I have a 2012 Santa Fe and during the last cold spell, both myself and passenger felt a lot of very cold drafts entering the car through the door handle and door switches.
View 3 RepliesAbout two years ago I paid the dealership to fix my drivers side door. It had TERRIBLE wind noise and once complete there was a major difference. I was very happy with the results. Guess what's back? Yes, that damn wind noise.
View 14 RepliesWhen the car is in a situation where there is a twisting force, such as entering an inclined driveway from an angle, a loud POP is sometimes heard from the rear of the car. The intensity of the POP varies dependent on speed and angle of incline, higher speed/greater incline/decline produce a louder POP.
View 4 RepliesMy wife's 2007 SF has a stuck gas door. When the button is depressed nothing happens. Is this a known issue ?
View 2 RepliesBought 2009 santa fe new [3.3]. after cold start up tac is moving up and down and it seems to be missing. After temp is reached tac is steady but there still seem to be a hesitation when driving. 21,000 miles on vehicle. could it be a bad tbs?
View 4 RepliesI just bought a 2010 Santa Fe. All seems fine except that when the car is cold it goes into R harshly (with a bump and a small delay)and also is a little bit irregular in normal gear. I'm used to have cars with transmission problems unfortunately and happily it's nothing like that but I'd really finally like to have a vehicle without any tranny issues.
View 3 RepliesMy car is an 08 AWD 3.3 I am noticing the engine will do a slight rev up, down, up, down when cold almost daily when I leave work in the afternoons.
I removed the airbox and intake tubing, cleaned the throttle body with TB cleaner and mass air sensor with electronics cleaner. I also used about half of a bottle of seafoam in one of the vacuum lines to the engine, and the other half in the fuel tank. Also ran some Chevron fuel system cleaner in the fuel tank. Nothing seemed to make a difference. It still persists.
It's noticeable the most in neutral, you can watch the tach rev up from 800 rpm to about 1100 and back down repeatedly. If the car is in drive and the brake is lightly applied, it will want to move when its revving up.
When its under ca -5degrece my oil lamp lighten up ca 8 sek. My oil pressure at warm motor is 3.3 bar, what is wrong...
View 2 RepliesI have a 2007 3.3 with 42K miles on it and the AC just started passing air that's not quite as cold as it used to be. When its at idle I would say its a mild cold and then when driving its the same mild cold but with more force. Understandably today is really the first hot, humid day of many to come so I was wondering is there any good indication that its just low freon with a leak or the compressor is going or is there any adjustment to the belt in case its just slipping? I did it drive it for quite awhile and it never improved. I would hate to drive it more and ask for a bigger problem.
View 2 RepliesWell its the coldest this SF has endured while in my barn. It was -23C last night or early this morning went we got up. -19C now but it doesn't warm up with a slight change sitting outside. I started it ok but these newer vehicles sure make a lot of whining and other noises when its this cold until they run for a minute they quiet down.
My old Grand Cherokee was a lot quieter even with near 300k on it it. But my wife's Jeep Compass a 2009 made enough noises as well. Both have synthetic oil in them. I just don't like hearing all that and wonder what its like for you that are in much colder climate with your SF since -30 to -40C is common in other parts of Canada in the Winter. Just curious because it cannot be good and the PS pump must be one of the complainers I am sure.
I have a 2007 SF 2.7L V6 with 55000km.
Recently we have noticed that from a cold start the engine idles roughly few a short time and especially bad if put into gear only moments after starting.
Do we need to let it warm up for longer?
I just purchased a certified 2011 Santa Fe GLS and has a mysterious creak or "pop" in door pillar or door area when on a rough road or the frame is in bind on uneven terrain (minor at most). It's not major....just irritating. Will I get anywhere when I ask Hyundai to see if they can find it?
View 2 RepliesAs long as we are mentioning things, the trim/gasket around my rear doors on my 08 Santa Fe does not fit right. You can see it in the attached photo. The gasket is one piece, and there is no way to arrange the slack so that there is not a gap. Maybe someone used the wrong one at the factory, or is this a common/known problem? I'll ask about it the next time I'm in the dealer.
View 18 RepliesI have 2007 Santa fe Limited and have problem with door locking while driving. All doors was locking automatically after acceleration before, but now all doors remains open no matter what speed and what distance I drive.
View 5 RepliesTwice this week our 2009 SantaFe (3.3l) had a squeal from the engine upon cold startup. The first time it was very cold (-20C or so) and this was louder and longer than the second time (-10C or so). The squeal lasted only a few seconds and trailed off to nothing. Each time the heater controls were set on defrost (fyi). In order of likely suspects, I suspect one of the following:
-compressor engaging and causing sudden increase in resistance on the belt or compressor engagement clutch noisy
-idler pulley for some reason causing belt to slip at first, but don't suspect idler bearing as noise disappears right away
-belt slippage due to resistance somewhere else--e.g. water pump or alternator.
This may not happen when I take the vehicle in for its next scheduled maintenance as by then the weather will likely be warmer. This has 76000 km on the clock.
I've been experiencing ENGINE RPM FLUCTUATION on cold starts. I took it into the dealer and they found an update available for the ECU and reprogrammed the ECU.
2009 Santa Fe ?
So far it appears to have corrected the RPM Fluctuation on a cold start... I see TSB 10-FL-010 cover this but also suggests to replace the Throttle Position Sensor which wasn't done on my vehicle.
The vehicle has 80,000kms, and from a cold start it is having this problem more and more frequently. I must crank the engine 3+ times, and then she starts. A prolonged cranking period doesn't seem to work, and this only occurs when cold. The car starts fine when warmed up. I have scanned the car with a generic OBD2 reader and there are no codes. Once the car is running, it runs great with no misfires.
View 1 RepliesHaving an issue with my 2007 Santa Fe 3.3L. When the engine is cold, been sitting for a few hours not when the temp outside is cold, it takes about 5 to 8 cranks before the engine will fire. I can then shut it off immediately and start it again and it will fire right up.
I currently have the P0464, P0463 and P2068 check engine error codes for the fuel level sensor units. I don't really know if these are directly related as I've had them for about 6 months and the starting issue has just shown up the last month or so. Plus, I would assume these should only be related to sending fuel level information to the fuel gauge. Either way, I'm still leaning toward a fuel delivery issue since it only has a hard time starting when the car has been sitting for a few hours. I don't know if maybe it's the fuel pump or a electrical component. If it's the fuel pump, I'd like to do that when I take care of the sending units so I don't have to go back in. I've tried turning the car to the 'on" position for about 10 seconds without starting it to see if I could get the pump to load the line, if that's the issue, but it doesn't seem to make a difference.
The battery is good. It tested 12.5v after sitting over night.
I have Santa fe 2009, I was in a 5 days trip, now I'm back home and it seems like that the car's light was on so the battery is goes dead, now I can not open the car's door neither by remote nor by the key! why I can not open the car door with key?
View 37 RepliesI have a 2010 Santa Fe. The passenger front door does not close well. It needs a very firm push to latch completely. Regular push and it only catches first click and bounces partially open. I loosened the catch on the jamb, but it seems this is not adjustable.
View 2 RepliesI am driving a 2012 Sante Fe with a bit of a problem. A rear door does not open from inside nor outside. Is there a way to remove the panel to gain access with the door closed?
View 3 Replies