differential that I can drain and refill to quieten this whine down a little?
I have a 2009 3.3L santa fe integral transmission and for the second time they have a really bad shacking in the steering wheel and in the stick shift when I'm on the road the same thing like your drive on the side road bump to wake you up. I stop two times on the side of the road to find if they have anything abnormal but with no resolute.
My oils are all ok and no loss of performance of the car except they consume a little bit more gas (around 10L/100Km. The last time this happened the arm shifter vibrated.
Back to my 2007 FWD 2.7L Santa Fe. It has no Visors because a prior owner had them break and fall while driving, hitting them in the face. They dangled by the vanity light wires. They tore them out to get the visor out of their face before an accident happened. I priced new visors at $230 a pair plus shipping online. Ouch, a lot for another set of junk visors!
Recently the car stumbles and the ESC and engine light comes on. Had the codes checked then I and surfed the web and found it to likely be the TPS but the only one to fix it would be of course be the dealer. Diagnosis is $125. plus $70 part plus installation and then $105 to reprogram the TPS. I found the part online for $35. I will install it and then take it to the dealer to program it. So $140 instead of $500! I have yet to do that because I took the TB off and cleaned it. It stumbled a few more times and then ran fine for weeks. Its doing it again though once in a while, some days nothing happens others it happens 4 or 5 times. So I will have to get it done sooner than later. I have however found that it wont stumble and die if I put the car in neutral before I come to a stop. It just happens when its in gear, otherwise it runs fine. So until I take it in to replace the TPS I will use that technique.
I will follow up once I have installed the new TPS and had it programmed so you all will know if that took care of it. I have read some installed the TPS and in short time the computer adjusted to where it worked fine but fuel mileage was poor. Being I know how to drive it to keep it from dying at a stop now, I will wait until I get time and $100 to take it to the dealer for programming.
On my 2012 Santa Fe I'm getting a whining noise from the engine while it is park. I think it might be alternator.
View 3 RepliesI have a 2007 SE with 3.3L and Auto transmission. 70k miles, regular service performed.
Starting a few months back, I've noticed a low volume hum/whine coming from the engine compartment. I notice it more when I'm in drive, but also notice it to a lesser degree when in park and revving. In drive, the sound gets just a bit louder and higher pitch, until shifts, then lowers at low RPM, growing again as revs move up.
since it happens in park, I'm thinking it is engine related, not transmission? (I usually change oil around 4k, sometimes as high as 5k)...
I just noticed a whine in my steering when turning right and left on my 2010 SE. Sounds like I am out of power steering fluid but I checked the level and it looks fine. No signs of a leak.
View 7 RepliesWe've got a 2011 Santa Fe V6 that's putting out a low pitch cyclical whine at speeds between 5 and 15 mph. It could be making the sound at higher speeds but if it is the engine/wind noise drown it out.
If you're coasting or braking and drop below 5-7 mph, the noise cuts out completely and abruptly. Makes noise regardless of A/C running or off. Sounds like a motor turning on and off. Never makes noise while parked and revved, only while moving at low speeds (stop and go traffic, driving through parking lots, etc) - and is just loud enough to drive us crazy wondering what it is!
Dealer service center checked it out for 3 days - 4 different techs drove it, all heard the noise, but none knew where it was coming from. When you're driving, it seems to be coming from the passenger side of the engine.
On a side note, we first started hearing this noise after we got it back from dealer service, where they replaced the TPS and A/C compressor. I'm wondering if it could be from something they had to move to access the compressor?
I recently purchased a new 2010 Toyota Corolla LE auto and I really like it. I have about 2000 miles on it now and just recently noticed a faint gear whine coming from the transmission at around 60 mph. You can only hear it when the radio is off and you really listen for it during the acceleration. It only does it when transmission fluid is fully warmed up after driving for about 15 miles. 2010 corolla uses U341E transmission that specifies Toyota WS transmission fluid. I noticed that 2001 - 2005 Supra uses the same transmission but it requires T-IV fluid which has more viscosity than WS. Noticed this faint gear whine on this car or do I need to take it to the dealer? My other car 2003 Toyota Echo uses U340E transmission and it has gear whine as well, except it is more pronounced than in Corolla, so I an trying to figure out if this is normal for this transmission or not.
View 10 RepliesMy 2.2 crtd is the first ever diesel car i have bought, but i have noticed a whine especially when cold, pitch bieng raised as engine revs. Is this a characteristic of this car or am i in for a bill further down the line.
View 3 RepliesThe car has about 53k miles. The problem has persisted since probably 20k miles. The whine is only after the trans warms up and is in drive or reverse, not in neutral. Whine is while the car is stationary or moving at low speed. The whine doesn't seem to change due to gear it is in. It does not change frequency with engine RPM. It does seem to diminish the more load the transmission is under.
Whine is probably not an accurate description, it sounds like a noisy pressure relief valve. Had Hyundai service look at it and all they said was all pressures in the transmission are normal. They could not find any cause.
It sounds like a bunch of small ball bearings running in a loop and can hear each one impact. Sharp raspy impact type sound.
You cannot hear it from the interior but it is quite pronounced while in the garage or if you hear the car coming down the driveway.
Recently i noticed that my gear stick is very loose. I have read that this is a problem with the linkage bushes. I have found that the bushes are in the engine bay (3 i think) but i was wondering if there are more bushes under the gear stick that i need to change. Looking for a complete kit for all the parts needed ? Do i have to change something else ?
View 1 RepliesThe car is a Citroen Xsara 1.3VTR. The gear stick shakes like crazy when I accelerate or if I'm driving up a hill it vibrates again and doesn't seem to have that much power either. There is no other problem with the car.
View 1 Repliesl got a problem with my 01 hyundia accent I have no gears at all,the gear stick is floppy. I have looked at the linkage from the stick to the gear box it's all ok but as it enters the box it has no resistance. The clutch is about 1year old.
View 2 RepliesSanta fe limited V6 will not go above 2nd gear. It will fall into failsafe mode. The motor will just rev up and not accelerate past 20-30mph. Have already done transmission flush and changed Input and Output speed sensors however the problem still exists. Where to go next before I send it off to repair shop. I don't remember the codes but it was described to me as no output from 4th gear .
View 4 RepliesGot the following problem with my 2004:
1. Unlocked ny car this morning by use of my remote key and the alarm went off.
2. Got the alarm turned off by locking and unlocking my car several times by use of my remote keys
3. Put the car in reverse and took out of the garage. Parked the car and put the gear stick in P position. The knob on the left side of the gear stick remained in the "in" position where one usually can move the gear stick up and down between the gears.
4. However, I was not able to move the gear stick, and the main display said something in German like "Call the workshop".
5. Locked the car bye use of one of my three remote keys.
6. Later, after trying to solve the gear stick problem by moving the knob and the gear stick in several ways I was not able to lock the car with any of my remote keys. No messages were displayed.
7. I was only able to manually lock the door where I used my key.
The knob on the gear stick is showing scratch marks so someone has tried to do something to it earlier. I have owned the car since easter this year and has not experienced this problem earlier.
The battery on the left side of the car is new, and the batteries were charged for 12 hours two weeks ago. The car has not been driven much since easter, and has only been taken in and out of the garage four times during the last three weeks without being driven.
When driving, a pin fell out of the shifter arm under the car and now the shift stick is extremely loose and, although it will go into gear, it is almost undriveable. I have reinserted a pin, but the stick shift is still loose. I gave it a test drive and I drove about 10 feet in first gear, but when I put it into reverse, the car continues to move forward.
View 7 RepliesI have a 2004 Hyundai Accent, has 167k miles on it. Transmission has 80k, put in at about 155k. Came home from Tahoe, and the next day, I tried to go to work, and the gear shift was stuck in first. Hadn't had the money to get anything fixed, but when I finally got it looked at, was told I needed a new clutch and possibly a new flywheel. Been cleaning it out to sell, and today I started it up and realized that the stick is in neutral and moves back and forth freely, but the transmission is in gear. I know that, because I had to keep my foot on the clutch to keep it running. What would cause that? I'm hoping it's something easy and cheaper to fix, because I love this car and am not ready to part with it just yet. The clutch doesn't have that many miles on it either, maybe 10-15k, if that. I've had the car for almost ten years, so it's not poor driving, on my part.
View 6 RepliesI have recently purchased an Hyundai Santa Fe 2006 2.2 diesel (Mk2).
I am experiencing a rattle when the car is out of gear. First heard it this morning. When I am in Neutral and I rev the car, as the revs drop back down to idle (700-800 rpm) i get a rattle from about 1000 rpm downover. Seems to disappear when at 800 rpm but not all the time. If I depress the clutch when sound is evident then it disappears.
Bought a 2001 hyundai accent 1.3 si petrol manual 2 weeks ago. After pulling off today, i went to go into 2nd gear, and I couldn't move the gear stick. I parked up and turned the engine off, then started the ignition again. When the clutch is in, the gear stick will not move in any direction, its completely stuck, but when the clutch is out, the gear stick will move in all directions.
View 6 Replies